Download or read book Separated and Vortical Flow in Aircraft Wing Aerodynamics written by Ernst Heinrich Hirschel and published by Springer Nature. This book was released on 2020-10-04 with total page 458 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fluid mechanical aspects of separated and vortical flow in aircraft wing aerodynamics are treated. The focus is on two wing classes: (1) large aspect-ratio wings and (2) small aspect-ratio delta-type wings. Aerodynamic design issues in general are not dealt with. Discrete numerical simulation methods play a progressively larger role in aircraft design and development. Accordingly, in the introduction to the book the different mathematical models are considered, which underlie the aerodynamic computation methods (panel methods, RANS and scale-resolving methods). Special methods are the Euler methods, which as rather inexpensive methods embrace compressibility effects and also permit to describe lifting-wing flow. The concept of the kinematically active and inactive vorticity content of shear layers gives insight into many flow phenomena, but also, with the second break of symmetry---the first one is due to the Kutta condition---an explanation of lifting-wing flow fields. The prerequisite is an extended definition of separation: “flow-off separation” at sharp trailing edges of class (1) wings and at sharp leading edges of class (2) wings. The vorticity-content concept, with a compatibility condition for flow-off separation at sharp edges, permits to understand the properties of the evolving trailing vortex layer and the resulting pair of trailing vortices of class (1) wings. The concept also shows that Euler methods at sharp delta or strake leading edges of class (2) wings can give reliable results. Three main topics are treated: 1) Basic Principles are considered first: boundary-layer flow, vortex theory, the vorticity content of shear layers, Euler solutions for lifting wings, the Kutta condition in reality and the topology of skin-friction and velocity fields. 2) Unit Problems treat isolated flow phenomena of the two wing classes. Capabilities of panel and Euler methods are investigated. One Unit Problem is the flow past the wing of the NASA Common Research Model. Other Unit Problems concern the lee-side vortex system appearing at the Vortex-Flow Experiment 1 and 2 sharp- and blunt-edged delta configurations, at a delta wing with partly round leading edges, and also at the Blunt Delta Wing at hypersonic speed. 3) Selected Flow Problems of the two wing classes. In short sections practical design problems are discussed. The treatment of flow past fuselages, although desirable, was not possible in the frame of this book.
Download or read book An Introduction to Flapping Wing Aerodynamics written by Wei Shyy and published by Cambridge University Press. This book was released on 2013-08-19 with total page 321 pages. Available in PDF, EPUB and Kindle. Book excerpt: This is an ideal book for graduate students and researchers interested in the aerodynamics, structural dynamics and flight dynamics of small birds, bats and insects, as well as of micro air vehicles (MAVs), which present some of the richest problems intersecting science and engineering. The agility and spectacular flight performance of natural flyers, thanks to their flexible, deformable wing structures, as well as to outstanding wing, tail and body coordination, is particularly significant. To design and build MAVs with performance comparable to natural flyers, it is essential that natural flyers' combined flexible structural dynamics and aerodynamics are adequately understood. The primary focus of this book is to address the recent developments in flapping wing aerodynamics. This book extends the work presented in Aerodynamics of Low Reynolds Number Flyers (Shyy et al. 2008).
Download or read book Analytical studies of separated vortex flow on highly swept wings written by John M. Kuhlman and published by . This book was released on 1978 with total page 72 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book A Theoretical Investigation of the Aerodynamics of Slender Wing body Combinations Exhibiting Leading edge Separation written by Alvin H. Sacks and published by . This book was released on 1967 with total page 124 pages. Available in PDF, EPUB and Kindle. Book excerpt: A theoretical analysis is presented for calculating the normal force and center of pressure on plane wing/body combinations exhibiting leading edge separation. The mathematical model for the separated flow involves the shedding of a number of discrete vortex pairs along the wing leading edge, each pair satisfying the Kutta condition at the position of shedding. The subsequent lateral positions of these vortex filaments are calculated step by step, so that the rolling up of the vortex sheet is taken into account. Hence, the method predicts the chordwise normal-force distributions as well as the vortex sheet shapes over the configuration.
Download or read book High Angle of Attack Aerodynamics written by Josef Rom and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 408 pages. Available in PDF, EPUB and Kindle. Book excerpt: The aerodynamics of aircraft at high angles of attack is a subject which is being pursued diligently, because the modern agile fighter aircraft and many of the current generation of missiles must perform well at very high incidence, near and beyond stall. However, a comprehensive presentation of the methods and results applicable to the studies of the complex aerodynamics at high angle of attack has not been covered in monographs or textbooks. This book is not the usual textbook in that it goes beyond just presenting the basic theoretical and experimental know-how, since it contains reference material to practical calculation methods and technical and experimental results which can be useful to the practicing aerospace engineers and scientists. It can certainly be used as a text and reference book for graduate courses on subjects related to high angles of attack aerodynamics and for topics related to three-dimensional separation in viscous flow courses. In addition, the book is addressed to the aerodynamicist interested in a comprehensive reference to methods of analysis and computations of high angle of attack flow phenomena and is written for the aerospace scientist and engineer who is familiar with the basic concepts of viscous and inviscid flows and with computational methods used in fluid dynamics.
Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1995 with total page 704 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Classical Aerodynamic Theory written by and published by . This book was released on 1979 with total page 324 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Flow Control Techniques and Applications written by Jinjun Wang and published by Cambridge University Press. This book was released on 2018-12-13 with total page 293 pages. Available in PDF, EPUB and Kindle. Book excerpt: Master the theory, applications and control mechanisms of flow control techniques.
Download or read book Basic Research Program written by United States. Department of Defense and published by . This book was released on 1985 with total page 96 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Aircraft Aerodynamic Design with Computational Software written by Arthur Rizzi and published by Cambridge University Press. This book was released on 2021-05-20 with total page 467 pages. Available in PDF, EPUB and Kindle. Book excerpt: This modern text presents aerodynamic design of aircraft with realistic applications, using CFD software and guidance on its use. Tutorials, exercises, and mini-projects provided involve design of real aircraft, ranging from straight to swept to slender wings, from low speed to supersonic. Supported by online resources and supplements, this toolkit covers topics such as shape optimization to minimize drag and collaborative designing. Prepares seniors and first-year graduate students for design and analysis tasks in aerospace companies. In addition, it is a valuable resource for practicing engineers, aircraft designers, and entrepreneurial consultants.
Download or read book Computation of a Delta wing Roll and hold Maneuver written by Raymond E. Gordnier and published by . This book was released on 1993 with total page 50 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report presents computations of the flowfield around an 80 degree sweep delta wing undergoing a constant roll-rate maneuver from 0 to 45 degrees. The governing equations for the problem are the unsteady, three- dimensional Navier-Stokes equations. The equations are solved using the implicit, approximately-factored algorithm of Beam-Warming. Fixed roll angle results are also presented and compared with experimental measurements to demonstrate the ability of the numerical technique to accurately capture the flowfield around a rolled delta wing. The dynamic behaviors of the vortex position and strength, as well as their corresponding effect on surface pressure, lift and roll moment, are described. A simple, quasi-static explanation of these vortex behaviors based on effective angle-of-attack and sideslip angle is proposed ... Delta wing roll, Vortex dynamics, Vortical flow, Unsteady maneuver.
Download or read book Recent Progress in Computational Sciences and Engineering 2 vols written by Theodore Simos and published by CRC Press. This book was released on 2019-05-07 with total page 1600 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume brings together selected contributed papers presented at the International Conference of Computational Methods in Science and Engineering (ICCMSE 2006), held in Chania, Greece, October 2006. The conference aims to bring together computational scientists from several disciplines in order to share methods and ideas. The ICCMSE is unique in its kind. It regroups original contributions from all fields of the traditional Sciences, Mathematics, Physics, Chemistry, Biology, Medicine and all branches of Engineering. It would be perhaps more appropriate to define the ICCMSE as a conference on computational science and its applications to science and engineering. Topics of general interest are: Computational Mathematics, Theoretical Physics and Theoretical Chemistry. Computational Engineering and Mechanics, Computational Biology and Medicine, Computational Geosciences and Meteorology, Computational Economics and Finance, Scientific Computation. High Performance Computing, Parallel and Distributed Computing, Visualization, Problem Solving Environments, Numerical Algorithms, Modelling and Simulation of Complex System, Web-based Simulation and Computing, Grid-based Simulation and Computing, Fuzzy Logic, Hybrid Computational Methods, Data Mining, Information Retrieval and Virtual Reality, Reliable Computing, Image Processing, Computational Science and Education etc. More than 800 extended abstracts have been submitted for consideration for presentation in ICCMSE 2005. From these 500 have been selected after international peer review by at least two independent reviewers.
Download or read book Theoretical and Computational Aerodynamics written by Tapan K. Sengupta and published by John Wiley & Sons. This book was released on 2014-10-20 with total page 544 pages. Available in PDF, EPUB and Kindle. Book excerpt: Aerodynamics has seen many developments due to the growth of scientific computing, which has caused the design cycle time of aerospace vehicles to be heavily reduced. Today computational aerodynamics appears in the preliminary step of a new design, relegating costly, time-consuming wind tunnel testing to the final stages of design. Theoretical and Computational Aerodynamics is aimed to be a comprehensive textbook, covering classical aerodynamic theories and recent applications made possible by computational aerodynamics. It starts with a discussion on lift and drag from an overall dynamical approach, and after stating the governing Navier-Stokes equation, covers potential flows and panel method. Low aspect ratio and delta wings (including vortex breakdown) are also discussed in detail, and after introducing boundary layer theory, computational aerodynamics is covered for DNS and LES. Other topics covered are on flow transition to analyse NLF airfoils, bypass transition, streamwise and cross-flow instability over swept wings, viscous transonic flow over airfoils, low Reynolds number aerodynamics, high lift devices and flow control. Key features: Blends classical theories of incompressible aerodynamics to panel methods Covers lifting surface theories and low aspect ratio wing and wing-body aerodynamics Presents computational aerodynamics from first principles for incompressible and compressible flows Covers unsteady and low Reynolds number aerodynamics Includes an up-to-date account of DNS of airfoil aerodynamics including flow transition for NLF airfoils Contains chapter problems and illustrative examples Accompanied by a website hosting problems and a solution manual Theoretical and Computational Aerodynamics is an ideal textbook for undergraduate and graduate students, and is also aimed to be a useful resource book on aerodynamics for researchers and practitioners in the research labs and the industry.
Download or read book Aerodynamics written by Theodore Von Kármán and published by Courier Corporation. This book was released on 2004-01-01 with total page 226 pages. Available in PDF, EPUB and Kindle. Book excerpt: Charming, reader-friendly chronicle by a famous pioneer in aerodynamic research traces the development of dynamic flight from the time of Newton through the 20th century. It recounts struggles of engineers and physicists with problems associated with lift, drag, stability, aeroelasticity, and the sound barrier. 72 figures. 1957 edition.
Download or read book Applied Computational Aerodynamics written by Russell M. Cummings and published by Cambridge University Press. This book was released on 2015-04-27 with total page 893 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book covers the application of computational fluid dynamics from low-speed to high-speed flows, especially for use in aerospace applications.
Download or read book Vortical Flows written by Jie-Zhi Wu and published by Springer. This book was released on 2015-06-23 with total page 453 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book is a comprehensive and intensive book for graduate students in fluid dynamics as well as scientists, engineers and applied mathematicians. Offering a systematic introduction to the physical theory of vortical flows at graduate level, it considers the theory of vortical flows as a branch of fluid dynamics focusing on shearing process in fluid motion, measured by vorticity. It studies vortical flows according to their natural evolution stages,from being generated to dissipated. As preparation, the first three chapters of the book provide background knowledge for entering vortical flows. The rest of the book deals with vortices and vortical flows, following their natural evolution stages. Of various vortices the primary form is layer-like vortices or shear layers, and secondary but stronger form is axial vortices mainly formed by the rolling up of shear layers. Problems are given at the end of each chapter and Appendix, some for helping understanding the basic theories, and some involving specific applications; but the emphasis of both is always on physical thinking.
Download or read book Advances in Effective Flow Separation Control for Aircraft Drag Reduction written by Ning Qin and published by Springer Nature. This book was released on 2019-10-17 with total page 341 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book presents the results of a European-Chinese collaborative research project, Manipulation of Reynolds Stress for Separation Control and Drag Reduction (MARS), including an analysis and discussion of the effects of a number of active flow control devices on the discrete dynamic components of the turbulent shear layers and Reynolds stress. From an application point of view, it provides a positive and necessary step to control individual structures that are larger in scale and lower in frequency compared to the richness of the temporal and spatial scales in turbulent separated flows.
