Download or read book Tunable Bulk Acoustic Wave Resonators Based on BaxSr1 xTiO3 Thin Films written by John Berge and published by . This book was released on 2009 with total page 41 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Switchable and Tunable Bulk Acoustic Wave Resonators Based on BaxSr1 xTiO3 Thin Films written by John Berge and published by . This book was released on 2012 with total page 101 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Tuneable Film Bulk Acoustic Wave Resonators written by Spartak Gevorgian and published by Springer Science & Business Media. This book was released on 2013-02-14 with total page 255 pages. Available in PDF, EPUB and Kindle. Book excerpt: To handle many standards and ever increasing bandwidth requirements, large number of filters and switches are used in transceivers of modern wireless communications systems. It makes the cost, performance, form factor, and power consumption of these systems, including cellular phones, critical issues. At present, the fixed frequency filter banks based on Film Bulk Acoustic Resonators (FBAR) are regarded as one of the most promising technologies to address performance -form factor-cost issues. Even though the FBARs improve the overall performances the complexity of these systems remains high. Attempts are being made to exclude some of the filters by bringing the digital signal processing (including channel selection) as close to the antennas as possible. However handling the increased interference levels is unrealistic for low-cost battery operated radios. Replacing fixed frequency filter banks by one tuneable filter is the most desired and widely considered scenario. As an example, development of the software based cognitive radios is largely hindered by the lack of adequate agile components, first of all tuneable filters. In this sense the electrically switchable and tuneable FBARs are the most promising components to address the complex cost-performance issues in agile microwave transceivers, smart wireless sensor networks etc. Tuneable Film Bulk Acoustic Wave Resonators discusses FBAR need, physics, designs, modelling, fabrication and applications. Tuning of the resonant frequency of the FBARs is considered. Switchable and tuneable FBARs based on electric field induced piezoelectric effect in paraelectric phase ferroelectrics are covered. The resonance of these resonators may be electrically switched on and off and tuned without hysteresis. The book is aimed at microwave and sensor specialists in the industry and graduate students. Readers will learn about principles of operation and possibilities of the switchable and tuneable FBARs, and will be given general guidelines for designing, fabrication and applications of these devices.
Download or read book Acoustic Wave and Electromechanical Resonators written by Humberto Campanella and published by Artech House. This book was released on 2010 with total page 364 pages. Available in PDF, EPUB and Kindle. Book excerpt: This groundbreaking book provides you with a comprehensive understanding of FBAR (thin-film bulk acoustic wave resonator), MEMS (microelectomechanical system), and NEMS (nanoelectromechanical system) resonators. For the first time anywhere, you find extensive coverage of these devices at both the technology and application levels. This practical reference offers you guidance in design, fabrication, and characterization of FBARs, MEMS and NEBS. It discusses the integration of these devices with standard CMOS (complementary-metal-oxide-semiconductor) technologies, and their application to sensing and RF systems. Moreover, this one-stop resource looks at the main characteristics, differences, and limitations of FBAR, MEMS, and NEMS devices, helping you to choose the right approaches for your projects. Over 280 illustrations and more than 130 equations support key topics throughout the book.
Download or read book Switchable and Tunable Bulk Acoustic Wave Devices Based on Ferroelectric Material written by Almonir Abdulgader Mansour and published by . This book was released on 2017 with total page 203 pages. Available in PDF, EPUB and Kindle. Book excerpt: The explosive development of personal communications systems, navigation, satellite communications as well as personal computer and data processing systems together with the constant demand for higher speeds and larger bandwidths has driven fabrication technology to its limits. This, in turn, necessitates the development of novel functional materials for the fabrication of devices with superior performance and higher capacity at reduced manufacturing costs. Ferroelectric materials such as barium strontium titanate (BST) and strontium titanium oxide (STO) have received more attention by researchers and industry because of their field-induced piezoelectric property. This property gives these types of ferroelectric materials the ability to be switchable and tunable in the presence of an electric field. These features have allowed the ferroelectric materials to be used in many applications such as non-volatile memory and DRAMs, sensors, pyroelectric detectors, and tunable microwave devices. Therefore, with the ever increasing complexity in RF front-end receivers, and the demand for services (which in turn requires more functionalities), ferroelectric bulk acoustic wave (BAW) resonators and filters that are intrinsically switchable and promise to reduce the size and complexity of component parts. In this work, we present the design, fabrication and experimental evaluation of switchable and tunable thin film bulk acoustic wave (BAW) resonators, filters and duplexers for radio frequency (RF) applications. The switchability and tunability of these devices come from utilizing the electrostrictive effect of ferroelectric materials such as barium strontium titanate (BST) with the application of an external DC-bias voltage. The BAW resonators, filters and duplexers in this work were fabricated on different substrates as solidly mounted resonator (SMR) structure with number of periodic layers of silicon dioxide and tantalum oxide as a Bragg reflector in order to acoustically isolate the resonator from the damping effect of the substrate, enhancing the quality factor and temperature compensation.
Download or read book Dual Mode Thin Film Bulk Acoustic Resonators FBARs Based on AlN ZnO and GaN Films with Tilted C Axis Orientation written by and published by . This book was released on 2010 with total page 91 pages. Available in PDF, EPUB and Kindle. Book excerpt: Thin film bulk acoustic wave resonators (FBAR) using piezoelectric AlN, ZnO and GaN thin films have attracted extensive research activities in the past years. Highly c-axis oriented (normal-plane orientation) binary semiconductor piezoelectric thin films are particularly investigated for resonators operating at the fundamental thickness longitudinal mode. Depending on the processing conditions, tilted polarization (c-axis off the normal direction to the substrate surface) is often found in the as-deposited piezoelectric thin films, which leads to the coexistence of thickness longitudinal mode and shear mode for the thin film resonators.
Download or read book Fabrication of Electronically Switchable and Tunable Bulk Acoustic Wave Resonators with Graphene Electrodes written by Wei Liu and published by . This book was released on 2017 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book High Coupling Materials for Thin Film Bulk Acoustic Wave Resonators written by Janine Conde and published by . This book was released on 2009 with total page 157 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book High Frequency Thin film Bulk Acoustic Wave Resonators for Gas and Bio analytical Applications written by G. M. Ashley and published by . This book was released on 2005 with total page 380 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Thin Film Bulk Acoustic Wave Devices written by Tuomas Pensala and published by . This book was released on 2011 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Thin film bulk acoustic wave (BAW) resonators and filters operating in the GHz range are used in mobile phones for the most demanding filtering applications and complement the surface acoustic wave (SAW) based filters. Their main advantages are small size and high performance at frequencies above 2 GHz. This work concentrates on the characterization, performance optimization, and modelling techniques of thin film BAW devices. Laser interferometric vibration measurements together with plate wave dispersion modeling are used to extract the full set of elastic material parameters for sputter deposited ZnO, demonstrating a method for obtaining material data needed for accurate simulation of the devices. The effectiveness of the acoustic interference reflector used to isolate the vibration from the substrate is studied by 1-D modeling, 2-D finite element method and by electrical and laser interferometric measurements. It is found that the Q-value of reflector-based BAW resonators operating at 2 GHz is limited to approximately 2000 by mechanisms other than leakage through the reflector. Suppression of spurious resonances in ZnO resonators is studied in depth by modeling and measurements. It is verified that the approximate mode orthogonality is behind the suppression in boundary frame type ZnO devices operating in the piston mode, but also another narrow band mode suppression mechanism is found. A plate wave dispersion based 2-D simulation scheme for laterally acoustically coupled BAW resonator filters is developed and employed in designing of experimental devices, which show both good agreement with the model predictions and a remarkable 4.9 % relative bandwidth.
Download or read book Progress in the Development of Miniature Thin Film BAW Resonator and Filter Technology written by T. W. Grudkowski and published by . This book was released on 1982 with total page 12 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fundamental mode bulk acoustic wave resonators and filters have been fabricated from ZnO/Si composite thin films prepared by sputter depositing c-axis oriented polycrystalline ZnO onto single crystal silicon. Resonant frequencies of these devices, which are compatible with silicon IC technology, can be readily controlled in the 100 MHz to 1000 MHz range. Development of improved fabrication procedures is described, emphasizing the importance of smooth resonator surfaces and precise control of ZnO sputtering conditions. Chemical etch treatments of the ZnO is shown to markedly reduce spurious resonances. Device modeling theory is described and the good agreement between experimental data and theory is discussed. Filter insertion loss as low as 4.1 dB and bandwidths between 0.5 and 5 percent have been achieved, Q values as high as 2700 were observed, and out of band rejection of 45 dB was realized. (Author.
Download or read book Ferroelectrics written by Mickaël Lallart and published by BoD – Books on Demand. This book was released on 2011-08-23 with total page 266 pages. Available in PDF, EPUB and Kindle. Book excerpt: Ferroelectric materials have been and still are widely used in many applications, that have moved from sonar towards breakthrough technologies such as memories or optical devices. This book is a part of a four volume collection (covering material aspects, physical effects, characterization and modeling, and applications) and focuses on the application of ferroelectric devices to innovative systems. In particular, the use of these materials as varying capacitors, gyroscope, acoustics sensors and actuators, microgenerators and memory devices will be exposed, providing an up-to-date review of recent scientific findings and recent advances in the field of ferroelectric devices.
Download or read book Polar Oxides written by Rainer Waser and published by John Wiley & Sons. This book was released on 2006-03-06 with total page 391 pages. Available in PDF, EPUB and Kindle. Book excerpt: Here, more than 20 experts from leading research institutes around the world present the entire scope of this rapidly developing field. In so doing, they cover a wide range of topics, including the characterization and investigation of structural, dielectric and piezoelectric properties of ceramic materials, a well as phase transitions, electrical and optical properties and microscopic investigations. Another feature is a complete profile of the properties of polar oxides -- from their proof to their latest applications. Throughout, the authors review, discuss and assess the material properties with regard to new and advanced characterization and imaging techniques. For physicists, physicochemists, semiconductor and solid state physicists, materials scientists, and students of chemistry and physics.
Download or read book Ferroelectric Thin Films written by Carlos Paz de Araujo and published by Taylor & Francis. This book was released on 1996 with total page 596 pages. Available in PDF, EPUB and Kindle. Book excerpt: The impetus for the rapid development of thin film technology, relative to that of bulk materials, is its application to a variety of microelectronic products. Many of the characteristics of thin film ferroelectric materials are utilized in the development of these products - namely, their nonvolatile memory and piezoelectric, pyroelectric, and electro-optic properties. It is befitting, therefore, that the first of a set of three complementary books with the general title Integrated Ferroelectric Devices and Technologies focuses on the synthesis of thin film ferroelectric materials and their basic properties. Because it is a basic introduction to the chemistry, materials science, processing, and physics of the materials from which integrated ferroelectrics are made, newcomers to this field as well as veterans will find this book self-contained and invaluable in acquiring the diverse elements requisite to success in their work in this area. It is directed at electronic engineers and physicists as well as process and system engineers, ceramicists, and chemists involved in the research, design, development, manufacturing, and utilization of thin film ferroelectric materials.
Download or read book Integration of Functional Oxides with Semiconductors written by Alexander A. Demkov and published by Springer Science & Business Media. This book was released on 2014-02-20 with total page 284 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book describes the basic physical principles of the oxide/semiconductor epitaxy and offers a view of the current state of the field. It shows how this technology enables large-scale integration of oxide electronic and photonic devices and describes possible hybrid semiconductor/oxide systems. The book incorporates both theoretical and experimental advances to explore the heteroepitaxy of tuned functional oxides and semiconductors to identify material, device and characterization challenges and to present the incredible potential in the realization of multifunctional devices and monolithic integration of materials and devices. Intended for a multidisciplined audience, Integration of Functional Oxides with Semiconductors describes processing techniques that enable atomic-level control of stoichiometry and structure and reviews characterization techniques for films, interfaces and device performance parameters. Fundamental challenges involved in joining covalent and ionic systems, chemical interactions at interfaces, multi-element materials that are sensitive to atomic-level compositional and structural changes are discussed in the context of the latest literature. Magnetic, ferroelectric and piezoelectric materials and the coupling between them will also be discussed. GaN, SiC, Si, GaAs and Ge semiconductors are covered within the context of optimizing next-generation device performance for monolithic device processing.
Download or read book Nonlinearities in Periodic Structures and Metamaterials written by Cornelia Denz and published by Springer. This book was released on 2010-03-11 with total page 299 pages. Available in PDF, EPUB and Kindle. Book excerpt: Optical information processing of the future is associated with a new generation of compact nanoscale optical devices operating entirely with light. Moreover, adaptive features such as self-guiding, reconfiguration and switching become more and more important. Nonlinear devices offer an enormous potential for these applications. Consequently, innovative concepts for all-optical communication and information technologies based on nonlinear effects in photonic-crystal physics and nanoscale devices as metamaterials are of high interest. This book focuses on nonlinear optical phenomena in periodic media, such as photonic crystals, optically-induced, adaptive lattices, atomic lattices or metamaterials. The main purpose is to describe and overview new physical phenomena that result from the interplay between nonlinearities and structural periodicities and is a guide to actual and future developments for the expert reader in optical information processing, as well as in the physics of cold atoms in optical lattices.
Download or read book Infrared Detectors and Emitters Materials and Devices written by Peter Capper and published by Springer Science & Business Media. This book was released on 2013-11-27 with total page 500 pages. Available in PDF, EPUB and Kindle. Book excerpt: An up-to-date view of the various detector/emitter materials systems currently in use or being actively researched. The book is aimed at newcomers and those already working in the IR industry. It provides both an introductory text and a valuable overview of the entire field.
