Download or read book Testing Statcom Model in IEEE Power System Network Using PSCAD Software written by Mohd Firdaus Daud and published by . This book was released on 2008 with total page 56 pages. Available in PDF, EPUB and Kindle. Book excerpt: In any transmission system, the ultimate goals are to transmit power with high quality, economical and low risk of system failure. The ever increasing of power demands and loads especially non-linear loads making the power system network become complex to operate and the system becomes insecure with large power flows without adequate control. One way to introduce power system control is by applying controller known as FACTS (Flexible AC Transmission System) controllers. STATCOM (Static Synchronous Compensator) is one of the FACTS controllers and can be introduced to the power system to regulate terminal voltage and to improve system's stability. By using IEEE 4 bus power system network, the effectiveness of STATCOM is tested by applying the controller at the critical location of the power system. The critical location of a power system is determined by the voltage drop that falls below 0.95 or above 1.05. Using PSCAD/EMTDC simulation software, the simulations of STATCOM in IEEE 4 bus power system networks can be realized. To verify the PSCAD/EMTDC simulation results, load flow analysis are acquired using MATLAB software through Hadi Saadat's load flow analysis method. With these softwares, both systems' power flow can be compared to determine the effectiveness of STATCOM in the power transmission system.

Download or read book Testing of Static Synchronous Series Compensator SSSC Model in IEEE 9 Bus Power System Network Using PSCAD and MATLAB Software written by Sukma Citra Jafirin and published by . This book was released on 2010 with total page 52 pages. Available in PDF, EPUB and Kindle. Book excerpt: Power system capability can be increased by the use of Flexible AC Transmission System devices (FACTS) in transmission systems experiencing high power flows. This thesis presents an analysis of one of these devices, namely, a Static Synchronous Series Compensator (SSSC). Voltage Source Converter (VSC) based FACTS is the most recent approach in FACTS technology. The SSSC is the key series compensation devices that open up new opportunities to control the power on transmission systems in order to enhance their utilization, increase power transfer capability and to improve voltage profile. In order to perform an investigation, an exact model of a 6-pulse GTO converter, is used as the basic building block of SSSC. Then by using a 9-bus test system the effects of SSSC on voltage stability in power systems are examined using MATLAB and PSCAD software. The optimal location of this controller is determined by analyze the lowest bus voltage profile. The 9-bus system parameters such as line voltage, line current, reactive power, Q, and real power, P, transmissions are observed when the SSSC is applied to the system.

Download or read book Power Electronic Control in Electrical Systems written by Enrique Acha and published by Newnes. This book was released on 2002-01-08 with total page 464 pages. Available in PDF, EPUB and Kindle. Book excerpt: Within this book the fundamental concepts associated with the topic of power electronic control are covered alongside the latest equipment and devices, new application areas and associated computer-assisted methods. *A practical guide to the control of reactive power systems *Ideal for postgraduate and professional courses *Covers the latest equipment and computer-aided analysis.

Download or read book Static Compensators STATCOMs in Power Systems written by Farhad Shahnia and published by Springer. This book was released on 2014-12-01 with total page 741 pages. Available in PDF, EPUB and Kindle. Book excerpt: A static compensator (STATCOM), also known as static synchronous compensator, is a member of the flexible alternating current transmission system (FACTS) devices. It is a power-electronics based regulating device which is composed of a voltage source converter (VSC) and is shunt-connected to alternating current electricity transmission and distribution networks. The voltage source is created from a DC capacitor and the STATCOM can exchange reactive power with the network. It can also supply some active power to the network, if a DC source of power is connected across the capacitor. A STATCOM is usually installed in the electric networks with poor power factor or poor voltage regulation to improve these problems. In addition, it is used to improve the voltage stability of a network. This book covers STATCOMs from different aspects. Different converter topologies, output filters and modulation techniques utilized within STATCOMs are reviewed. Mathematical modeling of STATCOM is presented in detail and different STATCOM control strategies and algorithms are discussed. Modified load flow calculations for a power system in the presence of STATCOMs are presented. Several applications of STATCOMs in transmission and distribution networks are discussed in different examples and optimization techniques for defining the optimal location and ratings of the STATCOMs in power systems are reviewed. Finally, the performance of the network protection scheme in the presence of STATCOMs is described. This book will be an excellent resource for postgraduate students and researchers interested in grasping the knowledge on STATCOMs.

Download or read book Power Quality Enhancement Using Custom Power Devices written by Arindam Ghosh and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 474 pages. Available in PDF, EPUB and Kindle. Book excerpt: Power Quality Enhancement Using Custom Power Devices considers the structure, control and performance of series compensating DVR, the shunt DSTATCOM and the shunt with series UPQC for power quality improvement in electricity distribution. Also addressed are other power electronic devices for improving power quality in Solid State Transfer Switches and Fault Current Limiters. Applications for these technologies as they relate to compensating busses supplied by a weak line and for distributed generation connections in rural networks, are included. In depth treatment of inverters to achieve voltage support, voltage balancing, harmonic suppression and transient suppression in realistic network environments are also covered. New material on the potential for shunt and series compensation which emphasizes the importance of control design has been introduced.

Download or read book Modeling and Control Aspects of Wind Power Systems written by S. M. Muyeen and published by BoD – Books on Demand. This book was released on 2013-03-20 with total page 216 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book covers the recent development and progress of the wind energy conversion system. The chapters are contributed by prominent researchers in the field of wind energy and cover grid integration issues, modern control theories applied in wind energy conversion system, and dynamic and transient stability studies. Modeling and control strategies of different variable speed wind generators such as switched reluctance generator, permanent magnet synchronous generator, doubly-fed induction generator, including the suitable power electronic converter topologies for grid integration, are discussed. Real time control study of wind farm using Real Time Digital Simulator (RTDS) is also included in the book, along with Fault ride through, street light application, integrated power flow solutions, direct power control, wireless coded deadbeat power control, and other interesting topics.

Download or read book Conference Proceedings written by IEEE Power Engineering Society. Winter Meeting and published by . This book was released on 2001 with total page 636 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Power Quality in Modern Power Systems written by Sanjeevikumar Padmanaban and published by Academic Press. This book was released on 2020-11-20 with total page 352 pages. Available in PDF, EPUB and Kindle. Book excerpt: Power Quality in Modern Power Systems presents an overview of power quality problems in electrical power systems, for identifying pitfalls and applying the fundamental concepts for tackling and maintaining the electrical power quality standards in power systems. It covers the recent trends and emerging topics of power quality in large scale renewable energy integration, electric vehicle charging stations, voltage control in active distribution network and solutions to integrate large scale renewable energy into the electric grid with several case studies and real-time examples for power quality assessments and mitigations measures. This book will be a practical guide for graduate and post graduate students of electrical engineering, engineering professionals, researchers and consultants working in the area of power quality. Explains the power quality characteristics through suitable real time measurements and simulation examples Explanations for harmonics with various real time measurements are included Simulation of various power quality events using PSCAD and MATLAB software PQ disturbance detection and classification through advanced signal processing and machine learning tools Overview about power quality problems associated with renewable energy integration, electric vehicle supply equipment’s, residential systems using several case studies

Download or read book IEEE Recommended Practice for Excitation System Models for Power System Stability Studies written by Institute of Electrical and Electronics Engineers and published by . This book was released on 1992 with total page 55 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Voltage Sourced Converters in Power Systems written by Amirnaser Yazdani and published by John Wiley & Sons. This book was released on 2010-03-25 with total page 473 pages. Available in PDF, EPUB and Kindle. Book excerpt: Presents Fundamentals of Modeling, Analysis, and Control of Electric Power Converters for Power System Applications Electronic (static) power conversion has gained widespread acceptance in power systems applications; electronic power converters are increasingly employed for power conversion and conditioning, compensation, and active filtering. This book presents the fundamentals for analysis and control of a specific class of high-power electronic converters—the three-phase voltage-sourced converter (VSC). Voltage-Sourced Converters in Power Systems provides a necessary and unprecedented link between the principles of operation and the applications of voltage-sourced converters. The book: Describes various functions that the VSC can perform in electric power systems Covers a wide range of applications of the VSC in electric power systems—including wind power conversion systems Adopts a systematic approach to the modeling and control design problems Illustrates the control design procedures and expected performance based on a comprehensive set of examples and digital computer time-domain simulation studies This comprehensive text presents effective techniques for mathematical modeling and control design, and helps readers understand the procedures and analysis steps. Detailed simulation case studies are included to highlight the salient points and verify the designs. Voltage-Sourced Converters in Power Systems is an ideal reference for senior undergraduate and graduate students in power engineering programs, practicing engineers who deal with grid integration and operation of distributed energy resource units, design engineers, and researchers in the area of electric power generation, transmission, distribution, and utilization.

