Download or read book Impact of Fuel Composition and Charge Stratification on HCCI Combustion Characteristics written by Philipp Werner and published by . This book was released on 2003 with total page 444 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book HCCI and CAI Engines for the Automotive Industry written by Hua Zhao and published by CRC Press. This book was released on 2007-09-10 with total page 562 pages. Available in PDF, EPUB and Kindle. Book excerpt: Homogeneous charge compression ignition (HCCI)/controlled auto-ignition (CAI) has emerged as one of the most promising engine technologies with the potential to combine fuel efficiency and improved emissions performance, offering reduced nitrous oxides and particulate matter alongside efficiency comparable with modern diesel engines. Despite the considerable advantages, its operational range is rather limited and controlling the combustion (timing of ignition and rate of energy release) is still an area of on-going research. Commercial applications are, however, close to reality. HCCI a.
Download or read book Effect of Ambient Conditions and Fuel Properties on Homogeneous Charge Compression Ignition Engine Operation written by Morgan MacKenzie Andreae and published by . This book was released on 2006 with total page 198 pages. Available in PDF, EPUB and Kindle. Book excerpt: (Cont.) During stoichiometric operation, this delay allowed a small extension (a few tenths of a bar in NIMEP) in the high load limit. During lean operation, the delay in combustion timing resulted in a reduction of the high load limit. The second phase of the project examined the impact of market fuel composition variations on HCCI operation. Twelve test fuels were created to vary the composition of 5 fuel properties: Research Octane Number (RON), Reid Vapor Pressure (RVP), olefin content, aromatic content, and ethanol content. The test fuels were blends of different commercial refinery streams and contained hundreds of different hydrocarbons to be representative market gasolines. Fuel type was found to have only a small impact on the HCCI operating range, and cam phasing was largely able to compensate for changes in fuel composition. The main effect of the different fuel composition appeared to be differences in ignition delay.
Download or read book Fuel Effects on Homogeneous Charge Compression Ignition Combustion written by Jacob Richard Zuehl and published by . This book was released on 2009 with total page 260 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Effects of Intake Charge Stratification on HCCI Combustion written by Robert J. Iverson and published by . This book was released on 2004 with total page 426 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Analysis of Intake Charge Temperature and EGR Stratification Effects on HCCI Combustion written by Angelo P. Chialva and published by . This book was released on 2006 with total page 332 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Potential of Using Natural Gas in HCCI Engines written by Junnian Zheng and published by . This book was released on 2012 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: With the depletion of petroleum based fuels and the corresponding concerns of national energy security issues, natural gas as an alternative fuel in IC engine applications has become an attractive option. Natural gas requires minimum mixture preparation, and is chemically stable, both of which make it a suitable fuel for homogeneous charged compression ignition (HCCI) engines. Compared to petroleum based fuels, natural gas produces less green-house emissions. However, natural gas is hard to auto-ignite and therefore requires a higher compression ratio, some amount of intake heating, or some type of pre-ignition. In addition, natural gas usually has large differences in fuel composition from field to field, which adds more uncertainties for engine applications. The current study determines the auto-ignition characteristics, engine performance, and nitric oxides emissions as functions of major operating parameters for a natural gas fueled HCCI engine, and determines differences relative to gasoline fueled HCCI engines which have been studied for many years. These tasks have been done using both zero- and multi-dimensional engine simulations. By zero-dimensional simulation, the effects of varying equivalence ratios, engine speeds, compression ratio, EGR level, intake pressure and fuel compositions are determined and analyzed in detail. To be able to account for the in-cylinder inhomogeneous effect on the HCCI combustion, multi-zone models coupled with cold-flow CFD simulations are employed in addition to the single-zone model. The effects of non-homogeneous temperature and equivalence ratio stratification on the ignition timing, combustion phasing, and emissions formation have been studied and discussed. Finally, the preliminary two-dimensional axial-symmetric CFD simulations have been conducted to study the in-cylinder temperature and the species distributions, which provide better visualization of the natural gas auto-ignition process.
Download or read book Advances in Internal Combustion Engine Research written by Dhananjay Kumar Srivastava and published by Springer. This book was released on 2017-11-29 with total page 346 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book discusses all aspects of advanced engine technologies, and describes the role of alternative fuels and solution-based modeling studies in meeting the increasingly higher standards of the automotive industry. By promoting research into more efficient and environment-friendly combustion technologies, it helps enable researchers to develop higher-power engines with lower fuel consumption, emissions, and noise levels. Over the course of 12 chapters, it covers research in areas such as homogeneous charge compression ignition (HCCI) combustion and control strategies, the use of alternative fuels and additives in combination with new combustion technology and novel approaches to recover the pumping loss in the spark ignition engine. The book will serve as a valuable resource for academic researchers and professional automotive engineers alike.
