Download or read book Notice of Construction Work in Tank Farm Waste Transfer Pit 244 TX Double Contained Receiver tank written by and published by . This book was released on 1999 with total page 34 pages. Available in PDF, EPUB and Kindle. Book excerpt: The following description and any attachments and references are provided to the Washington State Department of Health (WDOH), Division of Radiation Protection, Air Emissions & Defense Waste Section as a notice of construction (NOC) in accordance with Washington Administrative Code (WAC) 246-247, Radiation Protection - Air Emissions. WAC 246-247-060, ''Applications, registration, and licensing'', states ''This section describes the information requirements for approval to construct, modify, and operate an emission unit. Any NOC requires the submittal of information listed in Appendix A, '' Appendix A (WAC 246-247-1 10) lists the requirements that must be addressed. Additionally, the following description, attachments, and references are provided to the U.S. Environmental Protection Agency (EPA) as an NOC, in accordance with Title 40 Code of Federal Regulations (CFR), Part 61, ''National Emission Standards for Hazardous Air Pollutants.'' The information required for submittal to the EPA is specified in 40 CFR 61.07. The potential emissions from this activity are estimated to provide less than 0.1 milliredyear total effective dose equivalent to the hypothetical offsite maximally exposed individual, and commencement is needed within a short time. Therefore, this application also is intended to provide notification of the anticipated date of initial startup in accordance with the requirement listed in 40 CFR 61.09(a)(1), and it is requested that approval of this application also will constitute EPA acceptance of this initial startup notification. Written notification of the actual date of initial startup, in accordance with the requirement listed in 40 CFR 61.09(a)(2), will be provided later. The activities described in this NOC are estimated to provide a potential offsite (unabated) total effective dose equivalent (TEDE) to the hypothetical maximally exposed individual (MEI) of 2.36 E-02 millirem per year.
Download or read book Notice of Construction Work in Tank Farm Waste Transfer Pit 241 UX 154 Double contained Receiver Tank written by and published by . This book was released on 1999 with total page 34 pages. Available in PDF, EPUB and Kindle. Book excerpt: The following description and any attachments and references are provided to the Washington State Department of Health (WDOH), Division of Radiation Protection, Air Emissions & Defense Waste Section as a notice of construction (NOC) in accordance with Washington Administrative Code (WAC) 246-247, Radiation Protection - Air Emissions. WAC 246-247-060, ''Applications, registration, and licensing'', states ''This section describes the information requirements for approval to construct, modify, and operate an emission unit. Any NOC requires the submittal of information listed in Appendix A, '' Appendix A (WAC 246-247-110) lists the requirements that must be addressed. Additionally, the following description, attachments, and references are provided to the U.S. Environmental Protection Agency (EPA) as an NOC, in accordance with Title 40 Code of Federal Regulations (CFR), Part 61, ''National Emission Standards for Hazardous Air Pollutants.'' The information required for submittal to the EPA is specified in 40 CFR 61.07. The potential emissions from this activity are estimated to provide less than 0.1 millirem/year total effective dose equivalent to the hypothetical offsite maximally exposed individual, and commencement is needed within a short time. Therefore, this application also is intended to provide notification of the anticipated date of initial startup in accordance with the requirement listed in 40 CFR 61.09(a)(1), and it is requested that approval of this application also will constitute EPA acceptance of this initial startup notification. Written notification of the actual date of initial startup, in accordance with the requirement listed in 40 CFR 61.09(a)(2), will be provided later. The activities described in this NOC are estimated to provide a potential offsite (unabated) total effective dose equivalent (TEDE) to the hypothetical maximally exposed individual (h4EI) of 1.53 E02 millirem per year.
Download or read book EPA Publications Bibliography written by and published by . This book was released on 1999 with total page 752 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Water Code written by Texas and published by . This book was released on 1972 with total page 548 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Design Review Report AN Valve Pit Upgrades for Project W 314 Tank Farm Restoration and Safe Operations written by and published by . This book was released on 2001 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: This Design Review Report (DRR) documents the contractor design verification methodology and records associated with project W-314's AN Valve Pit Upgrades design package. The DRR includes the documented comments and their respective dispositions for this design. Acceptance of the comment dispositions and closure of the review comments is indicated by the signatures of the participating reviewers. Project W-314, Tank Farm Restoration and Safe Operations, is a project within the Tank Waste Remediation System (TWRS) Tank Waste Retrieval Program. This project provides capital upgrades for the existing Hanford tank farms' waste transfer, instrumentation, ventilation, and electrical infrastructure systems. To support established TWRS programmatic objectives, the project is organized into two distinct phases. The initial focus of the project (i.e., Phase 1) is on waste transfer system upgrades needed to support the TWRS Privatization waste feed delivery system. Phase 2 of the project will provide upgrades to support resolution of regulatory compliance issues, improve tank infrastructure reliability, and reduce overall plant operating/maintenance costs. Within Phase 1 of the W-314 project, the waste transfer system upgrades are further broken down into six major packages which align with the project's work breakdown structure. Each of these six sub-elements includes the design, procurement, and construction activities necessary to accomplish the specific tank farm upgrades contained within the package. The first package to be performed is the AN Valve Pit Upgrades package. The scope of the modifications includes new pit cover blocks, valve manifolds, leak detectors, transfer line connections (for future planned transfer lines), and special protective coating for the 241-AN-A and 241-AN-B valve pits.
Download or read book Notice of Construction Work in Tank Farm 241 UX 154 Diversion Box written by United States. Department of Energy. Richland Operations Office and published by . This book was released on 1999 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Notice of Construction for Tank Waste Remediation System Vadose Zone Characterization written by United States. Department of Energy. Office of River Protection and published by . This book was released on 2000 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Commerce Business Daily written by and published by . This book was released on 2000-10 with total page 1516 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book 60 day Waste Compatibility Safety Issues and Final Results for TX 244 Grab Samples written by and published by . This book was released on 1997 with total page 290 pages. Available in PDF, EPUB and Kindle. Book excerpt: Three grab samples (244-TX-96-1, 244-TX-96-2, and 244-TX-96-3) were taken from Riser 8 of Tank 241-TX-244 on October 18, 1996, and received by 222-S Laboratory on October 18, 1996. These samples were analyzed in accordance with Compatibility Grab Sampling and Analysis Plan (TSAP) and Data Quality Objectives for Tank Farms Waste Compatibility Program (DQO) in support ofthe Waste Compatibility Program. Notifications were made in accordance with TSAP for pH and OH- analyses. Upon further review, the pH notification was deemed unnecessary, as the notification limit did not apply to this tank.
Download or read book Evaluation of Tank Waste Transfers at 241 AW Tank Farm written by and published by . This book was released on 2001 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: A number of waste transfers are needed to process and feed waste to the private contractors in support of Phase 1 Privatization. Other waste transfers are needed to support the 242-A Evaporator, saltwell pumping, and other ongoing Tank Waste Remediation System (TWRS) operations. The purpose of this evaluation is to determine if existing or planned equipment and systems are capable of supporting the Privatization Mission of the Tank Farms and continuing operations through the end of Phase 1B Privatization Mission. Projects W-211 and W-314 have been established and will support the privatization effort. Equipment and system upgrades provided by these projects (W-211 and W-314) will also support other ongoing operations in the tank farms. It is recognized that these projects do not support the entire transfer schedule represented in the Tank Waste Remediation system Operation and Utilization Plan. Additionally, transfers surrounding the 241-AW farm must be considered. This evaluation is provided as information, which will help to define transfer paths required to complete the Waste Feed Delivery (WFD) mission. This document is not focused on changing a particular project, but it is realized that new project work in the 241-AW Tank Farm is required.
Download or read book EPA 745 B written by and published by . This book was released on 2000 with total page 186 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Onsite Wastewater Treatment Systems Manual written by and published by . This book was released on 2002 with total page 378 pages. Available in PDF, EPUB and Kindle. Book excerpt: "This manual contains overview information on treatment technologies, installation practices, and past performance."--Introduction.
Download or read book Conceptual Design Report for Tank Farm Restoration and Safe Operations Project W 314 written by and published by . This book was released on 1996 with total page 353 pages. Available in PDF, EPUB and Kindle. Book excerpt: This Conceptual Design Report (CDR) presents the conceptual level design approach that satisfies the established technical requirements for Project W-314, T̀ank Farm Restoration and Safe Operations. ̀The CDR also addresses the initial cost and schedule baselines for performing the proposed Tank Farm infrastructure upgrades. The scope of this project includes capital improvements to Hanfords̀ existing tank farm facilities(primarily focused on Double- Shell Tank Farms) in the areas of instrumentation/control, tank ventilation, waste transfer, and electrical systems.
Download or read book Property Code written by Texas and published by . This book was released on 2014 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Natural Resources Code written by Texas and published by . This book was released on 1978 with total page 588 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Fundamentals of Fire Fighter Skills written by David Schottke and published by Jones & Bartlett Publishers. This book was released on 2014 with total page 1229 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Chemical Engineering Design written by Gavin Towler and published by Elsevier. This book was released on 2012-01-25 with total page 1321 pages. Available in PDF, EPUB and Kindle. Book excerpt: Chemical Engineering Design, Second Edition, deals with the application of chemical engineering principles to the design of chemical processes and equipment. Revised throughout, this edition has been specifically developed for the U.S. market. It provides the latest US codes and standards, including API, ASME and ISA design codes and ANSI standards. It contains new discussions of conceptual plant design, flowsheet development, and revamp design; extended coverage of capital cost estimation, process costing, and economics; and new chapters on equipment selection, reactor design, and solids handling processes. A rigorous pedagogy assists learning, with detailed worked examples, end of chapter exercises, plus supporting data, and Excel spreadsheet calculations, plus over 150 Patent References for downloading from the companion website. Extensive instructor resources, including 1170 lecture slides and a fully worked solutions manual are available to adopting instructors. This text is designed for chemical and biochemical engineering students (senior undergraduate year, plus appropriate for capstone design courses where taken, plus graduates) and lecturers/tutors, and professionals in industry (chemical process, biochemical, pharmaceutical, petrochemical sectors). New to this edition: Revised organization into Part I: Process Design, and Part II: Plant Design. The broad themes of Part I are flowsheet development, economic analysis, safety and environmental impact and optimization. Part II contains chapters on equipment design and selection that can be used as supplements to a lecture course or as essential references for students or practicing engineers working on design projects. New discussion of conceptual plant design, flowsheet development and revamp design Significantly increased coverage of capital cost estimation, process costing and economics New chapters on equipment selection, reactor design and solids handling processes New sections on fermentation, adsorption, membrane separations, ion exchange and chromatography Increased coverage of batch processing, food, pharmaceutical and biological processes All equipment chapters in Part II revised and updated with current information Updated throughout for latest US codes and standards, including API, ASME and ISA design codes and ANSI standards Additional worked examples and homework problems The most complete and up to date coverage of equipment selection 108 realistic commercial design projects from diverse industries A rigorous pedagogy assists learning, with detailed worked examples, end of chapter exercises, plus supporting data and Excel spreadsheet calculations plus over 150 Patent References, for downloading from the companion website Extensive instructor resources: 1170 lecture slides plus fully worked solutions manual available to adopting instructors
