Download or read book Cadmium Its Metallurgy Properties and Uses written by Norman Frederick Budgen and published by . This book was released on 1924 with total page 290 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Toxicologic Assessment of the Army s Zinc Cadmium Sulfide Dispersion Tests written by National Research Council and published by National Academies Press. This book was released on 1997-05-30 with total page 386 pages. Available in PDF, EPUB and Kindle. Book excerpt: During the 1950s and 1960s, the U.S. Army conducted atmospheric dispersion tests in many American cities using fluorescent particles of zinc cadmium sulfide (ZnCdS) to develop and verify meteorological models to estimate the dispersal of aerosols. Upon learning of the tests, many citizens and some public health officials in the affected cities raised concerns about the health consequences of the tests. This book assesses the public health effects of the Army's tests, including the toxicity of ZnCdS, the toxicity of surrogate cadmium compounds, the environmental fate of ZnCdS, the extent of public exposures from the dispersion tests, and the risks of such exposures.
Download or read book Cadmium in the Environment written by Lars Friberg and published by CRC Press. This book was released on 2018-01-18 with total page 233 pages. Available in PDF, EPUB and Kindle. Book excerpt: The focus of this report is upon information essential to the understanding of the toxic action of cadmium and the relationship between dose (exposure) and effects on human beings and animals. The therapy of cadmium poisoning has not been discussed.This review on cadmium in the environment has been performed under a contract between the U.S. Environmental Protection Agency and the Department of Environmental Hygiene of the Karolinska Institute, Sweden. The report is intended to serve as a background paper for a future Air Quality Criteria document on cadmium. Therefore, particular attention has been given to information relevant for the evaluation of risks due to long-term exposure to low concentrations of cadmium. Acute effects from short-term exposure to high concentrations are dealt with briefly. In vitro studies without bearing on the main problem have not been dealt with.The report is not limited to effects from exposure via inhalation. Newly accessible information, showing that large populations may be exposed considerably via the oral route, can elucidate chronic effects of cadmium in general. Man and animals can be victims of secondary exposure through vehicles such as food and water which have been contaminated by cadmium in air.
Download or read book Mineral Commodity Summaries 2017 written by Government Publishing Office and published by U.S. Government Printing Office. This book was released on 2017-03-15 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt: This illustrated report is published annually to furnish estimates covering nonfuel mineral industry data. Data sheets contain information on the domestic industry structure, Government programs, tariffs, and 5-year salient statistics for more than 90 individual minerals and materials. Each chapter includes information on events, trends, and issues for each mineral commodity, as well as discussions and tabular presentations on domestic industry structure. Maps, charts, presentations, tables, and graphs are included throughout this text. Geoscientists, petroleum engineers, global community traders, construction industry engineering executives soil scientists, miners, economists, trade brokers specializing in mineral commodities and imports/exports, mineral manufacturers, statistical professionals, and American citizens may be interested in this updated historical reference. Students pursuing coursework for a Bachelor of Science or advanced degree in environmental science, geosciences, or geology may be interested in this volume for research. It is highly recommended that academic libraries with geology and mining engineering programs, special libraries within these fields, and public libraries place an updated annual copy of this primary source work in their business/economic and reference collections. Related collections: Minerals & Metals resources collection is available here: https://bookstore.gpo.gov/catalog/minerals-metals Environmental Protection & Conservation collection can be found here: https://bookstore.gpo.gov/catalog/environmental-protection-conservation Engineering: https://bookstore.gpo.gov/catalog/engineering Economic Indicators: https://bookstore.gpo.gov/catalog/economic-indicators
Download or read book Toxicological Profile for Cadmium written by and published by . This book was released on 1997 with total page 386 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Heavy Metals in Soils written by Brian J. Alloway and published by Springer Science & Business Media. This book was released on 2012-07-18 with total page 615 pages. Available in PDF, EPUB and Kindle. Book excerpt: This third edition of the book has been completely re-written, providing a wider scope and enhanced coverage. It covers the general principles of the natural occurrence, pollution sources, chemical analysis, soil chemical behaviour and soil-plant-animal relationships of heavy metals and metalloids, followed by a detailed coverage of 21 individual elements, including: antimony, arsenic, barium, cadmium, chromium, cobalt, copper, gold, lead, manganese, mercury, molybdenum, nickel, selenium, silver, thallium, tin, tungsten, uranium, vanadium and zinc. The book is highly relevant for those involved in environmental science, soil science, geochemistry, agronomy, environmental health, and environmental engineering, including specialists responsible for the management and clean-up of contaminated land.
Download or read book Tables of Physical and Chemical Constants and Some Mathematical Functions written by George William Clarkson Kaye and published by . This book was released on 1911 with total page 172 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Heavy Metals In Water written by Sanjay K. Sharma and published by Royal Society of Chemistry. This book was released on 2014 with total page 382 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book highlights the latest research on dissolved heavy metals in drinking water and their removal.
Download or read book The Journal of the Iron and Steel Institute written by Iron and Steel Institute and published by . This book was released on 1926 with total page 844 pages. Available in PDF, EPUB and Kindle. Book excerpt: Includes the institute's Proceedings.
Download or read book Cadmium in Soils and Plants written by M.J. McLaughlin and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 283 pages. Available in PDF, EPUB and Kindle. Book excerpt: Over forty years ago, concern was first focussed on cadmium contamination of soils, fertilisers and the food chain. Adverse effects on human health were first highlighted nearly 30 years ago in Japan with the outbreak of Itai-itai disease. Since then, substantial research data have accumulated for cadmium on chemistry in soils, additions to soils, uptake by plants, adverse effects on the soil biota and transfer through the food chain. However, this information has never been compiled into a single volume. This was the stimulus for the Kevin G. Tiller Memorial Symposium "Cadmium in Soils, Plants and the Food Chain", held at the University of California, Berkeley, in June 1997 as part of the Fourth International Conference on the Biogeochemistry of Trace Elements. This symposium brought together leading scientists in the field of cadmium behaviour in soils and plants, to review the scientific data in the literature and highlight gaps in our current knowledge of the subject. This series of review papers are presented here and deal with the chemistry of cadmium in soils, the potential for transfer through the food chain and management to minimise this problem. We hope this information provides a sound scientific basis to assist development of policies and regulations for controlling cadmium in the soil environment.
Download or read book Sources of Information on the Properties of Metals and Alloys books written by and published by . This book was released on 1938 with total page 24 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Sources of Information on the Properties of Metals and Alloys written by United States. Bureau of Standards and published by . This book was released on 1943 with total page 26 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Chelation Therapy in the Treatment of Metal Intoxication written by Jan Aaseth and published by Academic Press. This book was released on 2016-04-18 with total page 390 pages. Available in PDF, EPUB and Kindle. Book excerpt: Chelation Therapy in the Treatment of Metal Intoxication presents a practical guide to the use of chelation therapy, from its basic chemistry, to available chelating antidotes, and the application of chelating agents. Several metals have long been known to be toxic to humans, and continue to pose great difficulty to treat. These challenges pose particular problems in industrial settings, with lead smelting known to be associated with hemopoietic alterations and paralyses, and the inhalation of mercury vapor in mercury mining being extremely detrimental to the central nervous system. Clinical experience has demonstrated that acute and chronic human intoxications with a range of metals can be treated efficiently by administration of chelating agents. Chelation Therapy in the Treatment of Metal Intoxication describes the chemical and biological principles of chelation in the treatment of these toxic metal compounds, including new chelators such as meso-2,3-dimercaptosuccinic acid (DMSA) and D,L-2,3-dimercapto-1-propanesulfonic acid (DMPS). - Presents all the current findings on the potential for chelation as a therapy for metal intoxication - Presents practical guidelines for selecting the most appropriate chelating agent - Includes coverage on radionuclide exposure and metal storage diseases - Describes the chemical and biological principles of chelation in the treatment of toxic metal compounds
Download or read book Transactions of the American Institute of Mining and Metallurgical Engineers written by and published by . This book was released on 1928 with total page 844 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Sources of Information on the Properties of Metals and Alloys books written by United States. National Bureau of Standards and published by . This book was released on 1936 with total page 38 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Mineral Industry Its Statistics Technology and Trade written by Richard Pennefather Rothwell and published by . This book was released on 1926 with total page 946 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Materials Handbook written by François Cardarelli and published by Springer. This book was released on 2018-07-09 with total page 2302 pages. Available in PDF, EPUB and Kindle. Book excerpt: The unique and practical Materials Handbook (third edition) provides quick and easy access to the physical and chemical properties of very many classes of materials. Its coverage has been expanded to include whole new families of materials such as minor metals, ferroalloys, nuclear materials, food, natural oils, fats, resins, and waxes. Many of the existing families—notably the metals, gases, liquids, minerals, rocks, soils, polymers, and fuels—are broadened and refined with new material and up-to-date information. Several of the larger tables of data are expanded and new ones added. Particular emphasis is placed on the properties of common industrial materials in each class. After a chapter introducing some general properties of materials, each of twenty-four classes of materials receives attention in its own chapter. The health and safety issues connected with the use and handling of industrial materials are included. Detailed appendices provide additional information on subjects as diverse as crystallography, spectroscopy, thermochemical data, analytical chemistry, corrosion resistance, and economic data for industrial and hazardous materials. Specific further reading sections and a general bibliography round out this comprehensive guide. The index and tabular format of the book makes light work of extracting what the reader needs to know from the wealth of factual information within these covers. Dr. François Cardarelli has spent many years compiling and editing materials data. His professional expertise and experience combine to make this handbook an indispensable reference tool for scientists and engineers working in numerous fields ranging from chemical to nuclear engineering. Particular emphasis is placed on the properties of common industrial materials in each class. After a chapter introducing some general properties of materials, materials are classified as follows. ferrous metals and their alloys; ferroalloys; common nonferrous metals; less common metals; minor metals; semiconductors and superconductors; magnetic materials; insulators and dielectrics; miscellaneous electrical materials; ceramics, refractories and glasses; polymers and elastomers; minerals, ores and gemstones; rocks and meteorites; soils and fertilizers; construction materials; timbers and woods; fuels, propellants and explosives; composite materials; gases; liquids; food, oils, resin and waxes; nuclear materials. food materials
