Download or read book Evaluation of Novel Wet Chemistry Separation and Purification Methods to Facilitate Automation of Astatine 211 Isolation written by and published by . This book was released on 2016 with total page 52 pages. Available in PDF, EPUB and Kindle. Book excerpt: This research is a collaborative effort between the research groups of the PIs, Dr. D. Scott Wilbur in the Department of Radiation Oncology at the University of Washington (UW) and Matthew O'Hara at the Pacific Northwest National Laboratory (PNNL). In this report only those studies conducted at UW and the budget information from UW will be reported. A separate progress and financial report will be provided by PNNL. This final report outlines the experiments (Tasks) conducted and results obtained at UW from July 1, 2013 thru June 30, 2016 (2-year project with 1 year no-cost extension). The report divides the information on the experiments and results obtained into the 5 specific objectives of the research efforts and the Tasks within those objectives. This format is used so that it is easy to see what has been accomplished in each area. A brief summary of the major findings from the studies is provided below. Summary of Major Findings from Research/Training Activities at UW: Anion and cation exchange columns did not provide adequate 211At capture and/or extraction results under conditions studied to warrant further evaluation; PEG-Merrifield resins containing mPEG350, mPEG750, mPEG2000 and mPEG5000 were synthesized and evaluated; All of the mPEG resins with different sized mPEG moieties conjugated gave similar 211At capture (>95%) from 8M HCl solutions and release with conc. NH4OH (~50-80%), but very low quantities were released when NaOH was used as an eluent; Capture and release of 211At when loading [211At]astatate appeared to be similar to that of [211At]astatide on PEG columns, but further studies need to be conducted to confirm that; Capture of 211At on PEG columns was lower (e.g. 80-90%) from solutions of 8M HNO3, but higher capture rates (e.g. 99%) can be obtained when 10M HNO3 is mixed with an equal quantity of 8M HCl; Addition of reductants to the 211At solutions did not appear to change the percent capture, but may have an effect on the % extracted; There was some indication that the PEG-Merrifield resins could be saturated (perhaps with Bi) resulting in lower capture percentages, but more studies need to be done to confirm that; A target dissolution chamber, designed and built at PNNL, works well with syringe pumps so it can be used in an automated system; Preliminary semi-automated 211At isolation studies have been conducted with full scale target dissolution and 211At isolation using a PEG column on the Hamilton automated system gave low overall recoveries, but HNO3 was used (rather than HCl) for loading the 211At and flow rates were not optimized; Results obtained using PEG columns are high enough to warrant further development on a fully automated system; Results obtained also indicate that additional studies are warranted to evaluate other types of columns for 211At separation from bismuth, which allow use of HNO3/HCl mixtures for loading and NaOH for eluting 211At. Such a column could greatly simplify the overall isolation process and make it easier to automate.
Download or read book Evaluation of Column Separation Methods for Simplification of the Wet Chemistry Approach to Isolation of 211At written by S. Watanabe and published by . This book was released on 2015 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Separation and Purification Technology written by Norman Li and published by CRC Press. This book was released on 1992-07-21 with total page 324 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume addresses recent developments and approaches in selected application areas of separation and purification technology -- presenting a useful blend of current progress in theory, applications, process technology, and related economics. Exploring the continual and rapid evolution of this field, Separation and Purification Technology discusses mature, established technologies as well as new "cutting-edge" techniques ... treats the application of membrane-based separations in biotechnology, commercial applications of emulsion liquid membranes, and economic evaluation of membrane technology ... displays strong environmental connotations, examining liquid waste concentration by electrodialysis and the application of immobilized bioadsorbents for the recovery of dissolved metals ... describes novel applications of complexation phenomena ... considers new fundamental work in mass transfer in pulsed, sieveplate, extraction columns ... and more. Providing more than 200 helpful tables, figures, and equations, Separation and Purification Technology is an indispensable reference for chemical, industrial, and manufacturing engineers, and analytical chemists and biochemists. Book jacket.
Download or read book Recent Radiochemical Separation Procedures for As At Be Mg Ni Ru and Se written by K. V. Marsh and published by . This book was released on 1974 with total page 96 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Separation Methods in Chemical Analysis written by James M. Miller and published by Wiley-Interscience. This book was released on 1974 with total page 334 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Separation Methods in Biochemistry written by Colin John Owen Rhonabwy Morris and published by . This book was released on 1964 with total page 906 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Separation and Purification written by and published by . This book was released on 1956 with total page 873 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Chemical Separation Methods written by John Aurie Dean and published by . This book was released on 1969 with total page 398 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Separation and Purification Pt 1 written by and published by . This book was released on 1956 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Chemistry of the Actinide and Transactinide Elements 3rd ed Volumes 1 5 written by L.R. Morss and published by Springer Science & Business Media. This book was released on 2007-12-31 with total page 4059 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Chemistry of the Actinide and Transactinide Elements is a contemporary and definitive compilation of chemical properties of all of the actinide elements, especially of the technologically important elements uranium and plutonium, as well as the transactinide elements. In addition to the comprehensive treatment of the chemical properties of each element, ion, and compound from atomic number 89 (actinium) through to 109 (meitnerium), this multi-volume work has specialized and definitive chapters on electronic theory, optical and laser fluorescence spectroscopy, X-ray absorption spectroscopy, organoactinide chemistry, thermodynamics, magnetic properties, the metals, coordination chemistry, separations, and trace analysis. Several chapters deal with environmental science, safe handling, and biological interactions of the actinide elements. The Editors invited teams of authors, who are active practitioners and recognized experts in their specialty, to write each chapter and have endeavoured to provide a balanced and insightful treatment of these fascinating elements at the frontier of the periodic table. Because the field has expanded with new spectroscopic techniques and environmental focus, the work encompasses five volumes, each of which groups chapters on related topics. All chapters represent the current state of research in the chemistry of these elements and related fields.
