EBookClubs

Read Books & Download eBooks Full Online

EBookClubs

Read Books & Download eBooks Full Online

Book Two phase Pressure Drop and Phase Distribution at a Reduced Horizontal Tee Junction  the Effect of System Pressure

Download or read book Two phase Pressure Drop and Phase Distribution at a Reduced Horizontal Tee Junction the Effect of System Pressure written by and published by . This book was released on 1905 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: The present investigation generated phase-distribution and pressure-drop data for air-water flows in a reduced horizontal tee junction. This junction consisted of a 38.1-mm I.D. inlet tube with a 7.85-mm I.D. branch tube, thus yielding a diameter ratio of $\rm D\sb3/D\sb1=0.206.$ The operating conditions were as follows: an inlet* pressure of 3.0 bar (abs), an inlet temperature near ambient, an inlet mass flux in the range $\rm 11.5 \le G\sb1\le 181.5\ kg/m\sp2s, $ inlet superficial gas velocities in the range $\rm 2.7\le J\sb{G1}\le 40.1\ m/s, $ superficial liquid velocities in the range $\rm 0.0021\le J\sb{L1}\le 0.0398\ m/s, $ and extraction ratios in the range $\rm 0.049\le W\sb3/W\sb1\le 0.904.$ This combination of inlet conditions led to observed inlet flow regimes of stratified, stratified-wavy, wavy, semiannular, and annular. The present data were compared against those of Walters (1994) under similar conditions with the exception of system (inlet) pressure. (Abstract shortened by UMI.) ftn*The word "inlet, "as used in this thesis, refers to the tee junction inlet.

Book Two phase Pressure Drop and Phase Distribution at a Reduced Horizontal Tee Junction

Download or read book Two phase Pressure Drop and Phase Distribution at a Reduced Horizontal Tee Junction written by Casey A. Van Gorp and published by . This book was released on 1998 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Two phase Pressure Drop and Phase Distribution at Horizontal Tee Junctions

Download or read book Two phase Pressure Drop and Phase Distribution at Horizontal Tee Junctions written by Lori C. Walters and published by . This book was released on 1994 with total page 488 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Two phase Pressure Drop and Phase Distribution in a Horizontal Tee Junction

Download or read book Two phase Pressure Drop and Phase Distribution in a Horizontal Tee Junction written by John R. Buell and published by . This book was released on 1992 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Two phase Flow and Pressure Drop in a Horizontal  Equal sided Combining Tee Junction

Download or read book Two phase Flow and Pressure Drop in a Horizontal Equal sided Combining Tee Junction written by Gavin D. A. Joyce and published by . This book was released on 2016 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: A careful review of the literature showed that there is a serious lack of information (experimental or analytical) on the pressure losses during two-phase flow in combining tee junctions. Pipe networks in industrial applications involve combining and dividing junctions and knowledge of the pressure losses at these junctions is essential for analysis of the flow distribution in the network. To this end, the pressure losses of air-water mixtures passing through a horizontal, combining tee junction with a 37.8 mm diameter were experimentally studied with annular, wavy, and slug flow regimes in the outlet. The test matrix independently varied the outlet flow rates, the outlet mixture qualities, the gas distribution between the inlets, and the liquid distribution between the inlets. All experiments were conducted at room temperature and a nominal absolute pressure at the centre of the junction of 150 kPa. The pressure distribution in all three legs of the tee was determined using up to 49 pressure taps distributed among the three sides and monitored using pressure transducers to produce accurate measurements of the pressure losses. Time-averaged pressure measurements with annular and wavy flows are reported, while pressure measurements with slug flows were not repeatable. A new model and empirical coefficients is presented that allows accurate prediction of pressure losses for flows with either an annular or wavy outlet. Time-varying pressure measurements are presented and analyzed using probability density functions. Different distributions were found for differential measurements depending on whether or not slugging was present in the system. The probability density functions for cases with annular or wavy flow in the outlet followed Gaussian distributions, while cases with slug flow had skewed distributions. Time-varying pressure signals showed a time lag between slug events based on pressure tap locations. A visual study with slug flow present in the system showed upstream travelling waves induced in a stratified inlet when slug flow was present in the other, which led to unexpected slugging under certain flow conditions.

Book Two phase Flow in Horizontal Impacting Tee Junctions

Download or read book Two phase Flow in Horizontal Impacting Tee Junctions written by Ahmed M. F. El-Shaboury and published by . This book was released on 2000 with total page 502 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Phase Distribution and Pressure Drop of Two phase Flows in a Horizontal Impacting Tee Junction

Download or read book Phase Distribution and Pressure Drop of Two phase Flows in a Horizontal Impacting Tee Junction written by Ahmed Mohamed Fathy El-Shaboury and published by . This book was released on 2005 with total page 454 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Phase Distribution and Pressure Drop of Two phase Flows in a Horizontal Impacting Tee Junction

Download or read book Phase Distribution and Pressure Drop of Two phase Flows in a Horizontal Impacting Tee Junction written by Ahmed Mohamed Fathy El-Shaboury and published by . This book was released on 2005 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Two phase Pressure Drop in Piping Components

Download or read book Two phase Pressure Drop in Piping Components written by D. E. Fitzsimmons and published by . This book was released on 1964 with total page 74 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Applied Mechanics Reviews

Download or read book Applied Mechanics Reviews written by and published by . This book was released on 1967 with total page 686 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Two phase Flow Distribution and Pressure Changes for Horizontal Tee Junctions

Download or read book Two phase Flow Distribution and Pressure Changes for Horizontal Tee Junctions written by C. C. St. Pierre and published by . This book was released on 1972 with total page 51 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Pressure Drop in Two phase Flow

Download or read book Pressure Drop in Two phase Flow written by D. H. Weiss and published by . This book was released on 1953 with total page 100 pages. Available in PDF, EPUB and Kindle. Book excerpt: The purpose of this study was to investigate experimentally two-phase flow in a single vertical channel which was uniformly heated. The channel was a 0.174 inches I.D., 24 inches long, electrically heated stainless steel tube through which distilled water was passed.

Book Scientific and Technical Aerospace Reports

Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1995 with total page 702 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Some Problems in Horizontal Two phase Two Component Flow

Download or read book Some Problems in Horizontal Two phase Two Component Flow written by Bobbie L. Richardson and published by . This book was released on 1958 with total page 154 pages. Available in PDF, EPUB and Kindle. Book excerpt: A technique was developed for measuring the volume fraction of each phase, making use of the difference of the attenuation characteristics of the liquid and the vapor for gamma radiation. This technique was evaluated making use of a number of Lucite mockups with known void distributions.