Download or read book Design of an Outlet for Box Inlet Drop Spillway Classic Reprint written by Charles A. Donnelly and published by Forgotten Books. This book was released on 2018-01-26 with total page 38 pages. Available in PDF, EPUB and Kindle. Book excerpt: Excerpt from Design of an Outlet for Box Inlet Drop Spillway The outlet as designed in the past could more properly be called an apron, with the floor set at the grade of the downstream channel. The water leaves the apron at a high velocity, causing a horizontal whirling action of the water on each side of the channel. These whirls result in severe scour of the dam fill and the stream bed at the end of the apron. Outlets of this type have failed; two typical failures are shown in figure 1. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.
Download or read book Hydraulic Design of the Box Inlet Drop Spillway Classic Reprint written by Fred W. Blaisdell and published by Forgotten Books. This book was released on 2017-10-27 with total page 64 pages. Available in PDF, EPUB and Kindle. Book excerpt: Excerpt from Hydraulic Design of the Box Inlet Drop Spillway This paper contains sufficient information to permit the complete hydraulic design of a box inlet drop Spillway and explains briefly the various factors that influence the de sign. Its four major sections deal with the free flow capacity, the outlet design, the sub merged flow capacity, and the utilization of the preceding information in the design of box inlet drop spillways. The box inlet drop Spillway may be described as a rectangular box open at the top and at the downstream end. The Spillway is shown in figure 1. Storm runoff is directed to the box by dikes and headwalls, enters over the upstream end and two sides, and leaves through the Open downstream end. An outlet structure is attached to the down stream end of the box. The long crest of the box inlet permits large flows to pass over it with relatively low heads. Yet the width of the Spillway need be no greater than that of the exit channel. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.
Download or read book Design of an Outlet for Box Inlet Drop Spillway written by Charles A. Donnelly and published by . This book was released on 1947 with total page 36 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Design of an Outlet for Box Inlet Drop Spillway No TP 63 written by Charles A Donnelly and published by Hassell Street Press. This book was released on 2021-09-10 with total page 36 pages. Available in PDF, EPUB and Kindle. Book excerpt: This work has been selected by scholars as being culturally important and is part of the knowledge base of civilization as we know it. This work is in the public domain in the United States of America, and possibly other nations. Within the United States, you may freely copy and distribute this work, as no entity (individual or corporate) has a copyright on the body of the work. Scholars believe, and we concur, that this work is important enough to be preserved, reproduced, and made generally available to the public. To ensure a quality reading experience, this work has been proofread and republished using a format that seamlessly blends the original graphical elements with text in an easy-to-read typeface. We appreciate your support of the preservation process, and thank you for being an important part of keeping this knowledge alive and relevant.
Download or read book Hydraulic Design of the Box Inlet Drop Spillway written by Fred W. Blaisdell and published by . This book was released on 1951 with total page 60 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Hydraulic Design of the Box inlet Drop Spillway written by and published by . This book was released on 1966 with total page 40 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Hydraulic Design of the Box Inlet Drop Spillway written by Fred W. Blaisdell and published by . This book was released on 1951 with total page 63 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Hydraulic Design of Box Inlet Drop Spillway written by and published by . This book was released on 1951 with total page 52 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Box Inlet Drop Spillway and Its Outlet written by and published by . This book was released on 1954 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Comparison of Chute and Stilling Basin Performance for Three Different Drop Box Inlets Classic Reprint written by W. O. Ree and published by Forgotten Books. This book was released on 2018-03-19 with total page 24 pages. Available in PDF, EPUB and Kindle. Book excerpt: Excerpt from Comparison of Chute and Stilling Basin Performance for Three Different Drop Box Inlets Three different drop (entrance box) inlets were tested and compared to determine their influence on the performance of a chute spillway and a stilling basin at the outlet of the chute. Test results indicated that the steep and level entrance boxes did not affect the performance of the spillway and stilling basin differently than did the deep (original design) entrance box. Upstream pool levels, wave heights along the chute walls, and scour depths in the downstream channel were alike for the three entrance boxes. An advantage of the steep entrance box was a smaller associated uplift force. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.
Download or read book Model Test of Box Inlet Drop Spillway and Stilling Basin Proposed for Tillatoba Creek Tallahatchie County Miss Classic Reprint written by Fred W. Blaisdell and published by Forgotten Books. This book was released on 2018-08-25 with total page 66 pages. Available in PDF, EPUB and Kindle. Book excerpt: Excerpt from Model Test of Box Inlet Drop Spillway and Stilling Basin Proposed for Tillatoba Creek, Tallahatchie County, Miss. The Letter of Agreement was initiated on December 29, 1969, by W. L. Heard, State Conservationist, Soil Conservation Service, Jackson, Miss.; recommended on January 8, 1970, by A. R. Robinson, Director of the usda Sedimentation Laboratory, Agricultural Research Service, Oxford, Miss.; further recommended on January 12, 1970, by Fred W. Blaisdell, Hydraulic Engineer, Agricultural Research Service, St. Anthony Falls Hydraulic Laboratory, Minneapolis, Minn.; and approved on January 15, 197 0, by C. H. Wadleigh, Director of the Soil and Water Conservation Research Division, Agricultural Research Service, Beltsville, Md. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.
Download or read book Design of Small Dams written by United States. Bureau of Reclamation and published by . This book was released on 1973 with total page 860 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Dams and Public Safety written by Robert B. Jansen and published by . This book was released on 1983 with total page 348 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Low Volume Roads Engineering Best Management Practices Field Guide written by Gordon Keller and published by . This book was released on 2023-11-30 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: This Low-Volume Roads Engineering Best Management Practices Field Guide is intended to provide an overview of the key planning, location, design, construction, and maintenance aspects of roads that can cause adverse environmental impacts and to list key ways to prevent those impacts. Best Management Practices are general techniques or design practices that, when applied and adapted to fit site-specific conditions, will prevent or reduce pollution and maintain water quality. BMPs for roads have been developed by many agencies since roads often have a major adverse impact on water quality, and most of those impacts are preventable with good engineering and management practices. Roads that are not well planned or located, not properly designed or constructed, not well maintained, or not made with durable materials often have negative effects on water quality and the environment.
Download or read book Soil Erosion and Sedimentation Control written by and published by . This book was released on 1981 with total page 230 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Hydraulic Charts for the Selection of Highway Culverts written by Lester A. Herr and published by . This book was released on 1964 with total page 68 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Rules of Thumb for Mechanical Engineers written by J. Edward Pope and published by Gulf Professional Publishing. This book was released on 1997 with total page 417 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fluids -- Heat transfer -- Thermodynamics -- Mechanical seals -- Pumps and compressors -- Drivers -- Gears -- Bearings -- Piping and pressure vessels -- Tribology -- Vibration -- Materials -- Stress and strain -- Fatigue -- Instrumentation -- Engineering economics.
