Download or read book An Archaeological Reconnaissance of Eighteen Proposed Geothermal temperature gradient Test Wells in the Radium Springs Area written by David V. Hill and published by . This book was released on 1977 with total page 26 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book The Archaeological Reconnaissance of 44 Proposed Shallow Temperature Gradient Hole Locations and Access in Big Smoky Valley Nye County Nevada for Microgeophysics Corporation written by Susan Stornetta and published by . This book was released on 1981 with total page 30 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Deep Geothermal Test Well Geothermal Resource Investigations Imperial Valley California written by United States. Bureau of Reclamation. Region 3 and published by . This book was released on 1972 with total page 174 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Archaeological Reconnaissance of a Geothermal Well Site Access Road and Water Line in Grass Valley Near Leach Hot Springs Nevada written by and published by . This book was released on 1980 with total page 8 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book A Preliminary Archaeological Reconnaissance of the Proposed Kilbourne Hole Geothermal Area written by Stanley Dowlen Bussey and published by . This book was released on 1975* with total page 72 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book True Geothermal 6 500 Temperature Gradient Test Holes written by Mark Ziegenbein and published by . This book was released on 1983 with total page 3 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Proposed Deep Geothermal Test Well Geothermal Resources Investigations Imperial Valley California written by United States. Bureau of Reclamation and published by . This book was released on 1972 with total page 188 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Environmental Analysis Prepared for Sixteen Deep Test Wells in Roosevelt Hot Springs Unit Phillips Petroleum Co written by Geological Survey (U.S.). Office of the Area Geothermal Supervisor and published by . This book was released on 1976 with total page 420 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Archaeological Reconnaissance of Thirteen Proposed Well Sites in Book Cliffs Area Garfield County Colorado and Grand County Utah written by Paul R. Nickens and published by . This book was released on 1977 with total page 62 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Drilling and Testing of an Exploratory Well Truckhaven Geothermal Area Imperial County California written by Erik B. Layman and published by . This book was released on 2008 with total page 42 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Radium Springs Geothermal Area written by Robert J. Swanson and published by . This book was released on 1989 with total page 218 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Bridgeport Geothermal Temperature Gradient Well Project written by Mono County (Calif.) and published by . This book was released on 1994 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Investigation and Evaluation of Geopressured geothermal Wells Well test data written by and published by . This book was released on 1979 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book The Archaeological Reconnaissance of One Proposed Well Drilling Location in Lake Valley Lincoln County Nevada for Powers Elevation written by D. Zeier Charles and published by . This book was released on 1984 with total page 6 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Achaeological Reconnaissance of Proposed Access Routes to Eight Geothermal Well Sites in Grass Valley written by Robert Elston and published by . This book was released on 1980 with total page 5 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Design of a Film Cooling Experiment for Rocket Engines written by Air Force Institute of Technology Staff and published by BiblioScholar. This book was released on 2012-09 with total page 158 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Film Cooling Rig (FCR) is a new test rig at the Air Force Institute of Technology (AFIT) to study film cooling for rocket engine applications. The original researcher designed, built, and then utilized the FCR to study radial curvature effects on film cooling for a non-combustion environment. This effort modified the FCR by adding propane-air combustion. Modular stainless steel test sections were produced to allow study of various curvatures and coolant injection angles. A pre-mixed burner was designed and built to deliver main flow mass flow rates necessary to produce blowing ratios as low as 0.5. A water cooling system was designed for the entire FCR, but only implemented for the curved test sections. Instrumentation in this system allows calculation of the average heat flux to the test section. Once the necessary FCR and lab modifications were accomplished, the operating range of the FCR was developed and tested using infrared thermography. Surface temperature measurements near the cooling hole showed no cooling effect for 13 major test configurations, and many more minor variations. The lack of cooling was caused by inadequate spreading of the burner flow to the test section wall. Without the necessary main flow momentum across the test section wall, the coolant flow did not turn and adhere to the wall. Instead, it jetted into the main flow without cooling the wall as expected. Recommendations included modifications to the existing rig to correct the main flow issue, along with a completely new FCR design incorporating the lessons learned from this research to produce a simpler, more effective rig. The new design allows the laser and infrared diagnostics of the first rig without the manufacturing complications that hindered testing in the first FCR.

Download or read book Final Report Grace Geothermal Corporation Baltazor Hot Springs Nevada Hole No 45 14 written by and published by . This book was released on 1983 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: During the period from September 21, 1982 to November 1, 1982 one geothermal test well was drilled within the Baltazor Hot Springs KGRA in northwestern Nevada to a total depth of 2529 feet (Figure 1). Temperature-depth profiles from two temperature surveys run in the open hole are presented in Figure 2. The maximum temperature recorded was 223.77 F at a total survey depth of 2430 feet. Geothermal gradients from selected intervals in the well ranged from 2.25 F/100 ft to 11.00 F/100 ft. Individual temperature-depth plots, gradient plots, and interval gradient plots are provided in Appendix A. Rock types encountered ranged from unconsolidated alluvium to rhyolitic and basaltic flows, tuffs and flow breccias. A lithologic section for the well is provided in a pocket at the back of the report (Figure 3). Thermal conductivity measurements were performed on a total of 26 drill cutting samples that ranged from 2.9 TCU to 5.5 TCU (1 TCU = 1 mcal/cm-sec-deg C) and are presented in Appendix B. Selected heat flow data for the well are provided in Table 1. Well 45-14 was drilled by Southwest Drilling and Exploration, Inc., utilizing a Gardner Denver 2000 rotary drilling machine with a 53 foot mast rated at 100,000 lbs. capacity. Drilling conditions ranged from moderate to difficult with the major problems resulting from the hard and fractured rhyolite sequence in the upper part of the well. Drilling rates below 1750 feet were greatly reduced as a result of decreasing the weight on the bit to keep the vertical deviation within the required 4 degrees. Fluid losses were contained to a minimum below the rhyolite sequence and did not present a major problem. Selected drilling data and a detailed drilling history are provided in Appendix C. Earth Power Production Company completed two test holes in the immediate area in June and July 1979. Boreholes BZ 1500-1 and BZ 1500-2 were drilled to depths of 1543 feet and 1434 feet respectively. Selected temperature-depth plots from these holes are included in Appendix D.