Download or read book Use of Innovative Concrete Mixes for Improved Constructability and Sustainability of Bridge Decks written by and published by . This book was released on 2013 with total page 100 pages. Available in PDF, EPUB and Kindle. Book excerpt: Bridge deck crack surveys were performed on twelve bridges on US-59 south of Lawrence, Kansas, to determine the effects of mixture proportions, concrete properties, deck type, and girder type on the crack density of reinforced concrete bridge decks. Of the twelve decks surveyed, eight are supported by prestressed concrete girders and four are supported by steel girders. Four of the decks supported by prestressed girders are cast on partial-depth precast deck panels, two are monolithic with synthetic fibers, and two have overlays. Of the four decks supported by steel girders, two have silica fume overlays (SFO) and two are monolithic. One of two decks with a silica fume overlay contains synthetic fibers in the overlay. Following the surveys, crack maps were plotted and analyzed and cracking trends were observed. The results for the US-59 bridge decks are compared with crack densities obtained in a study of low-cracking high-performance concrete (LC-HPC) bridge decks. The monolithic concrete bridge decks supported by prestressed concrete girders within this study exhibit less cracking than decks supported by steel girders. At an age of approximately three and a half years, the US-59 monolithic decks supported by prestressed girders with deck panels are not displaying significant cracking; most of the cracks are short transverse cracks aligned with the joints between the deck panels. The US-59 decks supported by prestressed girders with overlays exhibit significantly more cracking than the decks on prestressed girders without overlays. Bridge decks supported by steel girders without overlays have slightly higher crack densities than the decks with overlays. No benefits of using fibers in either the overlay or deck have been observed in this study, the sample size, however, is small. An increase in crack density was observed with an increase in average concrete slump for decks supported by both prestressed and steel girders. Decks with deck panels supported by prestressed girders exhibited an increased crack density with an increase in paste content.

Download or read book Sustainability assessment of concrete bridge deck designs in coastal environments using neutrosophic criteria weights written by Ignacio J. Navarro and published by Infinite Study. This book was released on with total page 20 pages. Available in PDF, EPUB and Kindle. Book excerpt: Essential infrastructures such as bridges are designed to provide a long-lasting and intergenerational functionality. In those cases, sustainability becomes of paramount importance when the infrastructure is exposed to aggressive environments, which can jeopardise their durability and lead to significant maintenance demands. The assessment of sustainability is however often complex and uncertain. The present study assesses the sustainability performance of 16 alternative designs of a concrete bridge deck in a coastal environment on the basis of a neutrosophic group analytic hierarchy process (AHP). The use of neutrosophic logic in the field of multi-criteria decision-making, as a generalisation of the widely used fuzzy logic, allows for a proper capture of the vagueness and uncertainties of the judgements emitted by the decision-makers. TOPSIS technique is then used to aggregate the different sustainability criteria. From the results, it is derived that only the simultaneous consideration of the economic, environmental and social life cycle impacts of a design shall lead to adequate sustainable designs. Choices made based on the optimality of a design in only some of the sustainability pillars will lead to erroneous conclusions. The use of concrete with silica fume has resulted in a sustainability performance of 46.3% better than conventional concrete designs.

Download or read book Guidelines for Concrete Mixtures Containing Supplementary Cementitious Materials to Enhance Durability of Bridge Decks written by John S. Lawler and published by Transportation Research Board. This book was released on 2007 with total page 130 pages. Available in PDF, EPUB and Kindle. Book excerpt: NCHRP Report 566 is designed to help facilitate the use of supplementary cementitious materials to enhance durability of concrete used in highway construction, especially bridge decks. The report includes a methodology for selecting optimum concrete mixture proportions that focuses on durability aspects of concrete and the performance requirements for specific environmental conditions. The methodology is presented in a text format and as a computational tool, in the form of a Visual Basic?driven Microsoft Excel spreadsheet. Background information and a hypothetical case study was published as NCHRP Web-Only Document 110: Supplementary Cementitious Materials to Enhance Durability of Concrete Bridge Decks. The Statistical Experimental Design for Optimizing Concrete (SEDOC), the computational tool for the concrete mixture optimization methodology, and the user?s guide are available in a ZIP format for download.

Download or read book Rethinking Bridge Deck Longevity and Maintenance with Portland Cement Polymer Concrete written by Andrew P. Agosto and published by . This book was released on 2008 with total page 134 pages. Available in PDF, EPUB and Kindle. Book excerpt: Bridge deck deterioration in the northern Midwest creates significant costs to state Departments of Transportation (DOT's) in the region. The fundamental cause of the problem is low tensile strength and water permeable reinforced concrete resulting in deck cracking and ultimately reinforcing bar corrosion. Portland Cement Polymer Concrete (PCPC) combined with a design approach tailored to its advantages could virtually eliminate early deck deterioration and the associated costs providing an alternative asset management path for bridge decks. Bridge decks would no longer have to be removed from their substructure every fifteen years and replaced. The results would be higher quality, longer lasting bridge decks with lower life cycle costs. This project will demonstrate the feasibility and methodology of such a strategy. This project will develop a strategy that combines innovative concrete materials, novel design and cost analysis that enhances the longevity and reduces the life cycle cost of highway bridge decks. The project is expected to show significant life-cycle cost advantages to using a high performance bridge deck material.

Download or read book Abrasion resistant Concrete Mix Designs for Precast Bridge Deck Panels written by Todd V. Scholz and published by . This book was released on 2010 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Nonconventional Concrete Technologies written by Committee on Nonconventional Concrete Technologies for Renewal of the Highway Infrastructure and published by National Academies Press. This book was released on 1997-04-08 with total page 125 pages. Available in PDF, EPUB and Kindle. Book excerpt: Nonconventional Concrete Technologies: Renewal of the Highway Infrastructure identifies research and development opportunities in innovative, nonconventional materials and processes that have the potential to accelerate the construction process, improve the durability of highway pavement and bridges, and enhance the serviceability and longevity of new construction under adverse conditions.

Download or read book Design and Control of Concrete Mixtures written by Steven H. Kosmatka and published by . This book was released on 1988 with total page 224 pages. Available in PDF, EPUB and Kindle. Book excerpt: Portland Cement Association reference, dealing with fundamentals, cold weather concreting, curing, admixtures, aggregates, mixing, and much more.

Download or read book Integrated Materials and Construction Practices for Concrete Pavement written by and published by . This book was released on 2006 with total page 326 pages. Available in PDF, EPUB and Kindle. Book excerpt: Manual of integrated material and construction practices for concrete pavements.

Download or read book Prefabricated Bridge Elements and Systems to Limit Traffic Disruption During Construction written by Mohsen Shahawy and published by Transportation Research Board. This book was released on 2003 with total page 58 pages. Available in PDF, EPUB and Kindle. Book excerpt: TRB's National Cooperative Highway Research Program (NCHRP) Synthesis Report 324: Prefabricated Bridge Elements and Systems to Limit Traffic Disruption During Construction assesses and documents the use of innovative prefabricated elements and systems and assesses its effects on on-site construction time and cost, closure time, and environmental impacts. The synthesis report also looks at the use of fiber-reinforced polymers and other advanced materials and new technologies that are gaining in popularity but are still in the experimental stages.

Download or read book Internal Curing a 2010 State Of the Art Review written by nist and published by . This book was released on 2013-11-26 with total page 96 pages. Available in PDF, EPUB and Kindle. Book excerpt: The American Concrete Institute in 2010 defined internal curing as supplying water throughout a freshly placed cementitious mixture using reservoirs, via pre-wetted lightweight aggregates, that readily release water as needed for hydration or to replace moisture lost through evaporation or self-desiccation (American Concrete Institute, 2010). While internal curing has been inadvertently included in many lightweight concretes produced within the past 100 years, it is only within the first decade of the 21st century that this technology has been intentionally incorporated into concrete mixtures at the proportioning stage, using a variety of materials including pre-wetted lightweight aggregates, pre-wetted crushed returned concrete fines, superabsorbent polymers, and pre-wetted wood fibers. This report provides a state-of-the-art review of the subject of internal curing, first addressing its history and theory, andthen proceeding to summarize published guidance on implementing internal curing in practice and published research on its influence on the performance properties of concrete. The ongoing exploration of extensions of the internal curing concept that employ the internal reservoirs to contain materials other than water are reviewed. Finally, the critical issue of sustainability is addressed. An extensive internal curing bibliography that is also available over the Internet is included in an appendix. The report is mainly focused on the utilization of prewettedlightweight aggregates as the internal reservoirs due to thisbeing the current established practice within the U.S.

Download or read book Bridge Launching written by Marco Rosignoli and published by Thomas Telford. This book was released on 2002 with total page 366 pages. Available in PDF, EPUB and Kindle. Book excerpt: &Quot;This book is an essential purchase for all those involved in bridge construction and innovative building techniques, such as bridge owners, design offices, bridge consultants, and construction equipment suppliers."--BOOK JACKET.

Download or read book Basic Principles of Concrete Structures written by Xianglin Gu and published by Springer. This book was released on 2015-12-09 with total page 620 pages. Available in PDF, EPUB and Kindle. Book excerpt: Based on the latest version of designing codes both for buildings and bridges (GB50010-2010 and JTG D62-2004), this book starts from steel and concrete materials, whose properties are very important to the mechanical behavior of concrete structural members. Step by step, analysis of reinforced and prestressed concrete members under basic loading types (tension, compression, flexure, shearing and torsion) and environmental actions are introduced. The characteristic of the book that distinguishes it from other textbooks on concrete structures is that more emphasis has been laid on the basic theories of reinforced concrete and the application of the basic theories in design of new structures and analysis of existing structures. Examples and problems in each chapter are carefully designed to cover every important knowledge point. As a basic course for undergraduates majoring in civil engineering, this course is different from either the previously learnt mechanics courses or the design courses to be learnt. Compared with mechanics courses, the basic theories of reinforced concrete structures cannot be solely derived by theoretical analysis. And compared with design courses, this course emphasizes the introduction of basic theories rather than simply being a translation of design specifications. The book will focus on both the theoretical derivations and the engineering practices.

Download or read book Aluminum Alloys for Transportation Packaging Aerospace and Other Applications written by Subodh K. Das and published by Wiley-TMS. This book was released on 2007-05-01 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: The focus of this book is the study of the physical and mechanicalmetallurgy of aluminum alloys produced by processing methods. Itaddresses progress in research, development, testing andapplication of aluminum sheet, plate, extrusions, forgings, andother products in end uses. Those applications includetransportation, such as automotive, aerospace and marine, packagingand other key areas. A collection of papers from the ahref="http://www.tms.org/Meetings/Annual-07/AnnMtg07Home.html"target="_blank"2007 TMS Annual Meeting & Exhibition/a heldin Orlando, Florida, February 25 -- March 1, 2007.

Download or read book Design and Control of Concrete Mixtures written by Steven H. Kosmatka and published by Portland Cement Assn. This book was released on 2011-01 with total page 444 pages. Available in PDF, EPUB and Kindle. Book excerpt: Summary: This book presents the properties of concrete as needed in concrete construction, including strength and durability. All concrete ingredients (cementing materials, water, aggregates, admixtures, and fibers) are reviewed for their optimal use in designing and proportioning concrete mixtures. Applicable ASTM, AASHTO, and ACI standards are referred to extensively. The use of concrete from design to batching, mixing, transporting, placing, consolidating, finishing, and curing is addressed. Concrete sustainability, along with special concretes, including high-performance concretes, are also reviewed.

Download or read book LRFD Guide Specifications for the Design of Pedestrian Bridges written by American Association of State Highway and Transportation Officials and published by AASHTO. This book was released on 2009 with total page 38 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Life Cycle of Engineering Systems Emphasis on Sustainable Civil Infrastructure written by Jaap Bakker and published by CRC Press. This book was released on 2016-11-18 with total page 438 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume contains the papers presented at IALCCE2016, the fifth International Symposium on Life-Cycle Civil Engineering (IALCCE2016), to be held in Delft, The Netherlands, October 16-19, 2016. It consists of a book of extended abstracts and a DVD with full papers including the Fazlur R. Khan lecture, keynote lectures, and technical papers from all over the world. All major aspects of life-cycle engineering are addressed, with special focus on structural damage processes, life-cycle design, inspection, monitoring, assessment, maintenance and rehabilitation, life-cycle cost of structures and infrastructures, life-cycle performance of special structures, and life-cycle oriented computational tools. The aim of the editors is to provide a valuable source for anyone interested in life-cycle of civil infrastructure systems, including students, researchers and practitioners from all areas of engineering and industry.

Download or read book Bridge Engineering written by Weiwei Lin and published by Butterworth-Heinemann. This book was released on 2017-05-11 with total page 294 pages. Available in PDF, EPUB and Kindle. Book excerpt: Bridge Engineering: Classifications, Design Loading, and Analysis Methods begins with a clear and concise exposition of theory and practice of bridge engineering, design and planning, materials and construction, loads and load distribution, and deck systems. This is followed by chapters concerning applications for bridges, such as: Reinforced and Prestressed Concrete Bridges, Steel Bridges, Truss Bridges, Arch Bridges, Cable Stayed Bridges, Suspension Bridges, Bridge Piers, and Bridge Substructures. In addition, the book addresses issues commonly found in inspection, monitoring, repair, strengthening, and replacement of bridge structures. Includes easy to understand explanations for bridge classifications, design loading, analysis methods, and construction Provides an overview of international codes and standards Covers structural features of different types of bridges, including beam bridges, arch bridges, truss bridges, suspension bridges, and cable-stayed bridges Features step-by-step explanations of commonly used structural calculations along with worked out examples