Download or read book Comparison of Various Investigations Into the Static Strength of Tubular Joints Pt 1 Cross Joints written by J. Wardenier and published by . This book was released on 1976 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Static Strength of Elliptical Chords T tubular Joints Subjected to Mechanical Loading written by Abdalla F. Hamed and published by . This book was released on 1999 with total page 376 pages. Available in PDF, EPUB and Kindle. Book excerpt: T -Tubular joints of elliptical and circular cross-section tubes for the main tube (chord) with circular cross-section tubes for the braces have been studied. Experimental tests for the joint strength of these welded T -joints under tension, compression, in plane bending and out of plane bending have been carried out. A rig has been designed and built for that purpose. Three cases of T -joint connections were selected. For Case 1, the brace was perpendicular to the circular chord outer diameter. For Case 2, the brace was perpendicular to elliptical chord minor diameter and for Case 3, the brace was perpendicular to elliptical chord major diameter. The chord was held as fixed-fixed for all cases. The material used for all tubes was mild steel. The ultimate loads and ultimate moments obtained from the tests are converted to non-dimensional strengths throughout this investigation. This was done to make efficient comparisons. Finite element models 'for similar T -joints have been developed and used to analyze the effect of axial loading and bending moment. Tension, compression, in- plane bending and out-of-plane bending load modes were studied. A comparison between experimental results and finite element analysis was also carried out. Another comparison between experimental results and existing empirical equation results for similar circular chords tubular joints was also carried out. The results extracted from this study for tension, compression, in-plane bending and out-of-plane bending modes for the ultimate loads and moments of Case 1, are 53.85 kN, 25.43 kN, 0.76 kN.m and 0.40 kN.m respectively. On the other hand, the results for Case 2 of the ultimate loads and moments are 42.48 kN, 18.39 kN, 0.63 kN.m and 0.37 kN.m respectively. While for Case 3 the ultimate loads and moments are 64.86 kN, 28.95 kN, 1.00 kN.m and 0.55 kN.m respectively. The results obtained show that for axial tension and compression loading modes, Case 3 increases by 17.0% and 12.2% respectively when compared to Case 1 while 24.0% and 27.3% increase were found for in-plane and out-of-plane bending load modes respectively. This shows a significant improvement in the static strength for elliptical chords tubular joints (Case 3) under different loading modes when compared to circular chords tubular joints (Case 1).
Download or read book Static Strength of Tubular Joints written by Yousif A. Khalid and published by . This book was released on 1993 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Strength and Stiffness of Tubular Joints written by H. G. A. Stol and published by . This book was released on 1985 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Comparison of Tubular Joint Strength Provisions in Codes and Standards written by BOMEL Limited and published by . This book was released on 2002-03-11 with total page 28 pages. Available in PDF, EPUB and Kindle. Book excerpt: The purpose of this technical note is to present a comparison of the technical provisions concerning the static strength of tubular joints given in the following documents: API RP2A WSD and LRFD 1] and 2]; HSE 4th edition guidance notes (GNs) 3]; draft ISO standard for fixed steel offshore structures 5] and 6]; and NORSOK standard for the design of steel offshore structures 8].
Download or read book Tubular Structures V written by M.G. Coutie and published by CRC Press. This book was released on 2004-01-14 with total page 810 pages. Available in PDF, EPUB and Kindle. Book excerpt: The book forms the Proceedings of the 5th International Symposium on Tubular Structures, following previous events in Boston (1984), Tokyo (1986), Finland (1989), Delft (1991). Sponsored by British Steel, International Institute of Welding and CIDECT, it forms an important forum for advanced structural research and development.
Download or read book Static Strength of Cracked Tubular Joints written by Great Britain. Health and Safety Executive and published by . This book was released on 1995 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Design Charts for Static Strength of Structural Tubular Joints written by Paul V. Hebert and published by . This book was released on 1968 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Static Strength of Uniplanar and Multiplanar Tubular T and X joints written by Gerhardus Jacob van der Vegte and published by Coronet Books. This book was released on 1995 with total page 378 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Tubular Joints Under Static and Alternating Loads phase 1 written by Jack G. Bouwkamp and published by . This book was released on 1966 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Draft Guidance Notes on Static Strength of Tubular Joints written by Great Britain. Department of Energy and published by . This book was released on 1989 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Static and Fatigue Behavior of Tubular Connections A Summary Report written by A. A. Toprac and published by . This book was released on 1972 with total page 39 pages. Available in PDF, EPUB and Kindle. Book excerpt: In this final report the findings of research studies on the subject of tubular joints are presented. The report covers both static and fatigue strength of welded hollow, round shapes. After an introduction and a literature review of theoretical and experimental findings, design considerations are presented for the static strength and fatigue life of such connections. Suggested design curves indicate the static strength of tubular joints with yield strength and a thickness parameter as influence factors. S-N curves (stress range vs cycles to failure) for the fatigue life of T- and K-connections are also presented. It is believed that the data could be used in the design of tubular structures if dimensional ratios are about equal to those of the program. (Author).
Download or read book Static Srength Investigation of Tubular Y joint Using LUSAS Software written by Ying Yu Lee and published by . This book was released on 2005 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Applied Mechanics Reviews written by and published by . This book was released on 1964 with total page 538 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Tubular Structures XV written by Eduardo de Miranda Batista and published by CRC Press. This book was released on 2015-04-23 with total page 688 pages. Available in PDF, EPUB and Kindle. Book excerpt: Tubular Structures XV contains the latest scientific and engineering developments in the field of tubular structures, as presented at the 15th International Symposium on Tubular Structures (ISTS15, Rio de Janeiro, Brazil, 27-29 May 2015). The International Symposium on Tubular Structures (ISTS) has a long-standing reputation for being the principal
Download or read book Tubular Structures XIV written by Leroy Gardner and published by CRC Press. This book was released on 2012-08-24 with total page 798 pages. Available in PDF, EPUB and Kindle. Book excerpt: Tubular Structures XIV contains the latest scientific and engineering developments in the field of tubular steel structures, as presented at the 14th International Symposium on Tubular Structures (ISTS14, Imperial College London, UK, 12-14 September 2012). The International Symposium on Tubular Structures (ISTS) has a long-standing reputation for b
Download or read book Static Strength of Cracked Tubular Joints written by Great Britain. Health and Safety Executive and published by . This book was released on 1999 with total page 74 pages. Available in PDF, EPUB and Kindle. Book excerpt:
