Download or read book Design Considerations for Economically Competitive Sodium Cooled Fast Reactors written by and published by . This book was released on 2009 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: The technological viability of sodium cooled fast reactors (SFR) has been established by various experimental and prototype (demonstration) reactors such as EBR-II, FFTF, Phénix, JOYO, BN-600 etc. However, the economic competitiveness of SFR has not been proven yet. The perceived high cost premium of SFRs over LWRs has been the primary impediment to the commercial expansion of SFR technologies. In this paper, cost reduction options are discussed for advanced SFR designs. These include a hybrid loop-pool design to optimize the primary system, multiple reheat and intercooling helium Brayton cycle for the power conversion system and the potential for suppression of intermediate heat transport system. The design options for the fully passive decay heat removal systems are also thoroughly examined. These include direct reactor auxiliary cooling system (DRACS), reactor vessel auxiliary cooling system (RVACS) and the newly proposed pool reactor auxiliary cooling system (PRACS) in the context of the hybrid loop-pool design.
Download or read book Applying Risk Informed Methodologies to Improve the Economics of Sodium cooled Fast Reactors written by Christopher C. Nitta and published by . This book was released on 2010 with total page 102 pages. Available in PDF, EPUB and Kindle. Book excerpt: In order to support the increasing demand for clean sustainable electricity production and for nuclear waste management, the Sodium-Cooled Fast Reactor (SFR) is being developed. The main drawback has been its high capital and operating costs in comparison with traditional light water reactors. In order to compete, the SFR must be shown to be economically competitive. This study makes use of the proposed Technology Neutral Framework (TNF) being developed by the U.S. NRC. By applying this risk-based approach to safety, rather than the traditional approach of applying deterministic requirements, it will be shown that significant savings can be realized without compromising fundamental safety. A methodology was developed using the Technology Neutral Framework to judge design alternatives based on risk significance that provide acceptable safety within the framework at less cost. The key probabilistic metrics of Risk Achievement Worth and Limit Exceedence Factor will be used to assess whether a system or component plays an important safety function. If not the system, structure or component either can be eliminated, modified or its safety grade can be reduced resulting in cost savings. In addition, assessments were made to determine how to improve thermal efficiency by raising reactor exit temperature and by applying other design alternatives to reduce costs as evaluated on a safety, reliability and economic basis.
Download or read book Feasibility Study of a 1000 Mwe Sodium cooled Fast Reactor Research and development program written by North American Aviation. Atomics International Division and published by . This book was released on 1966 with total page 82 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Sodium Fast Reactors with Closed Fuel Cycle written by Baldev Raj and published by CRC Press. This book was released on 2015-04-15 with total page 901 pages. Available in PDF, EPUB and Kindle. Book excerpt: Sodium Fast Reactors with Closed Fuel Cycle delivers a detailed discussion of an important technology that is being harnessed for commercial energy production in many parts of the world. Presenting the state of the art of sodium-cooled fast reactors with closed fuel cycles, this book:Offers in-depth coverage of reactor physics, materials, design, s
Download or read book RISK INFORMED BALANCING OF SAFETY NONPROLIFERATION AND ECONOMICS FOR THE SFR written by and published by . This book was released on 2011 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: A substantial barrier to the implementation of Sodium-cooled Fast Reactor (SFR) technology in the short term is the perception that they would not be economically competitive with advanced light water reactors. With increased acceptance of risk-informed regulation, the opportunity exists to reduce the costs of a nuclear power plant at the design stage without applying excessive conservatism that is not needed in treating low risk events. In the report, NUREG-1860, the U.S. Nuclear Regulatory Commission describes developmental activities associated with a risk-informed, scenario-based technology neutral framework (TNF) for regulation. It provides quantitative yardsticks against which the adequacy of safety risks can be judged. We extend these concepts to treatment of proliferation risks. The objective of our project is to develop a risk-informed design process for minimizing the cost of electricity generation within constraints of adequate safety and proliferation risks. This report describes the design and use of this design optimization process within the context of reducing the capital cost and levelized cost of electricity production for a small (possibly modular) SFR. Our project provides not only an evaluation of the feasibility of a risk-informed design process but also a practical test of the applicability of the TNF to an actual advanced, non-LWR design. The report provides results of five safety related and one proliferation related case studies of innovative design alternatives. Applied to previously proposed SFR nuclear energy system concepts We find that the TNF provides a feasible initial basis for licensing new reactors. However, it is incomplete. We recommend improvements in terms of requiring acceptance standards for total safety risks, and we propose a framework for regulation of proliferation risks. We also demonstrate methods for evaluation of proliferation risks. We also suggest revisions to scenario-specific safety risk acceptance standards, particularly concerning seismic and aircraft impactrelated risks. Most importantly, within the context of the TNF historical SFR safety concerns about energetic core disruptive accidents are seen to be unimportant, but those of rare scenarios mentioned above are seen to be of dominant concern. In terms of proliferation risks the SFR energy system is seen not to be of considerably greater concern than with other nuclear power technologies, providing that highly effective safeguards are employed. We find the economic performance of proposed SFRs likely, due to the problems of using sodium as a coolant, to be inferior to those of LWRs unless they can be credited for services to improve nuclear waste disposal, nuclear fuel utilization and proliferation risk reductions. None of the design innovations investigated offers the promise to reverse this conclusion. The most promising innovation investigated is that of improving the plant's thermodynamic efficiency via use of the supercritical CO2 (rather than steam Rankine) power conversion system. We were unable to reach conclusions about the economic and proliferation risk implications of competing nuclear fuel processing methods, as available designs are too little developed to justify any such results. Overall, we find the SFR to be a promising alternative to LWRs should the conditions governing the valuation change substantially from current ones.
Download or read book Optimisation of Sodium cooled Fast Reactors written by Joyce S. Davis and published by Thomas Telford Publishing. This book was released on 1978 with total page 478 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Reactor Protection System Design Alternatives for Sodium Fast Reactors written by Jacob Dominic DeWitte and published by . This book was released on 2011 with total page 179 pages. Available in PDF, EPUB and Kindle. Book excerpt: Historically, unprotected transients have been viewed as design basis events that can significantly challenge sodium-cooled fast reactors. The perceived potential consequences of a severe unprotected transient in a sodium-cooled fast reactor include an energetic core disruptive accident, vessel failure, and a large early release. These consequences can be avoided if unprotected transients are properly defended against, potentially improving the economics of sodium fast reactors. One way to defend against such accidents is to include a highly reliable reactor protection system. The perceived undesirability of the consequences arising from an unprotected transient has led some sodium fast reactor designers to consider incorporating several design modifications to the reactor protection system, including: self-actuated shutdown systems, articulated control rods, and seismic anticipatory scram systems. This study investigates the performance of these systems in sodium fast reactors. To analyze the impact of these proposed design alternatives, a model to analyze plant performance that incorporates uncertainty analysis is developed using RELAP5-3D and the ABR-1000 as the reference design. The performance of the proposed alternatives is analyzed during unprotected loss of flow and unprotected transient overpower scenarios, each exacerbated by a loss of heat sink. The recently developed Technology Neutral Framework is used to contextually rate performance of the proposed alternatives. Ultimately, this thesis offers a methodology for a designer to analyze reactor protection system design efficacy. The principle results of this thesis suggest that when using the Technology Neutral Framework as a licensing framework for a sodium-cooled fast reactor, the two independent scram systems of the ABR- 1000's reactor protection system perform well enough to screen unprotected transients from the design basis. While a regulator may still require consideration of accidents involving the failure of the reactor protection system, these events will not drive the design of the system. However, self-actuated shutdown systems may be called for to diversify the reactor protection system. Of these, the Curie point latch marginally reduces the conditional cladding damage probability for metal cores because of their rapid inherent feedback effects, but is more effective for the more sluggish oxide cores given reasonably long pump coastdown times. Flow levitated absorbers are highly effective at mitigating unprotected loss of flow events for both fuel types, but are limited in response during unprotected transient overpower events. When considered from a risk-informed perspective, a clear rationale and objective is needed to justify the inclusion of an additional feature such as self-actuated shutdown systems. The use of articulated safety rods as one of the diverse means of reactivity insertion and the implementation of an anticipatory seismic scram system may be the most cost-effective alternatives to provide defense in depth in light of the sodium fast reactor's susceptibility to seismic events.
Download or read book Status of Fast Reactor Research and Technology Development written by International Atomic Energy Agency and published by . This book was released on 2012 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: "Based on a recommendation from the Technical Working Group on Fast Reactors, this publication is a regular update of previous publications on fast reactor technology. The publication provides comprehensive and detailed information on the technology of fast neutron reactors. The focus is on practical issues that are useful to engineers, scientists, managers, university students and professors. The main issues of discussion are experience in design, construction, operation and decommissioning, various areas of research and development, engineering, safety and national strategies, and public acceptance of fast reactors. In the summary the reader will find national strategies, international initiatives on innovative (i.e. Generation IV) systems and an assessment of public acceptance as related to fast reactors."--Résumé de l'éditeur.
