Download or read book Methylcyclohexane Ignition Delay Times Under a Wide Range of Conditions written by Aditya Nagulapalli and published by . This book was released on 2015 with total page 90 pages. Available in PDF, EPUB and Kindle. Book excerpt: During the last century, our dependence on oil has increased rapidly and is projected to increase for several decades. There is a critical need to improve the design of the combustion chamber for different kinds of engines to reduce fuel consumption. Chemical kinetics of the fuel plays an important role in reducing emissions and improving engine efficiency. Studying single components of a conventional fuel allows a fuller understanding of the physical and chemical behavior of the real fuel. Many studies have been conducted on all classes of hydrocarbons, with the exception of cycloalkanes. Only a few studies exist on cycloalkanes, which is an important class of hydrocarbons. Methylcyclohexane (MCH), which is widely used as a surrogate to represent the cycloalkane portion of a fuel, was chosen as the subject of this study. The shock tube is an established tool used for measuring the ignition delay, and was used as the experimental apparatus. Ignition delay was measured using the end-plate pressure rise, the OH* and CH* chemiluminescence and white light emission. In addition, experimental results were compared with kinetic modeling data using detailed MCH mechanisms developed by Pitz et al. and Orme et al. Different modeling approaches, such as constant volume and internal energy (with and without experimental pressure profiles) and constant pressure, were used to validate the models by comparing against experimental ignition delay data. It was observed that the equivalence ratio affects the ignition delay time. For the lower argon concentration (Ar = 93%) and higher pressure (P ~ 16 atm), ignition delay times were longest for rich conditions. Additionally, they were shorter at lower temperatures (T = 1250 K) for stoichiometric conditions in comparison to lean values, but the opposite trend was observed at the higher temperatures (T > 1250 K). Ignition delay times of stoichiometric mixtures were longer than lean mixtures across the studied temperature range for low pressure (P = 2 atm) and argon concentration (Ar = 93%), as well as high pressure (P ~ 16 atm) and argon concentration (Ar = 98%). The Orme et al. model using the approach of constant U,V assumption with experimental pressure profile showed a better agreement with experimental results at low temperatures than the approach without experimental pressure profile. Both models and approaches underestimate the experimental ignition delay times at high temperatures.

Download or read book Oxidation Kinetics of Pure and Blended Methyl Octanoate n nonane methylcyclohexane written by Brandon Rotavera and published by . This book was released on 2012 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: The focus of the present work is on the empirical characterization and modeling of ignition trends of ternary blends of three distinct hydrocarbon classes, namely a methyl ester (C9H18O2), a linear alkane (n-C9H20), and a cycloalkane (MCH). Numerous surrogate biofuel formulations have been proposed in the literature, yet specific blending of these species has not been studied. Moreover, the effects of blending biofuel compounds with conventional hydrocarbons are not widely studied and a further point is the lack of studies paying specific attention to the effects of fuel variation within a given blended biofuel. To this end, a statistical Design of Experiments L9 array, comprised of 4 parameters (%MO, %MCH, pressure, and equivalence ratio) with 3 levels of variation, constructed in order to systematically study the effects of relative fuel concentrations within the ternary blend enabled variations in fuel concentration for methyl octanoate and MCH of 10%, 30% and 20%, 40%, respectively. Variation in pressure of 1 atm, 5 atm, and 10 atm and in equivalence ratio of 0.5, 1.0, and 2.0 were used, respectively. The fuel-volume percentage of n-nonane varied from 30%? 70%. In total, 10 ternary blends were studied. Ignition delay times for the ternary blends and for the three constituents were obtained by monitoring excited-state OH or CH transitions, A2Epsilon+ -> X2Pi or A2Delta -> X2Pi, respectively, behind reflected shock waves using a heated shock tube facility. Dilute conditions of 99% Ar (vol.) were maintained in all shock tube experiments with the exception of a separate series of n-nonane and MCH experiments under stoichiometric conditions which used 4% oxygen (corresponding to ~ 95% Ar dilution). Temperatures behind reflected shock waves were varied over the range 1243

Download or read book Experimental and Kinetic Modeling Study of Cyclohexane and Its Mono alkylated Derivatives Combustion written by Zhandong Wang and published by Springer. This book was released on 2018-01-23 with total page 225 pages. Available in PDF, EPUB and Kindle. Book excerpt: This thesis investigates the combustion chemistry of cyclohexane, methylcyclohexane, and ethylcyclohexane on the basis of state-of-the-art synchrotron radiation photoionization mass spectrometry experiments, quantum chemistry calculations, and extensive kinetic modeling. It explores the initial decomposition mechanism and distribution of the intermediates, proposes a novel formation mechanism of aromatics, and develops a detailed kinetic model to predict the three cycloalkanes’ combustion properties under a wide range of conditions. Accordingly, the thesis provides an essential basis for studying much more complex cycloalkanes in transport fuels and has applications in engine and fuel design, as well as emission control.

Download or read book Modeling and Experimental Investigation of Methylcyclohexane Ignition in a Rapid Compression Machine written by W. J. Pitz and published by . This book was released on 2005 with total page 11 pages. Available in PDF, EPUB and Kindle. Book excerpt: A new mechanism for the oxidation of methylcyclohexane has been developed. The mechanism combined a newly-developed low temperature mechanism with a previously developed high temperature mechanism. Predictions from the chemical kinetic model have been compared to experimentally measured ignition delay times from a rapid compression machine. Predicted ignition delay times using the initial estimates of the methylcyclohexyl peroxy radical isomerization rate constants were much longer than those measured at low temperatures. The initial estimates of isomerization rate constants were modified based on the experimental findings of Gulati and Walker that indicate a much slower rate of isomerization. Predictions using the modified rate constants for isomerizations yielded faster ignition at lower temperatures that greatly improved the agreement between model predictions and the experimental data. These findings point to much slower isomerization rates for methylcyclohexyl peroxy radicals than previously expected.

Download or read book Ignition Delay at Various High Pressures An Experimental Study written by Ritu Gaur and published by GRIN Verlag. This book was released on 2019-11-13 with total page 22 pages. Available in PDF, EPUB and Kindle. Book excerpt: Research Paper (postgraduate) from the year 2019 in the subject Engineering - Chemical Engineering, , course: M.TECH, language: English, abstract: This work is an experimental study for the measurement of ignition delay characteristics of burning fuel sprays in cylindrical combustion chambers. It is carried out on hot air and high pressure. The objective of the study is to investigation the effect of hot air temperature and a well as high pressure on ignition delay of diesel fuel sprays. The effect of blending of n-Pentane with pure diesel was investigated. An experimental set up was design for this purpose with the emphasis on optical method for measurement of ignition delay at various pressures. The results presented here show that ignition delay of diesel fuel spray decreases with increase in the temperature and pressure of hot air. Results also show the effect of methyl group being more dominant at low ignition temperatures and that of alkyl group being more dominant at higher temperature. Blending of n-pentane with diesel fuel, increase its ignition delay at low ignition temperatures. However, as the concentration of blending fuel was increased beyond 30%, the ignition temperature increase. Ignition temperature for 40% pentane blends is much higher that the pure diesel.

Download or read book Homogeneous Charge Compression Ignition Engines 2007 written by and published by . This book was released on 2007 with total page 592 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Predicting Ignition Delay Times of C1 C3 Alkanes hydrogen Blends at Gas Engine Conditions written by and published by . This book was released on 2018 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Tableaux modernes figuration et abstraction sculptures peintres contemporains paysagistes written by and published by . This book was released on 1990 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book The Influence of Evaporation of Fuel on the Ignition Delay of Two phase Mixtures written by A. V. Kudryavtsev and published by . This book was released on 1969 with total page 14 pages. Available in PDF, EPUB and Kindle. Book excerpt: An analysis was made of the ignition process of dispersed fuel-air mixtures, and formulas were derived for calculating the ignition delay times under various conditions. For the case where the evaporation time of the droplet is smaller or approximately equal to the induction period, a formula was derived for the ignition delay time and formulas for the effect of pressure and air excess coefficient were also derived. (Author).

Download or read book Thermochemical Kinetics written by Sidney William Benson and published by . This book was released on 1976 with total page 344 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book International Aerospace Abstracts written by and published by . This book was released on 1996 with total page 530 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book AIAA Bulletin written by and published by . This book was released on 1964 with total page 2244 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book The Effect of Diluent Gases In The Shock Tube and Rapid Compression Machine written by and published by . This book was released on 2007 with total page 23 pages. Available in PDF, EPUB and Kindle. Book excerpt: Studying the details of hydrocarbon chemistry in an internal combustion engine is not straightforward. A number of factors, including varying conditions of temperature and pressure, complex fluid motions, as well as variation in the composition of gasoline, render a meaningful characterization of the combusting system difficult. Some simplified experimental laboratory devices offer an alternative to complex engine environments: they remove some of the complexities that exist in real engines but retain the ability to work under engine-relevant conditions. The choice of simplified experimental devices is limited by the range of temperature and pressure at which they can operate; only the shock tube and rapid compression machine (RCM) can reach engine-relevant temperatures and pressures quickly enough and yet withstand the high pressures that occur after the ignition event. Both devices, however, suffer a common drawback: the use of inert diluent gases has been shown to affect the measured ignition delay time under some experimental conditions. Interestingly, this effect appears to be opposite in the shock tube and RCM: in the comparative study of the carrier gases argon and nitrogen, argon decreases the ignition delay time in the shock tube, but increases it in the RCM. This observation is investigated in more detail in this study.

Download or read book Combustion Generated Fine Carbonaceous Particles written by Andrea D'Anna and published by KIT Scientific Publishing. This book was released on 2014-08-13 with total page 754 pages. Available in PDF, EPUB and Kindle. Book excerpt: Soot is of importance for its contribution to atmospheric particles with their adverse health impacts and for its contributions to heat transfer in furnaces and combustors, to luminosity from candles, and to smoke that hinders escape from buildings during fires and that impacts global warming or cooling. The different chapters of the book adress comprehensively the different aspects from fundamental approaches to applications in technical combustion devices.

Download or read book Fundamentals of Combustion Processes written by Sara McAllister and published by Springer Science & Business Media. This book was released on 2011-05-10 with total page 315 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fundamentals of Combustion Processes is designed as a textbook for an upper-division undergraduate and graduate level combustion course in mechanical engineering. The authors focus on the fundamental theory of combustion and provide a simplified discussion of basic combustion parameters and processes such as thermodynamics, chemical kinetics, ignition, diffusion and pre-mixed flames. The text includes exploration of applications, example exercises, suggested homework problems and videos of laboratory demonstrations

Download or read book Emergency Response Guidebook written by U.S. Department of Transportation and published by Simon and Schuster. This book was released on 2013-06-03 with total page 400 pages. Available in PDF, EPUB and Kindle. Book excerpt: Does the identification number 60 indicate a toxic substance or a flammable solid, in the molten state at an elevated temperature? Does the identification number 1035 indicate ethane or butane? What is the difference between natural gas transmission pipelines and natural gas distribution pipelines? If you came upon an overturned truck on the highway that was leaking, would you be able to identify if it was hazardous and know what steps to take? Questions like these and more are answered in the Emergency Response Guidebook. Learn how to identify symbols for and vehicles carrying toxic, flammable, explosive, radioactive, or otherwise harmful substances and how to respond once an incident involving those substances has been identified. Always be prepared in situations that are unfamiliar and dangerous and know how to rectify them. Keeping this guide around at all times will ensure that, if you were to come upon a transportation situation involving hazardous substances or dangerous goods, you will be able to help keep others and yourself out of danger. With color-coded pages for quick and easy reference, this is the official manual used by first responders in the United States and Canada for transportation incidents involving dangerous goods or hazardous materials.

Download or read book Low temperature Combustion and Autoignition written by M.J. Pilling and published by Elsevier. This book was released on 1997-11-27 with total page 823 pages. Available in PDF, EPUB and Kindle. Book excerpt: Combustion has played a central role in the development of our civilization which it maintains today as its predominant source of energy. The aim of this book is to provide an understanding of both fundamental and applied aspects of low-temperature combustion chemistry and autoignition. The topic is rooted in classical observational science and has grown, through an increasing understanding of the linkage of the phenomenology to coupled chemical reactions, to quite profound advances in the chemical kinetics of both complex and elementary reactions. The driving force has been both the intrinsic interest of an old and intriguing phenomenon and the centrality of its applications to our economic prosperity. The volume provides a coherent view of the subject while, at the same time, each chapter is self-contained.