Download or read book Thermal Vacuum Facility for Testing Thermal Protection Systems written by Kamran Daryabeigi and published by . This book was released on 2002 with total page 24 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Thermal Vacuum Facility for Testing Thermal Protection Systems written by National Aeronautics and Space Administration (NASA) and published by Createspace Independent Publishing Platform. This book was released on 2018-06-19 with total page 36 pages. Available in PDF, EPUB and Kindle. Book excerpt: A thermal vacuum facility for testing launch vehicle thermal protection systems by subjecting them to transient thermal conditions simulating re-entry aerodynamic heating is described. Re-entry heating is simulated by controlling the test specimen surface temperature and the environmental pressure in the chamber. Design requirements for simulating re-entry conditions are briefly described. A description of the thermal vacuum facility, the quartz lamp array and the control system is provided. The facility was evaluated by subjecting an 18 by 36 in. Inconel honeycomb panel to a typical re-entry pressure and surface temperature profile. For most of the test duration, the average difference between the measured and desired pressures was 1.6% of reading with a standard deviation of +/- 7.4%, while the average difference between measured and desired temperatures was 7.6% of reading with a standard deviation of +/- 6.5%. The temperature non-uniformity across the panel was 12% during the initial heating phase (t less than 500 sec.), and less than 2% during the remainder of the test. Daryabeigi, Kamran and Knutson, Jeffrey R. and Sikora, Joseph G. Langley Research Center NASA/TM-2002-211734, NAS 1.15:211734, L-18163
Download or read book An Automated Thermal Vacuum Test System for Use in Environmental Testing of Flight Systems and Components written by Craig S. Cleckner and published by . This book was released on 1991 with total page 34 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Langley Thermal Protection System Test Facility A Description Including Design Operating Boundaries written by and published by . This book was released on 1976 with total page 44 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book In flight Load Testing of Advanced Shuttle Thermal Protection Systems written by and published by . This book was released on 1983 with total page 18 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Thermoacoustic Fatigue Testing Facility for Space Shuttle Thermal Protection System written by RE. Grandle and published by . This book was released on 1973 with total page 9 pages. Available in PDF, EPUB and Kindle. Book excerpt: The development of a reusable space shuttle by NASA in the next decade depends in part on the design of a satisfactory thermal protection system (TPS). The booster and orbiter parts of the shuttle require TPS panels which will withstand thermoacoustic fatigue. The Langley Research Center has begun tests on early panel designs in a new acoustic fatigue facility which is capable of simulating the combined elevated temperature and acoustic environments which these panels are expected to experience. The capabilities of the facility and computer system are outlined, and problems encountered in establishing the test methods are discussed. The digital computer system which controls the acoustic and thermal test sequence and which records data from more than 20 transducers is described. Tests of a Haynes 25 TPS panel are described, and representative data from tests of the panel at 650 C are included.
Download or read book Current Technology for Thermal Protection Systems written by and published by . This book was released on 1992 with total page 336 pages. Available in PDF, EPUB and Kindle. Book excerpt: Summarizes the history and operational experience of thermal protection systems utilized in the national space program, and also covers development efforts in thermal insulation, refractory materials and coatings, actively cooled structures, and two-phase thermal control systems.
Download or read book Thermal Protection Systems Aspects of Thermal Protection of Interest to NASA and the Related Materials R and D Requirements written by and published by . This book was released on 1962 with total page 204 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book A Thermal Vacuum Test for the Screening of Space Materials written by European Space Research and Technology Centre. Product Assurance and Safety Department and published by . This book was released on 1994 with total page 27 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Reusable Launch Vehicle written by Committee on Reusable Launch Vehicle Technology and Test Program and published by National Academies Press. This book was released on 1996-01-22 with total page 99 pages. Available in PDF, EPUB and Kindle. Book excerpt: The key to opening the use of space to private enterprise and to broader public uses lies in reducing the cost of the transportation to space. More routine, affordable access to space will entail aircraft-like quick turnaround and reliable operations. Currently, the space Shuttle is the only reusable launch vehicle, and even parts of it are expendable while other parts require frequent and extensive refurbishment. NASA's highest priority new activity, the Reusable Launch Vehicle program, is directed toward developing technologies to enable a new generation of space launchers, perhaps but not necessarily with single stage to orbit capability. This book assesses whether the technology development, test and analysis programs in propulsion and materials-related technologies are properly constituted to provide the information required to support a December 1996 decision to build the X-33, a technology demonstrator vehicle; and suggest, as appropriate, necessary changes in these programs to ensure that they will support vehicle feasibility goals.
Download or read book Ultralight Fabric Reflux Tube Ufrt Thermal Vacuum Test written by National Aeronautics and Space Adm Nasa and published by . This book was released on 2018-11-18 with total page 158 pages. Available in PDF, EPUB and Kindle. Book excerpt: Spacecraft thermal control systems are essential to provide the necessary environment for the crew and equipment to function adequately on space missions. The Ultralight Fabric Reflux Tube (UFRT) was developed by Pacific Northwest Laboratory (PNL) as a lightweight radiator concept to be used on planetary-type missions (e.g., Moon, Mars). The UFRT consists of a thin-walled tube (acting as the fluid boundary), overwrapped with a low-mass ceramic fabric (acting as the primary pressure boundary). The tubes are placed in an array in the vertical position with the evaporators at the lower end. Heat is added to the evaporators, which vaporizes the working fluid. The vapor travels to the condenser end above and cools as heat is radiated to the environment. The fluid condensed on the tube wall is then returned to the evaporator by gravity. The primary objectives for the fiscal year 1994 program included the design and fabrication of prototype UFRTs and thermal/vacuum chamber testing of these test articles. Six UFRTS, with improved titanium liners, were successfully manufactured and provided to the Johnson Space Center in July 1994. Five were tested in a thermal/vacuum chamber in September 1994. Data obtained to characterize the performance of the UFRTs under simulated lunar conditions demonstrated the design concept successfully. In addition, a trade study showed that an optimized/improved UFRT could achieve as much as a 25% mass savings in the heat rejection subsystem of future planetary-type thermal control systems. Hurlbert, K. M. and Ewert, M. K. and Graf, J. P. and Keller, J. R. and Pauley, K. A. and Guenther, R. J. and Antoniak, Z. I. Johnson Space Center TEMPERATURE CONTROL; SPACECRAFT ENVIRONMENTS; THERMAL VACUUM TESTS; HEAT RADIATORS; HEAT PIPES; SPACECRAFT TEMPERATURE; VENTILATION; CERAMICS; VACUUM CHAMBERS; THERMAL PROTECTION; LUNAR BASES; FABRICS; THIN WALLS; SPACE MISSIONS; VENTS...
Download or read book Apollo Telescope Mount Thermal Systems Unit Thermal Vacuum Test written by H. F. Trucks and published by . This book was released on 1972 with total page 76 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Apollo Telescope Mount's thermal systems unit was utilized to conduct a full-scale thermal vacuum test to verify the thermal design and the analytical techniques used to develop the thermal mathematical models. Thermal vacuum test philosophy, test objectives configuration, test monitoring, environment simulation, vehicle test performance, and data correlation are discussed. Emphasis is placed on planning and execution of the thermal vacuum test with particular attention on problems encountered in conducting a test of this maguitude.
Download or read book Space Systems Thermal Vacuum Environmental Testing written by British Standards Institution and published by . This book was released on 2023 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Chamber B Thermal Vacuum Chamber written by Mike E. Montz and published by BiblioGov. This book was released on 2013-07 with total page 54 pages. Available in PDF, EPUB and Kindle. Book excerpt: Test process, milestones and inputs are unknowns to first-time users of Chamber B. The User Test Planning Guide aids in establishing expectations for both NASA and non-NASA facility customers. The potential audience for this guide includes both internal and commercial spaceflight hardware/software developers. It is intended to assist their test engineering personnel in test planning and execution. Material covered includes a roadmap of the test process, roles and responsibilities of facility and user, major milestones, facility capabilities, and inputs required by the facility. Samples of deliverables, test article interfaces, and inputs necessary to define test scope, cost, and schedule are included as an appendix to the guide.
Download or read book Technical Facilities Catalog written by United States. National Aeronautics and Space Administration and published by . This book was released on 1974 with total page 700 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Development of a Thermal Vacuum Chamber for Propulsion System Testing written by Mona Issa and published by . This book was released on with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: With the advent of small satellites, including CubeSats, and their widespread use in industry and educational institutions, testing facilities are required to accommodate, in complexity, size, and cost, the miniaturisation of spacecraft. Conducting thermal-vacuum tests on Electric Propulsion Systems used in small satellites poses the limitation of needing a path for the thruster beam to safely reach its target, thus complicating the process of designing a thermal shroud that could completely enclose the thruster. This project comprised the evaluation of a TVC setup with an open thermal shroud through experimental testing and numerical analysis. Following this evaluation an improved design of a thermal shroud for testing electric thrusters was developed and validated through numerical and experimental methods. The final design produced satisfactory results, where the thermal shroud, and in turn the test satellite were able to reach desired temperatures when the satellite was dissipating low or no heat. However, as the heat dissipated from the satellite was raised the cooling performance of the thermal shroud was less effective. Nevertheless with the improved shroud design the major drawbacks of the setup were eliminated, such as a large temperature jump at the interface between the shroud and the thermal plate, and temperature range achievable was improved.
Download or read book Thermal Vacuum Test Facility written by K. M. Miller and published by . This book was released on 1984 with total page 113 pages. Available in PDF, EPUB and Kindle. Book excerpt: An important part of development of electronic packages for space use is verification of performance under expected environmental conditions. The system developed at NRL is designed to provide thermal vacuum testing of atomic clocks in the Global Positioning System (GPS). It is capable of testing all pertinent clock parameters in a preprogrammed sequence. Test durations from minutes to months may be selected. Real time as well as historical data presentation and reductions are available. (Author).