Download or read book Development of Laser induced Fluorescence to Quantify In cylinder Fuel Wall Films written by and published by . This book was released on with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Development of a Laser Induced Fluorescence System for Measuring Oil Film Thickness in Two Dimensions in a Reciprocating Engine written by Pierre Miguel Mulgrave and published by . This book was released on 1997 with total page 165 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Strategies for Planar Laser induced Fluorescence Thermometry in Shock Tube Flows written by Ji Hyung Yoo and published by Stanford University. This book was released on 2011 with total page 151 pages. Available in PDF, EPUB and Kindle. Book excerpt: This thesis was motivated by the need to better understand the temperature distribution in shock tube flows, especially in the near-wall flow regions. Two main ideas in planar laser-induced fluorescence (PLIF) diagnostics are explored in this thesis. The first topic is the development of a single-shot PLIF diagnostic technique for quantitative temperature distribution measurement in shock tube flow fields. PLIF is a non-intrusive, laser-based diagnostic technique capable of instantaneously imaging key flow features, such as temperature, pressure, density, and species concentration, by measuring fluorescence signal intensity from laser-excited tracer species. This study performed a comprehensive comparison of florescence tracers and excitation wavelengths to determine the optimal combination for PLIF imaging in shock tube flow applications. Excitation of toluene at 248nm wavelength was determined to be the optimal strategy due to the resulting high temperature sensitivity and fluorescence signal level, compared to other ketone and aromatic tracers at other excitation wavelengths. Sub-atmospheric toluene fluorescence yield data was measured to augment the existing photophysical data necessary for this diagnostic technique. In addition, a new imaging test section was built to allow PLIF imaging in all regions of the shock tube test section, including immediately adjacent to the side and end walls. The signal-to-noise (SNR) and spatial resolution of the PLIF images were optimized using statistical analysis. Temperature field measurements were made with the PLIF diagnostic technique across normal incident and reflected shocks in the shock tube core flow. The resulting images show uniform spatial distribution, and good agreement with conditions calculated from the normal shock jump equations. Temperature measurement uncertainty is about 3.6% at 800K. The diagnostic was also applied to image flow over a wedge. The resulting images capture all the flow features predicted by numerical simulations. The second topic is the development of a quantitative near-wall diagnostic using tracer-based PLIF imaging. Side wall thermal boundary layers and end wall thermal layers are imaged to study the temperature distribution present under constant pressure conditions. The diagnostic technique validated in the shock tube core flow region was further optimized to improve near-wall image quality. The optimization process considered various wall materials, laser sheet orientations, camera collection angles, and optical components to find the configuration that provides the best images. The resulting images have increased resolution (15[Mu]m) and are able to resolve very thin non-uniform near-wall temperature layers (down to 60[Mu]m from the surface). The temperature field and thickness measurements of near-wall shock tube flows under various shock conditions and test gases showed good agreement with boundary layer theory. To conclude this thesis, new applications and future improvements to the developed PLIF diagnostic technique are discussed. These suggested refinements can provide an even more robust and versatile PLIF imaging technique capable of measuring a wider range of flow conditions near walls.

Download or read book Development and Optimisation of Two line Planar Laser Induced Fluorescence Technique for Combustion Measurements written by Mohammadreza Anbari Attar and published by . This book was released on 2012 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: This study has focused on development, optimisation and implementation of the 2-line Planar Laser Induced Fluorescence (2-line PLIF) technique for combustion measurements on a single cylinder optical Gasoline Direct Injection (GDI) engine with both Spark Ignition (SI) and Controlled Auto Ignition (CAI) combustion operations. The CAI combustion was achieved by employing Negative Valve Overlap (NVO). Two excitation wavelengths at 308 nm (directly from a XeCl laser) and 277 nm (via Raman shifting a KrF laser output at 248 nm) were exploited for the measurements. A calibration curve of fluorescence signal intensity ratio of the two laser beams as a function of temperature was obtained by conducting a series of static tests on a specially designed Constant Volume Chamber (CVC). The developed technique was validated by measurements of in-cylinder charge temperature during the compression stroke for both motoring and firing cycles and comparing the PLIF values with the temperature values calculated from in-cylinder pressure data assuming a polytropic compression. Following the validation measurements, the technique was applied to study of fuel spray characteristics and simultaneous measurements of in-cylinder charge temperature and mole fraction of Exhaust Gas Residuals (EGR). Further optimisation of the thermometry technique by enhancing the fluorescence Signal to Noise Ratio (SNR) and improving both the temporal and spatial resolutions as well as measurements precision provided the opportunity to apply the technique to other combustion measurements. The thesis presents the first application of the 2-line PLIF diagnostic in study of direct injection charge cooling effects and study of flame thermal stratification in IC engines.

Download or read book Advanced Developments in Ultra Clean Gasoline Powered Vehicles written by Fuquan Zhao and published by SAE International. This book was released on 2004-03-08 with total page 728 pages. Available in PDF, EPUB and Kindle. Book excerpt: During the last several years, significant efforts have been directed toward the development of ultra-clean, gasoline-powered vehicles in the automotive industry. With the coming of increasingly stringent emissions legislation, this development is more critical now than ever before. This has lead to an increase in the technical information available. Advanced Developments in Ultra-Clean Gasoline-Powered Vehicles provides the reader with technical information including a description of fundamental processes, insight on technical issues, key trends, and future R&D directions.

Download or read book Development of a Laser Induced Fluorescence LIF Method to Visualize the Gasoline Distribution in a Sl Engine written by Thomas A. Heinze and published by . This book was released on 1992 with total page 6 pages. Available in PDF, EPUB and Kindle. Book excerpt: Laser Induced Fluorescence (LIF) is used for planar imaging in a Sl engine. The gasoline was seeded with three different dopants: biacetyl, benzaldehyd, and tetramethyl-p-phenylene diamine (TMPD). Specific problems related to the application of LIF measurements in automative engines are discussed. The non-toxic biacetyl has important advantages. In contrast to TMPD and benzaldehyd it has good vaporization properties and its fluorescence is nearly insensitive to oxygen quenching. Therefore it can also be used in fire SI engines. The linearity investigations indicate the quantitative concentration measurements can be obtained. (Author).

Download or read book Investigation of Fuel Film Effects in a Small Air cooled Utility Engine written by Forrest Auchmuty Jehlik and published by . This book was released on 2000 with total page 386 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Calibration of the Laser Induced Fluorescence Technique Applied to Oil Film Thickness Measurements on a Diesel Engine Cylinder Liner by Using Capacitance Gauges written by Dan O. Ducu and published by . This book was released on 1996 with total page 652 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Quantitative Measurements of Liquid Fuel Film on the Piston Top of an Optical direct injection Engine by Laser induced Fluorescence written by Mong-Tung Lin and published by . This book was released on 2004 with total page 392 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Emission Control and Fuel Economy written by John H Johnson and published by SAE International. This book was released on 2005-06-27 with total page 700 pages. Available in PDF, EPUB and Kindle. Book excerpt: Emission and fuel economy regulations and standards are compelling manufacturers to build ultra-low emission vehicles. As a result, engineers must develop spark-ignition engines with integrated emission control systems that use reformulated low-sulfur fuel. Emission Control and Fuel Economy for Port and Direct Injected SI Engines is a collection of SAE technical papers that covers the fundamentals of gasoline direct injection (DI) engine emissions and fuel economy, design variable effects on HC emissions, and advanced emission control technology and modeling approaches. All papers contained in this book were selected by an accomplished expert as the best in the field; reprinted in their entirety, they present a pathway to integrated emission control systems that meet 2004-2009 EPA standards for light-duty vehicles.

Download or read book Measurement of Fuel Dilution of Oil in a Diesel Engine Using Laser Induced Fluorescence Spectroscopy written by and published by . This book was released on 2007 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: A technique for measuring the fuel dilution of oil in a diesel engine is presented. Fuel dilution can occur when advanced in-cylinder fuel injection techniques are employed for the purpose of producing rich exhaust for lean NOx trap catalyst regeneration. Laser-induced fluorescence (LIF) spectroscopy is used to monitor the oil in a Mercedes 1.7-liter engine operated on a dynamometer platform. A fluorescent dye suitable for use in diesel fuel and oil systems is added to the engine fuel. The LIF spectra are monitored to detect the growth of the dye signal relative to the background fluorescence of the oil; fuel mass concentration is quantified based on a known sample set. The technique was implemented with fiber optic probes which can be inserted at various points in the oil system of the engine. A low cost 532-nm laser diode was used for excitation of the fluorescence. Measurements of fuel dilution of oil are presented for various in-cylinder injection strategies for rich operation of the diesel engine. Rates of fuel dilution increase for all strategies relative to normal lean operation, and higher fuel dilution rates are observed when extra fuel injection occurs later in the combustion cycle when fuel penetration into the cylinder wall oil film is more likely.

Download or read book Tracer based Planar Laser induced Fluorescence Diagnostics written by Brian Ho-yin Cheung and published by Stanford University. This book was released on 2011 with total page 197 pages. Available in PDF, EPUB and Kindle. Book excerpt: Two advances to tracer-based planar laser-induced fluorescence (PLIF) diagnostics are presented in this work. The first improvement is the development of a 3-pentanone fluorescence quantum yield (FQY) database and model for a wide range of conditions in support of quantitative PLIF diagnostics. In addition, this work presents a sensitive, time-resolved tracer-based PLIF diagnostic, accomplished by using a continuous-wave (CW) laser with the high-FQY tracer toluene. Because of its ease of use and desirable photophysical properties, PLIF diagnostics using 3-pentanone as a tracer are common, particularly for internal combustion engine (ICE) diagnostics. Thus, there is a need for 3-pentanone FQY measurements and modeling over a wide range of temperatures, pressures, and excitation wavelengths. For insight into the collisionless process in the FQY model, measurements were made in 3-pentanone vapor at low-pressures across a range of temperatures using a flowing cell. Laser excitation with 248, 266, 277, 308 nm wavelengths were utilized, and Rayleigh scattering of the laser beam was used to calibrate the optical efficiency of the collection optics and detector. This low-pressure data allows calculation of the 3-pentanone fluorescence rate and non-radiative de-excitation rate in the fluorescence model. The vibrational relaxation cascade parameter for 3-pentanone collisions was also determined. Measurements of 3-pentanone FQY were also made over a range of temperatures and pressures relevant to diagnostic applications, and, in particular, combined high-temperature and high-pressure conditions applicable to internal combustion engines (ICE). These data were collected in a custom-built optical cell capable of simultaneous high-pressure and high-temperature conditions. The behavior of the FQY in nitrogen for temperatures up to 745 K and in air up to 570 K was examined for pressures from 1 to 25 bar. These data were used to further optimize the parameters in the FQY model representing collisional processes. The large quantity of data with 308 nm excitation allowed optimization of the nitrogen quenching rate, and data in air were used to optimize the oxygen quenching rate. These data were also used to optimize the vibrational relaxation parameters for nitrogen and oxygen. The model with the updated parameters is consistent with the data collected in the current work, as well as with fluorescence measurements made in optical ICEs up to 1100 K and 28 bar. Another area of tracer-based PLIF diagnostics development is time-resolved imaging. Because PLIF diagnostics are often performed using pulsed lasers, the time resolution of measurements is limited to the pulse rate of laser. Use of a high-powered visible laser with an off-the-shelf cavity frequency doubler is shown to produce a moderate-power CW beam in the ultraviolet wavelength regime. Application of this CW source to excite toluene, a high-FQY tracer, yields a sensitive, time-resolved tracer-based PLIF diagnostic. Fluctuation detection limits for tracer mole fraction were investigated by applying the diagnostic to an atmospheric temperature and pressure nitrogen jet seeded with 4% toluene, and detection limits of better than 1% of the maximum toluene mole fraction were achieved for detection of fluorescence signal at a point, along a line, and over a plane. The diagnostic was also demonstrated on a turbulent jet for line and planar detection and demonstrated the potential for toluene time-resolved PLIF diagnostics with CW lasers.

Download or read book Development of Laser induced Fluorescence for Combustion Engine Diagnostics written by Hans Neij and published by . This book was released on 1993 with total page 76 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Technologies for Near Zero Emission Gasoline Powered Vehicles written by Fuquan Zhao and published by SAE International. This book was released on 2006-10-23 with total page 486 pages. Available in PDF, EPUB and Kindle. Book excerpt: Dr. Fuquan (Frank) Zhao and experts in the field address a broad spectrum of key research and development issues in the rapidly progressing area of near-zero-emission gasoline-powered vehicles. Written in response to the increasingly stringent emissions legislation, this book provides the reader with a concise introduction to technology developments in near-zero-emission gasoline-powered vehicles. The material reflects global technical initiatives within the automotive and research communities. In all, this book contains more than 450 pages, with nearly 200 descriptive diagrams and/or images. It will serve as a valuable desk reference and provide the basics for those who are interested in understanding this advancing technology.

Download or read book Fuel Injection written by Daniela Siano and published by BoD – Books on Demand. This book was released on 2010-08-17 with total page 264 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fuel Injection is a key process characterizing the combustion development within Internal Combustion Engines (ICEs) and in many other industrial applications. State of the art in the research and development of modern fuel injection systems are presented in this book. It consists of 12 chapters focused on both numerical and experimental techniques, allowing its proper design and optimization.

Download or read book The Development and Application of Laser induced Fluorescence for the Study of Magnetically Confined Plasmas written by Warren Wright and published by . This book was released on 1989 with total page 584 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1995 with total page 456 pages. Available in PDF, EPUB and Kindle. Book excerpt: Lists citations with abstracts for aerospace related reports obtained from world wide sources and announces documents that have recently been entered into the NASA Scientific and Technical Information Database.