Download or read book Numerical Simulation and Optimal Control in Plasma Physics written by Jacques Blum and published by Bordas Editions. This book was released on 1989 with total page 392 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Optimal Control written by Leslie M. Hocking and published by Oxford University Press. This book was released on 1991 with total page 276 pages. Available in PDF, EPUB and Kindle. Book excerpt: Systems that evolve with time occur frequently in nature and modelling the behavior of such systems provides an important application of mathematics. These systems can be completely deterministic, but it may be possible too to control their behavior by intervention through "controls". The theory of optimal control is concerned with determining such controls which, at minimum cost, either direct the system along a given trajectory or enable it to reach a given point in its state space. This textbook is a straightforward introduction to the theory of optimal control with an emphasis on presenting many different applications. Professor Hocking has taken pains to ensure that the theory is developed to display the main themes of the arguments but without using sophisticated mathematical tools. Problems in this setting can arise across a wide range of subjects and there are illustrative examples of systems from fields as diverse as dynamics, economics, population control, and medicine. Throughout there are many worked examples, and numerous exercises (with solutions) are provided.
Download or read book Magnetic Control of Tokamak Plasmas written by Marco Ariola and published by Springer. This book was released on 2016-02-23 with total page 208 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book is a complete treatment of work done to resolve the problems of position-, current-, and shape-control of plasma in tokamak-type (toroidal) devices being studied as a potential means of commercial energy production by nuclear fusion. Modelling and control are both detailed, allowing non-expert readers to understand the control problem. Starting from the magneto-hydro-dynamic equations, all the steps needed for the derivation of plasma state-space models are enumerated with frequent recall of the basic concepts of electromagnetics. The control problem is then described, beginning with the control of current and position—vertical and radial—control and progressing to the more challenging shape control. The solutions proposed vary from simple PIDs to more sophisticated MIMO controllers. The second edition of Magnetic Control of Tokamak Plasmas contains numerous updates and a substantial amount of completely new material covering areas such as: • modelling and control of resistive wall modes—the most important non-axisimmetric mode; • the isoflux approach for shape control; • a general approach for the control of limiter plasmas; • the use of inner vessel coils for vertical stabilization; and • significantly enhanced treatment of plasma-shape control at JET, including experimental results and introducing a method implemented for operation in the presence of current saturations. Whenever possible, coverage of the various topics is rounded out with experimental results obtained on currently existing tokamaks. The book also includes a presentation of the typical actuators and sensors used for control purposes in tokamaks. Some mathematical details are given in the appendices for the interested reader. The ideas formulated in this monograph will be of great practical help to control engineers, academic researchers and graduate students working directly with problems related to the control of nuclear fusion. They will also stimulate control researchers interested more generally in the advanced applications of the discipline. Advances in Industrial Control aims to report and encourage the transfer of technology in control engineering. The rapid development of control technology has an impact on all areas of the control discipline. The series offers an opportunity for researchers to present an extended exposition of new work in all aspects of industrial control.
Download or read book Optimal Control of Nonlinear Parabolic Systems written by Pekka Neittaanmaki and published by CRC Press. This book was released on 1994-02-08 with total page 432 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book discusses theoretical approaches to the study of optimal control problems governed by non-linear evolutions - including semi-linear equations, variational inequalities and systems with phase transitions. It also provides algorithms for solving non-linear parabolic systems and multiphase Stefan-like systems.
Download or read book Real Time Optimization by Extremum Seeking Control written by Kartik B. Ariyur and published by John Wiley & Sons. This book was released on 2003-10-03 with total page 254 pages. Available in PDF, EPUB and Kindle. Book excerpt: An up-close look at the theory behind and application of extremum seeking Originally developed as a method of adaptive control for hard-to-model systems, extremum seeking solves some of the same problems as today's neural network techniques, but in a more rigorous and practical way. Following the resurgence in popularity of extremum-seeking control in aerospace and automotive engineering, Real-Time Optimization by Extremum-Seeking Control presents the theoretical foundations and selected applications of this method of real-time optimization. Written by authorities in the field and pioneers in adaptive nonlinear control systems, this book presents both significant theoretic value and important practical potential. Filled with in-depth insight and expert advice, Real-Time Optimization by Extremum-Seeking Control: * Develops optimization theory from the points of dynamic feedback and adaptation * Builds a solid bridge between the classical optimization theory and modern feedback and adaptation techniques * Provides a collection of useful tools for problems in this complex area * Presents numerous applications of this powerful methodology * Demonstrates the immense potential of this methodology for future theory development and applications Real-Time Optimization by Extremum-Seeking Control is an important resource for both students and professionals in all areas of engineering-electrical, mechanical, aerospace, chemical, biomedical-and is also a valuable reference for practicing control engineers.
Download or read book World Congress of Nonlinear Analysts 92 written by V. Lakshmikantham and published by Walter de Gruyter. This book was released on 2011-11-14 with total page 4040 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Control of Distributed Parameter Systems 1989 written by M. Amouroux and published by Elsevier. This book was released on 2014-06-28 with total page 533 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume presents state-of-the-art reports on the theory, and current and future applications of control of distributed parameter systems. The papers cover the progress not only in traditional methodology and pure research in control theory, but also the rapid growth of its importance for different applications. This title will be of interest to researchers working in the areas of mathematics, automatic control, computer science and engineering.
Download or read book Qualitative Problems For Differential Equations And Control Theory written by Constantin Corduneanu and published by World Scientific. This book was released on 1995-10-06 with total page 345 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book contains a collection of articles on the topics mentioned in the title or closely related to them, and is dedicated to Prof Aristide Halanay from the University of Bucharest, Romania, in occasion of his 70th birthday. The authors are in most cases former students of Halanay or research associates from the University of Bucharest, the Mathematical Institute of the Romanian Academy and the Technical University of Bucharest. There are contributions from mathematicians from Finland, Belgium, the United States of America, Morocco, India and Ireland.The topics indicated above are in most cases related to Halanay's work and constitute significant contemporary research items in Applied Mathematics and Engineering. The book is written at research level and is primarily addressing mathematicians interested in the above mentioned areas as well as research engineers. The book will be also useful to graduate students with specialization in the areas listed above.More than 25 authors have contributed to the volume.
Download or read book System Modeling and Optimization written by Lorena Bociu and published by Springer. This book was released on 2017-04-10 with total page 541 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book is a collection of thoroughly refereed papers presented at the 27th IFIP TC 7 Conference on System Modeling and Optimization, held in Sophia Antipolis, France, in June/July 2015. The 48 revised papers were carefully reviewed and selected from numerous submissions. They cover the latest progress in their respective areas and encompass broad aspects of system modeling and optimiza-tion, such as modeling and analysis of systems governed by Partial Differential Equations (PDEs) or Ordinary Differential Equations (ODEs), control of PDEs/ODEs, nonlinear optimization, stochastic optimization, multi-objective optimization, combinatorial optimization, industrial applications, and numericsof PDEs.
Download or read book Safety Factor Profile Control in a Tokamak written by Federico Bribiesca Argomedo and published by Springer Science & Business Media. This book was released on 2013-11-08 with total page 105 pages. Available in PDF, EPUB and Kindle. Book excerpt: Control of the Safety Factor Profile in a Tokamak uses Lyapunov techniques to address a challenging problem for which even the simplest physically relevant models are represented by nonlinear, time-dependent, partial differential equations (PDEs). This is because of the spatiotemporal dynamics of transport phenomena (magnetic flux, heat, densities, etc.) in the anisotropic plasma medium. Robustness considerations are ubiquitous in the analysis and control design since direct measurements on the magnetic flux are impossible (its estimation relies on virtual sensors) and large uncertainties remain in the coupling between the plasma particles and the radio-frequency waves (distributed inputs). The Brief begins with a presentation of the reference dynamical model and continues by developing a Lyapunov function for the discretized system (in a polytopic linear-parameter-varying formulation). The limitations of this finite-dimensional approach motivate new developments in the infinite-dimensional framework. The text then tackles the construction of an input-to-state-stability Lyapunov function for the infinite-dimensional system that handles the medium anisotropy and provides a common basis for analytical robustness results. This function is used as a control-Lyapunov function and allows the amplitude and nonlinear shape constraints in the control action to be dealt with. Finally, the Brief addresses important application- and implementation-specific concerns. In particular, the coupling of the PDE and the finite-dimensional subsystem representing the evolution of the boundary condition (magnetic coils) and the introduction of profile-reconstruction delays in the control loop (induced by solving a 2-D inverse problem for computing the magnetic flux) is analyzed. Simulation results are presented for various operation scenarios on Tore Supra (simulated with METIS) and on TCV (simulated with RAPTOR). Control of the Safety Factor Profile in a Tokamak will be of interest to both academic and industrially-based researchers interested in nuclear energy and plasma-containment control systems, and graduate students in nuclear and control engineering.
Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1994 with total page 568 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book System Modelling and Optimization written by Jacques Henry and published by Springer. This book was released on 2006-04-11 with total page 972 pages. Available in PDF, EPUB and Kindle. Book excerpt: This conference, organized jointly by UTC and INRIA, is the biennial general conference of the IFIP Technical Committee 7 (System Modelling and Optimization), and reflects the activity of its members and working groups. These proceedings contain a collection of papers (82 from the more than 400 submitted) as well as the plenary lectures presented at the conference.
Download or read book Computational Methods in Plasma Physics written by Stephen Jardin and published by CRC Press. This book was released on 2010-06-02 with total page 364 pages. Available in PDF, EPUB and Kindle. Book excerpt: Assuming no prior knowledge of plasma physics or numerical methods, Computational Methods in Plasma Physics covers the computational mathematics and techniques needed to simulate magnetically confined plasmas in modern magnetic fusion experiments and future magnetic fusion reactors. Largely self-contained, the text presents the basic concepts neces
Download or read book New Trends of Mathematical Inverse Problems and Applications written by Amine Laghrib and published by Springer Nature. This book was released on 2023-07-15 with total page 178 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume comprises the thoroughly reviewed and revised papers of the First International Conference on New Trends in Applied Mathematics, ICNTAM 2022, which took place in Béni Mellal, Morocco, 19-21 May 2022. The papers deal with the following topics: Inverse Problems, Partial Differential Equations, Mathematical Control, Numerical Analysis and Computer Science. The main interest is in recent trends on Inverse Problems analysis and real applications in Computer Science. The latter is viewed as a dynamic branch on the interface of mathematics and related fields, that has been growing rapidly over the past several decades. However, its mathematical analysis and interpretation still not well-detailed and needs much more clarifications. The main contribution of this book is to give some sufficient mathematical content with expressive results and accurate applications. As a growing field, it is gaining a lot of attention both in media as well as in the industry world, which will attract the interest of readers from different scientist discipline.
Download or read book Optimization of Elliptic Systems written by Pekka Neittaanmaki and published by Springer Science & Business Media. This book was released on 2007-01-04 with total page 514 pages. Available in PDF, EPUB and Kindle. Book excerpt: The present monograph is intended to provide a comprehensive and accessible introduction to the optimization of elliptic systems. This area of mathematical research, which has many important applications in science and technology. has experienced an impressive development during the past two decades. There are already many good textbooks dealing with various aspects of optimal design problems. In this regard, we refer to the works of Pironneau [1984], Haslinger and Neittaanmaki [1988], [1996], Sokolowski and Zolksio [1992], Litvinov [2000], Allaire [2001], Mohammadi and Pironneau [2001], Delfour and Zolksio [2001], and Makinen and Haslinger [2003]. Already Lions [I9681 devoted a major part of his classical monograph on the optimal control of partial differential equations to the optimization of elliptic systems. Let us also mention that even the very first known problem of the calculus of variations, the brachistochrone studied by Bernoulli back in 1696. is in fact a shape optimization problem. The natural richness of this mathematical research subject, as well as the extremely large field of possible applications, has created the unusual situation that although many important results and methods have already been est- lished, there are still pressing unsolved questions. In this monograph, we aim to address some of these open problems; as a consequence, there is only a minor overlap with the textbooks already existing in the field.
Download or read book Diagnostics for Experimental Thermonuclear Fusion Reactors written by Giuseppe Gorini and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 631 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book of proceedings collects the papers presented at the Workshop on Diagnostics for ITER, held at Villa Monastero, Varenna (Italy), from August 28 to September 1, 1995. The Workshop was organised by the International School of Plasma Physics "Piero Caldirola. " Established in 1971, the ISPP has organised over fifty advanced courses and workshops on topics mainly related to plasma physics. In particular, courses and workshops on plasma diagnostics (previously held in 1975, 1978, 1982, 1986, and 1991) can be considered milestones in the history of this institution. Looking back at the proceedings of the previous meetings in Varenna, one can appreciate the rapid progress in the field of plasma diagnostics over the past 20 years. The 1995 workshop was co-organised by the Istituto di Fisica del Plasma of the National Research Council (CNR). In contrast to previous Varenna meetings on diagnostics, which have covered diagnostics in present-day tokamaks and which have had a substantial tutorial component, the 1995 workshop concentrated specifically on the problems and challenges of ITER diagnostics. ITER (the International Thennonuclear Experimental Reactor, a joint venture of Europe, Japan, Russia, and the United States, presently under design) will need to measure a wide range of plasma parameters in order to reach and sustain high levels of fusion power. A list of the measurement requirements together with the parameter ranges, target measurement resolutions, and accuracies provides the starting point for selecting a list of candidate diagnostic systems.
Download or read book New Technical Books written by New York Public Library and published by . This book was released on 1990 with total page 428 pages. Available in PDF, EPUB and Kindle. Book excerpt:
