Download or read book Design of a 50 MW Klystron at X band written by and published by . This book was released on 1995 with total page 6 pages. Available in PDF, EPUB and Kindle. Book excerpt: This paper describes the design and performance of the XL-1 klystron; a 50 MW klystron operating at a frequency of 11.424 GHz for use on the SLAC Next Linear Collider Test Accelerator (NLCTA). Problems associated with the development of high-power rf sources for NLC, and the solutions implemented on XL-1 are discussed.
Download or read book The X band Klystron Program at SLAC written by and published by . This book was released on 1996 with total page 11 pages. Available in PDF, EPUB and Kindle. Book excerpt: The X-band rf source development at SLAC can be considered a qualified success. A total of twelve klystrons were built. Six of them are still in use. The latest tube, XL4, produced 75 MW at an efficiency of 47.5 percent. However, victory cannot be declared as yet, since an NLC prototype has not been fully designed and the decision between permanent magnet focusing and a super-conducting solenoid has not been formally made. Daryl Sprehn's paper will present the status of the PPM klystron development. The authors believe that a PPM X-band source will work, at 50 as well as at 75 megawatts. But they are prepared to adapt the XL4 design to a super-conducting solenoid, should the PPM klystron develop unexpected problems. The SLAC program is now in its seventh year. It may well be the longest and most expensive microwave tube development on record, in a government laboratory or in industry. Direct and related costs for the total effort are probably of the order of $10 million. In these circumstances it is perhaps not surprising that it has been possible to produce a klystron with the performance of XL4. At the same time, it must be said that the necessary leap in technology from the SLAC 60-megawatt S-band production klystrons to a klystron of comparable performance at four times the frequency could not be realized without some very careful experimentation and, most importantly, without the infrastructure for tube fabrication and testing available at SLAC. The design of an 11.4 GHz 50--100 MW klystron, with microsecond pulses and a pulse repetition frequency of 180 Hz presents a number of technical challenges which are listed here.
Download or read book High Energy Density and High Power RF written by David K. Abe and published by Springer Science & Business Media. This book was released on 2006-01-04 with total page 526 pages. Available in PDF, EPUB and Kindle. Book excerpt: This is the seventh in a series of international workshops on high-power and high-energy density microwave devices for accelerator, plasma physics, and defense applications. The scope of this workshop included accelerators for high energy physics, plasma heating and current drive in controlled thermonuclear fusion research, radar and directed energy/high power microwave systems, THz sources and technologies, and advanced 2D/3D computational tool development.
Download or read book X BAND KLYSTRON DEVELOPMENT AT SLAC written by and published by . This book was released on 2009 with total page 5 pages. Available in PDF, EPUB and Kindle. Book excerpt: The development of X-band klystrons at SLAC originated with the idea of building an X-band Linear Collider in the late 1980's. Since then much effort has been expended in developing a reliable X-band Power source capable of delivering>50 MW RF power in pulse widths>1.5 [mu]s. I will report on some of the technical issues and design strategies which have led to the current SLAC klystron designs.
Download or read book X Band Klystron Development at the Stanford Linear Accelerator Center written by and published by . This book was released on 2000 with total page 5 pages. Available in PDF, EPUB and Kindle. Book excerpt: X-band klystrons capable of 75 MW and utilizing either solenoidal or Periodic Permanent Magnet (PPM) focusing are undergoing design, fabrication and testing at the Stanford Linear Accelerator Center (SLAC). The klystron development is part of an effort to realize components necessary for the construction of the Next Linear Collider (NLC). SLAC has completed a solenoidal-focused X-band klystron development effort to study the design and operation of tubes with beam microperveances of 1.2. As of early 2000, nine 1.2[mu]K klystrons have been tested to 50 MW at 1.5[mu]s. The first 50 MW PPM klystron, constructed in 1996, was designed with a 0.6 [mu]K beam at 465 kV and uses a 5-cell traveling-wave output structure. Recent testing of this tube at wider pulsewidths has reached 50 MW at 55% efficiency, 2.4[mu]s and 60 Hz. A 75 MW PPM klystron prototype was constructed in 1998 and has reached the NLC design target of 75 MW at 1.5 [mu]s. A new 75 MW PPM klystron design, which is aimed at reducing the cost and increasing the reliability of multi-megawatt PPM klystrons, is under investigation. The tube is scheduled for testing during early 2001.
Download or read book A 12 GHZ 50 MW Klystron for Support of Accelerator Research written by and published by . This book was released on 2011 with total page 3 pages. Available in PDF, EPUB and Kindle. Book excerpt: A 12 GHz 50MW X-band klystron is under development at the SLAC National Accelerator Laboratory Klystron Department. The klystron will be fabricated to support programs currently underway at three European Labs; CERN, PSI, and INFN Trieste. The choice of frequency selection was due to the CLIC RF frequency changing from 30 GHz to the European X-band frequency of 11.99 GHz in 2008. Since the Klystron Department currently builds 50MW klystrons at 11.424 GHz known collectively as the XL4 klystrons, it was deemed cost-effective to utilize many XL4 components by leaving the gun, electron beam transport, solenoid magnet and collector unchanged. To realize the rf parameters required, the rf cavities and rf output hardware were necessarily altered. Some improvements to the rf design have been made to reduce operating gradients and increase reliability. Changes in the multi-cell output structure, waveguide components, and the window will be discussed along with testing of the devices. Five klystrons known as XL5 klystrons are scheduled for production over the next two years.
Download or read book Reliability Design Handbook written by United States. Naval Ship Systems Command and published by . This book was released on 1963 with total page 810 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Eps High Energy Physics 95 Proceedings Of The International Europhysics Conference written by Catherine Vander Velde and published by World Scientific. This book was released on 1996-05-28 with total page 1042 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book EPAC 92 written by H. Henke and published by Atlantica Séguier Frontières. This book was released on 1992 with total page 910 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Microwave Tube Transmitters written by L. Sivan and published by Springer Science & Business Media. This book was released on 1994-09-30 with total page 498 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book fulfills the needs of engineers and technicians who specify, procure, design, develop, test, manufacture, operate and service tubes, power supply/modulators and complete transmitters for radar, ECM and communications and broadcast systems. The material in the book is also applicable to microwave transmitters for scientific applications.
Download or read book PPM Focused X band Klystron Development at the Stanford Linear Accelerator Center written by and published by . This book was released on 1996 with total page 11 pages. Available in PDF, EPUB and Kindle. Book excerpt: X-band klystrons capable of 50 MW and utilizing Periodic Permanent Magnet (PPM) focusing are undergoing design and fabrication at the Stanford Linear Accelerator Center (SLAC). The klystron development is part of an effort to realize components necessary for the construction of the Next Linear Collider (NLC). The first klystron to be tested this year has a 0.6 microK beam at 465 kV, a 5 cells traveling wave output structure and a predicted efficiency of 63%. A 465 kV, 190 A beam stick with 12 periods of PPM focusing has recently operated to verify the gun optics and transmission of the beam in the absence of rf bunching. Beam transmission greater than 99.8% has been measured. Design and simulation of the beam stick and klystron are discussed, along with performance of the beam stick under confined flow and shielded conditions.
Download or read book SLAC RF Source Research at X Band written by and published by . This book was released on 2003 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: X-band klystrons capable of 75 MW and utilizing either solenoidal or Periodic Permanent Magnet (PPM) focusing are undergoing design, fabrication and testing at the Stanford Linear Accelerator Center (SLAC). The klystron development is part of an effort to realize components necessary for the construction of the Next Linear Collider (NLC). SLAC has developed a solenoidal-focused X-band klystron which is currently the workhorse of high power component testing for the NLC. A state-of-the-art modulator will drive eight of these tubes which, in turn, will power an rf distribution system referred to as the ''8-pack'' in order to test these modulators and waveguide components. Eventually, in an interest to save millions of dollars per year in the operational cost of the NLC, these tubes will be replaced by PPM klystrons. The PPM devices built to date which fit this class of operation consist of a variety of 50 MW and 75 MW devices constructed by SLAC, KEK (Tsukuba, Japan), and industry. These tubes follow from the successful 50 MW PPM design of 1996. Recent testing of this particular tube at wider pulsewidths has reached 50 MW at 55% efficiency, 2.4[micro]s and 60 Hz. Two 50 MW PPM klystrons produced by industry have been delivered to SLAC. One of these devices arrived with a vacuum suitable for test. Testing during 2001 revealed a serious, but curious, vacuum response which limited the operation to an rf output of[approx]40 MW. A 75 MW PPM klystron prototype was first constructed in 1997 and later modified in 1999 to eliminate oscillations. This tube has reached the NLC design target of 75 MW at 1.5[micro]s though at a significantly reduced rep rate. Two new 75 MW PPM klystrons were constructed and tested in 2002 after a diode was successfully tested in 2001. The new design was aimed at reducing the cost and increasing the reliability of such high-energy devices. The rf circuit and beam focusing for one of these devices was built by industry and incorporated into one of the tubes. Both of these latest devices suffered from a variety of issues concerning gun stability, beam confinement and rf stability. A rebuilt version of this latest design was constructed in early 2003 and completed testing in June. The performance of these various klystrons, particularly during 2002 and 2003, will be presented along with results of studies pertinent to their construction. Design and manufacturing issues of the various klystrons are discussed, along with plans for future modifications and areas of research.
Download or read book High Power Microwaves written by James Benford and published by CRC Press. This book was released on 2007-02-05 with total page 552 pages. Available in PDF, EPUB and Kindle. Book excerpt: The first edition of High Power Microwaves was considered to be the defining book for this field. Not merely updated but completely revised and rewritten, the second edition continues this tradition. Written from a systems perspective, the book provides a unified, coherent presentation of the fundamentals in this rapidly changing field. The p
Download or read book Klystrons Traveling Wave Tubes Magnetrons Crossed field Amplifiers and Gyrotrons written by A.S. Gilmour Jr. and published by Artech House. This book was released on 2011 with total page 883 pages. Available in PDF, EPUB and Kindle. Book excerpt: Microwave tubes are vacuum electron devices used for the generation and amplification of radio frequencies in the microwave range. An established technology area, the use of tubes remains essential in the field today for high-power applications. The culmination of the authorOCOs 50 years of industry experience, this authoritative resource offers you a thorough understanding of the operations and major classes of microwave tubes.Minimizing the use of advanced mathematics, the book places emphasis on clear qualitative explanations of phenomena. This practical reference serves as an excellent introduction for newcomers to the field and offers established tube engineers a comprehensive refresher. Professionals find coverage of all major tube classifications, including klystrons, traveling wave tubes (TWTs), magnetrons, cross field amplifiers, and gyrotrons."
Download or read book Physics And Experiments With Linear Colliders In 2 Vols written by P Eerola and published by World Scientific. This book was released on 1992-11-20 with total page 876 pages. Available in PDF, EPUB and Kindle. Book excerpt: This workshop brought together for the first time accelerator experts as well as experimental and theoretical high energy physicists from all over the world to consider the physics potential of high energy linear electron-positron colliders. A wide variety of physics cases were presented ranging from precision tests of the top quark and electroweak gauge bosons to searches of the intermediate mass Higgs bosons and supersymmetric particles.
Download or read book Stabilization and Maximization of Extracted Electromagnetic Power from Relativistic Traveling Wave Amplifiers written by Shahid Naqvi and published by . This book was released on 1996 with total page 488 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book European Particle Accelerator Conference Epac 94 In 3 Volumes written by Christine Petit-jean-genaz and published by World Scientific. This book was released on 1994-11-26 with total page 2968 pages. Available in PDF, EPUB and Kindle. Book excerpt: These proceedings aim to provide a comprehensive overview of research, technology and applications in the field of accelerators. Contributions from the entire field of accelerators are presented, including low and high energy machines, and medical and industrial accelerators.
