Download or read book Hydrogen Generation in SRAT with Nitric Acid and Late Washing Flowsheets written by and published by . This book was released on 1992 with total page 19 pages. Available in PDF, EPUB and Kindle. Book excerpt: Recently, SRTC recommended two process changes: (1) a final wash of the tetraphenylborate precipitate feed slurry and (2) the use of nitric acid to neutralize the sludge in the SRAT. The first change produced an aqueous hydrolysis product (PHA) with higher formic acid/formate and copper concentration, and reduced the nitrate content in the PHA by an order of magnitude. The second change is to substitute part of formic acid added to the SRAT with nitric acid, and therefore may reduce the hydrogen generated in the SRAT as well as provide nitrate as an oxidant to balance the redox state of the melter feed. The purpose of this report is to determine the pertinent variables that could affect the hydrogen generation rate with these process changes.
Download or read book Hydrogen Generation in SRAT with Nitric Acid and Late Washing Flowsheets Summary Report written by and published by . This book was released on 1992 with total page 6 pages. Available in PDF, EPUB and Kindle. Book excerpt: Melter feed preparation processes, incorporating a final wash of the precipitate slurry feed to Defense Waste Processing Facility (DWPF) and a partial substitution of the SRAT formic acid requirement with nitric acid, should not produce peak hydrogen generation rates during Cold Chemical Runs (CCR's) and radioactive operation greater than their current, respective hydrogen design bases of 0.024 lb/hr and 1.5 lb/hr. A single SRAT bench-scale process simulation for CCR-s produced a DWPF equivalent peak hydrogen generation rate of 0.004 lb/hr. During radioactive operation, the peak hydrogen generation rate will be dependent on the extent DWPF deviates from the nominal precipitate hydrolysis and melter feed preparation process operating parameters. Two actual radioactive sludges were treated according to the new flowsheets. The peak hydrogen evolution rates were equivalent to 0.038 and 0.20 lb/hr (DWPF scale) respectively. Compared to the formic acid -- HAN hydrolysis flowsheets, these peak rates were reduced by a factor of 2.5 and 3.4 for Tank 15 and Tank 11 sludges, respectively.
Download or read book Hydrogen Generation During IDMS Demonstrations of the Late Washing and Nitric Acid Flowsheets written by and published by . This book was released on 1992 with total page 14 pages. Available in PDF, EPUB and Kindle. Book excerpt: Recently, Late Washing (LW) and Nitric Acid (NA) flowsheets, developed respectively for the DWPF at Savannah River Technology Center SPC and CPC, were demonstrated in the one-fifth scale DWPF pilot facilities, PHEF and IDMS. Using the LW flowsheet, four runs in the PHEF produced enough PHA for two runs in the IDMS (denoted by PX4 and PX5). One of the objectives of these IDMS runs was to obtain peak hydrogen generation rates and compare them to the peak hydrogen generation rate design basis obtained from a previous IDMS run, based on the HAN and Formic Acid (HAN-FA) flowsheets.
Download or read book Energy Research Abstracts written by and published by . This book was released on 1994-02 with total page 484 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Late Wash written by and published by . This book was released on 1993 with total page 10 pages. Available in PDF, EPUB and Kindle. Book excerpt: Hydrogen generation data obtained from IDMS runs PX4 and PX5 will be used to determine a bases for a deflagration/detonation simulation in the DWPF CPC. This simulation is necessary due to the new chemistry associated with the Late Wash/ Nitric Acid flowsheet and process modifications associated with the presence of H2 in the offgas. The simulation will be performed by Professor Van Brunt from the University of South Carolina. The scenario which leads up to the deflagration/detonation simulation will be chosen such that the following conditions apply. The SRAT is filled to its maximum operating level with 9,600 gal of sludge, which corresponds to the minimum vapor space above the sludge. The SRAT is at the boiling point, producing H2 at a very low rate (about 10 % of the peak) and 15 scfm of air inleakage is entering the SRAT. Then, the H2 generation rate will be allowed to increase exponentially (catalyst activation) until it readies the peak H2 generation rate of the IDMS run, after which the H2 generation rate will be allowed to decay exponentially (catalyst deactivation) until the total amount of H2 produced is between 85 and 100% of that produced during the IDMS run.
Download or read book Radioactive Waste Management written by and published by . This book was released on 1981 with total page 556 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Nitric Glycolic Flowsheet Testing for Maximum Hydrogen Generation Rate written by and published by . This book was released on 2016 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: The Defense Waste Processing Facility (DWPF) at the Savannah River Site is developing for implementation a flowsheet with a new reductant to replace formic acid. Glycolic acid has been tested over the past several years and found to effectively replace the function of formic acid in the DWPF chemical process. The nitric-glycolic flowsheet reduces mercury, significantly lowers the chemical generation of hydrogen and ammonia, allows purge reduction in the Sludge Receipt and Adjustment Tank (SRAT), stabilizes the pH and chemistry in the SRAT and the Slurry Mix Evaporator (SME), allows for effective adjustment of the SRAT/SME rheology, and is favorable with respect to melter flammability. The objective of this work was to perform DWPF Chemical Process Cell (CPC) testing at conditions that would bound the catalytic hydrogen production for the nitric-glycolic flowsheet.
Download or read book China written by World Bank and published by World Bank Publications. This book was released on 1993 with total page 1422 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Republic of Korea's industrial policy has directed that nation's economy through nearly three decades of spectacular growth. But the authors of this paper maintain that this policy is showing signs of being outmoded. The time has come, the authors argue, for the Korean government to stop managing the economy's structural development and to redefine the responsibilities of business and government. Under this proposed compact, the allocation of resources would shift from the government to the private industrial and financial sectors. The transformation of the government bureaucracy from an ad hoc policy role to one of a transparent and predictable regulator is a key to the success of this undertaking. These new directions would present the government with enormous challenges. Greater competitive discipline and regulatory oversight would be required. While dealing with the complexities of the transition, the government would have to maintain macroeconomic stability and the momentum of savings and investment. For comparison, the study examines the industrial economies of France, Germany, Japan, and the United States, which underwent similar shifts.
Download or read book Government Reports Announcements Index written by and published by . This book was released on 1993 with total page 714 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Ammonium Generation During SRAT Cycle written by and published by . This book was released on 1992 with total page 11 pages. Available in PDF, EPUB and Kindle. Book excerpt: During the IDMS noble-metal demonstration runs ammonium nitrate deposition was found in the vessel vent system of the feed preparation area. In the bench-scale experiments of studying the hydrogen generation during the sludge treatment cycle, ammonium ion production was also monitored. It was found that: During a simulation of the DWPF Cold Chemical Runs SRAT cycle no detectable amount of ammonium ions was generated when treating a non-noble-metal containing sludge simulant according to the nitric acid flowsheet. Ammonium ions were generated during the SRAT-SME cycle when treating the noble-metal containing sludge with either formic acid or nitric acid/late-washing PHA. This is due to the reaction between formic acid and nitrate catalyzed by the noble metals in the sludge simulant. Ammonium ion production closely followed the hydrogen evolution from the catalytic decomposition of formic acid. This report summarizes the results of the production of ammonia during the SRAT cycle.
Download or read book Government Reports Annual Index written by and published by . This book was released on 1993 with total page 1300 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Chemical Engineering Design written by Gavin Towler and published by Elsevier. This book was released on 2012-01-25 with total page 1321 pages. Available in PDF, EPUB and Kindle. Book excerpt: Chemical Engineering Design, Second Edition, deals with the application of chemical engineering principles to the design of chemical processes and equipment. Revised throughout, this edition has been specifically developed for the U.S. market. It provides the latest US codes and standards, including API, ASME and ISA design codes and ANSI standards. It contains new discussions of conceptual plant design, flowsheet development, and revamp design; extended coverage of capital cost estimation, process costing, and economics; and new chapters on equipment selection, reactor design, and solids handling processes. A rigorous pedagogy assists learning, with detailed worked examples, end of chapter exercises, plus supporting data, and Excel spreadsheet calculations, plus over 150 Patent References for downloading from the companion website. Extensive instructor resources, including 1170 lecture slides and a fully worked solutions manual are available to adopting instructors. This text is designed for chemical and biochemical engineering students (senior undergraduate year, plus appropriate for capstone design courses where taken, plus graduates) and lecturers/tutors, and professionals in industry (chemical process, biochemical, pharmaceutical, petrochemical sectors). New to this edition: Revised organization into Part I: Process Design, and Part II: Plant Design. The broad themes of Part I are flowsheet development, economic analysis, safety and environmental impact and optimization. Part II contains chapters on equipment design and selection that can be used as supplements to a lecture course or as essential references for students or practicing engineers working on design projects. New discussion of conceptual plant design, flowsheet development and revamp design Significantly increased coverage of capital cost estimation, process costing and economics New chapters on equipment selection, reactor design and solids handling processes New sections on fermentation, adsorption, membrane separations, ion exchange and chromatography Increased coverage of batch processing, food, pharmaceutical and biological processes All equipment chapters in Part II revised and updated with current information Updated throughout for latest US codes and standards, including API, ASME and ISA design codes and ANSI standards Additional worked examples and homework problems The most complete and up to date coverage of equipment selection 108 realistic commercial design projects from diverse industries A rigorous pedagogy assists learning, with detailed worked examples, end of chapter exercises, plus supporting data and Excel spreadsheet calculations plus over 150 Patent References, for downloading from the companion website Extensive instructor resources: 1170 lecture slides plus fully worked solutions manual available to adopting instructors
Download or read book Emergency Response Guidebook written by U.S. Department of Transportation and published by Simon and Schuster. This book was released on 2013-06-03 with total page 400 pages. Available in PDF, EPUB and Kindle. Book excerpt: Does the identification number 60 indicate a toxic substance or a flammable solid, in the molten state at an elevated temperature? Does the identification number 1035 indicate ethane or butane? What is the difference between natural gas transmission pipelines and natural gas distribution pipelines? If you came upon an overturned truck on the highway that was leaking, would you be able to identify if it was hazardous and know what steps to take? Questions like these and more are answered in the Emergency Response Guidebook. Learn how to identify symbols for and vehicles carrying toxic, flammable, explosive, radioactive, or otherwise harmful substances and how to respond once an incident involving those substances has been identified. Always be prepared in situations that are unfamiliar and dangerous and know how to rectify them. Keeping this guide around at all times will ensure that, if you were to come upon a transportation situation involving hazardous substances or dangerous goods, you will be able to help keep others and yourself out of danger. With color-coded pages for quick and easy reference, this is the official manual used by first responders in the United States and Canada for transportation incidents involving dangerous goods or hazardous materials.
Download or read book Solvent Extraction of Uranium written by and published by . This book was released on 1957 with total page 24 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Production of Yellow Cake and Uranium Fluorides written by International Atomic Energy Agency and published by . This book was released on 1980 with total page 374 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Extractive Metallurgy of Niobium written by A.K. Suri and published by Routledge. This book was released on 2017-11-13 with total page 272 pages. Available in PDF, EPUB and Kindle. Book excerpt: The growth and development witnessed today in modern science, engineering, and technology owes a heavy debt to the rare, refractory, and reactive metals group, of which niobium is a member. Extractive Metallurgy of Niobium presents a vivid account of the metal through its comprehensive discussions of properties and applications, resources and resource processing, chemical processing and compound preparation, metal extraction, and refining and consolidation. Typical flow sheets adopted in some leading niobium-producing countries for the beneficiation of various niobium sources are presented, and various chemical processes for producing pure forms of niobium intermediates such as chloride, fluoride, and oxide are discussed. The book also explains how to liberate the metal from its intermediates and describes the physico-chemical principles involved. It is an excellent reference for chemical metallurgists, hydrometallurgists, extraction and process metallurgists, and minerals processors. It is also valuable to a wide variety of scientists, engineers, technologists, and students interested in the topic.
Download or read book Rules of Thumb for Chemical Engineers written by Carl Branan and published by Gulf Professional Publishing. This book was released on 2002 with total page 438 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fractionators, separators and accumulators, cooling towers, gas treating, blending, troubleshooting field cases, gas solubility, and density of irregular solids * Hundreds of common sense techniques, shortcuts, and calculations.
