Download or read book Progress at SLAC on High power Rf Pulse Compression written by and published by . This book was released on 1992 with total page 3 pages. Available in PDF, EPUB and Kindle. Book excerpt: Rf pulse compression is a technique for augmenting the peak power output of a klystron (typically 50--100 MW) to obtain the high peak power required to drive a linear collider at a high accelerating gradient (typically 200 MW/m is required for a gradient of 100 MV/m). The SLED pulse compression system, with a power gain of about 2.6, has been operational on the SLAC linac for more than a decade. Recently, a binary pulse-compression system with a power gain of about 5.2 has been tested up to an output power of 120 MW. Further high-power tests are in progress. Our current effort is focused on prototyping a so-called SLED-II pulse-compression system with a power gain of four. Over-moded TE01-mode circular waveguide components, some with novel technical features, are used to reduce losses at the 11.4-GHz operating frequency.
Download or read book High Energy Accelerators Heacc 92 Proceedings Of The Xv International Conference In 2 Volumes written by J Rossbach and published by World Scientific. This book was released on 1993-02-10 with total page 1288 pages. Available in PDF, EPUB and Kindle. Book excerpt: The High Energy Accelerator Conference has always been the monitor of the state of the art and the new trends in planning, construction and operation of large particle accelerators. It is held every three years. The 1992 conference is devoted to High Energy Hadron Accelerators and Colliders, Linear Colliders, e⁺e⁻ Storage Rings and related Technologies for these machines. In addition to status reports and contributed papers, the program features twelve survey talks which include summaries of individual poster papers.
Download or read book High power Rf Pulse Compression with SLED II at SLAC written by and published by . This book was released on 1993 with total page 3 pages. Available in PDF, EPUB and Kindle. Book excerpt: Increasing the peak rf power available from X-band microwave tubes by means of rf pulse compression is envisioned as a way of achieving the few-hundred-megawatt power levels needed to drive a next-generation linear collider with 50--100 MW klystrons. SLED-II is a method of pulse compression similar in principal to the SLED method currently in use on the SLC and the LEP injector linac. It utilizes low-los resonant delay lines in place of the storage cavities of the latter. This produces the added benefit of a flat-topped output pulse. At SLAC, we have designed and constructed a prototype SLED-II pulse-compression system which operates in the circular TE01 mode. It includes a circular-guide 3-dB coupler and other novel components. Low-power and initial high-power tests have been made, yielding a peak power multiplication of 4.8 at an efficiency of 40%. The system will be used in providing power for structure tests in the ASTA (Accelerator Structures Test Area) bunker. An upgraded second prototype will have improved efficiency and will serve as a model for the pulse compression system of the NLCTA (Next Linear Collider Test Accelerator).
Download or read book Binary Rf Pulse Compression Experiment at SLAC written by and published by . This book was released on 1990 with total page 3 pages. Available in PDF, EPUB and Kindle. Book excerpt: Using rf pulse compression it will be possible to boost the 50- to 100-MW output expected from high-power microwave tubes operating in the 10- to 20-GHz frequency range, to the 300- to 1000-MW level required by the next generation of high-gradient linacs for linear for linear colliders. A high-power X-band three-stage binary rf pulse compressor has been implemented and operated at the Stanford Linear Accelerator Center (SLAC). In each of three successive stages, the rf pulse-length is compressed by half, and the peak power is approximately doubled. The experimental results presented here have been obtained at low-power (1-kW) and high-power (15-MW) input levels in initial testing with a TWT and a klystron. Rf pulses initially 770 nsec long have been compressed to 60 nsec. Peak power gains of 1.8 per stage, and 5.5 for three stages, have been measured. This corresponds to a peak power compression efficiency of about 90% per stage, or about 70% for three stages, consistent with the individual component losses. The principle of operation of a binary pulse compressor (BPC) is described in detail elsewhere. We recently have implemented and operated at SLAC a high-power (high-vacuum) three-stage X-band BPC. First results from the high-power three-stage BPC experiment are reported here.
Download or read book Energy Research Abstracts written by and published by . This book was released on 1994-03 with total page 332 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book RF Pulse Compression Experiment at SLAC written by and published by . This book was released on 1989 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Using rf pulse compression it will be possible to boost a 50-100 MW output, expected from high power microwave tubes operating in the 10- 20 GHz frequency range, to the 300-600 MW level required by the next generation of high gradient linear colliders. Experiments have been performed at Stanford Linear Accelerator Center to test, at low power, a two-stage binary energy compressor (BEC) operating at 11.424 GHz. Using over-moded delay lines and 3 dB hybrid couplers, a 312 ns pulse was compressed to 78 ns, giving a power multiplication ratio of (approximately)3.2, and a power efficiency of 81%. Individual component insertion losses were measured to be in the range of 0.6% to 8.5%. Over-all efficiency calculated using these values agreed with measured values to (approximately)1.4%. Using best values of the measured component insertion losses, the efficiency of a proposed high power test of a three-stage BEC is estimated to be 71%, with a power multiplication of (approximately)5.7. 7 refs., 7 figs., 5 tabs.
Download or read book A High power SLED 2 Pulse Compression System written by and published by . This book was released on 1992 with total page 3 pages. Available in PDF, EPUB and Kindle. Book excerpt: The enhancement of peak power by means of RF pulse compression has found important application for driving high energy electron linacs, the SLAC linac in particular. The SLAC Energy Doubler (SLED), however, yields a pulse shape in the form of a decaying exponential which limits the applicability of the method. Two methods of improving this situation have been suggested: binary pulse compression (BPC), in which the pulse is compressed by successive factors of two, and SLED II in which the pair of resonant cavities of SLED are replaced by long resonant delay lines (typically waveguides). Intermediate schemes in which the cavity pair is replaced by sequences of coupled cavities have also been considered. In this paper we describe our efforts towards the design and construction of high-power SLED II systems, which are intended to provide drivers for various advanced accelerator test facilities and potentially for the Next Linear Collider itself. The design path we have chosen requires the development of a number of microwave components in overmoded waveguide, and the bulk of this paper will be devoted to reporting our progress.
Download or read book RF Pulse Compression in the NLC Test Accelerator at SLAC written by and published by . This book was released on 1995 with total page 6 pages. Available in PDF, EPUB and Kindle. Book excerpt: At the Stanford Linear Accelerator Center (SLAC), the authors are designing a Next Linear Collider (NLC) with linacs powered by X-band klystrons with rf pulse compression. The design of the linac rf system is based on X-band prototypes which have been tested at high power, and on a systems-integration test - the Next Linear Collider Test Accelerator (NLCTA) - which is currently under construction at SLAC. This paper discusses some of the systems implications of rf pulse compression, and the use of pulse compression in the NLCTA, both for peak power multiplication and for controlling, by rf phase modulation, intra-pulse variations in the linac beam energy.
Download or read book Radio Frequency Pulse Compression Experiments at SLAC Stanford Linear Accelerator Center written by and published by . This book was released on 1991 with total page 10 pages. Available in PDF, EPUB and Kindle. Book excerpt: Proposed future positron-electron linear colliders would be capable of investigating fundamental processes of interest in the 0.5--5 TeV beam-energy range. At the SLAC Linear Collider (SLC) gradient of about 20 MV/m this would imply prohibitive lengths of about 50--250 kilometers per linac. We can reduce the length by increasing the gradient but this implies high peak power, on the order of 400-- to 1000-MW at X-Band. One possible way to generate high peak power is to generate a relatively long pulse at a relatively low power and compress it into a short pulse with higher peak power. It is possible to compress before DC to RF conversion, as is done using magnetic switching for induction linacs, or after DC to RF conversion, as is done for the SLC. Using RF pulse compression it is possible to boost the 50-- to 100-MW output that has already been obtained from high-power X-Band klystrons the levels required by the linear colliders. In this note only radio frequency pulse compression (RFPC) is considered.
Download or read book ERDA Energy Research Abstracts written by and published by . This book was released on 1983 with total page 1028 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Lepton And Photon Interactions At High Energies Proceedings Of The Xix International Symposium written by John Jaros and published by World Scientific. This book was released on 2000-07-21 with total page 941 pages. Available in PDF, EPUB and Kindle. Book excerpt: Stanford University hosted the XIX International Symposium on Lepton and Photon Interactions at High Energies on August 9 - 14, 1999, at the Law School on the Stanford University Campus, the site of the previous Symposia. This volume constitutes the proceedings of the Symposium.
Download or read book High Energy Density and High Power RF written by David K. Abe and published by Springer Science & Business Media. This book was released on 2006-01-04 with total page 526 pages. Available in PDF, EPUB and Kindle. Book excerpt: This is the seventh in a series of international workshops on high-power and high-energy density microwave devices for accelerator, plasma physics, and defense applications. The scope of this workshop included accelerators for high energy physics, plasma heating and current drive in controlled thermonuclear fusion research, radar and directed energy/high power microwave systems, THz sources and technologies, and advanced 2D/3D computational tool development.
Download or read book Energy and Water Development Appropriations for 1988 written by United States. Congress. House. Committee on Appropriations. Subcommittee on Energy and Water Development and published by . This book was released on 1987 with total page 1580 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book XIX International Symposium on Lepton and Photon Interactions at High Energies written by John Jaros and published by World Scientific. This book was released on 2000 with total page 952 pages. Available in PDF, EPUB and Kindle. Book excerpt: Stanford University hosted the XIX International Symposium on Lepton and Photon Interactions at High Energies on August 9 - 14, 1999, at the Law School on the Stanford University Campus, the site of the previous Symposia. This volume constitutes the proceedings of the Symposium.
Download or read book High Energy Density and High Power RF written by Steven H. Gold and published by American Inst. of Physics. This book was released on 2003-12-04 with total page 474 pages. Available in PDF, EPUB and Kindle. Book excerpt: This is the sixth in a series of international workshops on high-power and high-energy density microwave devices for accelerator, plasma physics, and defense applications. Past workshops were held in Dubna, Montauk, Hayama, Pajaro Dunes, and Snowbird. The theme is research and development of techniques to increase microwave energy density and peak power in active and passive microwave devices and components ranging from L-band to W-band. The scope of this workshop has now been broadened to include radar and high power microwave (HPM) systems, space exploration, neutron sources, and even plasma heating and current drive in controlled thermonuclear fusion research.
Download or read book Beam Line written by and published by . This book was released on 1990 with total page 414 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Status and Plans of the United States and CERN High Energy Physics Programs and the Superconducting Super Collider SSC written by United States. Congress. House. Committee on Science and Technology. Subcommittee on Energy Development and Applications and published by . This book was released on 1986 with total page 1572 pages. Available in PDF, EPUB and Kindle. Book excerpt:
