Download or read book The Pentane Lamp as a Working Standard Classic Reprint written by E. C. Crittenden and published by Forgotten Books. This book was released on 2018-02-11 with total page 30 pages. Available in PDF, EPUB and Kindle. Book excerpt: Excerpt from The Pentane Lamp as a Working Standard Since all flames depend upon combustion it is to be expected that their intensity will vary with the proportion of oxygen and Of other constituents in the air supplied to the gaseous fuel of the flame. T O maintain a flame in a constant condition requires, therefore, not only uniform fuel, but also a uniform proportion Of oxygen in the air supplied to the flame. Good ventilation is con sequently desirable for all work with flames, and is indispensable where lamps Of other kinds are to be compared with a flame standard. The quantity Of air which must be supplied depends largely on the size and number Of flames in the room and also on the method of ventilating. The flames themselves set up currents of air, and if possible these currents should be utilized to remove immediately from the room all the vitiated air coming from the lamps. A hood placed above the photometer with a rising pipe to lead the warm air out of the room is most effective. If the gases from the flames are allowed to diffuse into the room and are simply diluted by the air entering, a much larger amount Of fresh air will be needed. In such a case it has been estimated 5 that to keep the carbon dioxide content of the air down to 6 parts in 10 000, 3000 cubic feet of fresh air per hour must be supplied for each person in a room. A committee Of the American Gas Institute 6 has on this basis estimated that 36 900 cubic feet Of air per hour should be supplied for a photometer room where two persons work with a pentane lamp and a 5-foot gas flame, since in the production Of carbon dioxide the gas flame is approximately equivalent to six persons and the pentane lamp to four. In a room where air enters at the bottom and escapes at or near the top the quantity estimated as above (about I 2 000 cubic feet per hour for a pentane lamp) is probably ample for any purpose, and if care is taken to allow direct escape Of the flame gases a much smaller amount is sufficient. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.
Download or read book The pentane lamp as a working standard written by A. H. Taylor and published by . This book was released on 1914 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Pentane Lamp as a Working Standard written by E. C. Crittenden and published by . This book was released on 1914 with total page 2 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Standard Methods for the Examination of Water and Wastewater written by American Public Health Association and published by . This book was released on 1981 with total page 1254 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Light Photometry and Illumination written by William Edward Barrows and published by Forgotten Books. This book was released on 2017-10-14 with total page 348 pages. Available in PDF, EPUB and Kindle. Book excerpt: Excerpt from Light, Photometry and Illumination: A Thoroughly Revised Edition of "Electrical Illuminating Engineering" Chapter IV. - standards OF luminous intensity The English candle - German candle - Carcel lamp - Methven screen - Kerosene standard - Hefner lamp - Pentane lamp - Color value Of flame standards - Violle platinum standard - Relation Of various standards - Arc standard - Black body standard - Radia tion standard - Object Of a primary standard - Incandescent lamp as a comparison standard - Summary of Chapter IV. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.
Download or read book Machinery written by Lester Gray French and published by . This book was released on 1914 with total page 1354 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Nature written by Sir Norman Lockyer and published by . This book was released on 1914 with total page 740 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Ignition written by John Drury Clark and published by Rutgers University Press. This book was released on 2018-05-23 with total page 217 pages. Available in PDF, EPUB and Kindle. Book excerpt: This newly reissued debut book in the Rutgers University Press Classics Imprint is the story of the search for a rocket propellant which could be trusted to take man into space. This search was a hazardous enterprise carried out by rival labs who worked against the known laws of nature, with no guarantee of success or safety. Acclaimed scientist and sci-fi author John Drury Clark writes with irreverent and eyewitness immediacy about the development of the explosive fuels strong enough to negate the relentless restraints of gravity. The resulting volume is as much a memoir as a work of history, sharing a behind-the-scenes view of an enterprise which eventually took men to the moon, missiles to the planets, and satellites to outer space. A classic work in the history of science, and described as “a good book on rocket stuff…that’s a really fun one” by SpaceX founder Elon Musk, readers will want to get their hands on this influential classic, available for the first time in decades.
Download or read book Machinery written by and published by . This book was released on 1914 with total page 1132 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Machinery written by Fred Herbert Colvin and published by . This book was released on 1914 with total page 1166 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Physics in Oxford 1839 1939 written by Robert Fox and published by OUP Oxford. This book was released on 2005-06-16 with total page 386 pages. Available in PDF, EPUB and Kindle. Book excerpt: Physics in Oxford, 1839-1939 offers a challenging new interpretation of pre-war physics at the University of Oxford, which was far more dynamic than most historians and physicists have been prepared to believe. It explains, on the one hand, how attempts to develop the University's Clarendon Laboratory by Robert Clifton, Professor of Experimental Philosophy from 1865 to 1915, were thwarted by academic politics and funding problems, and latterly by Clifton's idiosyncratic concern with precision instrumentation. Conversely, by examining in detail the work of college fellows and their laboratories, the book reconstructs the decentralized environment that allowed physics to enter on a period of conspicuous vigour in the late nineteenth and early twentieth centuries, especially at the characteristically Oxonian intersections between physics, physical chemistry, mechanics, and mathematics. Whereas histories of Cambridge physics have tended to focus on the self-sustaining culture of the Cavendish Laboratory, it was Oxford's college-trained physicists who enabled the discipline to flourish in due course in university as well as college facilities, notably under the newly appointed professors, J. S. E. Townsend from 1900 and F. A. Lindemann from 1919. This broader perspective allows us to understand better the vitality with which physicists in Oxford responded to the demands of wartime research on radar and techniques relevant to atomic weapons and laid the foundations for the dramatic post-war expansion in teaching and research that has endowed Oxford with one of the largest and most dynamic schools of physics in the world.
Download or read book Carbon Black written by Jean-Baptiste Donnet and published by Routledge. This book was released on 2018-05-04 with total page 484 pages. Available in PDF, EPUB and Kindle. Book excerpt: The second edition of this reference provides comprehensive examinations of developments in the processing and applications of carbon black, including the use of new analytical tools such as scanning tunnelling microscopy, Fourier transform infrared spectroscopy and inverse gas chromatography.;Completely rewritten and updated by numerous experts in the field to reflect the enormous growth of the field since the publication of the previous edition, Carbon Black: discusses the mechanism of carbon black formation based on recent advances such as the discovery of fullerenes; elucidates micro- and macrostructure morphology and other physical characteristics; outlines the fractal geometry of carbon black as a new approach to characterization; reviews the effect of carbon black on the electrical and thermal conductivity of filled polymers; delineates the applications of carbon black in elastomers, plastics, and zerographic toners; and surveys possible health consequences of exposure to carbon black.;With over 1200 literature citations, tables, and figures, this resource is intended for physical, polymer, surface and colloid chemists; chemical and plastics engineers; spectroscopists; materials scientists; occupational safety and health physicians; and upper-level undergraduate and graduate students in these disciplines.
Download or read book March s Advanced Organic Chemistry written by Michael B. Smith and published by John Wiley & Sons. This book was released on 2007-01-29 with total page 2379 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Sixth Edition of a classic in organic chemistry continues its tradition of excellence Now in its sixth edition, March's Advanced Organic Chemistry remains the gold standard in organic chemistry. Throughout its six editions, students and chemists from around the world have relied on it as an essential resource for planning and executing synthetic reactions. The Sixth Edition brings the text completely current with the most recent organic reactions. In addition, the references have been updated to enable readers to find the latest primary and review literature with ease. New features include: More than 25,000 references to the literature to facilitate further research Revised mechanisms, where required, that explain concepts in clear modern terms Revisions and updates to each chapter to bring them all fully up to date with the latest reactions and discoveries A revised Appendix B to facilitate correlating chapter sections with synthetic transformations
Download or read book Measures for Progress written by Rexmond Canning Cochrane and published by . This book was released on 1966 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Publications of the National Institute of Standards and Technology Catalog written by National Institute of Standards and Technology (U.S.) and published by . This book was released on 1990 with total page 424 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Chemical Engineering Design written by Gavin Towler and published by Elsevier. This book was released on 2012-01-25 with total page 1321 pages. Available in PDF, EPUB and Kindle. Book excerpt: Chemical Engineering Design, Second Edition, deals with the application of chemical engineering principles to the design of chemical processes and equipment. Revised throughout, this edition has been specifically developed for the U.S. market. It provides the latest US codes and standards, including API, ASME and ISA design codes and ANSI standards. It contains new discussions of conceptual plant design, flowsheet development, and revamp design; extended coverage of capital cost estimation, process costing, and economics; and new chapters on equipment selection, reactor design, and solids handling processes. A rigorous pedagogy assists learning, with detailed worked examples, end of chapter exercises, plus supporting data, and Excel spreadsheet calculations, plus over 150 Patent References for downloading from the companion website. Extensive instructor resources, including 1170 lecture slides and a fully worked solutions manual are available to adopting instructors. This text is designed for chemical and biochemical engineering students (senior undergraduate year, plus appropriate for capstone design courses where taken, plus graduates) and lecturers/tutors, and professionals in industry (chemical process, biochemical, pharmaceutical, petrochemical sectors). New to this edition: - Revised organization into Part I: Process Design, and Part II: Plant Design. The broad themes of Part I are flowsheet development, economic analysis, safety and environmental impact and optimization. Part II contains chapters on equipment design and selection that can be used as supplements to a lecture course or as essential references for students or practicing engineers working on design projects. - New discussion of conceptual plant design, flowsheet development and revamp design - Significantly increased coverage of capital cost estimation, process costing and economics - New chapters on equipment selection, reactor design and solids handling processes - New sections on fermentation, adsorption, membrane separations, ion exchange and chromatography - Increased coverage of batch processing, food, pharmaceutical and biological processes - All equipment chapters in Part II revised and updated with current information - Updated throughout for latest US codes and standards, including API, ASME and ISA design codes and ANSI standards - Additional worked examples and homework problems - The most complete and up to date coverage of equipment selection - 108 realistic commercial design projects from diverse industries - A rigorous pedagogy assists learning, with detailed worked examples, end of chapter exercises, plus supporting data and Excel spreadsheet calculations plus over 150 Patent References, for downloading from the companion website - Extensive instructor resources: 1170 lecture slides plus fully worked solutions manual available to adopting instructors
Download or read book Handbook of Essential Oils written by K. Husnu Can Baser and published by CRC Press. This book was released on 2009-12-28 with total page 994 pages. Available in PDF, EPUB and Kindle. Book excerpt: Egyptian hieroglyphs, Chinese scrolls, and Ayurvedic literature record physicians administering aromatic oils to their patients. Today society looks to science to document health choices and the oils do not disappoint. The growing body of evidence of their efficacy for more than just scenting a room underscores the need for production standards, quality control parameters for raw materials and finished products, and well-defined Good Manufacturing Practices. Edited by two renowned experts, the Handbook of Essential Oils covers all aspects of essential oils from chemistry, pharmacology, and biological activity, to production and trade, to uses and regulation. Bringing together significant research and market profiles, this comprehensive handbook provides a much-needed compilation of information related to the development, use, and marketing of essential oils, including their chemistry and biochemistry. A select group of authoritative experts explores the historical, biological, regulatory, and microbial aspects. This reference also covers sources, production, analysis, storage, and transport of oils as well as aromatherapy, pharmacology, toxicology, and metabolism. It includes discussions of biological activity testing, results of antimicrobial and antioxidant tests, and penetration-enhancing activities useful in drug delivery. New information on essential oils may lead to an increased understanding of their multidimensional uses and better, more ecologically friendly production methods. Reflecting the immense developments in scientific knowledge available on essential oils, this book brings multidisciplinary coverage of essential oils into one all-inclusive resource.
