Download or read book Red River Waterway John H Overton Lock and Dam written by Stephen T. Maynord and published by . This book was released on 1990 with total page 66 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Red River Waterway John H Overton Lock and Dam Report 4 Stilling Basin Riprap and Hydropower Requirements Spillway and Hydropower Model Investigation written by and published by . This book was released on 1990 with total page 66 pages. Available in PDF, EPUB and Kindle. Book excerpt: Tests were conducted on a 1:50-scale model of John H. Overton and Dam, Alexandria, LA, to develop a satisfactory spillway, stilling basin, and riprap plan for the proposed project. Tests were conducted with and without a proposed hydropower plan. The recommended stilling basin and riprap designs provided a stable conditions for single gate operation with normal upper pool and minimum tailwater. Tests were conducted with four- and three-unit powerhouse having various approach and exit configurations. During construction of John H. Overton Lock and Dam, sediment deposition problems occurred in the lower lock approach of Red River Lock and Dam No. 1. Additional sedimentation studies were conducted to ensure that these problems would not occur at John H. Overton. Dikes placed in the downstream channel were proposed as a solution to the sedimentation problem. The stability of the riprap forming these dikes and the impact of the dikes on the water-surface profiles were also studied in this investigation. (jhd).
Download or read book Red River Waterway Lock and Dam Number 4 Report 4 Stilling Basin and Riprap Requirements Spillway Hydraulic Model Study written by and published by . This book was released on 1992 with total page 65 pages. Available in PDF, EPUB and Kindle. Book excerpt: Lock and Dam No. 4 is proposed for construction in a cutoff canal on the Red River approximately 71 miles below Shreveport, LA. The principal structures consist of a lock with an adjacent gated spillway and overflow weir. The lock, which will be 84 ft wide with 685 ft of usable length, will be located on the left bank line looking downstream and will have a maximum lift of 25 ft. The gated spillway will contain four tainter gates, 60 ft wide by 36 ft high, with a sill elevation of 86.0 ft (elevations (el) are in feet referred to the National Geodetic Vertical Datum), and an overflow weir with three 100-ft-wide hinged gates. The crest of the hinge-gated weir will be at el 115.0, and the top of the hinged gate in its fully raised (closed) position will be at el 122.0. Tests were conducted in a 1:40-scale model of Lock and Dam No. 4 to develop a satisfactory energy dissipator and a stable riprap protection plan. The original crest was lowered to el 85, a fifth tainter gate was added, and the three 100- ft-wide hinge-gated crests were replaced by a single 100-ft-wide baffled chute. Tests were conducted to compare the two designs, and data obtained with both designs are presented in this report. Water-surface profiles were measured for the full range of expected operating conditions. The recommended stilling basin provides adequate energy dissipation for normal flow and for a single gate fully open and half open operating with minimum tailwater. The recommended riprap protection plan in the upstream and downstream areas adjacent to the structure remained stable for these conditions.
Download or read book Red River Waterway John H Overton Lock and Dam Report 3 Sedimentation Conditions Hydraulic Model Investigation written by and published by . This book was released on 1997 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: John H. Overton Lock and Dam, located in a cutoff channel between river miles 89.0 and 86.5 of the Red River, is designed to maintain a narrow pool elevation of 64 (all elevations are in feet referred to National Geodetic Vertical Datum) upstreaan to Lock and Dam 4. The design calls for an 84 ft by 685-ft usable lock chamber and a dam with five 60-ft-wide gates. A movable-bed model study was performed to determine the alignment of the channel and the arrangement of the lock and dam that would provide the most satisfactory channel for both navigation and sediment movement. The movable-bed model was built to a scale of 1:20 horizontally and 1:80 vertically and reproduced the study area from river miles 90.0 to 85.0. The movable bed was molded using crushed coal with a median grain size of 4 mm and a specific gravity of 1.30. The original design for the lock and dam (Plans A and B) used a six-gate dam, maintaining the upper pool at el 58. The darm was redesigned prior to testing of Plan C, going to the final design of five gates, maintaining the upper pool at el 64. Plan C-81 showed a tendency for reduced deposition along the left bank of the upper lock approach. Plan D reduced scour downstream of the lower lock approach, and Plan D-1 also reduced scour but increased deposition along the left bank of the lower lock approach. Plan E prevented shoaling in the upper lock approach, and Plan E-1 would likely increase shoaling compared with the Base Examination conditions.
