Download or read book Bond in concrete 2012 bond anchorage detailing proceedings of the 4 Bond in Concrete Conference Bond Anchorage Detailing Brescia Italy 17 20 June 2012 1 General aspects of bond written by Bond in Concrete Conference and published by . This book was released on 2012 with total page 557 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Bond in concrete 2012 bond anchorage detailing proceedings of the 4 Bond in Concrete Conference Bond Anchorage Detailing Brescia Italy 17 20 June 2012 2 Bond in new materials and under severe conditions written by Bond in Concrete Conference and published by . This book was released on 2012 with total page 545 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Bond in Concrete 2012 written by Giovanni A. Plizzari and published by . This book was released on 2012 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Bond in Concrete Bond Anchorage Detailing written by Jan Hofmann and published by . This book was released on 2022 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Bond and anchorage of embedded reinforcement Background to the fib Model Code for Concrete Structures 2010 written by fib - Fédération internationale du béton and published by fib - Fédération internationale du béton. This book was released on 2014-05-01 with total page 177 pages. Available in PDF, EPUB and Kindle. Book excerpt: As part of the preparation for the fib Model Code for Concrete Structures 2010, task group 4.5 Bond Models undertook a major review of rules for bond and anchorage of reinforcement in the CEB-FIP Model Code 1990. This bulletin presents the outcome of that review, describes the rationale for the revisions and presents the evidence on which the revisions are based. The principle changes in MC2010 include raising the limit on concrete strength that may be used when determining bond resistance to 110MPa, introduction of a coefficient η4 to cater for different reinforcement Classes, and coverage of new construction materials including epoxy coated and headed bars. The format of design rules has been changed to permit more rational treatment of confinement from concrete cover and transverse reinforcement, the contribution of end hooks and bends for tension bars, and end bearing to compression laps. New guidance is provided covering a range of construction techniques and service environments and the influence of long term degradation. Analyses of various aspects of detailing on performance of laps and anchorages have resulted in discontinuation of the ‘proportion lapped’ factor α6, alterations to requirements of transverse reinforcement at laps, and have resolved inconsistencies in provisions for bundled bars between major national codes. Apparent inconsistencies in existing rules for lapped joints and anchorages and between the local bond/slip model and design rules are also resolved, thus allowing integration of application rules and modelling. Finally, the basis for an attempt to introduce simple detailing rules for laps and anchorages is described.
Download or read book Advances on bond in concrete written by FIB – International Federation for Structural Concrete and published by FIB - International Federation for Structural Concrete. This book was released on 2022-12-01 with total page 326 pages. Available in PDF, EPUB and Kindle. Book excerpt: Structural behavior of reinforced concrete elements strongly depends on the interaction between the reinforcing bars and the surrounding concrete, which is generally referred as “bond in concrete”. In service conditions, the reinforcement-to-concrete bond governs deformability through the tension stiffening of concrete surrounding the bar as well the crack development and crack width. At Ultimate Limit State, bond governs anchorage and lap splices behavior as well as structural ductility. When plain (smooth) bars were used, the steel-to-concrete bond was mainly associated with “chemical adhesion/friction” that is related to the surface roughness of the rebar. As steel strengths increased the need to enhance interaction between steel and the surrounding concrete was recognized, and square twisted rebars, indented rebars or, later on, ribbed rebars came into the market, the latter being the type of deformed bar most commonly adopted since the 1960/70s. When ribbed rebars became widely used, several research studies started worldwide for better understanding the interaction between ribs and the surrounding concrete. Researchers evidenced the development of micro-cracks (due to the wedge action of the ribs) towards the external face of the structural element. If confinement is provided by the concrete cover, by transverse reinforcement or by an external transverse pressure, the full-anchorage capacity is guaranteed and a pull-out failure occurs, with crushing of concrete between the ribs. On the contrary, with lesser confining action, a splitting failure of bond occurs; the latter may provoke a brittle failure of the lap splice or, in some cases, of anchorages. However, after many years of research studies on bond-related topics, there are still several open issues. In fact, new materials entered into the market, as concrete with recycled aggregates or fibre reinforced concrete; the latter, having a kind of distributed reinforcement into the matrix (the fibres), provides a better confinement to the wedge action of the ribs. In addition, concrete and steel strength continuously increased over the years, causing changes in the bond behavior due to differences in mechanical properties of materials but also to the different concrete composition at the interface with the steel rebar causing a different bond behavior. Moreover, the lower water/cement ratio of these high-strength concrete makes the bleeding phenomena less evident, changing the concrete porosity in the upper layers of the structural element and thus making the current casting position parameters no-longer reliable. Finally, concrete with recycled aggregates are becoming more important in a market that is looking forward to a circular economy. As such, all the experimental results and database that allowed the calibration of bond rules now present in building codes for conventional concrete, may be not be representative of these new types of materials nowadays adopted in practice. Furthermore, after more than 50 years of service life, structural elements may not satisfy the current safety requirements for several reasons, including material degradation (with particular reference to steel corrosion) or increased loads, by also considering the seismic actions that were non considered by building codes at the time of the original design. The structural assessment of existing structures requires proper conceptual models and new approaches for evaluating the reliability of existing structures by also considering the remaining expected service life. In addition, specific rules for older materials, as plain smooth bars, should be revised for a better assessment of old structures. Last, but not least, interventions in existing structures may require new technologies now available such as post-installed rebars. While many advances have been achieved, there remain areas where a better understanding of bond and its mechanisms are required, and where further work is required to incorporate this understanding into safe and economic rules to guide construction and maintenance of existing infrastructures. These aspects were widely discussed within the technical community, particularly in the fib Task Group 2.5 and in the ACI 408 Committee dealing with bond and anchorage issues. Furthermore, special opportunities for discussing bond developments were represented by the International Conferences on ‘Bond in Concrete’ held each decade since 1982 as well as by joint workshops organized by fib TG2.5 and ACI 408. Within this technical collaboration, this Bulletin was conceived, and, thus, it collects selected papers presented at the joint fib-ACI Convention Session on Bond in Concrete held in Detroit (USA) in 2017. The bulletin is based on four main Sections concerning: - General aspects of bond - Anchorages and laps of bars and prestressing tendons - Bond under severe conditions - Degradation of bond for corrosion - Bond in new types of concrete The main aim of the Bulletin is to shed some new lights on the advances in understanding and application of bond related issues achieved over the last few years, and identify the challenges and priorities to be addressed in the next years. Another important aspect of the bulletin is to provide practical information from research findings.
