Download or read book Simulations of Intermediate Density Laser Fusion Targets written by and published by . This book was released on 1977 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: The attainment of low-adiabat compression to high final state density is essential for achieving high gain thermonuclear micro-implosions. Using 1- and 2-dimensional numerical simulations with LASNEX, the target performance which can be expected and the limitations imposed by absorption heating, and transport for targets designed to reach 100 x liquid DT density (20g/cm3) are discussed. The requirements imposed by the need for low preheat, adequate implosion symmetry, and the behavior of fluid instabilities are discussed for these recent target designs. Methods for diagnosis of density are discussed.
Download or read book Fusion Energy Update written by and published by . This book was released on 1982-04 with total page 170 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Assessment of Inertial Confinement Fusion Targets written by National Research Council and published by National Academies Press. This book was released on 2013-07-17 with total page 119 pages. Available in PDF, EPUB and Kindle. Book excerpt: In the fall of 2010, the Office of the U.S. Department of Energy's (DOE's) Secretary for Science asked for a National Research Council (NRC) committee to investigate the prospects for generating power using inertial confinement fusion (ICF) concepts, acknowledging that a key test of viability for this concept-ignition -could be demonstrated at the National Ignition Facility (NIF) at Lawrence Livermore National Laboratory (LLNL) in the relatively near term. The committee was asked to provide an unclassified report. However, DOE indicated that to fully assess this topic, the committee's deliberations would have to be informed by the results of some classified experiments and information, particularly in the area of ICF targets and nonproliferation. Thus, the Panel on the Assessment of Inertial Confinement Fusion Targets ("the panel") was assembled, composed of experts able to access the needed information. The panel was charged with advising the Committee on the Prospects for Inertial Confinement Fusion Energy Systems on these issues, both by internal discussion and by this unclassified report. A Panel on Fusion Target Physics ("the panel") will serve as a technical resource to the Committee on Inertial Confinement Energy Systems ("the Committee") and will prepare a report that describes the R&D challenges to providing suitable targets, on the basis of parameters established and provided to the Panel by the Committee. The Panel on Fusion Target Physics will prepare a report that will assess the current performance of fusion targets associated with various ICF concepts in order to understand: 1. The spectrum output; 2. The illumination geometry; 3. The high-gain geometry; and 4. The robustness of the target design. The panel addressed the potential impacts of the use and development of current concepts for Inertial Fusion Energy on the proliferation of nuclear weapons information and technology, as appropriate. The Panel examined technology options, but does not provide recommendations specific to any currently operating or proposed ICF facility.
Download or read book Energy Research Abstracts written by and published by . This book was released on 1993 with total page 754 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Numerical Simulation of Laser Fusion Plasmas Using a Reduced Description Formalism written by Rickey James Faehl and published by . This book was released on 1977 with total page 442 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Pressure Ionization in Laser fusion Target Simulation written by and published by . This book was released on 1978 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Accurate simulation of high density target implosion requires material properties (ionization, pressure, energy, opacity, and transport coefficients) at densities where bound electrons are significantly perturbed by neighboring atoms. In the LASNEX code, this data is supplied by tables and/or calculated from a Stromgren model for ionization equilibrium. Improvements have been made in this model which aim at assuring thermodynamic consistency and obtaining better agreement with more elaborate calculations. Arbitrary degeneracy is allowed for the free electrons. Consistent Coulomb contributions to pressure and continuum lowering are obtained. A new pressure ionization scheme merges bound electrons into the continuum as a smooth function of density and the corresponding contribution to pressure is calculated. Results are shown for aluminum.
Download or read book Frontiers in High Energy Density Physics written by National Research Council and published by National Academies Press. This book was released on 2003-05-11 with total page 177 pages. Available in PDF, EPUB and Kindle. Book excerpt: Recent scientific and technical advances have made it possible to create matter in the laboratory under conditions relevant to astrophysical systems such as supernovae and black holes. These advances will also benefit inertial confinement fusion research and the nation's nuclear weapon's program. The report describes the major research facilities on which such high energy density conditions can be achieved and lists a number of key scientific questions about high energy density physics that can be addressed by this research. Several recommendations are presented that would facilitate the development of a comprehensive strategy for realizing these research opportunities.
Download or read book A1 5 Fusion Performance written by and published by . This book was released on 2011 with total page 9 pages. Available in PDF, EPUB and Kindle. Book excerpt: Analysis and radiation hydrodynamics simulations for expected high-gain fusion target performance on a demonstration 1-GWe Laser Inertial Fusion Energy (LIFE) power plant in the mid-2030s timeframe are presented. The required laser energy driver is 2.2 MJ at a 0.351-[mu]m wavelength, and a fusion target gain greater than 60 at a repetition rate of 16 Hz is the design goal for economic and commercial attractiveness. A scaling-law analysis is developed to benchmark the design parameter space for hohlraum-driven central hot-spot ignition. A suite of integrated hohlraum simulations is presented to test the modeling assumptions and provide a basis for a near-term experimental resolution of the key physics uncertainties on the National Ignition Facility (NIF). The NIF is poised to demonstrate ignition by 2012 based on the central hot spot (CHS) mode of ignition and propagating thermonuclear burn [1]. This immediate prospect underscores the imperative and timeliness of advancing inertial fusion as a carbon-free, virtually limitless source of energy by the mid-21st century to substantially offset fossil fuel technologies. To this end, an intensive effort is underway to leverage success at the NIF and to provide the foundations for a prototype 'LIFE.1' engineering test facility by ≈2025, followed by a commercially viable 'LIFE.2' demonstration power plant operating at 1 GWe by ≈2035. The current design goal for LIFE.2 is to accommodate ≈2.2 MJ of laser energy (entering the high-Z radiation enclosure or 'hohlraum') at a 0.351-[mu]m wavelength operating at a repetition rate of 16 Hz and to provide a fusion target yield of 132 MJ. To achieve this design goal first requires a '0-d' analytic gain model that allows convenient exploration of parameter space and target optimization. This step is then followed by 2- and 3-dimensional radiation-hydrodynamics simulations that incorporate laser beam transport, x-ray radiation transport, atomic physics, and thermonuclear burn [2]. These simulations form the basis for assessing the susceptibility to hydrodynamic instability growth, target performance margins, laser backscatter induced by plasma density fluctuations within the hohlraum, and the threat spectrum emerging from the igniting capsule, e.g., spectra, fluences and anisotropy of the x rays and ions, for input into the chamber survivability calculations. The simulations follow the guidelines of a 'point design' methodology, which formally designates a well-defined milestone in concept development that meets established criteria for experimental testing. In Section 2, the 0-d analytic gain model to survey gain versus laser energy parameter space is discussed. Section 3 looks at the status of integrated hohlraum simulations and the needed improvements in laser-hohlraum coupling efficiency to meet the LIFE.2 threshold (net) target gain of ≈60. Section 4 considers advanced hohlraum designs to well exceed the LIFE.2 design goal for satisfactory performance margins. We summarize in Sec. 5.
Download or read book Inertial Confinement Fusion written by James J. Duderstadt and published by John Wiley & Sons. This book was released on 1982 with total page 380 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book An Assessment of the Prospects for Inertial Fusion Energy written by National Research Council and published by National Academies Press. This book was released on 2013-07-05 with total page 247 pages. Available in PDF, EPUB and Kindle. Book excerpt: The potential for using fusion energy to produce commercial electric power was first explored in the 1950s. Harnessing fusion energy offers the prospect of a nearly carbon-free energy source with a virtually unlimited supply of fuel. Unlike nuclear fission plants, appropriately designed fusion power plants would not produce the large amounts of high-level nuclear waste that requires long-term disposal. Due to these prospects, many nations have initiated research and development (R&D) programs aimed at developing fusion as an energy source. Two R&D approaches are being explored: magnetic fusion energy (MFE) and inertial fusion energy (IFE). An Assessment of the Prospects for Inertial Fusion Energy describes and assesses the current status of IFE research in the United States; compares the various technical approaches to IFE; and identifies the scientific and engineering challenges associated with developing inertial confinement fusion (ICF) in particular as an energy source. It also provides guidance on an R&D roadmap at the conceptual level for a national program focusing on the design and construction of an inertial fusion energy demonstration plant.
Download or read book INIS Atomindex written by and published by . This book was released on 1988 with total page 1308 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Advanced Diagnostics for Magnetic and Inertial Fusion written by Peter E. Stott and published by Springer Science & Business Media. This book was released on 2011-06-28 with total page 449 pages. Available in PDF, EPUB and Kindle. Book excerpt: Proceedings of the International Conference on Advanced Diagnostics for Magnetic and Inertial Fusion, held September 3-7, 2001 at Villa Monastero, Varenna, Italy. This volume focuses on future diagnostic requirements for fusion energy research emphasizing advanced diagnostics, new techniques and areas where further progress is required.
Download or read book Numerical Simulation of the High Density Approach to Laser fusion written by and published by . This book was released on 1973 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: From joint meetlng of the American Nuclear Society and the Atomic Industrial Forum and Nuclear Energy Exhibition; San Francisco, California, USA (11 Nov 1973). Physical processes important to laser-fusion are discussed along with the models of these processes used by the LASNEX code. Arguments are presented to show the validity of diffusion theory and calculational results are compared to a more detailed transport method and to several experimental observations. A study of stabillty and symmetry results in a full two- dimensional calculation of a typical laser-fusion pellet. (auth).
Download or read book Department of Energy Fiscal Year 1979 Authorization written by United States. Congress. Senate. Committee on Energy and Natural Resources. Subcommittee on Energy Research and Development and published by . This book was released on 1978 with total page 1140 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book ERDA Energy Research Abstracts written by United States. Energy Research and Development Administration and published by . This book was released on with total page 600 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book ERDA Energy Research Abstracts written by United States. Energy Research and Development Administration. Technical Information Center and published by . This book was released on 1976 with total page 588 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Hearings on H R 11036 HR 11686 written by United States. Congress. House. Committee on Armed Services. Intelligence and Military Application of Nuclear Energy Subcommittee and published by . This book was released on 1978 with total page 1152 pages. Available in PDF, EPUB and Kindle. Book excerpt:
