EBookClubs

Read Books & Download eBooks Full Online

EBookClubs

Read Books & Download eBooks Full Online

Book An Experimental Investigation of Two dimensional Vortex Development

Download or read book An Experimental Investigation of Two dimensional Vortex Development written by Steven Henry Reichenbach and published by . This book was released on 1984 with total page 174 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book An Experimental Investigation and Dimensional Analysis of Confined Vortex Flows

Download or read book An Experimental Investigation and Dimensional Analysis of Confined Vortex Flows written by Hing Chum Lam and published by . This book was released on 1993 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: This work provides the vortex chamber designer a relatively simple method to calculate the magnitudes of the main flow parameters with a good accuracy.

Book Experimental Study of Two dimensional Vortex Patterns for Impulsively Started Bodies in Comparison with Other Configurations

Download or read book Experimental Study of Two dimensional Vortex Patterns for Impulsively Started Bodies in Comparison with Other Configurations written by Fathi Finaish and published by . This book was released on 1987 with total page 358 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book An Experimental Investigation of the Heat transfer Effects of a Longitudinal Vortex Embedded in a Turbulent Boundary Layer

Download or read book An Experimental Investigation of the Heat transfer Effects of a Longitudinal Vortex Embedded in a Turbulent Boundary Layer written by Stanford University. Thermosciences Division. Thermosciences Division and published by . This book was released on 1985 with total page 276 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Research in Progress

Download or read book Research in Progress written by and published by . This book was released on 1971 with total page 834 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book NASA Technical Paper

Download or read book NASA Technical Paper written by and published by . This book was released on 1986 with total page 32 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Measurement of Vortex Separation  Part I  Two dimensional Circular and Elliptic Bodies

Download or read book Measurement of Vortex Separation Part I Two dimensional Circular and Elliptic Bodies written by Eric G. Friberg and published by . This book was released on 1965 with total page 75 pages. Available in PDF, EPUB and Kindle. Book excerpt: An experimental investigation of vortex separation about two-dimensional circular and elliptic cylinders using the hydrogen bubble technique for flow visualization is discussed. Data on the time-dependent motion of the separation point of the vortex feeding sheet are presented. Semi-empirical formulas are determined which correlate the time-dependent motion of the separation point as well as its position on an elliptic body of arbitrary axis ratio. Most of the data presented are for turbulent flow, but by changing the constants in the semi-empirical equations, they may be made applicable in the laminar regime as well. (Author).

Book Scientific and Technical Aerospace Reports

Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1994 with total page 1038 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Theoretical   Experimental Investigation of Coherent Structure in the Turbulent Boundary Layer

Download or read book Theoretical Experimental Investigation of Coherent Structure in the Turbulent Boundary Layer written by and published by . This book was released on 1982 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: This program combines both experimental flow visualization studies with analytical investigations of a series of phenomenological and theoretical models based upon three-dimensional, vortical flow structures developing and interacting in proximity to a solid surface. The experimental program considered a range of sub-problems including the effect of surface modifications on low-speed streak formation and drag, and the effect of vortex loop inter-action with a solid boundary. To augment visual studies, a computerized interface with the video system has been developed which allows quantitative data to be obtained from flow visualization pictures. The specific thrust of the theoretical studies has been focussed on three areas: (1) how two and three-dimensional vortex structures interact with wall boundary layers; (2) the development of a new type of prediction method for two-dimensional turbulent boundary-layer flows; and (3) improvement in numerical techniques for solving parabolic, boundary-layer equations.

Book OAR Cumulative Index of Research Results

Download or read book OAR Cumulative Index of Research Results written by and published by . This book was released on 1967 with total page 1264 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Experimental Investigation of the Performance of a Mach 2 7 Two dimensional Bifurcated Duct Inlet with 30 Percent Internal Contraction

Download or read book Experimental Investigation of the Performance of a Mach 2 7 Two dimensional Bifurcated Duct Inlet with 30 Percent Internal Contraction written by Joseph F. Wasserbauer and published by . This book was released on 1996 with total page 50 pages. Available in PDF, EPUB and Kindle. Book excerpt: An experimental study was conducted to determine the performance of a two-dimensional, mixed-compression bifurcated duct inlet system designed for a free-stream Mach number of 2.7. Thirty percent of the supersonic area contraction occurred internally. A movable ramp was used to vary the contraction ratio for off-design operation. Boundary layer bleed regions were located on the cowl, centerbody, and sidewall surfaces. There were also provisions for vortex generators on the cowl and centerbody of the subsonic diffuser. Data were obtained over the Mach number range of 2.0 to 2.8 and at angles of yaw from 0 deg. to the maximum value prior to inlet un-start. The test at Mach 2.8 was to obtain data for an over- speed condition. The Reynolds number varied from 2.5 to 2.3 million/ft for Mach numbers above 2.5. At Mach numbers of 2.5 and lower, the Reynolds number was set at 2.5 million/ft. Bleed patterns, vortex generator patterns, and ramp position were varied, and three inlet configurations were selected for more extensive study. Two of these configurations had self-starting capability. The self-starting configuration that was developed produced 89 percent total pressure recovery at the compressor face station with 6.8 percent total bleed. The compressor face distortion was about 16 percent. Vortex generators were extremely effective in re-distributing flow but were not as effective in reducing distortion. Excellent flow symmetry was achieved between the separated halves of the inlet, and twin-duct instability was not observed. The ramp tip shock was steeper than expected. This caused the cowl lip shock to be reflected from the ramp instead of being cancelled at the shoulder. However, peak recovery at the throat was still obtained with the ramp near the design position.

Book Masters Theses in the Pure and Applied Sciences

Download or read book Masters Theses in the Pure and Applied Sciences written by Wade H. Shafer and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 341 pages. Available in PDF, EPUB and Kindle. Book excerpt: Masters Theses in the Pure and Applied Sciences was first conceived, published, and disseminated by the Center for Information and Numerical Data Analysis and Synthesis (CINDAS)* at Purdue University in 1957, starting its coverage of theses with the academic year 1955. Beginning with Volume 13, the printing and dis semination phases of the activity were transferred to University Microfilms/Xerox of Ann Arbor, Michigan, with the thought that such an arrangement would be more beneficial to the academic and general scientific and technical community. After five years of this jOint undertaking we had concluded that it was in the interest of all concerned if the printing and distribution of the volumes were handled by an international publishing house to assure improved service and broader dissemination. Hence, starting with Volume 18, Masters Theses in the Pure and Applied Sciences has been disseminated on a worldwide basis by Plenum Publishing Corporation of New York, and in the same year the coverage was broadened to include Canadian universities. All back issues can also be ordered from Plenum. We have reported in Volume 40 (thesis year 1995) a total of 10,746 thesis titles from 19 Canadian and 144 United States universities. We are sure that this broader base for these titles reported will greatly enhance the value of this impor tant annual reference work. While Volume 40 reports theses submitted in 1995, on occasion, certain uni versities do report theses submitted in previous years but not reported at the time.

Book An Experimental Investigation of Pressure Driven Three dimensional Turbulent Boundary Layers

Download or read book An Experimental Investigation of Pressure Driven Three dimensional Turbulent Boundary Layers written by Stanford University. Thermosciences Division and published by . This book was released on 1987 with total page 390 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Applied Mechanics Reviews

Download or read book Applied Mechanics Reviews written by and published by . This book was released on 1967 with total page 742 pages. Available in PDF, EPUB and Kindle. Book excerpt: