Download or read book Nd YAG Laser written by Dan C. Dumitras and published by BoD – Books on Demand. This book was released on 2012-03-09 with total page 332 pages. Available in PDF, EPUB and Kindle. Book excerpt: Discovered almost fifty years ago at Bell Labs (1964), the Nd:YAG laser has undergone an enormous evolution in the years, being now widely used in both basic research and technological applications. Nd:YAG Laser covers a wide range of topics, from new systems (diode pumping, short pulse generation) and components (a new semiorganic nonlinear crystal) to applications in material processing (coating, welding, polishing, drilling, processing of metallic thin films), medicine (treatment, drug administration) and other various fields (semiconductor nanotechnology, plasma spectroscopy, laser induced breakdown spectroscopy).

Download or read book 888 nm pumping of Nd YVO4 for high power TEM00 lasers written by Louis McDonagh and published by Cuvillier Verlag. This book was released on 2011-02-28 with total page 180 pages. Available in PDF, EPUB and Kindle. Book excerpt: For the last decade, neodymium-doped orthovanadate has established itself as the active material of choice for commercial solid-state lasers emitting in the 1 µm range, with output powers from several hundred milliwatts to a few tens of watts, in continuous-wave, short nanosecond Q-switched, or picosecond modelocked pulsed regimes. Its main advantages over other Nd-doped hosts such as YAG are a large stimulated-emission cross section leading to a high gain, a strong pump absorption allowing the efficient mode-matching of tightly-focused pump light, and a natural birefringence resulting in a continuously polarized output. The main drawbacks, however, are rather poor mechanical characteristics and strong thermal lensing, effectively limiting the maximum applicable pump power before excessively strong and aberrated thermal lensing prevents an efficient operation in a diffraction-limited beam, and ultimately the crystal’s fracture. Put aside the power limitation, the association of vanadate with diode end pumping allows for the realization of highly efficient and reliable laser sources based on well-known technologies, which provides an advantage in terms of manufacturability and cost-effectiveness over other high-potential technologies such as disks and fibers. This thesis introduces a novel pumping technique for Nd:YVO4 that allows for the realization of significantly higher-power laser sources with a high optical-to-optical efficiency and diffraction-limited beam quality, while keeping the benefits of a well-established technology. It consists in pumping at a wavelength of 888 nm instead of the classic 808 nm, providing a low and isotropic absorption, which results in a smooth distribution of the absorbed pump light in long crystals, effectively limiting the deleterious effects of high inversion density such as crystal end-facet bulging, high crystal temperature, aberrated thermal lensing, and upconversion. After presenting vanadate’s spectroscopic and physical characteristics, a complete analysis of the heatgenerating effects is performed, allowing for side-by-side simulations of the thermal effects in practical 808 nm and 888 nm pumped systems, and for an evaluation of their respective thermal lensing behaviors. Continuous-wave operation was thoroughly investigated, first in a multi-transversal mode oscillator to assess the maximum optical efficiency with optimum pump-mode matching and the thermal lensing characteristics. A TEM00 resonator was then developed with a single crystal and one pump diode, providing 60 W of output power with an optical efficiency of 55% and a beam quality of M2 = 1.05. This resonator was symmetrically replicated to form a periodic resonator, providing 120 W of output with the same optical efficiency and beam quality. This two-crystal configuration was then modified to an oscillator-amplifier configuration, providing a single-pass extraction efficiency of 53% and a total oscillator-amplifier output of 117 W without any beam-quality degradation. Intracavity doubling of the one and two-crystal configurations was achieved by inserting a non-critically phase-matched LiB5O3 (LBO) non-linear crystal in the resonator, providing up to 62 W of diffraction-limited green light at 532 nm with low-noise characteristics thanks to a large number of oscillating modes, thus limiting the effects of the “green problem”. A strong industrial interest resides in Q-switched lasers emitting nanosecond pulses, particularly with a high average power, high pulse repetition rate, and pulse durations of a few to several tens of nanoseconds. Achieving high-frequency and short-pulse operation both require a high gain, which explains the domination of Nd:YVO4 over lower-gain materials such as Nd:YAG or Yb:YAG. Thus, an acousto-optically Q-switched oscillator was demonstrated with 50 W output power and 28 ns pulse duration at 50 kHz. Pulse duration, however, is inversely proportional to the pulse energy, so that an increase in repetition rate inevitably results in an almost linear increase in pulse width. A cavity-dumped Q-switched oscillator was built to circumvent this limitation, the pulse length being defined by the cavity roundtrip time and the electro-optic cell switching time. It provided a constant pulse duration of 6 ns up to a repetition rate of 100 kHz and a maximum output power of 47 W. Such short pulse durations are normally available with output powers of a few watts from Q-switched lasers, and conversely Q-switched lasers of similarly high output power deliver pulses of several tens to over 100 ns in duration. There exists another strong interest in high average power quasi-cw picosecond sources, which allow for the efficient generation of green and UV radiation, or even red-green-blue for laser video projection. Passive mode locking with a semiconductor saturable absorber mirror (SESAM) is the preferred technique employed for the stable and self-starting generation of picosecond pulse trains, yet a high gain is necessary for achieving high repetition rates while avoiding the Q-switched mode-locking regime. Thus SESAM mode locking was applied to an 888 nm pumped oscillator, achieving 57 W of output power at a repetition-rate of 110 MHz and a pulse duration of 33 ps. Its output was efficiently amplified in a single pass up to 111 W without any beam quality, temporal, or spectral degradation. The high peak power of 30 kW allowed for the generation of 87 W of second harmonic at 532 nm with an efficiency of 80%, and 35 W of 355 nm third harmonic with a conversion efficiency of 33% in LBO crystals. The wide range of high-power systems demonstrated in this work illustrate the benefits of the optimized pumping of Nd:YVO4 at 888 nm, maintaining its highly-desirable characteristics such as a high gain and a polarized output while extending its power capabilities far beyond regular 808 nm pumped systems. This improvement should allow Nd:YVO4 systems to compete with high-power technologies such as disks and fibers, which often struggle in the generation of short pulses because of their low gain and strong non-linear effects, respectively.

Download or read book Nd YAG Laser written by Dan C. Dumitras and published by IntechOpen. This book was released on 2012-03-09 with total page 330 pages. Available in PDF, EPUB and Kindle. Book excerpt: Discovered almost fifty years ago at Bell Labs (1964), the Nd:YAG laser has undergone an enormous evolution in the years, being now widely used in both basic research and technological applications. Nd:YAG Laser covers a wide range of topics, from new systems (diode pumping, short pulse generation) and components (a new semiorganic nonlinear crystal) to applications in material processing (coating, welding, polishing, drilling, processing of metallic thin films), medicine (treatment, drug administration) and other various fields (semiconductor nanotechnology, plasma spectroscopy, laser induced breakdown spectroscopy).