Download or read book Porous Metal Filters written by T. Shapiro and published by . This book was released on 1961 with total page 54 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Porous Metal Filters by Selective Laser Sintering written by Kirsten Jeanne Hendricksen and published by . This book was released on 1999 with total page 142 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Developments in Porous Metal Media for Gas Filtration written by R. P. Levey and published by . This book was released on 1959 with total page 56 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Handbook of Filter Media written by Derek B. Purchas and published by Elsevier. This book was released on 2002-10-28 with total page 606 pages. Available in PDF, EPUB and Kindle. Book excerpt: An Introduction to Filter Media -- Textiles -- Filter Papers and Filter Sheets -- Media for air and gas filters -- Screens and Meshes -- Porous Sheets and Tubes (excluding Membranes) -- Membranes -- Cartridges and Special Fabrications -- Loose Powders, granules and fibres -- Testing filter media.

Download or read book Performance of Tubular Porous Metal Crossflow Filters written by Gita R. Golcar and published by . This book was released on 2002 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Porosint Sintered Metal Filters written by and published by . This book was released on 1965 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Investigation of Alternative Approaches for Cleaning Mott Porous Metal Filters written by M. R. Poirier and published by . This book was released on 2003 with total page 5 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Department of Energy selected Caustic Side Solvent Extraction (CSSX) as the preferred cesium removal technology for Savannah River Site (SRS) waste. As a pretreatment step for the CSSX flowsheet, the incoming salt solution that contains entrained sludge is contacted with monosodium titanate (MST) to adsorb strontium and select actinides. The resulting slurry is filtered to remove the sludge and MST. Filter fouling occurs during this process. At times, personnel can increase the filtrate rate by backpulsing or scouring. At other times, the filtrate rate drops significantly and only chemical cleaning will restore filter performance. The current baseline technology for filter cleaning uses 0.5 M oxalic acid. The Salt Processing Project (SPP) at SRS, through the Tanks Focus Area, requested an evaluation of other cleaning agents to determine their effectiveness at removing trapped sludge and MST solids compared with the baseline oxalic acid method. A review of the technical literature identified compounds that appear effective at dissolving solid compounds. Consultation with the SPP management team, engineering personnel, and researchers led to a selection of oxalic acid, nitric acid, citric acid, and ascorbic acid for testing. Tests used simulated waste and actual waste as follows. Personnel placed simulated or actual SRS High Level Waste sludge and MST in a beaker. They added the selected cleaning agents, stirred the beakers, and collected supernate samples periodically analyzing for dissolved metals.

Download or read book Blowback of Sintered metal Filters written by Erwin L. Carls and published by . This book was released on 1968 with total page 30 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Sintered Metal Filters for Sodium Coolant Systems written by and published by . This book was released on 1958 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Equations which express the relations between the pressure drop, pore size, flow rate, and filter thickness for sodium flowing thrcugh sintered metal filters were derived. (C.J.G.).

Download or read book Development and Use of Sintered Metal Filters with Fluidized Bed and Spray Calcination of Simulated High level Waste written by and published by . This book was released on 1976 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: Sintered metal filters have been used for off-gas particulate removal on a pilot-scale fluidized bed calciner and spray calciner. The units calcined simulated commercial HLW at rates equivalent to 1 to 3 MTU/day fuel reprocessed. Filters were cleaned by a periodic pulse of air in a reverse direction through the filters. Filter systems design and recommended operating parameters are described.

Download or read book BLOWBACK OF SINTERED METAL FILTERS written by and published by . This book was released on 1968 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book High Efficiency Particulate Removal with Sintered Metal Filters written by and published by . This book was released on 1981 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Because of their particle removal efficiencies and durability, sintered metal filters have been chosen for high efficiency particulate air (HEPA) filter protection in the off-gas treatment system for the proposed Idaho National Engineering Laboratory Transuranic Waste Treatment Facility. Process evaluation of sintered metal filters indicated a lack of sufficient process design data to ensure trouble-free operation. Subsequence pilot scale testing was performed with flyash as the test particulate. The test results showed that the sintered metal filters can have an efficiency greater than 0.9999999 for the specific test conditions used. Stable pressure drop characteristics were observed in pulsed and reversed flow blowback modes of operation. Over 4900 hours of operation were obtained with operating conditions ranging up to approximately 90°C and 24 vol % water vapor in the gas stream.

Download or read book Porous Metals with Directional Pores written by Hideo Nakajima and published by Springer Science & Business Media. This book was released on 2013-09-27 with total page 291 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book reviews the recent development of fabrication methods and various properties of lotus-type porous metals and their applications. The nucleation and growth mechanism of the directional pores in metals are discussed in comparison with a model experiment of carbon dioxide pores in ice. Three casting techniques are introduced to produce not only metals and alloys but also intermetallic compounds, semiconductors, and ceramics: mold casting, continuous zone melting, and continuous casting. The latter has merits for mass production of lotus metals to control porosity, pore size and pore direction. Furthermore, anisotropic behavior of elastic, mechanical properties, thermal and electrical conductivity, magnetic properties, and biocompatibility are introduced as peculiar features of lotus metals.

Download or read book Porous Stainless Steel Filters for Removing Dust from Hot Gases written by Leslie J. Kane and published by . This book was released on 1961 with total page 26 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Sintered Metal Fibre Filters for Hot Gas Applications in the Refinery and Petrochemical chemical Industry written by Inge Schildermans and published by . This book was released on 2004 with total page 189 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Filters and Filtration written by Ronald Horace Warring and published by . This book was released on 1969 with total page 270 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Bibliography on Powder Metallurgy with Emphasis on Porous Metals written by Fred E. Croxton and published by . This book was released on 1950 with total page 32 pages. Available in PDF, EPUB and Kindle. Book excerpt: