Download or read book Test Hardware Design for Flightlike Operation of Advanced Stirling Convertors Asc E3 written by National Aeronautics and Space Adm Nasa and published by Independently Published. This book was released on 2019-01-22 with total page 32 pages. Available in PDF, EPUB and Kindle. Book excerpt: NASA Glenn Research Center (GRC) has been supporting development of the Advanced Stirling Radioisotope Generator (ASRG) since 2006. A key element of the ASRG project is providing life, reliability, and performance testing of the Advanced Stirling Convertor (ASC). For this purpose, the Thermal Energy Conversion branch at GRC has been conducting extended operation of a multitude of free-piston Stirling convertors. The goal of this effort is to generate long-term performance data (tens of thousands of hours) simultaneously on multiple units to build a life and reliability database. The test hardware for operation of these convertors was designed to permit in-air investigative testing, such as performance mapping over a range of environmental conditions. With this, there was no requirement to accurately emulate the flight hardware. For the upcoming ASC-E3 units, the decision has been made to assemble the convertors into a flight-like configuration. This means the convertors will be arranged in the dual-opposed configuration in a housing that represents the fit, form, and thermal function of the ASRG. The goal of this effort is to enable system level tests that could not be performed with the traditional test hardware at GRC. This offers the opportunity to perform these system-level tests much earlier in the ASRG flight development, as they would normally not be performed until fabrication of the qualification unit. This paper discusses the requirements, process, and results of this flight-like hardware design activity. Oriti, Salvatore M. Glenn Research Center NASA/TM-2012-217726, AIAA Paper 2012-4254, E-18224
Download or read book Test hardware design for flightlike operation of Advanced Stirling Convertors ASC E3 written by Salvatore M. Oriti and published by . This book was released on 2012 with total page 8 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Advanced Stirling Convertor Performance Testing at Nasa Glenn Research Center written by Nasa Technical Reports Server (Ntrs) and published by BiblioGov. This book was released on 2013-07 with total page 24 pages. Available in PDF, EPUB and Kindle. Book excerpt: The National Aeronautics and Space Administration (NASA) Glenn Research Center (GRC) has been supporting development of the Advanced Stirling Radioisotope Generator (ASRG) since 2006. A key element of the ASRG Project is providing life, reliability, and performance testing of the Advanced Stirling Convertor (ASC). For this purpose, four pairs of ASCs capable of operating to 850 C and designated with the model number ASC-E2, were delivered by Sunpower of Athens, Ohio, to GRC in 2010. The ASC-E2s underwent a series of tests that included workmanship vibration testing, performance mapping, and extended operation. Workmanship vibration testing was performed following fabrication of each convertor to verify proper hardware build. Performance mapping consisted of operating each convertor at various conditions representing the range expected during a mission. Included were conditions representing beginning-of-mission (BOM), end-of-mission (EOM), and fueling. This same series of tests was performed by Sunpower prior to ASC-E2 delivery. The data generated during the GRC test were compared to performance before delivery. Extended operation consisted of a 500-hr period of operation with conditions maintained at the BOM point. This was performed to demonstrate steady convertor performance following performance mapping. Following this initial 500-hr period, the ASC-E2s will continue extended operation, controller development and special durability testing, during which the goal is to accumulate tens of thousands of hours of operation. Data collected during extended operation will support reliability analysis. Performance data from these tests is summarized in this paper.
Download or read book Advanced Stirling Convertor Testing at NASA Glenn Research Center written by National Aeronaut Administration (Nasa) and published by . This book was released on 2020-07-28 with total page 24 pages. Available in PDF, EPUB and Kindle. Book excerpt: The U.S. Department of Energy (DOE), Lockheed Martin Space Systems (LMSS), Sunpower Inc., and NASA Glenn Research Center (GRC) have been developing an Advanced Stirling Radioisotope Generator (ASRG) for use as a power system on space science and exploration missions. This generator will make use of the free-piston Stirling convertors to achieve higher conversion efficiency than currently available alternatives. The ASRG will utilize two Advanced Stirling Convertors (ASC) to convert thermal energy from a radioisotope heat source to electricity. NASA GRC has initiated several experiments to demonstrate the functionality of the ASC, including: in-air extended operation, thermal vacuum extended operation, and ASRG simulation for mobile applications. The in-air and thermal vacuum test articles are intended to provide convertor performance data over an extended operating time. These test articles mimic some features of the ASRG without the requirement of low system mass. Operation in thermal vacuum adds the element of simulating deep space. This test article is being used to gather convertor performance and thermal data in a relevant environment. The ASRG simulator was designed to incorporate a minimum amount of support equipment, allowing integration onto devices powered directly by the convertors, such as a rover. This paper discusses the design, fabrication, and implementation of these experiments. Oriti, Salvatore M. and Blaze, Gina M. Glenn Research Center NASA/TM-2007-215010, AIAA Paper-2007-4840, E-16190 STIRLING CYCLE; RADIOISOTOPE HEAT SOURCES; THERMOELECTRIC POWER GENERATION; ENERGY CONVERSION EFFICIENCY; ALTERNATING CURRENT; THERMAL VACUUM TESTS; SIMULATION; AEROSPACE SYSTEMS; PROPULSION SYSTEM PERFORMANCE
Download or read book Advanced Stirling Convertor Testing at Nasa Glenn Research Center written by Nasa Technical Reports Server (Ntrs) and published by BiblioGov. This book was released on 2013-07 with total page 28 pages. Available in PDF, EPUB and Kindle. Book excerpt: The U.S. Department of Energy (DOE), Lockheed Martin Space Systems (LMSS), Sunpower Inc., and NASA Glenn Research Center (GRC) have been developing an Advanced Stirling Radioisotope Generator (ASRG) for use as a power system on space science and exploration missions. This generator will make use of the free-piston Stirling convertors to achieve higher conversion efficiency than currently available alternatives. The ASRG will utilize two Advanced Stirling Convertors (ASC) to convert thermal energy from a radioisotope heat source to electricity. NASA GRC has initiated several experiments to demonstrate the functionality of the ASC, including: in-air extended operation, thermal vacuum extended operation, and ASRG simulation for mobile applications. The in-air and thermal vacuum test articles are intended to provide convertor performance data over an extended operating time. These test articles mimic some features of the ASRG without the requirement of low system mass. Operation in thermal vacuum adds the element of simulating deep space. This test article is being used to gather convertor performance and thermal data in a relevant environment. The ASRG simulator was designed to incorporate a minimum amount of support equipment, allowing integration onto devices powered directly by the convertors, such as a rover. This paper discusses the design, fabrication, and implementation of these experiments.
Download or read book Advanced Stirling Convertor Characterization Testing written by Zachary D. Williams and published by BiblioGov. This book was released on 2013-06 with total page 24 pages. Available in PDF, EPUB and Kindle. Book excerpt: Testing has been conducted on Advanced Stirling Convertor (ASC-E2) convertors at NASA Glenn Research Center in support of the Advanced Stirling Radioisotope Generator (ASRG) Project. This testing has been conducted to understand sensitivities of convertor parameters due to environmental and operational changes during operation of the ASRG in missions to space. This paper summarizes test results and explains in terms of operation of the ASRG during space missions.
Download or read book Automotive Stirling Engine Development Project written by William D. Ernst and published by . This book was released on 1997 with total page 174 pages. Available in PDF, EPUB and Kindle. Book excerpt: The objectives of the Automotive Stifling Engine (ASE) Development project were to transfer European Stirling engine technology to the United States and develop an ASE that would demonstrate a 30% improvement in combined metro-highway fuel economy over a comparable spark ignition (SI) engine in the same production vehicle. In addition, the ASE should demonstrate the potential for reduced emissions levels while maintaining the performance characteristics of SI engines. Mechanical Technology Incorporated (MTI) developed the ASE in an evolutionary manner, starting with the test and evaluation of an existing stationary Stirling engine and proceeding through two experimental engine designs: the Mod I and the Mod II. Engine technology development resulted in elimination of strategic materials, increased power density, higher temperature and efficiency operation, reduced system complexity, long-life seals, and low-cost manufacturing designs. Mod Ii engine dynamometer tests demonstrated that the engine system configuration had accomplished its performance goals for power (60 kW) and efficiency (38.5%) to within a few percent. Tests with the Mod II installed in a delivery van demonstrated a combined fuel economy improvement consistent with engine performance goals and the potential for low emissions levels. A modified version of the Mod II was identified as a manufacturable ASE design for commercial production. In conjunction with engine technology development, technology transfer proceeded through two ancillary efforts: the Industry Test and Evaluation Program (ITEP) and the NASA Technology Utilization (TU) project. The ITEP served to introduce Stirling technology to industry, and the TU project provided vehicle field demonstrations for thirdparty evaluation in everyday use and accomplished more than 3100 hr and 8,000 miles of field operation. To extend technology transfer beyond the ASE project, a Space Act Agreement between MTI and NASA-Lewis Research Center allowed utilization of project resources for additional development work and emissions testing as part of an industry-funded Stirling Natural Gas Engine program.
Download or read book Electronic Warfare and Radar Systems Engineering Handbook written by and published by . This book was released on 1997-04-01 with total page 605 pages. Available in PDF, EPUB and Kindle. Book excerpt: This handbook is designed to aid electronic warfare and radar systems engineers in making general estimations regarding capabilities of systems. It is not intended as a detailed designer's guide, due to space limitations. Portions of the handbook and future changes will be posted on an internet link.
Download or read book Civil Space Technology Initiative written by and published by . This book was released on 1990 with total page 28 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Applied Digital Logic Exercises Using FPGAs written by Kurt Wick and published by Morgan & Claypool Publishers. This book was released on 2017-10-03 with total page 190 pages. Available in PDF, EPUB and Kindle. Book excerpt: FPGAs have almost entirely replaced the traditional Application Specific Standard Parts (ASSP) such as the 74xx logic chip families because of their superior size, versatility, and speed. For example, FPGAs provide over a million fold increase in gates compared to ASSP parts. The traditional approach for hands-on exercises has relied on ASSP parts, primarily because of their simplicity and ease of use for the novice. Not only is this approach technically outdated, but it also severely limits the complexity of the designs that can be implemented. By introducing the readers to FPGAs, they are being familiarized with current digital technology and the skills to implement complex, sophisticated designs. However, working with FGPAs comes at a cost of increased complexity, notably the mastering of an HDL language, such as Verilog. Therefore, this book accomplishes the following: first, it teaches basic digital design concepts and then applies them through exercises; second, it implements these digital designs by teaching the user the syntax of the Verilog language while implementing the exercises. Finally, it employs contemporary digital hardware, such as the FPGA, to build a simple calculator, a basic music player, a frequency and period counter and it ends with a microprocessor being embedded in the fabric of the FGPA to communicate with the PC. In the process, readers learn about digital mathematics and digital-to-analog converter concepts through pulse width modulation.
Download or read book Space 2030 Exploring the Future of Space Applications written by OECD and published by OECD Publishing. This book was released on 2004-05-03 with total page 234 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report adopts a scenario-based approach to explore the future evolution of major components of the space sector (military space, civil space, commercial space) over the next thirty years.
Download or read book Solar and Space Physics written by National Research Council and published by National Academies Press. This book was released on 2014-09-25 with total page 37 pages. Available in PDF, EPUB and Kindle. Book excerpt: In 2010, NASA and the National Science Foundation asked the National Research Council to assemble a committee of experts to develop an integrated national strategy that would guide agency investments in solar and space physics for the years 2013-2022. That strategy, the result of nearly 2 years of effort by the survey committee, which worked with more than 100 scientists and engineers on eight supporting study panels, is presented in the 2013 publication, Solar and Space Physics: A Science for a Technological Society. This booklet, designed to be accessible to a broader audience of policymakers and the interested public, summarizes the content of that report.
Download or read book Terrain Flying written by United States. Federal Aviation Administration and published by . This book was released on 1968 with total page 120 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Stirling Engine Design Manual written by William Martini and published by CreateSpace. This book was released on 2013-01-25 with total page 414 pages. Available in PDF, EPUB and Kindle. Book excerpt: For Stirling engines to enjoy widespread application and acceptance, not only must the fundamental operation of such engines be widely understood, but the requisite analytic tools for the stimulation, design, evaluation and optimization of Stirling engine hardware must be readily available. The purpose of this design manual is to provide an introduction to Stirling cycle heat engines, to organize and identify the available Stirling engine literature, and to identify, organize, evaluate and, in so far as possible, compare non-proprietary Stirling engine design methodologies. This report was originally prepared for the National Aeronautics and Space Administration and the U. S. Department of Energy.
Download or read book Isotopes in Agriculture written by and published by . This book was released on 1958 with total page 476 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Nuclear Science Abstracts written by and published by . This book was released on 1971 with total page 1040 pages. Available in PDF, EPUB and Kindle. Book excerpt: NSA is a comprehensive collection of international nuclear science and technology literature for the period 1948 through 1976, pre-dating the prestigious INIS database, which began in 1970. NSA existed as a printed product (Volumes 1-33) initially, created by DOE's predecessor, the U.S. Atomic Energy Commission (AEC). NSA includes citations to scientific and technical reports from the AEC, the U.S. Energy Research and Development Administration and its contractors, plus other agencies and international organizations, universities, and industrial and research organizations. References to books, conference proceedings, papers, patents, dissertations, engineering drawings, and journal articles from worldwide sources are also included. Abstracts and full text are provided if available.
Download or read book Research and Technology Program written by and published by . This book was released on 1994 with total page 74 pages. Available in PDF, EPUB and Kindle. Book excerpt:
