Download or read book Steady and Periodic Pressure Measurements on a Generic Helicopter Fuselage Model in the Presence of a Rotor written by Raymond E. Mineck and published by . This book was released on 2000 with total page 190 pages. Available in PDF, EPUB and Kindle. Book excerpt: A wind tunnel test of a generic helicopter fuselage model with an independently mounted rotor has been conducted to obtain steady and periodic pressure data on the helicopter body. The model was tested at four advance ratios and three thrust coefficients. The periodic unsteady pressure coefficients are marked by four peaks associated with the passage of the four rotor blades. Blade passage effects are largest on the nose and tail boom of the model. The magnitude of the pulse increases with rotor thrust coefficient. Tabular listings of the unsteady pressure data are included to permit independent analysis. A CDrom containing the steady and unsteady pressure data presented in the report is available from the authors.
Download or read book Steady and Periodic Pressure Measurements on a Generic Helicopter Fuselage Model in the Presence of a Rotor written by National Aeronautics and Space Administration (NASA) and published by Createspace Independent Publishing Platform. This book was released on 2018-06-13 with total page 188 pages. Available in PDF, EPUB and Kindle. Book excerpt: A wind tunnel test of a generic helicopter fuselage model with an independently mounted rotor has been conducted to obtain steady and periodic pressure data on the helicopter body. The model was tested at four advance ratios and three thrust coefficients. The periodic unsteady pressure coefficients are marked by four peaks associated with the passage of the four rotor blades. Blade passage effects are largest on the nose and tail boom of the model. The magnitude of the pulse increases with rotor thrust coefficient. Tabular listings of the unsteady pressure data are included to permit independent analysis. A CD-rom containing the steady and unsteady pressure data presented in the report is available from the authors. Mineck, Raymond E. and Gorton, Susan A. Langley Research Center RTOP 581-10-11-01
Download or read book New Results in Numerical and Experimental Fluid Mechanics XIII written by Andreas Dillmann and published by Springer Nature. This book was released on 2021-07-13 with total page 787 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book offers timely insights into research on numerical and experimental fluid mechanics and aerodynamics, mainly for (but not limited to) aerospace applications. It reports on findings by members of the STAB (German Aerospace Aerodynamics Association) and DGLR (German Society for Aeronautics and Astronautics) and covers both nationally and EC-funded projects. Continuing on the tradition of the previous volumes, the book highlights innovative solutions, promoting translation from fundamental research to industrial applications. It addresses academics and professionals in the field of aeronautics, astronautics, ground transportation, and energy alike.
Download or read book 2023 Asia Pacific International Symposium on Aerospace Technology APISAT 2023 Proceedings written by Song Fu and published by Springer Nature. This book was released on with total page 1991 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Handbook of Numerical Simulation of In Flight Icing written by Wagdi George Habashi and published by Springer Nature. This book was released on 2024-01-12 with total page 1278 pages. Available in PDF, EPUB and Kindle. Book excerpt: This Handbook of Numerical Simulation of In-Flight Icing covers an array of methodologies and technologies on numerical simulation of in-flight icing and its applications. Comprised of contributions from internationally recognized experts from the Americas, Asia, and the EU, this authoritative, self-contained reference includes best practices and specification data spanning the gamut of simulation tools available internationally that can be used to speed up the certification of aircraft and make them safer to fly into known icing. The collection features nine sections concentrating on aircraft, rotorcraft, jet engines, UAVs; ice protection systems, including hot-air, electrothermal, and others; sensors and probes, CFD in the aid of testing, flight simulators, and certification process acceleration methods. Incorporating perspectives from academia, commercial, government R&D, the book is ideal for a range of engineers and scientists concerned with in-flight icing applications.
Download or read book 43rd AIAA Aerospace Sciences Meeting Exhibit written by and published by . This book was released on 2005 with total page 630 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book NASA Langley Scientific and Technical Information Output 2000 written by and published by . This book was released on 2001 with total page 162 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Fuselage Surface Pressure Measurements of a Helicopter Wind tunnel Model with a 3 15 meter Diameter Single Rotor written by and published by . This book was released on 1979 with total page 176 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Preliminary Study of a Model Rotor in Descent written by and published by . This book was released on 2000 with total page 44 pages. Available in PDF, EPUB and Kindle. Book excerpt: Within a program designed to develop experimental techniques for measuring the trajectory and structure of vortices trailing from the tips of rotor blades, the present preliminary study focuses on a method for quantifying the trajectory of the trailing vortex during descent flight conditions. This study also presents rotor loads and blade surface pressures for a range of tip-path plane angles and Mach numbers. Blade pressures near the leading edge and along the outer radius are compared with data obtained on the same model rotor, but in open jet facilities. A triangulation procedure based on two directable laser-light sheets, each containing an embedded reference, proved effective in defining the spatial coordinates of the trailing vortex. When interrogating a cross section of the flow that contains several trailing vortices, the greatest clarity was found to result when the flow is uniformly seeded. Surface pressure responses during blade-vortex interactions appeared equally sensitive near the leading edge and along the outer portion of the blade, but diminished rapidly as the distance along the blade chord increased. The pressure response was virtually independent of whether the tip-path plane angle was obtained through shaft tilt or cyclic pitch. Although the shape and frequency of the pressure perturbations on the advancing blade during blade-vortex interaction are similar to those obtained in open-jet facilities, the angle of the tip-path plane may need to be lower than the range covered in this study.
Download or read book Flow Environment Study Near the Empennage of a 15 Percent Scale Helicopter Model written by Susan Althoff Gorton and published by . This book was released on 2000 with total page 32 pages. Available in PDF, EPUB and Kindle. Book excerpt: Development of advanced rotorcraft configurations has highlighted a need for high-quality experimental data to support the development of flexible and accurate analytical design tools. To provide this type of data, a test program was conducted in the Langley 14- by 22-Foot Subsonic Tunnel to measure the flow near the empennage of a 15-percent scale powered helicopter model with an operating tail fan. Three-component velocity profiles were measured with laser velocimetry (LV) one chord forward of the horizontal tail for four advance ratios to evaluate the effect of the rotor wake impingement on the horizontal tail angle of attack. These velocity data indicate the horizontal tail can experience unsteady angle of attack variations of over 30 degress due to the rotor wake influence. The horizontal tail is most affected by the rotor wake above advance ratios of 0.10. Velocity measurements of the flow on the inlet side of the tail fan were made for a low-speed flight condition using conventional LV techniques. The velocity data show an accelerated flow near the tail fan duct, and vorticity calculations track the passage of main rotor wake vortices through the measurement plane.
Download or read book A Tabulation of Helicopter Rotor blade Differential Pressures Stresses and Motions as Measured in Flight written by James Scheiman and published by . This book was released on 1964 with total page 704 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Wind tunnel Investigation of Effects of Fuselage Cross sectional Shape Fuselage Bend and Vertical tail Size on Directional Characteristics of Nonoverlap type Helicopter Fuselage Models Without Rotors written by James L. Williams and published by . This book was released on 1956 with total page 736 pages. Available in PDF, EPUB and Kindle. Book excerpt: A low-speed investigatio was made in the Langley stability tunnel to determine the directional stability characteristics of tandem nonoverlap-type helicopter fuselages without rotors. The investigation consisted of a study of both bent and straight fuselages having either circular or essentially elliptical cross sections and with two vertical-tail sizes.
Download or read book Surface Pressure Measurements at Two Tips of a Model Helicopter Rotor in Hover written by Robin Bryant Gray and published by . This book was released on 1980 with total page 62 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Static thrust Tests of Six Rotor blade Designs on a Helicopter in the Langley Full scale Tunnel written by Richard C. Dingeldein and published by . This book was released on 1945 with total page 28 pages. Available in PDF, EPUB and Kindle. Book excerpt: Measurements of the static-thrust performance of six sets of rotor blades mounted on a helicopter fuselage have been made in the Langley full-scale tunnel. The rotor blades differ in surface condition, pitch distribution, airfoil section, plan form, and solidity. These differences are largely unsystematic. The variation of rotor thrust coefficient with torque coefficient and the power required to hover are compared for each set of blades. Because of the indeterminate condition of ground restraint caused by the wind-tunnel balance house and test-chamber walls, the absolute magnitude of the data is questionable but the comparative results are believed to be reliable.
Download or read book Aeronautical Engineering written by and published by . This book was released on 1993 with total page 712 pages. Available in PDF, EPUB and Kindle. Book excerpt: A selection of annotated references to unclassified reports and journal articles that were introduced into the NASA scientific and technical information system and announced in Scientific and technical aerospace reports (STAR) and International aerospace abstracts (IAA)
Download or read book Aeronautical Engineering A Cumulative Index to a Continuing Bibliography supplement 287 written by and published by . This book was released on 1993 with total page 706 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Aerodynamic Characteristics of Several Current Helicopter Tail Boom Cross Sections Including the Effect of Spoilers written by John C. Wilson and published by . This book was released on 1986 with total page 80 pages. Available in PDF, EPUB and Kindle. Book excerpt: Aerodynamic characteristics were determined of three cylindrical shapes representative of tail boom cross sections of the AH-64, UH-60, and UH-1H helicopters. Forces and pressures were measured in a wind-tunnel investigation. Data was obtained for a flow incidence range from -45 to 90 deg and a dynamic pressure range from 1.5 to 50 psf. These ranges provided data representative of full-scale Reynolds numbers and the full range of flow incidence to which these helicopter tail boom shapes would be subjected at low flight speeds. The effects of protuberances such as tail rotor drive-shaft covers and spoilers were evaluated. The data indicate that significant side loads on tail booms of helicopters can be generated and that the addition of spoilers can beneficially alter the side loads. Although an increase in vertical drag occurs, the net effect through reduction of tail rotor thrust required can be an improvement in helicopter performance. Keywords: Rotorcraft; Aerodynamics; Stability and control; Helicopters; Tail booms.