Download or read book Liquid Metal Cooled Reactors written by International Atomic Energy Agency and published by . This book was released on 2007 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: Presents a survey of worldwide experience gained with fast breeder reactor design, development and operation. Coverage includes state of the art of liquid metal fast reactor development; lead-bismuth cooled (LBC) ship reactor operation experience and LBC fast power reactor development; and treatment and disposal of spent sodium.
Download or read book Super Light Water Reactors and Super Fast Reactors written by Yoshiaki Oka and published by Springer Science & Business Media. This book was released on 2010-07-01 with total page 664 pages. Available in PDF, EPUB and Kindle. Book excerpt: Super Light Water Reactors and Super Fast Reactors provides an overview of the design and analysis of nuclear power reactors. Readers will gain the understanding of the conceptual design elements and specific analysis methods of supercritical-pressure light water cooled reactors. Nuclear fuel, reactor core, plant control, plant stand-up and stability are among the topics discussed, in addition to safety system and safety analysis parameters. Providing the fundamentals of reactor design criteria and analysis, this volume is a useful reference to engineers, industry professionals, and graduate students involved with nuclear engineering and energy technology.
Download or read book Nuclear Energy written by Nicholas Tsoulfanidis and published by Springer Science & Business Media. This book was released on 2012-12-12 with total page 522 pages. Available in PDF, EPUB and Kindle. Book excerpt: Nuclear Energy provides an authoritative reference on all aspects of the nuclear industry from fundamental reactor physics calculations to reactor design, nuclear fuel resources, nuclear fuel cycle, radiation detection and protection, and nuclear power economics. Featuring 19 peer-reviewed entries by recognized authorities in the field, this book provides comprehensive, streamlined coverage of fundamentals, current areas of research, and goals for the future. The chapters will appeal to undergraduate and graduate students, researchers, and energy industry experts.
Download or read book Hearings written by United States. Congress. Joint Committee ... and published by . This book was released on 1963 with total page 2156 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Development Growth and State of the Atomic Energy Industry written by United States. Congress. Joint Committee on Atomic Energy and published by . This book was released on 1963 with total page 576 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Structural Materials for Generation IV Nuclear Reactors written by Pascal Yvon and published by Woodhead Publishing. This book was released on 2016-08-27 with total page 686 pages. Available in PDF, EPUB and Kindle. Book excerpt: Operating at a high level of fuel efficiency, safety, proliferation-resistance, sustainability and cost, generation IV nuclear reactors promise enhanced features to an energy resource which is already seen as an outstanding source of reliable base load power. The performance and reliability of materials when subjected to the higher neutron doses and extremely corrosive higher temperature environments that will be found in generation IV nuclear reactors are essential areas of study, as key considerations for the successful development of generation IV reactors are suitable structural materials for both in-core and out-of-core applications. Structural Materials for Generation IV Nuclear Reactors explores the current state-of-the art in these areas. Part One reviews the materials, requirements and challenges in generation IV systems. Part Two presents the core materials with chapters on irradiation resistant austenitic steels, ODS/FM steels and refractory metals amongst others. Part Three looks at out-of-core materials. Structural Materials for Generation IV Nuclear Reactors is an essential reference text for professional scientists, engineers and postgraduate researchers involved in the development of generation IV nuclear reactors. Introduces the higher neutron doses and extremely corrosive higher temperature environments that will be found in generation IV nuclear reactors and implications for structural materials Contains chapters on the key core and out-of-core materials, from steels to advanced micro-laminates Written by an expert in that particular area
Download or read book Papers Presented at the Technical Briefing Session on the Boiling Water Reactor Program and the Fast Reactor Program Held at Idaho Falls Idaho November 1 2 1955 Unclassified written by W. H. Zinn and published by . This book was released on 1956 with total page 228 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Handbook of Generation IV Nuclear Reactors written by Igor Pioro and published by Woodhead Publishing. This book was released on 2022-12-07 with total page 1112 pages. Available in PDF, EPUB and Kindle. Book excerpt: Handbook of Generation IV Nuclear Reactors, Second Edition is a fully revised and updated comprehensive resource on the latest research and advances in generation IV nuclear reactor concepts. Editor Igor Pioro and his team of expert contributors have updated every chapter to reflect advances in the field since the first edition published in 2016. The book teaches the reader about available technologies, future prospects and the feasibility of each concept presented, equipping them users with a strong skillset which they can apply to their own work and research. Provides a fully updated, revised and comprehensive handbook dedicated entirely to generation IV nuclear reactors Includes new trends and developments since the first publication, as well as brand new case studies and appendices Covers the latest research, developments and design information surrounding generation IV nuclear reactors
Download or read book NUREG CR written by U.S. Nuclear Regulatory Commission and published by . This book was released on 1977 with total page 48 pages. Available in PDF, EPUB and Kindle. Book excerpt:
