Download or read book Evaluation and Summary of Studies in Speed Control Methods in Work Zones written by R. F. Benekohal and published by . This book was released on 1992 with total page 114 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report summarizes and evaluates the important findings from the literature review of the studies on work zone speed control techniques. The following treatments are included in this report: 1) flagging, 2) lane width reduction, 3) law enforcement, 4) changeable message signs (CMS), 5) rumble strips, and 6) flashing beacons. The effects of the speed control treatments on speed and traffic flow are evaluated based on: A) experiences with treatment, B) effects of treatment on speed, C) effectiveness of treatment, and D) comments about treatment. A brief description of the conditions under which the treatments were applied is provided, and the speed reduction effects of each technique are discussed. A reference matrix was prepared to identify publications related to each type of speed reduction treatment used in work zones.
Download or read book Speed Reduction Methods and Studies in Work Zones written by R. F. Benekohal and published by . This book was released on 1992 with total page 82 pages. Available in PDF, EPUB and Kindle. Book excerpt: The objectives of this project were to determine the effectiveness of speed control methods and study traffic behavior in construction zones. This report provides a brief introduction and summary of findings from the following reports which were prepared as part of this study: (1) Evaluation and Summary of Studies in Speed Control Methods in Work Zones. (2) Evaluation of a Radar-Activated Horn System for Speed Control in Highway Maintenance Operations. (3) Survey of Driver's Opinion about Work Zone Traffic Control on a Rural Highway. (4) Speed Reduction Effects of Drone Radar in Rural Interstate Work Zones. (5) Speed Reduction Effects of Changeable Message Signs in a Construction Zone. (6) Effects of Police Presence on Speed in a Highway Work Zone: Circulating Marked Police Car Experiment. (7) Evaluation of Work Zone Speed Limit Signs with Strobe Lights. (8) Speed Reduction Profiles of Vehicles in a Highway Construction zone. Data only for those vehicles in free flow traffic are used for speed reduction evaluation. A vehicle was considered to be in free flow traffic when its time headway was greater than 5 seconds.
Download or read book Speed Reduction Methods and Studies in Work Zones written by R. F. Benekohal and published by . This book was released on 1992 with total page 82 pages. Available in PDF, EPUB and Kindle. Book excerpt: The objectives of this project were to determine the effectiveness of speed control methods and study traffic behavior in construction zones. This report provides a brief introduction and summary of findings from the following reports which were prepared as part of this study: (1) Evaluation and Summary of Studies in Speed Control Methods in Work Zones. (2) Evaluation of a Radar-Activated Horn System for Speed Control in Highway Maintenance Operations. (3) Survey of Driver's Opinion about Work Zone Traffic Control on a Rural Highway. (4) Speed Reduction Effects of Drone Radar in Rural Interstate Work Zones. (5) Speed Reduction Effects of Changeable Message Signs in a Construction Zone. (6) Effects of Police Presence on Speed in a Highway Work Zone: Circulating Marked Police Car Experiment. (7) Evaluation of Work Zone Speed Limit Signs with Strobe Lights. (8) Speed Reduction Profiles of Vehicles in a Highway Construction zone. Data only for those vehicles in free flow traffic are used for speed reduction evaluation. A vehicle was considered to be in free flow traffic when its time headway was greater than 5 seconds.
Download or read book Speed Control Through Work Zones written by and published by . This book was released on 1987 with total page 56 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Evaluation of Work Zone Speed Limit Signs with Strobe Lights written by R. F. Benekohal and published by . This book was released on 1992 with total page 98 pages. Available in PDF, EPUB and Kindle. Book excerpt: The construction zone speed limit sign used in Illinois consists of a regulatory 45 mph speed limit sign augmented with two small strobe lights and two orange colored plates. When the lights are flashing the speed limit is 45 mph. This report contains the findings from evaluation of the effectiveness of the flashing lights in reducing speeds in a rural interstate construction zone. The speed reduction effects on cars and trucks were determined at two locations within the work zone. The results indicated that the average speed of cars was reduced by 1.9-7.1 mph and that of trucks by 1.3-6.0 mph when the strobe lights were flashing. In general, the speed reduction effects were more pronounced on the cars than on the trucks, and at a location past the work space than before it. The reductions at the location past the work space were 2-3 times more than the reductions at the location before the work space. Cars reduced their speeds, on the average, by 1.9 to 4.9 mph before and by 5.9 to 7.1 mph after the work space. Similarly, the speed reduction for trucks was 1.3-2.9 mph before and 3.3-6.0 after the work space. In general, the percentages of vehicles with excessive speeds in the work zone decreased when the lights were flashing.
Download or read book Controlling Speeds in Highway Work Zones written by Stephen H. Richards and published by . This book was released on 1984 with total page 104 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Evaluation of Work Zone Speed Reduction Measures written by T. H. Maze and published by . This book was released on 2000 with total page 146 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Iowa Department of Transportation (DOT) has made improving work zone (WZ) safety a high priority. Managing vehicle speeds through work zones is perceived to be an important factor in achieving this goal. A number of speed reduction techniques are currently used by transportation agencies throughout the country to control speeds and reduce speed variation at work zones. The purpose of this project is to study these and other applicable work zone speed reduction strategies. Furthermore, this research explores transportation agencies' policies regarding managing speeds in long-term, short-term, and moving work zones. This report consists of three chapters. The first chapter, a literature review, examines the current speed reduction practices at work zones and provides a review of the relevant literature. The speed control strategies reviewed in this chapter range from posting regulatory and advisory speed limit signs to using the latest radar technologies to reduce speeds at work zones. The second chapter includes a short write-up for each identified speed control technique. The write-up includes a description, the results of any field tests, the benefits and the costs of the technology or technique. To learn more about other state policies regarding work zone speed reduction and management, the Center for Transportation Research and Education conducted a survey. The survey consists of six multipart questions. The third chapter provides summaries of the response to each question.