Download or read book Cyclotron Produced Radionuclides written by International Atomic Energy Agency and published by . This book was released on 2009 with total page 266 pages. Available in PDF, EPUB and Kindle. Book excerpt: Application of radioisotopes has shown significant growth in the past decade, and a major factor contributing towards this growth is the availability of a large number of cyclotrons dedicated to the production of radioisotopes for medical applications. Although there are many articles in journals on cyclotrons and their use for radioisotope production, there is no single source of information for beginners on radioisotope production using cyclotrons. This publication attempts to address this deficiency. Its contains chapters on accelerator technology, theoretical considerations of nuclear reactions, the technology behind targetry, techniques on preparation of targets, irradiation of targets under high beam currents, target processing and target recovery.
Download or read book Separation and Purification Methods written by Edmond S. Perry and published by . This book was released on 1975 with total page 413 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Cyclotron Produced Radionuclides written by and published by . This book was released on 2008 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book provides a comprehensive treatment of cyclotrons, with a special emphasis on production of radionuclides. Individual sections are devoted to accelerator technology, theoretical aspects of nuclear reactions, the technology behind targetry, techniques for preparation of targets, irradiation of targets under high beam currents, target processing and target recovery. This book will appeal to scientists and technologists interested in translating cyclotron technology into practice, as well as postgraduate students in this field.
Download or read book Radiopharmacy and Radiopharmaceuticals written by A. E. Theobald and published by Taylor & Francis Group. This book was released on 1985 with total page 242 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book ACS Style Guide written by Anne M. Coghill and published by American Chemical Society. This book was released on 2006 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: In the time since the second edition of The ACS Style Guide was published, the rapid growth of electronic communication has dramatically changed the scientific, technical, and medical (STM) publication world. This dynamic mode of dissemination is enabling scientists, engineers, and medicalpractitioners all over the world to obtain and transmit information quickly and easily. An essential constant in this changing environment is the requirement that information remain accurate, clear, unambiguous, and ethically sound.This extensive revision of The ACS Style Guide thoroughly examines electronic tools now available to assist STM writers in preparing manuscripts and communicating with publishers. Valuable updates include discussions of markup languages, citation of electronic sources, online submission ofmanuscripts, and preparation of figures, tables, and structures. In keeping current with the changing environment, this edition also contains references to many resources on the internet.With this wealth of new information, The ACS Style Guide's Third Edition continues its long tradition of providing invaluable insight on ethics in scientific communication, the editorial process, copyright, conventions in chemistry, grammar, punctuation, spelling, and writing style for any STMauthor, reviewer, or editor. The Third Edition is the definitive source for all information needed to write, review, submit, and edit scholarly and scientific manuscripts.
Download or read book Introduction to Wine Laboratory Practices and Procedures written by Jean L. Jacobson and published by Springer Science & Business Media. This book was released on 2006-06-14 with total page 390 pages. Available in PDF, EPUB and Kindle. Book excerpt: In the beginning, for me, winemaking was a romanticized notion of putting grape juice into a barrel and allowing time to perform its magic as you sat on the veranda watching the sunset on a Tuscan landscape. For some small wineries, this notion might still ring true, but for the majority of wineries commercially producing quality wines, the reality of winemaking is far more complex. The persistent evolution of the wine industry demands continual advan- ments in technology and education to sustain and promote quality winem- ing. The sciences of viticulture, enology, and wine chemistry are becoming more intricate and sophisticated each year. Wine laboratories have become an integral part of the winemaking process, necessitating a knowledgeable staff possessing a multitude of skills. Science incorporates the tools that new-age winemakers are utilizing to produce some of the best wines ever made in this multibillion dollar trade. A novice to enology and wine chemistry can find these subjects daunting and intimidating. Whether you are a home winemaker, a new winemaker, an enology student, or a beginning-to-intermediate laboratory technician, p- ting all the pieces together can take time. As a winemaker friend once told me, “winemaking is a moving target. ” Introduction to Wine Laboratory Practices and Procedures was written for the multitude of people entering the wine industry and those that wish to learn about wine chemistry and enology.
Download or read book Practical Handbook of Materials Science written by Charles T. Lynch and published by CRC Press. This book was released on 1989-08-31 with total page 654 pages. Available in PDF, EPUB and Kindle. Book excerpt: CRC Practical Handbooks are a series of single-volume bench manuals that feature a synthesis of frequently used, basic reference information. These highly abridged versions of existing CRC multi-volume Handbooks contain largely tabular and graphic data. They provide extensive coverage in a scientific discipline and enable quick, convenient access to the most practical reference information...on the spot! Leading professionals in their respective fields collaborated to provide individuals and institutions with an economical and easy-to-use source of classic reference information. Practical Handbook of Materials Science is a concise reference for the physical properties of solid state and structural materials. This work is interdisciplinary in approach and content, and it covers a variety of types of materials, including materials of present commercial importance, plus new biomedical, composite, and nuclear materials. Research scientists and practicing engineers in the fields of materials science and engineering, civil engineering, chemistry, physics, and nuclear chemists and engineers will benefit from this economical desktop reference. It also has a large interdisciplinary market for students at the advanced undergraduate and graduate levels in science and engineering.
