Download or read book Behavior of Plain Concrete Under Various High Triaxial Compression Loading Conditions written by James Chinn and published by . This book was released on 1965 with total page 160 pages. Available in PDF, EPUB and Kindle. Book excerpt: Triaxial compression tests were performed on 6-inch by 12-inch concrete cylinders. Axial pressures of up to 177,000 psi and lateral pressures of up to 75,000 psi were applied in the triaxial testing machine of the Bureau of Reclamation, Denver. Concrete mixes with average compressive strengths of 5,200 psi, 8,100 psi, and 8,700 psi were tested under four different types of triaxial compression. Type I and Type IV tests were run until the axial stress dropped or until 2 inches of axial deformation were produced. The results of the Type I and Type IV loadings differed little. Considerable bulging occurred, and it appeared that the average normal stress at midheight remained nearly constant during bulging and represented an approximate yield stress. Type II tests were run until the lateral stress had an effect. No drop-off of load occurred in the Type III tests, but the unconfined compressive strength of the concrete cylinders was decreased. The results obtained are in good agreement with those of previous investigators, but much higher stresses were attained in the present tests than in any previous tests. (Author).
Download or read book Correlation of Hardened Concrete Test Methods and Results written by K. L. Saucier and published by . This book was released on 1969 with total page 60 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Plasticity in Reinforced Concrete written by Wai-Fah Chen and published by J. Ross Publishing. This book was released on 2007 with total page 500 pages. Available in PDF, EPUB and Kindle. Book excerpt: J. Ross Publishing Classics are world-renowned texts and monographs written bt preeminent scholars. These books are available to students, researchers, professionals, and libararies.
Download or read book Concrete under multi axial states of stress constitutive equations for practical design written by FIB – International Federation for Structural Concrete and published by FIB - International Federation for Structural Concrete. This book was released on 1983-06-01 with total page 154 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Manual of Numerical Methods in Concrete written by M Y H Bangash and published by Thomas Telford. This book was released on 2001-07-27 with total page 940 pages. Available in PDF, EPUB and Kindle. Book excerpt: Manual of numerical methods in concrete aims to present a unified approach for the available mathematical models of concrete, linking them to finite element analysis and to computer programs in which special provisions are made for concrete plasticity, cracking and crushing with and without concrete aggregate interlocking. Creep, temperature, and shrinkage formulations are included and geared to various concrete constitutive models.
Download or read book Technical Abstract Bulletin written by and published by . This book was released on with total page 684 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Computational Mechanics 88 written by S.N. Atluri and published by Springer Science & Business Media. This book was released on 2013-11-11 with total page 1775 pages. Available in PDF, EPUB and Kindle. Book excerpt: The aim of this Conference was to become a forum for discussion of both academic and industrial research in those areas of computational engineering science and mechanics which involve and enrich the rational application of computers, numerical methods, and mechanics, in modern technology. The papers presented at this Conference cover the following topics: Solid and Structural Mechanics, Constitutive Modelling, Inelastic and Finite Deformation Response, Transient Analysis, Structural Control and Optimization, Fracture Mechanics and Structural Integrity, Computational Fluid Dynamics, Compressible and Incompressible Flow, Aerodynamics, Transport Phenomena, Heat Transfer and Solidification, Electromagnetic Field, Related Soil Mechanics and MHD, Modern Variational Methods, Biomechanics, and Off-Shore-Structural Mechanics.
Download or read book Technical Memodrandum written by Waterways Experiment Station (U.S.) and published by . This book was released on 1969 with total page 618 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Plasticity for Structural Engineers written by Wai-Fah Chen and published by J. Ross Publishing. This book was released on 2007-02-15 with total page 625 pages. Available in PDF, EPUB and Kindle. Book excerpt: J. Ross Publishing Classics are world-renowned texts and monographs written by preeminent scholars. These books are suitable for students, researchers, professionals and libraries.
Download or read book ACI Materials Journal written by and published by . This book was released on 2008 with total page 242 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Structural Integrity of Recycled Aggregate Concrete Produced With Fillers and Pozzolans written by Paul O. Awoyera and published by Woodhead Publishing. This book was released on 2021-12-01 with total page 499 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Structural Integrity of Recycled Aggregate Concrete Produced with Fillers and Pozzolans presents a review on the use of by-products, fillers and pozzolanic materials in the development of concrete, with an emphasis on structural integrity. The volume is broken down into key sections, including a review of the types of materials that are used as latent hydraulic supplements, fillers and pozzolans for making recycled aggregate concrete, rheology and hydration phenomenon, the mechanical and microscale nature of concrete, and the impact of fillers and pozzolans on the workability of concrete with case studies. Durability and strength development are also discussed. The final section looks at issues such as performance effect, LCA, environmental impact, sustainability and cost benefit analysis. With detailed case studies throughout, this volume will provide useful information for all stakeholders involved in the built environment, including materials scientists, civil engineers, builders, architects and policymakers. - Identifies several potential by-products, fillers and pozzolans for the development of durable concrete - Acts as a guidebook for constructors and researchers working in the broad field of material science, engineering and in-situ application - Presents the durability properties of concrete made of by-products, fillers and pozzolans
Download or read book Annual Book of ASTM Standards written by American Society for Testing and Materials and published by . This book was released on 1982 with total page 904 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Deep Mixing Method written by Coastal Development Institute Tokyo and published by CRC Press. This book was released on 2002-01-01 with total page 148 pages. Available in PDF, EPUB and Kindle. Book excerpt: A growing population and increasing urbanization over the past century have made it difficult to locate suitable ground for siting infrastructures in densely populated areas. The Deep Mixing Method (DMM) was developed and put into practice in Japan in 1975 to cope with the headaches of stability and/or excessive settlement in soft soil areas. This method involves using cement and/or lime as a soil stabilizer, added in-situ to deep soils, and has now been adopted not only in Japan but in the USA and other parts of the world as well. This book presents properties of this treated soil method, its various applications, its design and execution, and accumulated research results over the last twenty-five years.
Download or read book Structures and Granular Solids written by Jian-Fei Chen and published by CRC Press. This book was released on 2008-06-23 with total page 342 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume features 29 invited papers presented at the Royal Society of Edinburgh on 1-2 July 2008 by colleagues, collaborators, students and friends of Professor J. Michael Rotter (FREng, FRSE, FICE, FASCE, FIStructE, FIEAust) in honour of his 60th birthday.The articles published in this volume will be of great value to readers as it contains con
Download or read book Applied Mechanics Reviews written by and published by . This book was released on 1969 with total page 736 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Book of ASTM Standards with Related Material written by American Society for Testing and Materials and published by . This book was released on 1976 with total page 736 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Journal of Testing and Evaluation written by and published by . This book was released on 1975 with total page 512 pages. Available in PDF, EPUB and Kindle. Book excerpt:
