EBookClubs

Read Books & Download eBooks Full Online

EBookClubs

Read Books & Download eBooks Full Online

Book Design and Commissioning of the APS Beam Charge and Current Monitor

Download or read book Design and Commissioning of the APS Beam Charge and Current Monitor written by and published by . This book was released on 1994 with total page 8 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book The Development of Beam Current Monitors in the APS

Download or read book The Development of Beam Current Monitors in the APS written by and published by . This book was released on 1995 with total page 4 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Advanced Photon Source (APS) is a third-generation 7-GeV synchrotron radiation source. The precision measurement of beam current is a challenging task in high energy accelerators, such as the APS, with a wide range of beam parameters and complicated noise, radiation, and thermal environments. The beam pulses in the APS injector and storage ring have charge ranging from 50pC to 25nC with pulse durations varying from 30ps to 30ns. A total of nine non- intercepting beam current monitors have been installed in the APS facility (excluding those in the linac) for general current measurement. In addition, several independent current monitors with specially designed redundant interlock electronics are installed for personnel safety and machine protection. This paper documents the design and development of current monitors in the APS, . discusses the commissioning experience in the past year, and presents the results of recent operations.

Book Logos

    Book Details:
  • Author :
  • Publisher :
  • Release : 1996
  • ISBN :
  • Pages : 88 pages

Download or read book Logos written by and published by . This book was released on 1996 with total page 88 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Initial Commissioning Results from the APS Loss Monitor System

Download or read book Initial Commissioning Results from the APS Loss Monitor System written by and published by . This book was released on 1996 with total page 8 pages. Available in PDF, EPUB and Kindle. Book excerpt: The design of the beam loss monitor system for the Argonne National Laboratory Advanced Photon Source is based on using a number of air dielectric coaxial cables as long ionization chambers. Results to date show that the loss monitor is useful in helping to determine the cause of injection losses and losses large enough to limit circulating currents in the storage ring to short lifetimes. Sensitivities ranging from 13 to 240 pC of charge collected in the injector BTS (booster-to-storage-ring) loss monitor per picocoulomb of loss have been measured, depending on the loss location. These results have been used to predict that the storage ring loss monitor leakage current limit of 10 pA per cable should allow detection of losses resulting in beam lifetimes of 100 hours or less with 100 mA stored beam. Significant DC bias levels associated with the presence of stored beam have been observed. These large bias levels are most likely caused by the loss monitor responding to hard x-ray synchrotron radiation. No such response to synchrotron radiation was observed during earlier tests at SSRL. However, the loss monitor response to average stored beam current in APS has provided a reasonable alternative to the DC current transformer (DCCT) for measuring beam lifetimes.

Book Design of the Beam Shut off Current Monitor Upgrade for the Advanced Photon Source

Download or read book Design of the Beam Shut off Current Monitor Upgrade for the Advanced Photon Source written by and published by . This book was released on 2000 with total page 10 pages. Available in PDF, EPUB and Kindle. Book excerpt: Plans to eliminate the positron accumulator ring (PAR) from the Advanced Photon Source (APS) injector complex have created the need for a device to limit the allowable beam charge injected into the APS injector synchrotrons. The beam shut-off current monitor (BESOCM) was chosen to provide this function. This new application of the BESOCM provided the opportunity to explore new design philosophies. Two design goals were to de-emphasize reliance on external signals and to become insensitive to timing variations. Both of these goals were accomplished by deriving the trigger directly from the beam. This paper will discuss the features of the new BESOCM design and present data demonstrating its function.

Book European Particle Accelerator Conference  Epac 94   In 3 Volumes

Download or read book European Particle Accelerator Conference Epac 94 In 3 Volumes written by Christine Petit-jean-genaz and published by World Scientific. This book was released on 1994-11-26 with total page 2968 pages. Available in PDF, EPUB and Kindle. Book excerpt: These proceedings aim to provide a comprehensive overview of research, technology and applications in the field of accelerators. Contributions from the entire field of accelerators are presented, including low and high energy machines, and medical and industrial accelerators.

Book Design and Initial Tests of Beam Current Monitoring Systems for the APS Transport Lines

Download or read book Design and Initial Tests of Beam Current Monitoring Systems for the APS Transport Lines written by and published by . This book was released on 1992 with total page 8 pages. Available in PDF, EPUB and Kindle. Book excerpt: The non-intercepting beam current monitoring systems suitable for a wide, range of beam parameters have been developed for the Advanced Photon Source (APS) low energy transport lines and high energy transport line. The positron or electron beam pulse in the transport lines wig have peak beam currents ranging from 8 mA to 29 A with pulse widths varying from 120 ps to 30 ns and pulse repetition rates from 2 Hz to 60 Hz. The peak beam current or total beam charge is measured with the fast or integrating current transformer, respectively, manufactured by Bergoz. In-house high speed beam signal processing electronics provide a DC level output proportional to the peak current or total charge for the digitizer input. The prototype systems were tested on the linacs which have beam pulse structures similar to that of the APS transport lines. This paper describes the design of beam signal processing electronics and grounding and shielding methods for current transformers. The results of the initial operations are presented. A short introduction on the preliminary design of current monitoring systems for the APS rings is also included.

Book Proceedings

Download or read book Proceedings written by and published by . This book was released on 1995 with total page 788 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Energy Research Abstracts

Download or read book Energy Research Abstracts written by and published by . This book was released on 1994 with total page 444 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book INIS Atomindex

Download or read book INIS Atomindex written by and published by . This book was released on 1995 with total page 640 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Government Reports Announcements   Index

Download or read book Government Reports Announcements Index written by and published by . This book was released on 1995 with total page 672 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book The Development of Beam Current Monitors in the APS

Download or read book The Development of Beam Current Monitors in the APS written by X. Wang and published by . This book was released on 1995 with total page 4 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Commissioning Results of the APS Storage Ring Rf Beam Position Monitors

Download or read book Commissioning Results of the APS Storage Ring Rf Beam Position Monitors written by and published by . This book was released on 2001 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: The commissioning of the 360 rf beam position monitors (BPMs) in the Advanced Photon Source (APS) storage ring (SR) is nearing completion. After using the single-turn capability of the BPM electronics in the early ring commissioning phase, resolution measurements versus current and bandwidth were successfully performed. In the standard Sr vacuum chamber geometry, the resolution was measured with beam as 0.16[micro]mA/[radical](Hz). For the insertion device vacuum chamber geometry, the resolution was measured to be 0.1[micro]mA/[radical](Hz). Since the photon beam stability requirement for the users is only 4.5 microns rms in the vertical direction, investigations of rf BPM offset versus current and bunch pattern have also been initiated. Both single bunch and multibunch beam patterns with varying intensity were used to determine offset stability for both the global and the local orbit feedback applications.

Book Initial Diagnostics Commissioning Results for the Advanced Photon Source  APS

Download or read book Initial Diagnostics Commissioning Results for the Advanced Photon Source APS written by and published by . This book was released on 1995 with total page 4 pages. Available in PDF, EPUB and Kindle. Book excerpt: Principal diagnostics systems have been installed and nearly all have been commissioned on the subsystems of the Advanced Photon Source (APS) facility. Data have been obtained on beam position, beam profile, current, beam loss rate, and synchrotron radiation monitors on both injector rings and most recently the main 7-GeV storage ring. Results for the 150- to 450-MeV electron beams in the accumulator ring, up to 7 GeV in the injector synchrotron, and 4.5 to 7 GeV in the SR will be presented.

Book Design and Commissioning of the Photon Monitors and Optical Transport Lines for the Advanced Photon Source Positron Accumulator Ring

Download or read book Design and Commissioning of the Photon Monitors and Optical Transport Lines for the Advanced Photon Source Positron Accumulator Ring written by and published by . This book was released on 2001 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Two photon monitors have been designed and installed in the positron accumulator ring (PAR) of the Advanced Photon Source. The photon monitors characterize the beam's transverse profile, bunch length, emittance, and energy spread in a nonintrusive manner. An optical transport line delivers synchrotron light from the PAR out of a high radiation environment. Both charge-coupled device and fast-gated, intensified cameras are used to measure the transverse beam profile (0.11 - 1 mm for damped beam) with a resolution of 0.06 mm. A streak camera ([theta][sub[tau]]=I ps) is used to measure the bunch length which is in the range of 0.3-1 ns. The design of the various transport components and commissioning results of the photon monitors will be discussed.

Book Beam Instrumentation

Download or read book Beam Instrumentation written by Alex H. Lumpkin and published by A I P Press. This book was released on 1997 with total page 632 pages. Available in PDF, EPUB and Kindle. Book excerpt: Proceedings of the May 1996 workshop, including tutorial, invited, and contributed papers. Subjects include a subpicosecond bunch duration measurement technique based on autocorrelation of coherent transition radiation, commissioning results of the APS storage ring diagnostics systems, bunch instabi