Download or read book The fatigue crack growth behaviour of super duplex stainless steel zeron 100 written by Ritsuko Tsuzuki and published by . This book was released on 1999 with total page 52 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Aspects of fatigue crack propagation behaviour of duplex stainless steels written by Muyiwa Christopher Mayaki and published by . This book was released on 1989 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book The Low Temperature Fracture Behaviour of the Super Duplex Stainless Steel Zeron 100 written by Alan Owen Humphreys and published by . This book was released on 1997 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Influence of Temperature and Microstructure on the Fatigue Behaviour in the Threshold Regime for a Super Duplex Stainless Steel written by S. Hansson and published by . This book was released on 2005 with total page 11 pages. Available in PDF, EPUB and Kindle. Book excerpt: The fatigue crack propagation behaviour of a super duplex stainless steel in the near threshold regime at -50°C, 20°C (RT) and 150°C has been studied. The fatigue threshold values of the stress intensity factor range and the effective threshold value of this material are higher at -50°C and 150°C than at RT. The closure threshold value is also smaller at RT than at -50°C, but comparable with that at 150°C. The material aged at 475°C for 3 hours shows similar effective threshold value, but a smaller closure threshold value. Crack propagation mismatch at the interface of the two phases and brittle to ductile fracture transition in the material at -50°C or in the aged material at RT were observed, and possible mechanisms were discussed.

Download or read book Fatigue Crack Growth of Duplex Stainless Steels written by Magnus Nyström and published by . This book was released on 1991 with total page 50 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Fatigue Crack Growth Behaviour of Explosively Bonded Stainless Steel Clad Steel Plate written by K Ogura and published by . This book was released on 1990 with total page 12 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Fatigue Crack Growth Behaviour in Proton Irradiated Austenitic Stainless Steel written by Rory Spencer and published by . This book was released on 2019 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Near threshold Fatigue Crack Growth Behavior of 304 Stainless Steel written by William Barry Zagrany and published by . This book was released on 1987 with total page 74 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Fatigue Crack Growth Analysis of Stainless Steel Under Mode 1 written by Ahmad Azam Azizan Azlan and published by . This book was released on 2010 with total page 68 pages. Available in PDF, EPUB and Kindle. Book excerpt: Stainless steel is widely used in the industries nowadays due to their good properties of resistance to corrosion and rust. Due to its application in many industries, an analysis of fatigue crack growth was carried out to study the effect of stress ratio. The study of fatigue crack growth is important since fatigue has become a critical issue in industries that plague any structures that is subjected to cyclic and variable loading. A necessary analysis of fatigue crack growth need to be done to study the behaviour of fatigue crack growth. The effect of stress ratio on fatigue crack growth can affect the behavior of fatigue crack growth. In the project, three different stress ratios were used to investigate the effect of stress ratio towards crack growth. As the stress ratio increase, the stress intensity threshold and fracture toughness will decrease. This shows that an increasing stress ratio will lead to material failure. This happens when the stress intensity factor has entered the critical region where it exceeds the fracture toughness value. To remain the material unbroken or fail, the stress intensity factor value must not exceed the value of stress intensity threshold where below the stress intensity threshold value, the material remains stable. An analysis of fatigue crack growth was done using MSC software where the stress analysis is done using MSC PATRAN and MSC NASTRAN. After the results of stress analysis were obtained, the analysis of fatigue crack growth with different stress ratio was done using MSC FATIGUE software. Life prediction of the material is determined using Modified Paris Law equation of Fracture Mechanics. At certain level of stresses, below the endurance limit of the material, the effect of stress ratio does not affecting the life of the material. This is because the stress is not big enough to break the material.

Download or read book ASM Handbook written by ASM International. Handbook Committee and published by . This book was released on 1990 with total page 1080 pages. Available in PDF, EPUB and Kindle. Book excerpt: These volumes cover the properties, processing, and applications of metals and nonmetallic engineering materials. They are designed to provide the authoritative information and data necessary for the appropriate selection of materials to meet critical design and performance criteria.

Download or read book Influence of Microstructure on the Fatigue and Corrosion Fatigue Crack Growth Behavior of 17 4 Precipitation Hardening Stainless Steel written by Kenneth Lee Money and published by . This book was released on 1978 with total page 274 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Fatigue Crack Growth Behavior of Different Stainless Steels in Pressurized Water Reactor Environments written by C. Amzallag and published by . This book was released on 1990 with total page 32 pages. Available in PDF, EPUB and Kindle. Book excerpt: An experimental program has been conducted in order to determine the fatigue crack growth rate (FCGR) curves of different stainless steels for nuclear pressure vessels and pipings in pressurized water reactor environments and to define reference fatigue crack growth rate curves for these materials. The parameters studied are: the steel structure, the load ratio (R), and the water chemistry. A slight, but clear effect of environment was observed for the five steels studied. The paper presents the FCGR curves and the fractographic examinations for the different testing conditions and stresses the differences between FCGR behavior of stainless steels and low-alloy steels.

Download or read book Fatigue Crack Growth Behavior of Stainless Steel Type 316 Plate and 16 8 2 Weldments in Air and High carbon Liquid Sodium written by J. L. Yuen and published by . This book was released on 1979 with total page 13 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Metals Abstracts written by and published by . This book was released on 1999 with total page 1014 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Fatigue Crack Growth Behavior and Overload Effect of AISI 304 Stainless Steel in Different Atmospheres written by Mehmet Halidun Keleștemur and published by . This book was released on 1998 with total page 304 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Specimen Size considerations in Fatigue Crack Growth Rate Testing written by and published by . This book was released on 1979 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: The effect of specimen size upon the fatigue-crack growth behavior of annealed AISI Type 304 stainless steel was studied at two stress ratios at an elevated temperature. The resulting data were examined in the light of the present ASTM size criterion (based upon monotonic yield stength) as well as a proposed criterion based upon the material flow strength. The flow stress criterion is considerably less restrictive than the present ASTM Criterion, and the results of this study indicate that the flow stress criterion is entirely appropriate for strain-hardening materials such as the austenitic stainless steels.

Download or read book Hydrogen Effects in Materials written by Anthony W. Thompson and published by John Wiley & Sons. This book was released on 2013-09-27 with total page 1303 pages. Available in PDF, EPUB and Kindle. Book excerpt: Proceedings of the Fifth International Conference on the Effect of Hydrogen on the Behavior of Materials sponsored by the Structural Materials Division (SMD) Mechanical Metallurgy and Corrosion & Environmental Effects Committees of The Minerals, Metals & Materials Society held at Jackson Lake Lodge, Moran, Wyoming, September 11-14, 1994.