Download or read book Transonic Aerodynamic Loading Characteristics of a Wing body tail Combination Having 52 5 Sweptback Wing of Aspect Ratio 3 with Conical Wing Camber and Body Indentation for a Design Mach Number square Root Of 2 written by Marlowe D. Cassetti and published by . This book was released on 1961 with total page 104 pages. Available in PDF, EPUB and Kindle. Book excerpt: An investigation has been made of the effects of conical wing camber and body indentation according to the supersonic area rule on the aerodynamic wing loading characteristics of a wing-body-tail configuration at transonic speeds. The wing aspect ratio was 3, taper ratio was 0.1, and quarter-chord-line sweepback was 52.5° with 3-percent-thick airfoil sections. The tests were conducted in the Langley 16-foot transonic tunnel at Mach numbers from 0.80 to 1.05 and at angles of attack from 0° to 14°, with Reynolds numbers based on mean aerodynamic chord varying from 7 x 106 to 8 x 106. Conical camber delayed wing-tip stall and reduced the severity of the accompanying longitudinal instability but did not appreciably affect the spanwise load distribution at angles of attack below tip stall. Body indentation reduced to transonic chordwise center-of-pressure travel from about 8 percent to 5 percent of the mean aerodynamic chord.
Download or read book Transonic Aerodynamic Loading Characteristics of a Wing body tail Combination Having a 52 5 Degree Sweptback Wing of Aspect Ratio 3 with Conical Wing Camber and Body Indentation for a Design Mach Number of the Square Root of 2 written by MARLOWE D. CASSETTI and published by . This book was released on 1961 with total page 1 pages. Available in PDF, EPUB and Kindle. Book excerpt: A inves iga io as been made of the effects of conical wing camber and body indentation ccordi g to t e supersonic area rule on the aerodynamic wing loading characteristics of a wingbody-tail configuration at transonic speeds. The wing aspect ratio was 3, aper ratio was 0.1, and quarter-chord-line sweepback was 52.5 deg with 3-perc t- ick airfoil sec ions. The tests were conducted in the Langley 16-foot transonic unnel at Mach numbers from 0.80 to 1.05 and at angles of attack from 0 to 14 deg with Rey olds numbers based on mean aerodyna ic chord varying from 7 x 10 to the 6th power to 8 x 10 to the 6th power. Conical camber delayed wing-tip stall and r duced s verity of the accompanying longitudinal instability but did not appreciably affect the spanwise load distribution at angles of attack below tip stall. Body indentation reduced the transonic chordwise centerof-pressure travel from about 8 percent to 5 percent of the mean aerodyn mic chord. (Author).
Download or read book Transonic Aerodynamic Characteristics of a Wing body Combination Having a 52 20 Sweptback Wing of Aspect Ratio 3 with Conical Camber and Designed for a Mach Number of 2 written by William B. Igoe and published by . This book was released on 1961 with total page 56 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Transonic Aerodynamic Characteristics of a Wing Body Combination Having a 52 5 Deg Sweptback Wing of Aspect Ratio 3 with Conical Camber and Designed for a Mach Number of the Square Root of 2 written by William B. Igoe and published by . This book was released on 1961 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Transonic Aerodynamic Characteristics of a Wingbody Combination Having a 52 5 Degree Sweptback Wing of Aspect Ratio 3 with Conical Camber and Designed for a Mach Number of 1 1416 written by WILLIAM B. IGOE and published by . This book was released on 1961 with total page 1 pages. Available in PDF, EPUB and Kindle. Book excerpt: An investigation was made of the effects of conical wing camber and supersonic body indentation on the aerodynamic characteristics of a wing-body configuration at transonic speeds. Wing aspect ratio was 3.0, taper ratio was 0.1, and quarterchord line sweepback was 52.5 with airfoil sections of 0.03 thickness ratio. The tests were conducted in the Langley 16-foot transonic tunnel at various Mach numbers from 0.80 to 1.05 at angles of attack from -4 to 14. The camberedwing configuration achieved higher lift-drag ratios than a similar plane-wing configuration. The camber also reduced the effects of wing-tip flow separation on the aerodynamic characteristics. In general, no stability or trim changes below wing-tip flow separation resulted from the use of camber. The use of supersonic body indentation improved the lift-drag ratios at Mach numbers from 0.96 to 1.05. (Author).
Download or read book Transonic Aerodynamic Characteristics of a Wing body Combination Having a 52 2 Sweptback Wing of Aspect Ratio 3 with Conical Camber and Designed for a Mach Number of 2 written by William B. Igoe and published by . This book was released on 1961 with total page 51 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Transonic Aerodynamic Characteristics of a Wing body Combination Having a 52 20 Sweptback Wing of Aspect Ratio 3 with Conical Camber and Designed for a Mach Number of 2 written by William B. Igoe and published by . This book was released on 1961 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Transonic Aerodynamic Characteristics of a Wing body Combination Having a 52 5 sweptback Wing of Aspect Ratio 3 with Conical Camber and Designed for a Mach Number of 2 written by William B. Igoe and published by . This book was released on 1961 with total page 51 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Investigation at Transonic Speeds of the Loading Over a 45 Degree Sweptback Wing Having an Aspect Ratio of 3 a Taper Ratio of 0 2 and NACA 65A004 Airfoil Sections written by Jack F. Runckel and published by . This book was released on 1956 with total page 104 pages. Available in PDF, EPUB and Kindle. Book excerpt: An investigation at transonic speeds of the loading over a 45 degree sweptback wing having an aspect ratio of 3, a taper ratio of 0.2, and NACA 65A004 airfoil sections has been conducted in the Langley16-foot transonic tunnel. Pressure measurements on the wing-body combination were obtained at angles of attack from 0 to 26 degrees at Mach numbers from 0.80 to 0.98 and from 0 to about 12 degrees at Mach numbers from 1.00 to 1.05. Reynolds number, based on the wing mean aerodynamic chord, varied from 7,000,000 to 8,500,000 over the test Mach number range.
Download or read book An Experimental Transonic Investigation of a 45 Sweptback Wing body Combination with Several Types of Body Indentation with Theoretical Comparisons Included written by Melvin M. Carmel and published by . This book was released on 1954 with total page 60 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Effects of Wing Incidence on the Aerodynamic Loading Characteristics of a Sweptback Wing body Combination at Transonic Speeds written by Harold L. Robinson and published by . This book was released on 1954 with total page 94 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Aerodynamic center Considerations of Wings and Wing body Combinations written by John E. Lamar and published by . This book was released on 1966 with total page 20 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Aerodynamic Characteristics at Supersonic Speeds of a Series of Wing body Combinations Having Cambered Wings with an Aspect Ratio of 3 5 and a Taper Ratio of 0 2 written by Lowell E. Hasel and published by . This book was released on 1952 with total page 36 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Longitudinal Aerodynamic Characteristics at Mach Number 2 02 of a Series of Wing body Configurations Employing a Cambered and Twisted Arrow Wing written by Harry W. Carlson and published by . This book was released on 1963 with total page 20 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Loads on Thin Wings at Transonic Speeds written by Don D. Davis (Jr.) and published by . This book was released on 1955 with total page 22 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Longitudinal Aerodynamic Characteristics of a Sweptback Wing body Combination with and Without End Plates at Mach Numbers from 0 40 to 0 93 written by W. P. Henderson and published by . This book was released on 1960 with total page 26 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Effects of Wing tip Droop on the Longitudinal Characteristics of Two Highly Swept Wing body Combinations at Mach Numbers from 0 6 to 1 4 written by Earl D. Knechtel and published by . This book was released on 1957 with total page 32 pages. Available in PDF, EPUB and Kindle. Book excerpt: An investigation was conducted to determine the effects of wing-tip droop on the longitudinal stability characteristics of a 53 and a 63 degree sweptback wing-body combination. Both models were tested with flat and abruptly drooped wing tips. The 63 degree wing was also tested with a curved drooped tip. In addition, the combined effects of wing fences and extended leading-edge flaps were investigated. The results showed that abrupt droop of the outer 40 percent of the basic 53 degree wing improved the stability characteristics of the model. For the 63 degree swept wing, curved droop caused slight beneficial effects on the stability, whereas abrupt droop caused adverse effects. In general, the most favorable stability characteristics were obtained for either flat or abruptly drooped wings with fences and extended leading-edge flaps.