Download or read book List of Publications of the U S Army Engineer Waterways Experiment Station written by U.S. Army Engineer Waterways Experiment Station and published by . This book was released on 1993 with total page 408 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Red River Waterway Lock and Dam 3 Report 2 Navigation Alignment Conditions Hydraulic Model Investigation written by and published by . This book was released on 1997 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: Lock and Dam 3 is located on the Red River, in a cutoff channel between 1967 river miles 140 and 142, and about 53 channel miles above John H. Overton Lock and Dam. The lock and dam will be the third lock in a series of five locks and dams designed to furnish the required maximum lift of 141 ft to provide year-round navigation on the Old and Red River Waterway from the Mississippi River to Shreveport, LA, a distance of 236 miles. The principal structures are an 84-ft-wide by 685-ft-long lock, a spillway containing six 60-ft-wide by 42-ft-high tainter gates, and a 315-ft-long fixed-crest weir adjacent to the gated spillway. The dam provides a navigation pool that extends upstream to Lock and Dam 4. The dam is operated to maintain a navigation pool of el 95.0 at the dam (all elevations (el) cited herein are in feet referred to the National Geodetic Vertical Datum). A fixed-bed model reproduced about 3.5 miles of the Red River and adjacent overbank from about 13,500 ft upstream to about 4,800 ft downstream of the dam to an undistorted scale of 1:100. Since Lock and Dam 3 was to be constructed in an excavated channel bypassing the natural river channel, it was important that the alignment of the channel and the arrangement of the lock and dam be satisfactory for navigation. The model investigation was concerned with evaluation of navigation conditions for proposed lock designs and development of modifications required to ensure satisfactory navigation conditions. The study identified any needed modifications to the navigation channel alignment, guard wall lengths, or remedial structures. Results of the investigation revealed that a system of structures was required to eliminate adverse current patterns and establish satisfactory navigation conditions for tows entering and leaving the upper lock approach.
Download or read book Red River Waterway John A Overton Lock and Dam written by Bradley M. Comes and published by . This book was released on 1989 with total page 62 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book John H Overton Lock and Dam Red River Waterway written by United States. Army. Corps of Engineers. New Orleans District and published by . This book was released on 1979 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Red River Waterway Lock and Dam No 4 Report 2 Navigation Alignment Conditions Hydraulic Model Investigation written by and published by . This book was released on 1997 with total page 134 pages. Available in PDF, EPUB and Kindle. Book excerpt: Lock and Dam No. 4 is the fourth lock in a series of five to be constructed on the Red River Waterway from the vicinity of Old River to Shreveport, LA. Lock 4 is located in a cutoff canal on the left descending bank about 169 post project river miles above the mouth of the Red River. The principal structures include an 84- by 785-ft lock, a gated spillway containing five tainter gates, and a hinged crest gate 100 ft wide. The fixed bed model reproduced about 3.5 miles of realigned river channel and adjacent overbank area at an undistorted model scale of 1:100. The model investigation was concerned with determining the effects on navigation through the study reach for the proposed design and developing modifications required to the design that would provide satisfactory navigation conditions.
Download or read book John H Overton Lock and Dam Red River Waterway written by United States. Army. Corps of Engineers. New Orleans District and published by . This book was released on 1978 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Red River Waterway Lock and Dam No 4 written by Howard E. Park and published by . This book was released on 1997 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Spillway for Columbus Lock and Dam Tombigbee River Alabama written by Noel R. Oswalt and published by . This book was released on 1974 with total page 40 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book John H Overton Lock and Dam Red River Waterway written by United States. Army. Corps of Engineers. New Orleans District and published by . This book was released on 1981 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book John H Overton Lock and Dam Red River Waterway written by United States. Army. Corps of Engineers. New Orleans District and published by . This book was released on 1981 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book John H Overton Lock and Dam Red River Waterway Mississippi River to Shreveport LA written by United States. Army. Corps of Engineers. Vicksburg District and published by . This book was released on 1984 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book John H Overton Lock and Dam Red River Waterway Supplement No 1 written by United States. Army. Corps of Engineers. New Orleans District and published by . This book was released on 1980 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Lock and Dam 1 Red River Waterway written by James Edward Foster and published by . This book was released on 1986 with total page 112 pages. Available in PDF, EPUB and Kindle. Book excerpt: Lock and Dam 1 is the first navigation structure for the development of navigation on the Red River Waterway. The structure is located in a cutoff channel in the left overbank about 43.7 realigned channel miles above the Mississippi River. The structure includes one lock located along the left bank with clear chamber dimensions of 84 by 785 ft and a dam, consisting of a spillway with eleven 50-ft-wide gates, that is designed to provide a normal pool to el 40 upstream to Lock and Dam 2 (mile 74) and to pass a project flood flow of 225,000 cfs. A model reproducing two reaches of the Red River frm 1967 river mile 52.0 to 49.8 and from mile 44.0 to 41.5 and the proposed cutoff connecting these two reached, including Lock and Dam 1, was built for this study. The model was built with provisions to model the channel bed either in pea rock to an undistorted scale of 1:120 for navigation tests so velocities and current directions could be taken or in crushed coal to a distorted scale of 1:120 horizontally and 1:80 vertically for channel development tests to study bed configuration changes. The model study was conducted to determine navigation conditions and channel developments to be expected from the original design and to develop modification that might be required to: (a) improve flow conditions that would be adverse to navigation, and (b) minimize the dredging required to maintain a channel of satisfactory dimensions along a desired alignment.