Download or read book Effects of Police Presence on Speed in a Highway Work Zone written by R. F. Benekohal and published by . This book was released on 1992 with total page 84 pages. Available in PDF, EPUB and Kindle. Book excerpt: This study evaluated the effects of police presence on the speed of vehicles in a work zone and determined the "halo" effects of police presence (lasting effects when police are gone) on vehicular speeds. A marked police car circulated in a 4-mile long interstate highway work zone and actively enforced the speed limit laws. Variables such as the average speed, speed distribution, percentage of fast-moving motorists, and net speed reductions for cars and trucks were used for evaluation. The results indicated that the average speeds of the cars and trucks were 4.3-4.4, and 4.3-5.0 mph, respectively, lower when police were patrolling the work zone compared to no-police patrol condition. The percentage of fast-moving cars and trucks before the work space decreased by 14% and 32%, respectively, when police were in the work zone. These speed reductions indicate that the police presence was effective in decreasing the speed of vehicles in the work zone. The police presence had halo effects on trucks but not on cars. Trucks traveled at reduced speed when police were present in the work zone and this trend of traveling at the reduced speed continued for a time period at least one hour after the police departed from the work zone. However, cars traveled 2. 4-3. o mph faster and the percentage of fast-moving cars in the work zone increased after the police left the area.
Download or read book An Evaluation of Speed Control Techniques in Work Zones work Zones 2 written by R. W. Lyles and published by . This book was released on 1999 with total page 22 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book FHWA Nationally Coordinated Program of Highway Research Development and Technology Annual Progress Report Fiscal Year 1992 written by and published by . This book was released on 1992 with total page 148 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Speed Control Through Freeway Work Zones written by and published by . This book was released on 1988 with total page 39 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Better Management of Speed Control in Work Zones written by and published by . This book was released on 2006 with total page 116 pages. Available in PDF, EPUB and Kindle. Book excerpt: Statistics from the South Carolina Department of Transportation (SCDOT) for incidents between 1998 and 2002 reveal that a leading cause of crashes in work zones is driving too fast for conditions. In April 2005, a team of researchers led by Clemson University Transportation Systems Laboratory embarked on research to better manage speed control in work zones. The research tasks included field trials of several devices, a literature review, and a survey of states. Based on the literature review and meetings with the project steering committee, a number of devices and strategies were selected for field evaluation. The selected devices included drone radar, changeable message sign with radar (CMR), a speed monitoring display (SMD) with CMS, portable rumble strips, and a novel speed activated sign designed by the researchers. Each of the devices had to be acquired and/or developed for this project and preliminary testing was conducted to identify an acceptable configuration for actual data collection. After the initial testing, field surveillance of the speed management devices at a variety of different work zone sites on interstates and state route highways in South Carolina was completed to collect the empirical data needed for evaluation. Both quantitative and qualitative analyses of the performance of the devices and strategies were completed. Some of the devices were also studied in combination with police enforcement. The results of the analysis show that all of the speed control devices studied during this project has the capability of lowering speeds. This report summarizes the findings of this research and provides several recommendations in choosing a speed control device for a particular work zone application.
Download or read book Highway Research Abstracts written by and published by . This book was released on 1994 with total page 1006 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Corridor Traffic Management for Major Highway Reconstruction written by and published by . This book was released on 1986 with total page 284 pages. Available in PDF, EPUB and Kindle. Book excerpt: This publication, which describes reconstruction experiences, gives case studies which document the varied projects, and gives specific ideas for the management of major highway reconstruction. This report also discusses the use of incentive/disincentive provisions for early contract completion. Ways to expedite expressway and bridge rehabilitation are summarized, and a policy statememt is provided on the application of traffic management actions. Abstracts and summaries are given of recently published literature in the area of corridor traffic management for temporary flow disruptions.
Download or read book Evaluation of Traffic Controls for Highway Work Zones written by Richard F. Pain and published by . This book was released on 1979 with total page 192 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Civil Engineering Studies written by and published by . This book was released on 1992 with total page 488 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Speed Reduction Effects of Changeable Message Signs in a Construction Zone written by R. F. Benekohal and published by . This book was released on 1992 with total page 94 pages. Available in PDF, EPUB and Kindle. Book excerpt: This study evaluated the vehicular speed reduction effects of displaying speed limit and information messages on a changeable message sign (CMS) placed inside the work activity area in a work zone for a one lane closure on a rural interstate highway. It also examined the additional effects of using two CMS devices compared to one CMS. The following three experiments were conducted: (1) One CMS in advance of the work zone (Experiment 1), (2) One CMS inside the work activity area (Experiment 2), and (3) Two CMSs inside the work activity area (Experiment 3). Displaying speed limit and information messages on CMSs placed in the work activity area was effective in reducing the average speed and percentages of vehicles with excessive speeds. Comparing the results from Experiments 2 and 3 indicated that displaying the CMS messages reduced the speed of cars immediately after passing the CMS, but not at a point far from the CMS. Although trucks did not consistently reduce their speeds near the first CMS, trucks traveled at reduced speeds after passing the CMS. Cars and trucks reduced their speeds by as much as 5 and 4 mph, respectively, near the CMS. The speed reduction depended on the travel speed of the vehicles. Placing the CMS in the work activity area was more effective than putting it in advance of the work zone.