Download or read book Bond of Reinforcement in Concrete written by fib Fédération internationale du béton and published by fib Fédération internationale du béton. This book was released on 2000-01-01 with total page 448 pages. Available in PDF, EPUB and Kindle. Book excerpt: "In 1993, the CEB Commission 2 Material and Behavior Modelling established the Task Group 2.5 Bond Models. It's terms of reference were ... to write a state-of-art report concerning bond of reinforcement in concrete and later recommend how the knowledge could be applied in practice (Model Code like text proposal)... {This work} covers the first part ... the state-of-art report."--Pref.
Download or read book Bond in Concrete written by Peter Bartos and published by . This book was released on 1982 with total page 488 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Design of anchorages in concrete written by fib Fédération internationale du béton and published by fib Fédération internationale du béton. This book was released on 2011-01-01 with total page 277 pages. Available in PDF, EPUB and Kindle. Book excerpt: Despite the widespread use of cast-in-place and post-installed anchors in construction, the overall level of understanding in the engineering community regarding their behaviour remains quite limited. Furthermore, since the publication of the original CEB design guide, “Design of Fastenings in Concrete”, ongoing research and additional application experience has led to an improved understanding and deepened knowledge in various areas of fastening technology. fib Bulletin 58 therefore represents a substantial revision of the original 1997 guide. It addresses a variety of loading types and failure modes and takes into account the current state of the art for anchorages in new construction as well as for their use in the repair and strengthening of existing concrete structures. fib Bulletin 58 provides a method for the design of the anchorage and additional rules for the design of the concrete member to which the load is transferred. The specified provisions are based on the currently available research.
Download or read book Studies on Bond Between Concrete and Steel written by Duff Andrew Abrams and published by . This book was released on 1925 with total page 34 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Anchorage Bond in Concrete Bases written by Willem Jacobus Vermaak and published by . This book was released on 1981* with total page 182 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book A Study of Anchorage Bond in Prestressed Concrete written by R. W. Keuning and published by . This book was released on 1962 with total page 84 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Tests of Bond Between Concrete and Steel written by Duff A. B. 1880 Abrams and published by Palala Press. This book was released on 2016-05-02 with total page 246 pages. Available in PDF, EPUB and Kindle. Book excerpt: This work has been selected by scholars as being culturally important, and is part of the knowledge base of civilization as we know it. This work was reproduced from the original artifact, and remains as true to the original work as possible. Therefore, you will see the original copyright references, library stamps (as most of these works have been housed in our most important libraries around the world), and other notations in the work.This work is in the public domain in the United States of America, and possibly other nations. Within the United States, you may freely copy and distribute this work, as no entity (individual or corporate) has a copyright on the body of the work.As a reproduction of a historical artifact, this work may contain missing or blurred pages, poor pictures, errant marks, etc. Scholars believe, and we concur, that this work is important enough to be preserved, reproduced, and made generally available to the public. We appreciate your support of the preservation process, and thank you for being an important part of keeping this knowledge alive and relevant.
Download or read book Tests of Bond Between Concrete and Steel Classic Reprint written by Duff Andrew Abrams and published by Forgotten Books. This book was released on 2018-02-08 with total page 246 pages. Available in PDF, EPUB and Kindle. Book excerpt: Excerpt from Tests of Bond Between Concrete and Steel Comparative Values for Bond on Plain Round Bars Effect of Varying Quantity of Cement and Mortar Effect of Anchoring Ends of Bars. About the Publisher Forgotten Books publishes hundreds of thousands of rare and classic books. Find more at www.forgottenbooks.com This book is a reproduction of an important historical work. Forgotten Books uses state-of-the-art technology to digitally reconstruct the work, preserving the original format whilst repairing imperfections present in the aged copy. In rare cases, an imperfection in the original, such as a blemish or missing page, may be replicated in our edition. We do, however, repair the vast majority of imperfections successfully; any imperfections that remain are intentionally left to preserve the state of such historical works.
Download or read book Bond and Anchorage of Reinforcement in Concrete written by and published by . This book was released on with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Bond and Development of Straight Reinforcing Bars in Tension written by and published by . This book was released on 2003 with total page 49 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Bond in Concrete written by Comité euro-international du béton and published by . This book was released on 1992 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
