Download or read book GASOLINE VEHICLE EXHAUST PARTICLE SAMPLING STUDY written by J. Johnson and published by . This book was released on 2003 with total page 11 pages. Available in PDF, EPUB and Kindle. Book excerpt: The University of Minnesota collaborated with the Paul Scherrer Institute, the University of Wisconsin (UWI) and Ricardo, Inc to physically and chemically characterize the exhaust plume from recruited gasoline spark ignition (SI) vehicles. The project objectives were: (1) Measure representative particle size distributions from a set of on-road SI vehicles and compare these data to similar data collected on a small subset of light-duty gasoline vehicles tested on a chassis dynamometer with a dilution tunnel using the Unified Drive Cycle, at both room temperature (cold start) and 0 C (cold-cold start). (2) Compare data collected from SI vehicles to similar data collected from Diesel engines during the Coordinating Research Council E-43 project. (3) Characterize on-road aerosol during mixed midweek traffic and Sunday midday periods and determine fleet-specific emission rates. (4) Characterize bulk- and size-segregated chemical composition of the particulate matter (PM) emitted in the exhaust from the gasoline vehicles. Particle number concentrations and size distributions are strongly influenced by dilution and sampling conditions. Laboratory methods were evaluated to dilute SI exhaust in a way that would produce size distributions that were similar to those measured during laboratory experiments. Size fractionated samples were collected for chemical analysis using a nano-microorifice uniform deposit impactor (nano-MOUDI). In addition, bulk samples were collected and analyzed. A mixture of low, mid and high mileage vehicles were recruited for testing during the study. Under steady highway cruise conditions a significant particle signature above background was not measured, but during hard accelerations number size distributions for the test fleet were similar to modern heavy-duty Diesel vehicles. Number emissions were much higher at high speed and during cold-cold starts. Fuel specific number emissions range from 1012 to 3 x 1016 particles/kg fuel. A simple relationship between number and mass emissions was not observed. Data were collected on-road to compare weekday with weekend air quality around the Twin Cities area. This portion of the study resulted in the development of a method to apportion the Diesel and SI contribution to on-road aerosol.

Download or read book Automobile Exhaust Emission Testing written by H. Klingenberg and published by Springer. This book was released on 1996-09-17 with total page 383 pages. Available in PDF, EPUB and Kindle. Book excerpt: Differing legislation between the countries or unions of countries involved in pollution reduction has turned gas measuring technology into such an extremely extensive and complex field that only a few specialists in environmental agencies and the automobile industry have a grasp of it. This book is intended as an overview of the basics of exhaust gas measuring technology describing the interrelation between emissions, immissions and the effects of pollutants. It aims to provide experts and students alike with an understanding of the interrelationships and details within this field. The results presented are based on the experience gathered by the author during work spanning more than two decades in the automobile industry.

Download or read book Physical Characterization of Exhaust Particle Emissions from Late Technology Gasoline Vehicles written by Giorgio Martini and published by . This book was released on 2012 with total page 55 pages. Available in PDF, EPUB and Kindle. Book excerpt: The study assesses the feasibility of introducing the regulated particle number measurement procedure for the regulation of gasoline vehicles, focusing on the established cut-off size of 23 nm. A range of late technology gasoline vehicles were tested under regulated and unregulated test conditions. The results indicated a distinct emission behavior of Direct Injection Gasolines (G-DI), Port Fuel Injection gasolines (PFI) and Diesels equipped with Particulate Filters (DPF), that differed both in terms of the absolute levels but also with respect to the fraction of undetected nano-sized non-volatile particles. The latter was found to be around 20% (based on comparisons with a Condensation Particle Counter (CPC) having a 50% cut-off size at 4.5 nm) for three G-DI vehicles tested, but ranged between 40 and 70% for the two PFIs measured. Interestingly, a relatively large fraction of undetected nanosized was also observed for two late technology DPFs, ranging between 30 and 50%.^To a large extent these differences originate from differences in the size distributions and the relatively blunt shape of the counting efficiency curve of PMP compliant CPCs. Under conditions favouring nucleation mode formation in the dilution tunnel, excessive particle concentrations were detected by the low cut-off size CPCs, and especially the one with a d50 at 4.5 nm, that could exceed those of the PMP compliant CPC by up to one order of magnitude. However, the concentration of these nano-sized particles was found to decrease with increasing the dilution ratio in the first stage of the Volatile Particle Remover (VPR), indicating that this is rather a volatile artifact possibly originating from re-nucleation of evaporated material downstream of the VPR. The study also investigated the potential offered by a range of available approaches to effectively control particle emissions from G-DIs.^These included the use of a Gasoline Particulate Filter (GPF), the introduction of ethanol in the fuel but also an advanced engine concept combining port and direct fuel injection. The GPF system was found to very efficient in controlling particle number emissions under all driving conditions, having no visible impact on carbon dioxide emissions. The use of fuel with hi-ethanol content (75-85%) was also found to be beneficial especially at high engine loads (up to 97% reduction of nonvolatile particle numbers) and during cold start operation (up to 70% reduction). The tests with the "hybrid" G-DI-PFI vehicle indicated that there exists the potential for significant reduction of PM formation through engine measures. The non-volatile particle number emissions of this vehicle remained below the diesel limit over all hot start tests.

Download or read book Evaluation of Particulate Matter Emissions of Light duty Gasoline Vehicles Operating in California written by Wei Li and published by . This book was released on 2007 with total page 310 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Nanoparticle Emissions From Combustion Engines written by Jerzy Merkisz and published by Springer. This book was released on 2015-03-19 with total page 146 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book focuses on particulate matter emissions produced by vehicles with combustion engines. It describes the physicochemical properties of the particulate matter, the mechanisms of its formation and its environmental impacts (including those on human beings). It discusses methods for measuring particulate mass and number, including the state-of-the-art in Portable Emission Measurement System (PEMS) equipment for measuring the exhaust emissions of both light and heavy-duty vehicles and buses under actual operating conditions. The book presents the authors’ latest investigations into the relations between particulate emission (mass and number) and engine operating parameters, as well as their new findings obtained through road tests performed on various types of vehicles, including those using diesel particulate filter regeneration. The book, which addresses the needs of academics and professionals alike, also discusses relevant European regulations on particulate emissions and highlights selected methods aimed at the reduction of particulate emissions from automobiles.

Download or read book Particulate Emissions of Gasoline Vehicles and Influence of the Sampling Procedure written by Martin Mohr and published by . This book was released on 2000 with total page 10 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Characterization of Particulate Emissions from Gasoline fueled Vehicles written by Joseph M. Norbeck and published by . This book was released on 1998 with total page 138 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Diesel and Gasoline Engine Exhausts and Some Nitroarenes written by IARC Working Group on the Evaluation of Carcinogenic Risks to Humans and published by IARC Monographs on the Evaluat. This book was released on 2015-06-04 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume of the IARC Monographs provides evaluations of the carcinogenicity of diesel and gasoline engine exhausts, and of 10 nitroarenes found in diesel engine exhaust: 3,7-dinitrofluoranthene, 3,9-dinitrofluoranthene, 1,3-dinitropyrene, 1,6-dinitropyrene, 1,8-dinitropyrene, 6-nitrochrysene, 2-nitrofluorene, 1-nitropyrene, 4-nitropyrene, and 3-nitrobenzanthrone. Diesel engines are used for transport on and off roads (e.g. passenger cars, buses, trucks, trains, ships), for machinery in various industrial sectors (e.g. mining, construction), and for electricity generators, particularly in developing countries. Gasoline engines are used in cars and hand-held equipment (e.g. chainsaws). The emissions from such combustion engines comprise a complex and varying mixture of gases (e.g. carbon monoxide, nitrogen oxides), particles (e.g. PM10, PM2.5, ultrafine particles, elemental carbon, organic carbon, ash, sulfate, and metals), volatile organic compunds (e.g. benzene, formaldehyde) and semi-volatile organic compounds (e.g. polycyclic aromatic hydrocarbons) including oxygenated and nitrated derivatives of polycyclic aromatic hydrocarbons. Diesel and gasoline engines thus make a significant contribution to a broad range of air pollutants to which people are exposed in the general population as well as in different occupational settings. An IARC Monographs Working Group reviewed epidemiological evidence, animal bioassays, and mechanistic and other relevant data to reach conclusions as to the carcinogenic hazard to humans of environmental or occupational exposure to diesel and gasoline engine exhausts (including those associated with the mining, railroad, construction, and transportation industries) and to 10 selected nitroarenes. -- Back cover.

Download or read book Particulate Emissions from Vehicles written by Peter Eastwood and published by John Wiley & Sons. This book was released on 2008-04-15 with total page 512 pages. Available in PDF, EPUB and Kindle. Book excerpt: The public health risks posed by automotive particulate emissions are well known. Such particles are sufficiently small to reach the deepest regions of the lungs; and moreover act as carriers for many potentially toxic substances. Historically, diesel engines have been singled out in this regard, but recent research shows the need to consider particulate emissions from gasoline engines as well. Already implicated in more than one respiratory disease, the strongest evidence in recent times points to particle-mediated cardiovascular disorders (strokes and heart attacks). Accordingly, legislation limiting particulate emissions is becoming increasingly stringent, placing great pressure on the automotive industry to produce cleaner vehicles - pressure only heightened by the ever-increasing number of cars on our roads. Particulate Emissions from Vehicles addresses a field of increased international interest and research activity; discusses the impact of new legislation globally on the automotive industry; and explains new ways of measuring particle size, number and composition that are currently under development. The expert analysis and summary of the state-of-the-art, which encompasses the key areas of combustion performance, measurement techniques and toxicology, will appeal to R&D practitioners and engineers working in the automotive industry and related mechanical fields, as well as postgraduate students and researchers of engine technology, air pollution and life/ environmental science. The public health aspects will also appeal to the biomedical research community.

Download or read book Particulate Matter Mass Measurement and Physical Characterization written by and published by . This book was released on 2004 with total page 110 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book WHO global air quality guidelines written by Weltgesundheitsorganisation and published by World Health Organization. This book was released on 2021-09-07 with total page 300 pages. Available in PDF, EPUB and Kindle. Book excerpt: The main objective of these updated global guidelines is to offer health-based air quality guideline levels, expressed as long-term or short-term concentrations for six key air pollutants: PM2.5, PM10, ozone, nitrogen dioxide, sulfur dioxide and carbon monoxide. In addition, the guidelines provide interim targets to guide reduction efforts of these pollutants, as well as good practice statements for the management of certain types of PM (i.e., black carbon/elemental carbon, ultrafine particles, particles originating from sand and duststorms). These guidelines are not legally binding standards; however, they provide WHO Member States with an evidence-informed tool, which they can use to inform legislation and policy. Ultimately, the goal of these guidelines is to help reduce levels of air pollutants in order to decrease the enormous health burden resulting from the exposure to air pollution worldwide.

Download or read book Smog Chamber Reactivities of Emissions from Leaded and Lead free Fuels written by G. P. Sturm and published by . This book was released on 1973 with total page 22 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Analysis of Vehicle derived Particulate Matter Emissions Using Pyrolysis gas Chromatography mass Spectrometry and Laser Desorption ionization Time of flight Mass Spectrometry written by Saskia Katherine Bianca Van Bergen and published by . This book was released on 2003 with total page 266 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Particulate Measurements and Emissions Characterization of Alternative Fuel Vehicle Exhaust written by Thomas D. Durbin and published by . This book was released on 1998 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Characterization of Gas and Particle phase Emissions from On road Motor Vehicles written by George Alexander Ban-Weiss and published by . This book was released on 2008 with total page 414 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Size and Composition Quantification of Particulate Matter Emissions from Motor Vehicles written by Michael Arthur Robert and published by . This book was released on 2008 with total page 400 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Size Distribution and Mass Output of Particulates from Diesel Engine Exhausts written by John A. Breslin and published by . This book was released on 1976 with total page 20 pages. Available in PDF, EPUB and Kindle. Book excerpt: