Download or read book Performance of the SLC Polarized Electron Source with High Polarization written by and published by . This book was released on 1993 with total page 3 pages. Available in PDF, EPUB and Kindle. Book excerpt: For the 1992 operating cycle of the SLAC Linear Collider (SLC), the polarized electron source (PES) during its maiden run successfully met the pulse intensity and overall efficiency requirements of the SLC. However, the polarization of the bulk GaAs cathode was low ((approximately)27%) and the pulse-to-pulse stability was marginal. We have shown that adequate charge for the SLC can be extracted from a strained layer cathode having P{sub e}(approximately)80% even though the quantum efficiency (QE) is

Download or read book Polarized Electron Sources written by and published by . This book was released on 1995 with total page 5 pages. Available in PDF, EPUB and Kindle. Book excerpt: Polarized electron sources for high energy accelerators took a significant step forward with the introduction of a new laser-driven photocathode source for the SLC in 1992. With an electron beam polarization of>80% and with (approximately)99% uptime during continuous operation, this source is a key factor in the success of the current SLC high-energy physics program. The SLC source performance is used to illustrate both the capabilities and the limitations of solid-state sources. The beam requirements for future colliders are similar to that of the SLC with the addition in most cases of multiple-bunch operation. A design for the next generation accelerator source that can improve the operational characteristics and at least minimize some of the inherent limitations of present sources is presented. Finally, the possibilities for producing highly polarized electron beams for high-duty-factor accelerators are discussed.

Download or read book Advanced Strained Superlattice Photocathodes for Polarized Electron Sources written by and published by . This book was released on 2005 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Polarized electrons have been essential for high-energy parity-violating experiments and measurements of the nucleon spin structure. The availability of a polarized electron beam was crucial to the success of the Stanford Linear Collider (SLC) in achieving a precise measurement of the electroweak mixing angle, and polarized electron beams will be required for all future linear colliders. Polarized electrons are readily produced by GaAs photocathode sources. When a circularly polarized laser beam tuned to the bandgap minimum is directed to the negative-electron-affinity (NEA) surface of a GaAs crystal, longitudinally polarized electrons are emitted into vacuum. The electron polarization is easily reversed by reversing the laser polarization. The important properties of these photocathodes for accelerator applications are: degree of polarization of the extracted beam; ability to extract sufficient charge to meet accelerator pulse-structure requirements; efficiency and stability of operation; and absence of any asymmetries in the beam properties (charge, position, energy, etc.) upon polarization reversal. The performance of GaAs photocathodes has improved significantly since they were first introduced in 1978 [1]. The theoretical maximum polarization of 50% for natural GaAs was first exceeded in 1991 using the lattice mismatch of a thin InGaAs layer epitaxially grown over a GaAs substrate to generate a strain in the former that broke the natural degeneracy between the heavy- and light-hole valence bands [2]. Polarizations as high as 78% were produced for the SLC from photocathodes based on a thin GaAs epilayer grown on GaAsP [3,4]. After 10 years of experience with many cathode samples at several laboratories [5], the maximum polarization using the GaAs/GaAsP single strained-layer cathode remained limited to 80%, while the quantum efficiency (QE) for a 100-nm epilayer is only 0.3% or less. Two factors were known to limit the polarization of these cathodes: (1) the limited band splitting; and (2) a relaxation of the strain in the epilayer since the 10-nm critical thickness for maintaining perfect strain is exceeded for a 1 % lattice-mismatch [6]. Strained superlattice structures, consisting of very thin quantum well layers alternating with lattice-mismatched barrier layers are excellent candidates for higher polarization. Due to the difference in the effective mass of the heavy- and light-holes, a superlattice exhibits a natural splitting of the valence band, which adds to the strain-induced splitting. In addition, each of the SL layers is thinner than the critical thickness. Polarized photoemission from strained InGaAs/GaAs [7], InGaAdAlGaAs [8], and GaAs/GaAsP [9,10] superlattice structures have been reported in the literature. For this Phase II program, SVT Associates worked with the Stanford Linear Accelerator Center (SLAC) and University of Wisconsin at Madison to create photocathodes with improved polarization by employing GaAs/GaAsP superlattices. These superlattices consist of alternating thin layers of GaAs and GaAsP. The thicknesses and alloy compositions are designed to create a strained GaAs photoemission layer. Under strain, the heavy-hole and light-hole valence bands in GaAs split, removing degeneracy and allowing high polarization, theoretically 100%. This final report discusses the efforts and results achieved, comparing the device performance of newly created superlattice photocathodes grown by molecular beam epitaxy (MBE) with the devices created by other fabrication technologies, and efforts to optimize and improve the device operation.

