Download or read book Numerical Simulation of Wind Turbines written by Alessandro Bianchini and published by MDPI. This book was released on 2021-09-10 with total page 308 pages. Available in PDF, EPUB and Kindle. Book excerpt: The book contains the research contributions belonging to the Special Issue "Numerical Simulation of Wind Turbines", published in 2020-2021. They consist of 15 original research papers and 1 editorial. Different topics are discussed, from innovative design solutions for large and small wind turbine to control, from advanced simulation techniques to noise prediction. The variety of methods used in the research contributions testifies the need for a holistic approach to the design and simulation of modern wind turbines and will be able to stimulate the interest of the wind energy community.

Download or read book Numerical Simulation of Wind Turbines written by Giovanni Ferrara and published by . This book was released on 2021 with total page 308 pages. Available in PDF, EPUB and Kindle. Book excerpt: The book contains the research contributions belonging to the Special Issue "Numerical Simulation of Wind Turbines", published in 2020-2021. They consist of 15 original research papers and 1 editorial. Different topics are discussed, from innovative design solutions for large and small wind turbine to control, from advanced simulation techniques to noise prediction. The variety of methods used in the research contributions testifies the need for a holistic approach to the design and simulation of modern wind turbines and will be able to stimulate the interest of the wind energy community.

Download or read book Numerical Simulation of the Flow Around a Wind Turbine Using OpenFOAM written by Oscar Alejandro Urbina Rivas and published by . This book was released on 2014 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Numerical Simulation of Local Climatic Impact of an Operating Wind Turbine written by Yuan Yang and published by Open Dissertation Press. This book was released on 2017-01-26 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: This dissertation, "Numerical Simulation of Local Climatic Impact of an Operating Wind Turbine" by Yuan, Yang, 杨源, was obtained from The University of Hong Kong (Pokfulam, Hong Kong) and is being sold pursuant to Creative Commons: Attribution 3.0 Hong Kong License. The content of this dissertation has not been altered in any way. We have altered the formatting in order to facilitate the ease of printing and reading of the dissertation. All rights not granted by the above license are retained by the author. Abstract: Wind energy is commonly considered to be a clean and environmentally friendly renewable energy resource, as they do not pollute our atmosphere with greenhouse gas, nor do they cause any radioactive problems compared to nuclear energy. However, there are still some environmental impacts due to the installation and operation of the wind turbines that cannot be ignored, such as noise, visual and climatic impact. Especially, the observed local climate change in some wind farm areas has attracted general concern in recent years. Experts suspected that long time operation of wind turbines in an area can cause changes to local precipitation, evaporation of the water on earth surface, and even affect the frequency of drought happening. Nevertheless, we still cannot figure out whether these changes would be caused by wind turbines or not. The target of this study is to investigate the potential local impact of an operating wind turbine by numerical simulation. Because of the big geometric size of commercial wind turbines, experimental method is very limited in this type of study. Numerical simulation using CFD is considered to be a suitable approach and commercial software "FLUENT" is utilized in this study. Firstly, an accurate 3-D numerical wind turbine model was established and the frozen blade method was used to realize the rotation of the wind blades. Before further simulation, a wind-tunnel test has been undertaken by using a scaled physical wind turbine model for validation purpose. The experimental results show good agreement with those predicted by the numerical simulation. This suggested that the computation results were validated and the computational model can be used for further study. In this research, three wind turbine cases, with different typical ambient temperature and surface temperature, were simulated. Characters like wake structure, turbulence intensity and local temperature change was collected and analyzed in each simulated case. The results show that the operating wind turbine can bring obvious velocity deficit in the wake and a strong turbulence intensity enhancement was observed at the top tip because of the rotation. Also, local temperature change was found in the near wake region. The investigation of the local impact of the operating wind turbine is very significant. This study provides a valuable insight into the potential impacts of wind farms on local meteorology, which is rarely studied before. Meanwhile, a more comprehensive study on the effect of a wind farm on the environment is highly recommended. DOI: 10.5353/th_b5016282 Subjects: Wind turbines - Environmental aspects

Download or read book Modelling and Numerical Simulation of Wind Turbine Performance in Rainy Conditions Using a Multiphase Flow Approach written by Ming Cai and published by . This book was released on 2012 with total page 214 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Fundamentals of Wind Farm Aerodynamic Layout Design written by Farschad Torabi and published by Academic Press. This book was released on 2022-01-20 with total page 374 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fundamentals of Wind Farm Aerodynamic Layout Design, Volume Four provides readers with effective wind farm design and layout guidance through algorithm optimization, going beyond other references and general approaches in literature. Focusing on interactions of wake models, designers can combine numerical schemes presented in this book which also considers wake models’ effects and problems on layout optimization in order to simulate and enhance wind farm designs. Covering the aerodynamic modeling and simulation of wind farms, the book's authors include experimental tests supporting modeling simulations and tutorials on the simulation of wind turbines. In addition, the book includes a CFD technique designed to be more computationally efficient than currently available techniques, making this book ideal for industrial engineers in the wind industry who need to produce an accurate simulation within limited timeframes. Features novel CFD modeling Offers global case studies for turbine wind farm layouts Includes tutorials on simulation of wind turbine using OpenFoam

Download or read book Numerical Computation of Wind Turbine Flows and Fluid Problem by OpenFOAM and ANSYS written by Yi-Ching Wang and published by . This book was released on 2015 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Wind energy is the mainstream source of clean and renewable energy and it is also the fastest-growing source of sustainable energy in the world. In the Global Wind Energy Council's report in 2014, wind industry grew 44% worldwide. In order to optimize the efficiency of wind farms, it is important to observe wake interactions among wind turbines. Computational mathematics and mechanics provide fundamental methods and tools for simulating physical processes. Numerical computation can offer important insights and data that are either difficult or expensive to measure or to perform tests experimentally. In this dissertation, we use Computational Fluid Dynamics (CFD) software OpenFOAM and ANSYS FLUENT to simulate the wake effect of Horizontal Axis Wind Turbines (HAWT) and related problems. Numerical simulation can also help us comprehend and control man-made disasters. Air craft crashworthiness and human survivability are of utmost concerns in any emergency landing situation. Motivated by the air incidents lately, the disappearance of Malaysia Airlines Flight MH370 in March 2014 and Germanwings Flight 9525 crash in March 2015, we use Computational Structural Dynamics (CSD) software ANSYS Explicit Dynamics and LS-DYNA to try different numerical simulations of Airbus A320 crashing into a wall and compare the results to the reality. We calculate three CFD problems in this dissertation: lid-driven problems, one turbine wake problem, and two serial turbines wake problem. We simulate a lid-driven flow in both two- (2D) and three-dimension (3D) to compare the simulation capability of the three turbulence modelings, i.e., Direct Numerical Simulation (DNS), Large Eddy Simulation (LES), and Reynolds-Averaged Navier-Stokes Equations Simulation (RANS) by OpenFOAM. Among these three turbulence models, we can find that LES is capable of capturing more details of turbulence flow. We simulate the airflow effect of one wind turbine with both fixed angular velocity and wind-driven case, run benchmark tests based on NRELs reports, and compare the numerical results under the same condition by OpenFOAM and FLUENT. For the fixed angular velocity case, we use wind speed 8 m/s and angular velocity of the wind turbine 75 deg/s. For the wind-driven case, we use wind speed 8 m/s and 16 m/s and the angular velocity of the wind turbine calculated by FLUENT converges faster than OpenFOAM case. We simulate the interactions of wake flow for two serial wind turbines by FLUENT. We use wind speed 8 m/s and angular velocity of the wind turbine 75 deg/s. The wake of former turbine affects the rear one and the diffusion of flow caused by two turbines can be seen clearly. For both one and two serial turbines problems, the turbulence model RANS [lowercase kappa][lowercase epsilon] is used. We calculate and simulate Airbus A320 crashing into a wall by ANSYS Explicit Dynamics and LS-DYNA. For ANSYS Explicit Dynamics, we use the angle of approach 0°, 15°, and 30°. For LS-DYNA, we only test the pitch angles 0°. For all cases, we use the speed of aircarft 200 m/s. The deformation of both aircraft and wall can be seen clearly. The electronic version of this dissertation is accessible from http://hdl.handle.net/1969.1/155665

Download or read book The Numerical Simulation of Fluid Flow written by Robert Castilla and published by Mdpi AG. This book was released on 2022-02-17 with total page 158 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book collects the accepted contributions to the Special Issue "The Numerical Simulation of Fluid Flow" in the Energies journal of MDPI. It is focused more on practical applications of numerical codes than in its development. It covers a wide variety of topics, from aeroacoustics to aerodynamics and flow-particles interaction.

Download or read book Advances in Wind Power written by Rupp Carriveau and published by IntechOpen. This book was released on 2012-11-21 with total page 376 pages. Available in PDF, EPUB and Kindle. Book excerpt: Today's wind energy industry is at a crossroads. Global economic instability has threatened or eliminated many financial incentives that have been important to the development of specific markets. Now more than ever, this essential element of the world energy mosaic will require innovative research and strategic collaborations to bolster the industry as it moves forward. This text details topics fundamental to the efficient operation of modern commercial farms and highlights advanced research that will enable next-generation wind energy technologies. The book is organized into three sections, Inflow and Wake Influences on Turbine Performance, Turbine Structural Response, and Power Conversion, Control and Integration. In addition to fundamental concepts, the reader will be exposed to comprehensive treatments of topics like wake dynamics, analysis of complex turbine blades, and power electronics in small-scale wind turbine systems.

Download or read book Performance Numerical Simulation of a Wind Turbine with Variable Pitch Blades written by 鄭伊庭 and published by . This book was released on 2011 with total page 147 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Numerical Simulation of Wind Farm Control written by Chengyu Wang and published by . This book was released on 2021 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Computational and Numerical Simulations written by Jan Awrejcewicz and published by BoD – Books on Demand. This book was released on 2014-02-12 with total page 492 pages. Available in PDF, EPUB and Kindle. Book excerpt: Computational and Numerical Simulations is an edited book including 20 chapters. Book handles the recent research devoted to numerical simulations of physical and engineering systems. It presents both new theories and their applications, showing bridge between theoretical investigations and possibility to apply them by engineers of different branches of science. Numerical simulations play a key role in both theoretical and application oriented research.

Download or read book Numerical Simulation of a Wind Farm written by R. Ganesh Rajagopalan and published by . This book was released on 1985 with total page 72 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Numerical Simulation of Local Climatic Impact of an Operating Wind Turbine written by Yuan Yang (M. Phil.) and published by . This book was released on 2012 with total page 141 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Numerical Simulation of Local Climatic Impact of an Operating Wind Turbine written by 杨源 and published by . This book was released on 2012 with total page 141 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Numerical Simulation of a Flat Back Airfoil for Wind Turbine Applications written by Matthew Fuller and published by . This book was released on 2010 with total page 53 pages. Available in PDF, EPUB and Kindle. Book excerpt: Wind energy provides an attractive power source as an alternative to fossil fuels because it is abundant, clean, and produces no harmful emissions. To extract more energy from the wind we need to increase the wind turbine size. However, the increase in size has begun to reach a limit in terms of material composition and structural stability. To quell the trend of increasing size in wind power systems alternative wind turbine blade designs are investigated and evaluated to increase power production and efficiency of present size machines. Flat back airfoils have been proposed for the inboard region of large wind turbine blades because they provide structural and aerodynamic advantages. In this work we will investigate the aerodynamic performance of flat back airfoils with computational fluid dynamics techniques. To reduce the drag and noise inherent from the blunt trailing edge, a splitter plate with varying lengths is added to the trailing edge of the airfoils. Comparisons are made with experimental data. Excellent agreement is achieved with the measurements. Our numerical simulations show that the flat back airfoil can increase lift production as much as 20%. The splitter can effectively reduce drag by as much as 20% and tonal noise by as much as 20 dB.

Download or read book Numerical Simulation of the Aerodynamic Performance of an H rotor written by Yan Chen and published by . This book was released on 2011 with total page 150 pages. Available in PDF, EPUB and Kindle. Book excerpt: Vertical axis wind turbines (VAWTs) are devices to convert wind energy into electricity. Unlike horizontal axis wind turbines (HAWT) where the main rotor shaft is set horizontally, VAWTs use vertical rotor shaft. Unlike HAWTs, VAWTs can be effectively used in urban environment where flow is characterized with unsteadiness and turbulence. The efficiency of the VA WTs highly depends on the aerodynamics of the wind blades. In this thesis we study the aerodynamics of the H-rotor, one type of VAWTs using computational fluid dynamics methods. Two different approaches are used in this study. One is based on direct numerical simulation (DNS) method and another is based on Reynolds averaged Navier-Stoke (RANS) model. For DNS study we solve the incompressible Navier-Stokes equations with a CFD package, OVERTURE. An overlapping moving grids technique is employed to handle the rotation of the wind turbine. For RANS simulation we used a commercial CFD package ANSYS-Fluent. The sliding mesh model of ANSYS-Fluent is applied to evaluate unsteady interaction between the stationary and rotating components. Our simulation shows that the DNS cannot correctly predict the power coefficient due to the lack of grid resolution at high Reynolds numbers. The RANS simulation results closely match the experimental data and RANS provides a way to study wind turbine aerodynamics in an efficient and reliable manner. Our simulation shows that the rotor with NACA0015 blade section obtains a maximum power coefficient of 0.16 at tip speed ratio of 2.5 for mean wind velocity of 3.9m/s. By replacing the blade section with NACA0022 airfoil profile, the maximum power coefficient of the rotor can be improved to 0.21 at tip speed ratio of 2.5 in the same wind conditions.