Download or read book The Influence of Low Wall Temperature on Boundary layer Transition and Local Heat Transfer on 2 inch diameter Hemispheres at a Mach Number of 4 95 and a Reynolds Number Per Foot of 73 2 X 106 written by Morton Cooper and published by . This book was released on 1960 with total page 42 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book A Review of High speed Convective Heat transfer Computation Methods written by Michael E. Tauber and published by . This book was released on 1989 with total page 44 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Convective Heat Transfer in Planetary Gases written by Joseph G. Marvin and published by . This book was released on 1965 with total page 60 pages. Available in PDF, EPUB and Kindle. Book excerpt: Equilibrium convective heat transfer in several real gases was investigated. The gases considered were air, nitrogen, hydrogen, carbon dioxide, and argon. Solutions to the similar form of the boundary-layer equations were obtained for flight velocities to 30,000 ft/sec for a range of parameters sufficient to define the effects of pressure level, pressure gradient, boundary-layer-edge velocity, and wall temperature. Results are presented for stagnation-point heating and for the heating-rate distribution. For the range of parameters investigated the wall heat transfer depended on the transport properties near the wall and precise evaluation of properties in the high-energy portions of the boundary layer was not needed. A correlation of the solutions to the boundary-layer equations was obtained which depended only on the low temperature properties of the gases. This result can be used to evaluate the heat transfer in gases other than those considered. The largest stagnation-point heat transfer at a constant flight velocity was obtained for argon followed successively by carbon dioxide, air, nitrogen, and hydrogen. The blunt-body heating-rate distribution was found to depend mainly on the inviscid flow field. For each gas, correlation equations of boundary-layer thermodynamic and transport properties as a function of enthalpy are given for a wide range of pressures to a maximum enthalpy of 18,000 Btu/lb.
Download or read book Physical and Computational Aspects of Convective Heat Transfer written by T. Cebeci and published by Springer Science & Business Media. This book was released on 2013-04-18 with total page 497 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume is concerned with the transport of thermal energy in flows of practical significance. The temperature distributions which result from convective heat transfer, in contrast to those associated with radiation heat transfer and conduction in solids, are related to velocity characteristics and we have included sufficient information of momentum transfer to make the book self-contained. This is readily achieved because of the close relation ship between the equations which represent conservation of momentum and energy: it is very desirable since convective heat transfer involves flows with large temperature differences, where the equations are coupled through an equation of state, as well as flows with small temperature differences where the energy equation is dependent on the momentum equation but the momentum equation is assumed independent of the energy equation. The equations which represent the conservation of scalar properties, including thermal energy, species concentration and particle number density can be identical in form and solutions obtained in terms of one dependent variable can represent those of another. Thus, although the discussion and arguments of this book are expressed in terms of heat transfer, they are relevant to problems of mass and particle transport. Care is required, however, in making use of these analogies since, for example, identical boundary conditions are not usually achieved in practice and mass transfer can involve more than one dependent variable.
Download or read book Hypersonic and High Temperature Gas Dynamics written by John David Anderson and published by AIAA. This book was released on 1989 with total page 710 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book is a self-contained text for those students and readers interested in learning hypersonic flow and high-temperature gas dynamics. It assumes no prior familiarity with either subject on the part of the reader. If you have never studied hypersonic and/or high-temperature gas dynamics before, and if you have never worked extensively in the area, then this book is for you. On the other hand, if you have worked and/or are working in these areas, and you want a cohesive presentation of the fundamentals, a development of important theory and techniques, a discussion of the salient results with emphasis on the physical aspects, and a presentation of modern thinking in these areas, then this book is also for you. In other words, this book is designed for two roles: 1) as an effective classroom text that can be used with ease by the instructor, and understood with ease by the student; and 2) as a viable, professional working tool for engineers, scientists, and managers who have any contact in their jobs with hypersonic and/or high-temperature flow.
Download or read book Handbook of Supersonic Aerodynamics written by Johns Hopkins University. Applied Physics Laboratory, Silver Spring, Md and published by . This book was released on 1961 with total page 516 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Rules of Thumb for Mechanical Engineers written by J. Edward Pope and published by Gulf Professional Publishing. This book was released on 1997 with total page 417 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fluids -- Heat transfer -- Thermodynamics -- Mechanical seals -- Pumps and compressors -- Drivers -- Gears -- Bearings -- Piping and pressure vessels -- Tribology -- Vibration -- Materials -- Stress and strain -- Fatigue -- Instrumentation -- Engineering economics.
Download or read book Handbook of Hydraulic Resistance written by I. E. Idelchik and published by . This book was released on 2005 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: The handbook has been composed on the basis of processing, systematization and classification of the results of a great number of investigations published at different time. The essential part of the book is the outcome of investigations carried out by the author. The present edition of this handbook should assist in increasing the quality and efficiency of the design and usage of indutrial power engineering and other constructions and also of the devices and apparatus through which liquids and gases move.
Download or read book Hot wire Anemometry written by Anthony Edward Perry and published by Oxford University Press, USA. This book was released on 1982 with total page 216 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book High speed Wind Tunnels written by Luigi Crocco and published by . This book was released on 1946 with total page 236 pages. Available in PDF, EPUB and Kindle. Book excerpt: The importance assumed in recent times by experimental supersonic wind tunnels, as well as the power required, has brought about the need for a study which would permit a comparison of the types tested and the principal theoretical plans.
Download or read book Fundamentals of Momentum Heat and Mass Transfer written by James R. Welty and published by . This book was released on 1976 with total page 828 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book A Physical Introduction to Fluid Mechanics written by Alexander J. Smits and published by Wiley-VCH. This book was released on 2000 with total page 552 pages. Available in PDF, EPUB and Kindle. Book excerpt: Uncover Effective Engineering Solutions to Practical Problems With its clear explanation of fundamental principles and emphasis on real world applications, this practical text will motivate readers to learn. The author connects theory and analysis to practical examples drawn from engineering practice. Readers get a better understanding of how they can apply these concepts to develop engineering answers to various problems. By using simple examples that illustrate basic principles and more complex examples representative of engineering applications throughout the text, the author also shows readers how fluid mechanics is relevant to the engineering field. These examples will help them develop problem-solving skills, gain physical insight into the material, learn how and when to use approximations and make assumptions, and understand when these approximations might break down. Key Features of the Text * The underlying physical concepts are highlighted rather than focusing on the mathematical equations. * Dimensional reasoning is emphasized as well as the interpretation of the results. * An introduction to engineering in the environment is included to spark reader interest. * Historical references throughout the chapters provide readers with the rich history of fluid mechanics.
Download or read book Chemical Engineering Fluid Mechanics written by Ron Darby and published by CRC Press. This book was released on 2016-11-30 with total page 547 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book provides readers with the most current, accurate, and practical fluid mechanics related applications that the practicing BS level engineer needs today in the chemical and related industries, in addition to a fundamental understanding of these applications based upon sound fundamental basic scientific principles. The emphasis remains on problem solving, and the new edition includes many more examples.
Download or read book Boundary Layer Flows written by Vallampati Ramachandra Prasad and published by BoD – Books on Demand. This book was released on 2020-01-22 with total page 236 pages. Available in PDF, EPUB and Kindle. Book excerpt: Written by experts in the field, this book, "Boundary Layer Flows - Theory, Applications, and Numerical Methods" provides readers with the opportunity to explore its theoretical and experimental studies and their importance to the nonlinear theory of boundary layer flows, the theory of heat and mass transfer, and the dynamics of fluid. With the theory's importance for a wide variety of applications, applied mathematicians, scientists, and engineers - especially those in fluid dynamics - along with engineers of aeronautics, will undoubtedly welcome this authoritative, up-to-date book.
Download or read book Hypersonic Flow Theory written by Wallace Hayes and published by Elsevier. This book was released on 2012-12-02 with total page 481 pages. Available in PDF, EPUB and Kindle. Book excerpt: Hypersonic Flow Theory presents the fundamentals of fluid mechanics, focusing on the hypersonic flow theory and approaches in theoretical aerodynamics. This book discusses the assumptions underlying hypersonic flow theory, unified supersonic-hypersonic similitude, two-dimensional and axisymmetric bodies, and circular cylinder. The constant-streamtube-area approximation, streamtube-continuity methods, and tangent-wedge and tangent-cone are also deliberated. This text likewise covers the similar laminar boundary layer solutions, bluntness induced interactions on slender bodies, and free molecule transfer theory. The dynamics of hypersonic flight or hypersonic wing theory, magnetohydrodynamic theory, or any developments involving treatment of the Boltzmann equation are not included. This publication is intended for hypersonic aerodynamicists, students, and researchers conducting work on the hypersonic flow phenomena.
Download or read book Prandtl s Essentials of Fluid Mechanics written by Herbert Oertel and published by Springer Science & Business Media. This book was released on 2006-04-18 with total page 731 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book is an update and extension of the classic textbook by Ludwig Prandtl, Essentials of Fluid Mechanics. It is based on the 10th German edition with additional material included. Chapters on wing aerodynamics, heat transfer, and layered flows have been revised and extended, and there are new chapters on fluid mechanical instabilities and biomedical fluid mechanics. References to the literature have been kept to a minimum, and the extensive historical citations may be found by referring to previous editions. This book is aimed at science and engineering students who wish to attain an overview of the various branches of fluid mechanics. It will also be useful as a reference for researchers working in the field of fluid mechanics.
Download or read book Laminar Flow Control Technology written by and published by . This book was released on 1979 with total page 8 pages. Available in PDF, EPUB and Kindle. Book excerpt:
