Download or read book Heat Transfer to Boiling Water Forced Through a Uniformly Heated Tube written by J. F. Mumm and published by . This book was released on 1954 with total page 114 pages. Available in PDF, EPUB and Kindle. Book excerpt: An electrically heated, horizontal, Type 347 stainless steel tube was used to obtain local coefficients of heat transfer in the region of net steam generation. The maximum weight fraction evaporated was 0.60. The investigation covered a range of pressure from 45 to 200 psia, of heat fluxes from 50,000 to 250,000 Btu/(hr)(sq ft), and of flow rates from 70 to 280 lb/(sec)(sq ft).

Download or read book Downflow Forced convection Boiling of Water in Uniformly Heated Tubes written by Roger Maurice Wright and published by . This book was released on 1961 with total page 264 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book An Empirical Correlation of Critical Boiling Heat Flux in Forced Flow Upward Through Uniformly Heated Tubes written by U. Von Glahn and published by . This book was released on 1962 with total page 32 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Downflow Boiling of N butanol in a Uniformly Heated Tube written by Graham F. Somerville and published by . This book was released on 1962 with total page 114 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Subcooled Boiling Heat Transfer Under Forced Convection in a Heated Tube written by S. Stephen Papell and published by . This book was released on 1963 with total page 28 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Downflow Boiling and Nonboiling Heat Transfer in a Uniformly Heated Tube written by Robert LeRoy Sani and published by . This book was released on 1960 with total page 112 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Forced convection Boiling Burnout for Water in Uniformly Heated Tubular Test Sections written by Jack Griffel and published by . This book was released on 1965 with total page 184 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Downflow Boiling and Nonboiling Heat Transfer in a Uniformly Heated Tube thesis written by and published by . This book was released on 1960 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Local heat-transfer coefficients in forced convection, downflow boiling, and nonboiling were measured by use of an electrically heated type-304 stainless steel tube (0.7194 in. i.d. x 0.7502 in. o.d. x 68.0 in. long). Average forcedconvection heat-transfer coefficients in turbulent onephase flow and local total pressure gradients in two-phase flow were also determined. Data were obtained for the boiling of distilled water with mass fluxes of 51 to 165 lb/sec sq ft, heat fluxes from 13.8 x 10/sup 3/ to 49.8 x 10/sup 3/ BTU/hr sq ft, pressures at 15.8 to 30.9 psia, and qualities up to 14%. The boiling heat transfer data were compared with the correlations proposed by Mumm, Dengler, Rohsenow, and Grossman and Schrock. No attempt was made to formulate a new correlation because of the limited range of conditions investigated. The nonboiling heat transfer data were compared to the Dittus-Poelter and SiederTate correlations. The local total pressure gradients in two-phase flow were correlated by the Martinelli parameter, X/sub tt/, for turbulent two-phase flow. (auth).

Download or read book Experimental Results of Forced Convection Boiling Potassium Heat Transfer and Pressure Drop Tests written by E. Bernstein and published by . This book was released on 1964 with total page 90 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Boiling Heat Transfer And Two Phase Flow written by L S Tong and published by CRC Press. This book was released on 1997-02-01 with total page 582 pages. Available in PDF, EPUB and Kindle. Book excerpt: Completely updated, this graduate text describes the current state of boiling heat transfer and two-phase flow, in terms through which students can attain a consistent understanding. Prediction of real or potential boiling heat transfer behaviour, both in steady and transient states, is covered to aid engineering design of reliable and effective systems.

Download or read book Investigation of Forced convection Nucleate Boiling of Water for Nozzle Cooling at Very High Heat Fluxes written by John W. Schaefer and published by . This book was released on 1962 with total page 52 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Boiling Water Heat Transfer Burnout in Uniformly Heated Round Tubes written by B. Thompson and published by . This book was released on 1964 with total page 29 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Heat Transfer to Boiling Water Forced Through a Tube written by J. F. Mumm and published by . This book was released on 1954 with total page 66 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Heat Transfer in Condensation and Boiling written by Karl Stephan and published by Springer Science & Business Media. This book was released on 2013-06-29 with total page 342 pages. Available in PDF, EPUB and Kindle. Book excerpt: I welcome the opportunity to have my book translated, because of the great emphasis on two-phase flow and heat transfer in the English-speaking world, as related to research, university education, and industrial practice. The 1988 Springer-Verlag edition of "Warmeiibergang beim Kondensieren und beim Sieden" has been enlarged to include additional material on falling film evaporation (Chapter 12) and pressure drop in two-phase flow (Chapter 13). Minor errors in the original text have also been corrected. I would like to express my sincere appreciation to Professor Green, Asso ciate Professor of German at Rensselaer, for his excellent translation and co operation. My thanks go also to Professor Bergles for his close attention to technical and linguistic details. He carefully read the typescript and made many comments and suggestions that helped to improve the manuscript. I hope that the English edition will meet with' a favorable reception and contribute to better understanding and to progress in the field of heat transfer in condensation and boiling. February 1992 K. Stephan Preface to the German-Language Edition This book is a continuation of the series "Heat and Mass Transfer" edited by U. Grigull, in which three volumes have already been published. Its aim is to acquaint students and practicing engineers with heat transfer during condensa tion and boiling, and is intended primarily for students and engineers in mechanical, chemical, electrical, and industrial processing engineering.

Download or read book Encyclopedia of Thermal Packaging Set 1 Thermal Packaging Techniques a 6 Volume Set written by Avram Bar-Cohen and published by World Scientific. This book was released on 2012-02-01 with total page 1582 pages. Available in PDF, EPUB and Kindle. Book excerpt: Packaging, the physical design and implementation of electronic systems is responsible for much of the progress in miniaturization, reliability and functional density achieved by the full range of electronic, microelectronic and nanoelectronic products during the past several decades. The inherent inefficiency of electronic devices and their sensitivity to heat have placed thermal management on the critical path of nearly every organization dealing with traditional electronic product development, as well as emerging, product categories. Successful thermal packaging is the key differentiator in electronic products, as diverse as supercomputers and cell phones, and continues to be of critical importance in the refinement of traditional products and in the development of products for new applications.The Encyclopedia of Thermal Packaging, compiled into four 5-volume sets (Thermal Packaging Techniques, Thermal Packaging Configurations, Thermal Packaging Tools and Thermal Packaging Applications), will provide comprehensive, one-stop treatment of the techniques, configurations, tools and applications of electronic thermal packaging. Each volume in a set comprises 250–350 pages and is written by world experts in thermal management of electronics.

Download or read book Encyclopedia Of Thermal Packaging Set 1 Thermal Packaging Techniques A 6 volume Set written by and published by World Scientific. This book was released on 2012-09-25 with total page 1582 pages. Available in PDF, EPUB and Kindle. Book excerpt: remove This Encyclopedia comes in 3 sets. To check out Set 2 and Set 3, please visit Set 2: Thermal Packaging Tools and Set 3: Thermal Packaging Applications /remove Thermal and mechanical packaging — the enabling technologies for the physical implementation of electronic systems - are responsible for much of the progress in miniaturization, reliability, and functional density achieved by electronic, microelectronic, and nanoelectronic products during the past 50 years. The inherent inefficiency of electronic devices and their sensitivity to heat have placed thermal packaging on the critical path of nearly every product development effort in traditional, as well as emerging, electronic product categories.Successful thermal packaging is the key differentiator in electronic products, as diverse as supercomputers and cell phones, and continues to be of pivotal importance in the refinement of traditional products and in the development of products for new applications. The Encyclopedia of Thermal Packaging, compiled in multi-volume sets (Set 1: Thermal Packaging Techniques, Set 2: Thermal Packaging Tools, Set 3: Thermal Packaging Applications, and Set 4: Thermal Packaging Configurations) will provide a comprehensive, one-stop treatment of the techniques, tools, applications, and configurations of electronic thermal packaging. Each of the author-written sets presents the accumulated wisdom and shared perspectives of a few luminaries in the thermal management of electronics.Set 1: Thermal Packaging TechniquesThe first set of the Encyclopedia, Thermal Packaging Techniques, focuses on the technology “building blocks” used to assemble a complete thermal management system and provide detailed descriptions of the underlying phenomena, modeling equations, and correlations, as well as guidance for achieving the optimal designs of individual “building blocks” and their insertion in the overall thermal solution. Specific volumes deal with microchannel coolers, cold plates, immersion cooling modules, thermoelectric microcoolers, and cooling devices for solid state lighting systems, as well as techniques and procedures for the experimental characterization of thermal management components. These “building blocks” are the essential elements in the creation of a complete, cost-effective thermal management system.The four sets in the Encyclopedia of Thermal Packaging will provide the novice and student with a complete reference for a quick ascent on the thermal packaging ';learning curve,'; the practitioner with a validated set of techniques and tools to face every challenge, and researchers with a clear definition of the state-of-the-art and emerging needs to guide their future efforts. This encyclopedia will, thus, be of great interest to packaging engineers, electronic product development engineers, and product managers, as well as to researchers in thermal management of electronic and photonic components and systems, and most beneficial to undergraduate and graduate students studying mechanical, electrical, and electronic engineering.

Download or read book An Experimental Investigation of Pressure Drop and Heat Transfer for Water Boiling in a Vertical upflow Single tube Heat Exchanger written by James R. Stone and published by . This book was released on 1967 with total page 42 pages. Available in PDF, EPUB and Kindle. Book excerpt: