Download or read book Wideband Amplifiers written by Peter Staric and published by Springer Science & Business Media. This book was released on 2007-11-03 with total page 648 pages. Available in PDF, EPUB and Kindle. Book excerpt: This work covers two bases, both performance optimization strategies and a complete introduction to mathematical procedures required for a successful circuit design. It starts from the basics of mathematical procedures and circuit analysis before moving on to the more advanced topics of system optimization and synthesis, along with the complete mathematical apparatus required. The authors have been at pains to make the material accessible by limiting the mathematics to the necessary minimum.

Download or read book Highly Linear Integrated Wideband Amplifiers written by Henrik Sjöland and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 171 pages. Available in PDF, EPUB and Kindle. Book excerpt: Highly Linear Integrated Wideband Amplifiers: Design and Analysis Techniques for Frequencies from Audio to RF deals with the complicated issues involved in the design of high-linearity integrated wideband amplifiers for different operating frequencies. The book demonstrates these principles using a number of high-performance designs. New topologies for high linearity are presented, as well as a novel method for estimating the intermodulation distortion of a wideband signal. One of the most exciting results presented is an enhanced feedback configuration called feedback boosting that is capable of very low distortion. Also important is a statistical method for relating the intermodulation distortion of a wideband signal to the total harmonic distortion (THD) of a single tone. The THD, as opposed to the intermodulation distortion of the wideband signal, is easy to measure and use as a design parameter. Three different applications where high linearity is needed are identified, namely audio power amplifiers, wideband IF amplifiers and RF power amplifiers. For these applications high-performance integrated amplifier designs using novel topologies are presented together with measurement results. The audio amplifiers are built in CMOS and are capable of driving 8Omega loudspeaker loads directly without using any external components. One of the designs can operate on a supply voltage down to 1.5V. Both bipolar and CMOS wideband IF amplifiers are built; they are fully differential and have linearity from DC to 20 MHz. Finally, an RF power amplifier is built in CMOS, without using inductors, in order to investigate what performance can be achieved without them. Highly Linear Integrated Wideband Amplifiers: Design and Analysis Techniques for Frequencies from Audio to RF is an excellent reference for researchers and designers of integrated amplifiers, and may be used as a text for advanced courses on the topic.

Download or read book Wideband Low Noise Amplifiers Exploiting Thermal Noise Cancellation written by Federico Bruccoleri and published by Springer Science & Business Media. This book was released on 2006-03-30 with total page 191 pages. Available in PDF, EPUB and Kindle. Book excerpt: Low Noise Amplifiers (LNAs) are commonly used to amplify signals that are too weak for direct processing for example in radio or cable receivers. Traditionally, low noise amplifiers are implemented via tuned amplifiers, exploiting inductors and capacitors in resonating LC-circuits. This can render very low noise but only in a relatively narrow frequency band close to resonance. There is a clear trend to use more bandwidth for communication, both via cables (e.g. cable TV, internet) and wireless links (e.g. satellite links and Ultra Wideband Band). Hence wideband low-noise amplifier techniques are very much needed. Wideband Low Noise Amplifiers Exploiting Thermal Noise Cancellation explores techniques to realize wideband amplifiers, capable of impedance matching and still achieving a low noise figure well below 3dB. This can be achieved with a new noise cancelling technique as described in this book. By using this technique, the thermal noise of the input transistor of the LNA can be cancelled while the wanted signal is amplified! The book gives a detailed analysis of this technique and presents several new amplifier circuits. This book is directly relevant for IC designers and researchers working on integrated transceivers. Although the focus is on CMOS circuits, the techniques can just as well be applied to other IC technologies, e.g. bipolar and GaAs, and even in discrete component technologies.

Download or read book Wideband Amplifier Design written by Allen L. Hollister and published by SciTech Publishing. This book was released on 2007-06-30 with total page 411 pages. Available in PDF, EPUB and Kindle. Book excerpt: Allen Hollister uses easy models to develop the theory needed to understand wideband amplifier design. With this theory, he develops equations used in high frequency design, giving the reader an understanding of the process and circuit.

Download or read book Low Noise Wide Band Amplifiers in Bipolar and CMOS Technologies written by Zhong Yuan Chong and published by Springer Science & Business Media. This book was released on 2013-03-09 with total page 219 pages. Available in PDF, EPUB and Kindle. Book excerpt: Analog circuit design has grown in importance because so many circuits cannot be realized with digital techniques. Examples are receiver front-ends, particle detector circuits, etc. Actually, all circuits which require high precision, high speed and low power consumption need analog solutions. High precision also needs low noise. Much has been written already on low noise design and optimization for low noise. Very little is available however if the source is not resistive but capacitive or inductive as is the case with antennas or semiconductor detectors. This book provides design techniques for these types of optimization. This book is thus intended firstly for engineers on senior or graduate level who have already designed their first operational amplifiers and want to go further. It is especially for engineers who do not want just a circuit but the best circuit. Design techniques are given that lead to the best performance within a certain technology. Moreover, this is done for all important technologies such as bipolar, CMOS and BiCMOS. Secondly, this book is intended for engineers who want to understand what they are doing. The design techniques are intended to provide insight. In this way, the design techniques can easily be extended to other circuits as well. Also, the design techniques form a first step towards design automation. Thirdly, this book is intended for analog design engineers who want to become familiar with both bipolar and CMOS technologies and who want to learn more about which transistor to choose in BiCMOS.

Download or read book Low Noise Wide Band Amplifiers in Bipolar and CMOS Technologies written by Zhong Yuan Chong and published by Springer Science & Business Media. This book was released on 1990-11-30 with total page 234 pages. Available in PDF, EPUB and Kindle. Book excerpt: Analog circuit design has grown in importance because so many circuits cannot be realized with digital techniques. Examples are receiver front-ends, particle detector circuits, etc. Actually, all circuits which require high precision, high speed and low power consumption need analog solutions. High precision also needs low noise. Much has been written already on low noise design and optimization for low noise. Very little is available however if the source is not resistive but capacitive or inductive as is the case with antennas or semiconductor detectors. This book provides design techniques for these types of optimization. This book is thus intended firstly for engineers on senior or graduate level who have already designed their first operational amplifiers and want to go further. It is especially for engineers who do not want just a circuit but the best circuit. Design techniques are given that lead to the best performance within a certain technology. Moreover, this is done for all important technologies such as bipolar, CMOS and BiCMOS. Secondly, this book is intended for engineers who want to understand what they are doing. The design techniques are intended to provide insight. In this way, the design techniques can easily be extended to other circuits as well. Also, the design techniques form a first step towards design automation. Thirdly, this book is intended for analog design engineers who want to become familiar with both bipolar and CMOS technologies and who want to learn more about which transistor to choose in BiCMOS.

Download or read book Design of Low Noise Amplifiers for Ultra Wideband Communications written by Roberto Díaz Ortega and published by McGraw Hill Professional. This book was released on 2014-01-13 with total page 129 pages. Available in PDF, EPUB and Kindle. Book excerpt: Cutting-edge techniques for ultra-wideband, low-noise amplifier design This pioneering resource presents alternatives for implementing power- and area-efficient integrated low-noise amplifiers for ultra-wideband communications. Design methodologies for distributed amplifiers, feedback amplifiers, inductor structures with reduced area, and inductorless techniques are discussed. Cowritten by international experts in industry and academia, this book addresses the state of the art in integrated circuit design in the context of emerging systems. Design of Low-Noise Amplifiers for Ultra-Wideband Communications covers: Ultra-wideband overview and system approach Distributed amplifiers Wideband low-noise amplifiers Feedback wideband low-noise amplifiers Inductorless techniques

Download or read book Highly Linear Integrated Wideband Amplifiers written by Henrik Sjoland and published by . This book was released on 1999-01-31 with total page 184 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Raman Amplifiers for Telecommunications 2 written by Mohammad N. Islam and published by Springer. This book was released on 2007-06-04 with total page 457 pages. Available in PDF, EPUB and Kindle. Book excerpt: This edited monograph is written by leading experts in this area and is the first book entirely devoted to Raman amplification. Three sections include extensive background on Raman physics, descriptions of sub-systems and modules utilizing Raman technology, and a review of current state-of-the-art systems.

Download or read book Bibliography on Feedback Amplifiers written by R. B. Hartman and published by . This book was released on 1948 with total page 64 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Wideband Low Noise Amplifiers Exploiting Thermal Noise Cancellation written by Federico Bruccoleri and published by Springer. This book was released on 2008-11-01 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: Low Noise Amplifiers (LNAs) are commonly used to amplify signals that are too weak for direct processing for example in radio or cable receivers. Traditionally, low noise amplifiers are implemented via tuned amplifiers, exploiting inductors and capacitors in resonating LC-circuits. This can render very low noise but only in a relatively narrow frequency band close to resonance. There is a clear trend to use more bandwidth for communication, both via cables (e.g. cable TV, internet) and wireless links (e.g. satellite links and Ultra Wideband Band). Hence wideband low-noise amplifier techniques are very much needed. Wideband Low Noise Amplifiers Exploiting Thermal Noise Cancellation explores techniques to realize wideband amplifiers, capable of impedance matching and still achieving a low noise figure well below 3dB. This can be achieved with a new noise cancelling technique as described in this book. By using this technique, the thermal noise of the input transistor of the LNA can be cancelled while the wanted signal is amplified! The book gives a detailed analysis of this technique and presents several new amplifier circuits. This book is directly relevant for IC designers and researchers working on integrated transceivers. Although the focus is on CMOS circuits, the techniques can just as well be applied to other IC technologies, e.g. bipolar and GaAs, and even in discrete component technologies.

Download or read book Distributed CMOS Bidirectional Amplifiers written by Ziad El-Khatib and published by Springer Science & Business Media. This book was released on 2012-05-02 with total page 158 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book describes methods to design distributed amplifiers useful for performing circuit functions such as duplexing, paraphrase amplification, phase shifting power splitting and power combiner applications. A CMOS bidirectional distributed amplifier is presented that combines for the first time device-level with circuit-level linearization, suppressing the third-order intermodulation distortion. It is implemented in 0.13um RF CMOS technology for use in highly-linear, low-cost UWB Radio-over-Fiber communication systems.

Download or read book Control Engineering and Information Systems written by Zhijing Liu and published by CRC Press. This book was released on 2015-01-19 with total page 1054 pages. Available in PDF, EPUB and Kindle. Book excerpt: Control Engineering and Information Systems contains the papers presented at the 2014 International Conference on Control Engineering and Information Systems (ICCEIS 2014, Yueyang, Hunan, China, 20-22 June 2014). All major aspects of the theory and applications of control engineering and information systems are addressed, including: – Intelligent systems – Teaching cases – Pattern recognition – Industry application – Machine learning – Systems science and systems engineering – Data mining – Optimization – Business process management – Evolution of public sector ICT – IS economics – IS security and privacy – Personal data markets – Wireless ad hoc and sensor networks – Database and system security – Application of spatial information system – Other related areas Control Engineering and Information Systems provides a valuable source of information for scholars, researchers and academics in control engineering and information systems.

Download or read book Op Amp Circuits Manual written by R. M. Marston and published by Elsevier. This book was released on 2016-06-24 with total page 220 pages. Available in PDF, EPUB and Kindle. Book excerpt: Op-amp Circuits Manual discusses the operating and applications of operational amplifier (op-amp) circuits. The book is comprised of 10 chapters that present practical circuits, diagrams, and tables. The text first deals with the standard op-amp of the 741 type. Next, the book covers the special types of op-amp, such as the Norton amplifier, the operational transductance amplifier (OTA), and the LM 10 op-amp/reference IC. The selection will be of great use to design engineers and technicians. Undergraduate students of electronics-related degree will also find this book interesting.

Download or read book The VLSI Handbook written by Wai-Kai Chen and published by CRC Press. This book was released on 2018-10-03 with total page 2320 pages. Available in PDF, EPUB and Kindle. Book excerpt: For the new millenium, Wai-Kai Chen introduced a monumental reference for the design, analysis, and prediction of VLSI circuits: The VLSI Handbook. Still a valuable tool for dealing with the most dynamic field in engineering, this second edition includes 13 sections comprising nearly 100 chapters focused on the key concepts, models, and equations. Written by a stellar international panel of expert contributors, this handbook is a reliable, comprehensive resource for real answers to practical problems. It emphasizes fundamental theory underlying professional applications and also reflects key areas of industrial and research focus. WHAT'S IN THE SECOND EDITION? Sections on... Low-power electronics and design VLSI signal processing Chapters on... CMOS fabrication Content-addressable memory Compound semiconductor RF circuits High-speed circuit design principles SiGe HBT technology Bipolar junction transistor amplifiers Performance modeling and analysis using SystemC Design languages, expanded from two chapters to twelve Testing of digital systems Structured for convenient navigation and loaded with practical solutions, The VLSI Handbook, Second Edition remains the first choice for answers to the problems and challenges faced daily in engineering practice.

Download or read book RF Power Amplifiers written by Mihai Albulet and published by SciTech Publishing. This book was released on 2001-06-30 with total page 376 pages. Available in PDF, EPUB and Kindle. Book excerpt: The book reviews developments in the following fields: RF power amplifiers, modulators and power transistors

Download or read book Feedforward Amplifiers for Wideband Communication Systems written by Jon Legarda and published by Springer Science & Business Media. This book was released on 2006-11-10 with total page 189 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book has been possible thanks to the research carried out in the field of the linearization techniques applied to digital communication systems, particularly to those with high spectral efficient modulation techniques. It merges in the need of developing frequency efficient modulations with widespread codification techniques. The book puts into practice the Feedforward linearization technique, aimed at improving either the linearity or efficiency parameters of power amplifiers.