Download or read book Electrical Electronics Abstracts written by and published by . This book was released on 1997 with total page 2240 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book FACTS written by Enrique Acha and published by John Wiley & Sons. This book was released on 2004-10-22 with total page 420 pages. Available in PDF, EPUB and Kindle. Book excerpt: The first book to provide comprehensive coverage of FACTS power systems modeling and simulation. * Detailed coverage of the development of FACTS controllers and guidance on the selection of appropriate equipment * Computer modelling examples of the FACTS controllers for steady-state and transient stability systems * Numerous case studies and practical examples

Download or read book Innovations in Electrical and Electronic Engineering written by Margarita N. Favorskaya and published by Springer Nature. This book was released on 2020-07-25 with total page 775 pages. Available in PDF, EPUB and Kindle. Book excerpt: The book is a compilation of selected papers from 2020 International Conference on Electrical and Electronics Engineering (ICEEE 2020) held in National Power Training Institute HQ (Govt. of India) on February 21 – 22, 2020. The work focuses on the current development in the fields of electrical and electronics engineering like power generation, transmission and distribution, renewable energy sources and technology, power electronics and applications, robotics, artificial intelligence and IoT, control, and automation and instrumentation, electronics devices, circuits and systems, wireless and optical communication, RF and microwaves, VLSI, and signal processing. The book is beneficial for readers from both academia and industry.

Download or read book PowerFactory Applications for Power System Analysis written by Francisco M. Gonzalez-Longatt and published by Springer. This book was released on 2014-12-27 with total page 496 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book presents a comprehensive set of guidelines and applications of DIgSILENT PowerFactory, an advanced power system simulation software package, for different types of power systems studies. Written by specialists in the field, it combines expertise and years of experience in the use of DIgSILENT PowerFactory with a deep understanding of power systems analysis. These complementary approaches therefore provide a fresh perspective on how to model, simulate and analyse power systems. It presents methodological approaches for modelling of system components, including both classical and non-conventional devices used in generation, transmission and distribution systems, discussing relevant assumptions and implications on performance assessment. This background is complemented with several guidelines for advanced use of DSL and DPL languages as well as for interfacing with other software packages, which is of great value for creating and performing different types of steady-state and dynamic performance simulation analysis. All employed test case studies are provided as supporting material to the reader to ease recreation of all examples presented in the book as well as to facilitate their use in other cases related to planning and operation studies. Providing an invaluable resource for the formal instruction of power system undergraduate/postgraduate students, this book is also a useful reference for engineers working in power system operation and planning.

Download or read book Thyristor Based FACTS Controllers for Electrical Transmission Systems written by R. Mohan Mathur and published by John Wiley & Sons. This book was released on 2002-02-27 with total page 534 pages. Available in PDF, EPUB and Kindle. Book excerpt: Theoretische Grundlagen und praktische Details werden in diesem Band gleichermaßen tiefgründig abgehandelt. Beispiele und Fallstudien zum Entwurf von Steuerungen und zur Messung der Leistungsfähigkeit runden den Text ab.

Download or read book Innovation in Electrical Power Engineering Communication and Computing Technology written by Manohar Mishra and published by Springer Nature. This book was released on 2021-12-15 with total page 573 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book features selected high-quality papers from the Second International Conference on Innovation in Electrical Power Engineering, Communication, and Computing Technology (IEPCCT 2021), held at Siksha 'O' Anusandhan (Deemed to be University), Bhubaneswar, India, on 24–26 September 2021. Presenting innovations in power, communication, and computing, it covers topics such as mini, micro, smart and future power grids; power system economics; energy storage systems; intelligent control; power converters; improving power quality; signal processing; sensors and actuators; image/video processing; high-performance data mining algorithms; advances in deep learning; and optimization methods.

Download or read book VSC FACTS HVDC written by Enrique Acha and published by John Wiley & Sons. This book was released on 2019-08-05 with total page 414 pages. Available in PDF, EPUB and Kindle. Book excerpt: An authoritative reference on the new generation of VSC-FACTS and VSC-HVDC systems and their applicability within current and future power systems VSC-FACTS-HVDC and PMU: Analysis, Modelling and Simulation in Power Grids provides comprehensive coverage of VSC-FACTS and VSC-HVDC systems within the context of high-voltage Smart Grids modelling and simulation. Readers are presented with an examination of the advanced computer modelling of the VSC-FACTS and VSC-HVDC systems for steady-state, optimal solutions, state estimation and transient stability analyses, including numerous case studies for the reader to gain hands-on experience in the use of models and concepts. Key features: Wide-ranging treatment of the VSC achieved by assessing basic operating principles, topology structures, control algorithms and utility-level applications. Detailed advanced models of VSC-FACTS and VSC-HVDC equipment, suitable for a wide range of power network-wide studies, such as power flows, optimal power flows, state estimation and dynamic simulations. Contains numerous case studies and practical examples, including cases of multi-terminal VSC-HVDC systems. Includes a companion website featuring MATLAB software and Power System Computer Aided Design (PSCAD) scripts which are provided to enable the reader to gain hands-on experience. Detailed coverage of electromagnetic transient studies of VSC-FACTS and VSC-HVDC systems using the de-facto industry standard PSCAD/EMTDC simulation package. An essential guide for utility engineers, academics, and research students as well as industry managers, engineers in equipment design and manufacturing, and consultants.