Download or read book Superlattice Photocathodes for Accelerator Based Polarized Electron Source Applications written by and published by . This book was released on 1999 with total page 5 pages. Available in PDF, EPUB and Kindle. Book excerpt: A major improvement in the performance of the SLC was achieved with the introduction of thin strained-layer semiconductor crystals. After some optimization, polarizations of 75-85% became standard with lifetimes that were equal to or better than that of thick unstrained crystals. Other accelerators of polarized electrons, generally operating with a much higher duty factor, have now successfully utilized similar photocathodes. For future colliders, the principal remaining problem is the limit on the total charge that can be extracted in a time scale of 10 to 100 ns. In addition, higher polarization is critical for exploring new physics, especially supersymmetry. However, it appears that strained-layer crystals have reached the limit of their optimization. Today strained superlattice crystals are the most promising candidates for better performance. The individual layers of the superlattice can be designed to be below the critical thickness for strain relaxation, thus in principle improving the polarization. Thin layers also promote high electron conduction to the surface. In addition the potential barriers at the surface for both emission of conduction-band electrons to vacuum and for tunneling of valence-band holes to the surface can be significantly less than for single strained-layer crystals, thus enhancing both the yield at any intensity and also decreasing the limitations on the total charge. The inviting properties of the recently developed AlInGaAs/GaAs strained superlattice with minimal barriers in the conduction band are discussed in detail.

Download or read book High Energy Accelerators Heacc 92 Proceedings Of The Xv International Conference In 2 Volumes written by J Rossbach and published by World Scientific. This book was released on 1993-02-10 with total page 1288 pages. Available in PDF, EPUB and Kindle. Book excerpt: The High Energy Accelerator Conference has always been the monitor of the state of the art and the new trends in planning, construction and operation of large particle accelerators. It is held every three years. The 1992 conference is devoted to High Energy Hadron Accelerators and Colliders, Linear Colliders, e⁺e⁻ Storage Rings and related Technologies for these machines. In addition to status reports and contributed papers, the program features twelve survey talks which include summaries of individual poster papers.

Download or read book Physics With High Energy Colliders Proceedings Of 22nd Ins International Symposium written by Sachie Yamada and published by World Scientific. This book was released on 1995-04-26 with total page 490 pages. Available in PDF, EPUB and Kindle. Book excerpt: Recent results from all types of high energy colliders (e⁺e⁻, pp, ep) are presented from the view point of electroweak interaction and QCD/Jet physics together with related phenomenological reviews. Expected physics at future colliders, both being built or planned, are also discussed including e+e- linear collider, pp collider and heavy ion collider.

Download or read book Energy Research Abstracts written by and published by . This book was released on 1994 with total page 444 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Polarized Beams And Polarized Gas Targets Proceedings Of The International Workshop written by Hans Paetz Gen Schieck and published by World Scientific. This book was released on 1996-03-21 with total page 478 pages. Available in PDF, EPUB and Kindle. Book excerpt: The International Workshop on Polarized Beams and Polarized Gas Targets was held in Cologne, Germany from June 6 to 9, 1995 as the last in a series held at 2-3 years intervals. It was attended by about 110 scientists; there were 47 invited and contributed talks, 5 round-table discussions and 17 poster contributions, all of which will appear as a written contribution in the Proceedings. The main subjects were Optically-Pumped Polarized Targets, Polarized Electron Sources, Atomic-Beam Polarized-Ion Sources, Optically-Pumped Polarized Ion Sources, Targets and Storage Rings. Significant progress and latest developments in this field were covered as well as future developments both from the technical, but also from the physics aspects.

Download or read book European Particle Accelerator Conference Epac 94 In 3 Volumes written by Christine Petit-jean-genaz and published by World Scientific. This book was released on 1994-11-26 with total page 2968 pages. Available in PDF, EPUB and Kindle. Book excerpt: These proceedings aim to provide a comprehensive overview of research, technology and applications in the field of accelerators. Contributions from the entire field of accelerators are presented, including low and high energy machines, and medical and industrial accelerators.

Download or read book Physics Results with Polarized Electrons at SLAC written by and published by . This book was released on 1996 with total page 11 pages. Available in PDF, EPUB and Kindle. Book excerpt: Polarized electron beams can play an important role in the dynamics of interactions at high energies. Polarized electron beams at SLAC have been an important part of the physics program since 1970, when they were first proposed for use in testing the spin structure of the proton. Since 1992, the SLAC linear accelerator and the SLC have operated solely with polarized electrons, providing data for tests of QCD in studies of the spin structure of the nucleon and tests of the electroweak sector of the Standard Model. In the following sections, the performance of the source is summarized, and some of the recent results using the polarized beams are discussed.

Download or read book Photocathode Performance Measurements for the SLC Polarized Electron Gun written by and published by . This book was released on 1993 with total page 3 pages. Available in PDF, EPUB and Kindle. Book excerpt: A low-voltage test system is used to qualify various III-V semiconductor materials as photocathodes for the SLC. The system features a load lock to introduce samples, high pumping speed, a sensitive residual gas analyzer, and an infrared temperature detector. Heat cleaning, cesiation, and oxidation procedures have been studied to optimize cathode activation for achieving an optimum NEA surface. VGF GaAs, MBE-grown AlGaAs, MBE GaAs layered on AlGaAs, and MOCVD GaAsP cathodes with different active layer thicknesses and doping concentrations have been tested for quantum efficiency and lifetime. New higher-polarization strained-layer GaAs on GaAsP photocathodes have also been tested. Results and operational experience are discussed.

Download or read book Polarization Developments written by and published by . This book was released on 1993 with total page 6 pages. Available in PDF, EPUB and Kindle. Book excerpt: Recent developments in laser-driven photoemission sources of polarized electrons have made prospects for highly polarized electron beams in a future linear collider very promising. This talk discusses the experiences with the SLC polarized electron source, the recent progress with research into gallium arsenide and strained gallium arsenide as a photocathode material, and the suitability of these cathode materials for a future linear collider based on the parameters of the several linear collider designs that exist.

Download or read book The Stanford Linear Collider written by and published by . This book was released on 1995 with total page 5 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Stanford Linear Collider (SLC) is the first and only high-energy ee− linear collider in the world. Its most remarkable features are high intensity, submicron sized, polarized (e−) beams at a single interaction point. The main challenges posed by these unique characteristics include machine-wide emittance preservation, consistent high intensity operation, polarized electron production and transport, and the achievement of a high degree of beam stability on all time scales. In addition to serving as an important machine for the study of Z° boson production and decay using polarized beams, the SLC is also an indispensable source of hands-on experience for future linear colliders. Each new year of operation has been highlighted with a marked improvement in performance. The most significant improvements for the 1994-95 run include new low impedance vacuum chambers for the damping rings, an upgrade to the optics and diagnostics of the final focus systems, and a higher degree of polarization from the electron source. As a result, the average luminosity has nearly doubled over the previous year with peaks approaching 103° cm−2s−1 and an 80% electron polarization at the interaction point. These developments as well as the remaining identifiable performance limitations will be discussed.

Download or read book Precision Tests Of The Standard Electroweak Model written by Paul G Langacker and published by World Scientific. This book was released on 1995-02-23 with total page 1032 pages. Available in PDF, EPUB and Kindle. Book excerpt: High precision measurements of weak neutral current and charged current processes and of the properties of the Z and W bosons have established the standard electroweak model as correct down to a distance scale of 10-16 cm, and are a sensitive probe of possible underlying physics. In this book, all aspects of the program are considered in detail, including the structure of the standard model, radiative corrections, high precision experiments, and their implications. The major classes of experiments are surveyed, covering the experiments themselves, the data analysis, results, and prospects.This volume is a detailed reference for theoretical and experimental researchers, as well as an introductory text for advanced students.

Download or read book Proceedings of the 1993 Particle Accelerator Conference written by and published by . This book was released on 1993 with total page 800 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Polarized Electron Source Developments written by and published by . This book was released on 1990 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Presently, only two methods of producing beams of polarized electrons for injection into linear accelerators are in use. Each of these methods uses optical pumping by circularly polarized light to produce electron polarization. In one case, electron polarization is established in metastable helium atoms, while in the other case, the polarized electrons are produced in the conduction band of appropriate semiconductors. The polarized electrons are liberated from the helium metastable by chemi-ionization, and from the semiconductors by lowering the work function at the surface of the material. Developments with each of these sources since the 1988 Spin Physics Conference are reviewed, and the prospects for further improvements discussed.

Download or read book High Energy Physics Index written by and published by . This book was released on 1993 with total page 600 pages. Available in PDF, EPUB and Kindle. Book excerpt: