Download or read book Tunnels and Shafts in Rock written by United States. Army. Corps of Engineers and published by . This book was released on 1978 with total page 474 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Tunnels and Shafts in Rock written by U. S. Army Corps of Engineers and published by . This book was released on 2005 with total page 248 pages. Available in PDF, EPUB and Kindle. Book excerpt: This manual was prepared by the U.S. Army Corps of Engineers and provides technical criteria and guidance for the planning, design, and construction of tunnels and shafts in rock for civil works projects. Specific areas covered include geological and geotechnical explorations required, construction of tunnels and shafts, design considerations, geomechanical analysis, design of linings, and instrumentation and monitoring. The manual emphasizes design, construction and an understanding of the methods, and conditions of construction essential to the preparation of good designs.
Download or read book Shafts and Tunnels written by George Richard Fansett and published by . This book was released on 1918 with total page 72 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book An Introduction to Construction of Tunnels and Shafts written by J. Paul Guyer, P.E., R.A. and published by Guyer Partners. This book was released on 2020-11-11 with total page 134 pages. Available in PDF, EPUB and Kindle. Book excerpt: Introductory technical guidance for civil and geotechnical engineers and construction managers interested in construction of tunnels and shafts. Here is what is discussed: 1. GENERAL 2. TUNNEL EXCAVATION BY DRILLING AND BLASTING 3. TUNNEL EXCAVATION BY MECHANICAL MEANS 4. INITIAL GROUND SUPPORT 5. SEQUENTIAL EXCAVATION AND SUPPORT 6. PORTAL CONSTRUCTION 7. SHAFT CONSTRUCTION 8. OPTIONS FOR GROUND IMPROVEMENT 9. DRAINAGE AND CONTROL OF GROUNDWATER 10. CONSTRUCTION OF FINAL, PERMANENT TUNNEL LININGS 11. VENTILATION OF TUNNELS AND SHAFTS 12. SURVEYING FOR TUNNELS AND SHAFTS 13. CONSTRUCTION HAZARDS AND SAFETY REQUIREMENTS 14. ENVIRONMENTAL CONSIDERATIONS AND EFFECTS 15. CONTRACTING PRACTICES 16. PRACTICAL CONSIDERATIONS FOR THE PLANNING OF TUNNEL PROJECTS.
Download or read book An Introduction to Tunnels and Shafts in Rock written by J. Paul Guyer, P.E., R.A. and published by Guyer Partners. This book was released on 2020-03-22 with total page 55 pages. Available in PDF, EPUB and Kindle. Book excerpt: Introductory technical guidance for civil, geotechnical and structural engineers and construction managers interested in tunnels and shafts in rock. Here is what is discussed: 1. FUNDAMENTAL APPROACH TO GROUND SUPPORT DESIGN 2. FUNCTIONAL REQUIREMENTS OF TUNNELS AND SHAFTS 3. MODES OF FAILURE OF TUNNELS AND SHAFTS 4. SEISMIC EFFECTS ON TUNNELS.
Download or read book An Introduction to Engineering of Tunnels and Shafts written by J. Paul Guyer, P.E., R.A. and published by Guyer Partners. This book was released on 2021-07-11 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Introductory technical guidance for civil engineers, geotechnical engineers and construction managers interested in engineering for tunnels and shafts. Here is what is discussed: 1. CONSTRUCTION BY BLASTING AND BORING 2. DESIGN CONSIDERATIONS 3. GEOTECHNICAL ANALYSIS 4. INITIAL GROUND SUPPORT DESIGN 5. CONSTRUCTION OF TUNNELS AND SHAFTS 6. GEOTECHNICAL EXPLORATION 7. GROUND SUPPORT 8. TUNNELS AND SHAFTS IN ROCK
Download or read book Tunnels and shafts in rock written by United States. Army. Corps of Engineers and published by . This book was released on 1978 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book An Introduction to Construction of Tunnels and Shafts written by J Paul Guyer and published by Independently Published. This book was released on 2020-11-11 with total page 140 pages. Available in PDF, EPUB and Kindle. Book excerpt: Introductory technical guidance for civil and geotechnical engineers and construction managers interested in construction of tunnels and shafts. Here is what is discussed:1. GENERAL2. TUNNEL EXCAVATION BY DRILLING AND BLASTING3. TUNNEL EXCAVATION BY MECHANICAL MEANS4. INITIAL GROUND SUPPORT5. SEQUENTIAL EXCAVATION AND SUPPORT6. PORTAL CONSTRUCTION7. SHAFT CONSTRUCTION8. OPTIONS FOR GROUND IMPROVEMENT9. DRAINAGE AND CONTROL OF GROUNDWATER10. CONSTRUCTION OF FINAL, PERMANENT TUNNEL LININGS11. VENTILATION OF TUNNELS AND SHAFTS12. SURVEYING FOR TUNNELS AND SHAFTS13. CONSTRUCTION HAZARDS AND SAFETY REQUIREMENTS14. ENVIRONMENTAL CONSIDERATIONS AND EFFECTS15. CONTRACTING PRACTICES16. PRACTICAL CONSIDERATIONS FOR THE PLANNING OF TUNNEL PROJECTS.
Download or read book Practical Tunnelling written by Frederick Walter Simms and published by . This book was released on 1877 with total page 434 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Tunnel Engineering Handbook written by Thomas R. Kuesel and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 559 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Tunnel Engineering Handbook, Second Edition provides, in a single convenient volume, comprehensive coverage of the state of the art in the design, construction, and rehabilitation of tunnels. It brings together essential information on all the principal classifications of tunnels, including soft ground, hard rock, immersed tube and cut-and-cover, with comparisons of their relative advantages and suitability. The broad coverage found in the Tunnel Engineering Handbook enables engineers to address such critical questions as how tunnels are planned and laid out, how the design of tunnels depends on site and ground conditions, and which types of tunnels and construction methods are best suited to different conditions. Written by the leading engineers in the fields, this second edition features major revisions from the first, including: * Complete updating of all chapters from the first edition * Seven completely new chapters covering tunnel stabilization and lining, difficult ground, deep shafts, water conveyance tunnels, small diameter tunnels, fire life safety, tunnel rehabilitation and tunnel construction contracting *New coverage of the modern philosophy and techniques of tunnel design and tunnel construction contracting The comprehensive coverage of the Tunnel Engineering Handbook makes it an essential resource for all practicing engineers engaged in the design of tunnels and underground construction. In addition, the book contains a wealth of information that government administrators and planners and transportation officials will use in the planning and management of tunnels.
Download or read book Zuiderzee Visscherij written by and published by . This book was released on 1929 with total page 4 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book State of the art Construction Technology for Deep Tunnels and Shafts in Rock written by Robert D. Bennett and published by . This book was released on 1985 with total page 470 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book An Introduction to Construction of Tunnels and Shafts for Professional Engineers written by J. Paul Guyer, P.E., R.A. and published by Guyer Partners. This book was released on 2022-06-09 with total page 134 pages. Available in PDF, EPUB and Kindle. Book excerpt: Introductory technical guidance for civil engineers, geotechnical engineers and construction managers interested in construction of tunnels and shafts. Here is what is discussed: 1. GENERAL, 2. TUNNEL EXCAVATION BY DRILLING AND BLASTING, 3. TUNNEL EXCAVATION BY MECHANICAL MEANS, 4. INITIAL GROUND SUPPORT, 5. SEQUENTIAL EXCAVATION AND SUPPORT, 6. PORTAL CONSTRUCTION, 7. SHAFT CONSTRUCTION, 8. OPTIONS FOR GROUND IMPROVEMENT, 9. DRAINAGE AND CONTROL OF GROUNDWATER, 10. CONSTRUCTION OF FINAL, PERMANENT TUNNEL LININGS, 11. VENTILATION OF TUNNELS AND SHAFTS, 12. SURVEYING FOR TUNNELS AND SHAFTS, 13. CONSTRUCTION HAZARDS AND SAFETY REQUIREMENTS, 14. ENVIRONMENTAL CONSIDERATIONS AND EFFECTS, 15. CONTRACTING PRACTICES, 16. PRACTICAL CONSIDERATIONS FOR THE PLANNING OF TUNNEL PROJECTS.
Download or read book Underground Structures written by R.S. Sinha and published by Elsevier. This book was released on 2012-12-02 with total page 501 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book presents the most up to date information relevant to the design and instrumentation of underground structures. The structure might be a tunnel, shaft, cavern, or pressure unit, or a combination thereof. Empirical, rational, numerical, convergence and confinement, and discontinuity analysis methods are treated comprehensively. Special chapters are devoted to underground structures in rock burst, swelling, squeezing, and seismic zones. Water control, instrumentation, and tunneling through soft ground are also treated extensively. Sections on the design of pressure tunnels, shafts, caverns, shotcreting, water control, and soft ground tunnels are informative and authoritative. Worked examples are included on the design of rock tunnels, soft ground tunnels, and the treatment of underground structures through difficult ground. Extensive references are provided, and figures, sketches and photographs aid presentation. Important tables on planning, and case histories, allow the reader to build confidence in his design of underground structures. The book will be beneficial to civil, structural, geotechnical and mining engineers, geologists, and planners and managers associated with the design and construction of underground structures.
Download or read book An Introduction to Ground Support for Tunnels and Shafts written by J. Paul Guyer, P.E., R.A. and published by Guyer Partners. This book was released on 2018-07-16 with total page 60 pages. Available in PDF, EPUB and Kindle. Book excerpt: Introductory technical guidance for civil, structural and geotechnical engineers interested in ground support for tunnels and shafts. Here is what is discussed: 1. FUNDAMENTAL APPROACH TO GROUND SUPPORT DESIGN 2. FUNCTIONAL REQUIREMENTS OF TUNNELS AND SHAFTS 3. MODES OF FAILURE OF TUNNELS AND SHAFTS 4. SEISMIC EFFECTS ON TUNNELS.
Download or read book Practical Tunnelling written by Frederick Walter Simms and published by Cambridge University Press. This book was released on 2014-07-31 with total page 211 pages. Available in PDF, EPUB and Kindle. Book excerpt: An illustrated 1844 textbook covering tunnel construction for railways, written by a leading authority on the subject at the time.
Download or read book An Introduction to Tunnels and Shafts for Professional Engineers written by J. Paul Guyer, P.E., R.A. and published by Guyer Partners. This book was released on 2024-01-09 with total page 406 pages. Available in PDF, EPUB and Kindle. Book excerpt: Introductory technical guidance for civil engineers, geotechnical engineers and other professional engineers nd construction managers interested in design and construction of tunnels and shafts in rock and soil. Here is what is discussed: 1. CONSTRUCTION BY BLASTING AND BORING, 2. DESIGN CONSIDERATIONS, 3. GEOTECHNICAL ANALYSIS, 4. INITIAL GROUND SUPPORT DESIGN, 5. CONSTRUCTION OF TUNNELS AND SHAFTS, 6. GEOTECHNICAL EXPLORATION, 7. GROUND SUPPORT, 8. TUNNELS AND SHAFTS IN ROCK.