Download or read book Analysis of Stratified Charge Operation and Negative Valve Overlap Operation Using Direct Fuel Injection in Homogeneous Charge Compression Ignition Engines written by Tanet Aroonsrisopon and published by . This book was released on 2006 with total page 242 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book SI Combustion written by and published by . This book was released on 2003 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Low temperature Combustion and Autoignition written by M.J. Pilling and published by Elsevier. This book was released on 1997-11-27 with total page 823 pages. Available in PDF, EPUB and Kindle. Book excerpt: Combustion has played a central role in the development of our civilization which it maintains today as its predominant source of energy. The aim of this book is to provide an understanding of both fundamental and applied aspects of low-temperature combustion chemistry and autoignition. The topic is rooted in classical observational science and has grown, through an increasing understanding of the linkage of the phenomenology to coupled chemical reactions, to quite profound advances in the chemical kinetics of both complex and elementary reactions. The driving force has been both the intrinsic interest of an old and intriguing phenomenon and the centrality of its applications to our economic prosperity. The volume provides a coherent view of the subject while, at the same time, each chapter is self-contained.
Download or read book An Investigation Into the Effects of Thermal and Compositional Stratification on HCCI Combustion written by James M. Krasselt and published by . This book was released on 2008 with total page 156 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Comparison Study on Combustion Characteristics and Emissions of a Homogeneous Charge Compression Ignition HCCI Engine with and Without Pre combustion Chamber written by and published by . This book was released on 2015 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Natural Gas Engines written by Kalyan Kumar Srinivasan and published by Springer. This book was released on 2018-11-03 with total page 419 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book covers the various advanced reciprocating combustion engine technologies that utilize natural gas and alternative fuels for transportation and power generation applications. It is divided into three major sections consisting of both fundamental and applied technologies to identify (but not limited to) clean, high-efficiency opportunities with natural gas fueling that have been developed through experimental protocols, numerical and high-performance computational simulations, and zero-dimensional, multizone combustion simulations. Particular emphasis is placed on statutes to monitor fine particulate emissions from tailpipe of engines operating on natural gas and alternative fuels.
Download or read book Fuel Effect on HCCI Engine with Negative Valve Overlap written by Keitaro Okuno and published by . This book was released on 2009 with total page 292 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Cost Effectiveness and Deployment of Fuel Economy Technologies for Light Duty Vehicles written by National Research Council and published by National Academies Press. This book was released on 2015-09-28 with total page 812 pages. Available in PDF, EPUB and Kindle. Book excerpt: The light-duty vehicle fleet is expected to undergo substantial technological changes over the next several decades. New powertrain designs, alternative fuels, advanced materials and significant changes to the vehicle body are being driven by increasingly stringent fuel economy and greenhouse gas emission standards. By the end of the next decade, cars and light-duty trucks will be more fuel efficient, weigh less, emit less air pollutants, have more safety features, and will be more expensive to purchase relative to current vehicles. Though the gasoline-powered spark ignition engine will continue to be the dominant powertrain configuration even through 2030, such vehicles will be equipped with advanced technologies, materials, electronics and controls, and aerodynamics. And by 2030, the deployment of alternative methods to propel and fuel vehicles and alternative modes of transportation, including autonomous vehicles, will be well underway. What are these new technologies - how will they work, and will some technologies be more effective than others? Written to inform The United States Department of Transportation's National Highway Traffic Safety Administration (NHTSA) and Environmental Protection Agency (EPA) Corporate Average Fuel Economy (CAFE) and greenhouse gas (GHG) emission standards, this new report from the National Research Council is a technical evaluation of costs, benefits, and implementation issues of fuel reduction technologies for next-generation light-duty vehicles. Cost, Effectiveness, and Deployment of Fuel Economy Technologies for Light-Duty Vehicles estimates the cost, potential efficiency improvements, and barriers to commercial deployment of technologies that might be employed from 2020 to 2030. This report describes these promising technologies and makes recommendations for their inclusion on the list of technologies applicable for the 2017-2025 CAFE standards.
Download or read book Mixture Formation in Internal Combustion Engines written by Carsten Baumgarten and published by Springer Science & Business Media. This book was released on 2006-09-28 with total page 312 pages. Available in PDF, EPUB and Kindle. Book excerpt: A systematic control of mixture formation with modern high-pressure injection systems enables us to achieve considerable improvements of the combustion pr- ess in terms of reduced fuel consumption and engine-out raw emissions. However, because of the growing number of free parameters due to more flexible injection systems, variable valve trains, the application of different combustion concepts within different regions of the engine map, etc., the prediction of spray and m- ture formation becomes increasingly complex. For this reason, the optimization of the in-cylinder processes using 3D computational fluid dynamics (CFD) becomes increasingly important. In these CFD codes, the detailed modeling of spray and mixture formation is a prerequisite for the correct calculation of the subsequent processes like ignition, combustion and formation of emissions. Although such simulation tools can be viewed as standard tools today, the predictive quality of the sub-models is c- stantly enhanced by a more accurate and detailed modeling of the relevant pr- esses, and by the inclusion of new important mechanisms and effects that come along with the development of new injection systems and have not been cons- ered so far. In this book the most widely used mathematical models for the simulation of spray and mixture formation in 3D CFD calculations are described and discussed. In order to give the reader an introduction into the complex processes, the book starts with a description of the fundamental mechanisms and categories of fuel - jection, spray break-up, and mixture formation in internal combustion engines.
