Download or read book Back calculating Emission Rates for Ammonia and Particulate Matter from Area Sources Using Dispersion Modeling written by Jacqueline Elaine Price and published by . This book was released on 2004 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Engineering directly impacts current and future regulatory policy decisions. The foundation of air pollution control and air pollution dispersion modeling lies in the math, chemistry, and physics of the environment. Therefore, regulatory decision making must rely upon sound science and engineering as the core of appropriate policy making (objective analysis in lieu of subjective opinion). This research evaluated particulate matter and ammonia concentration data as well as two modeling methods, a backward Lagrangian stochastic model and a Gaussian plume dispersion model. This analysis assessed the uncertainty surrounding each sampling procedure in order to gain a better understanding of the uncertainty in the final emission rate calculation (a basis for federal regulation), and it assessed the differences between emission rates generated using two different dispersion models. First, this research evaluated the uncertainty encompassing the gravimetric sampling of particulate matter and the passive ammonia sampling technique at an animal feeding operation. Future research will be to further determine the wind velocity profile as well as determining the vertical temperature gradient during the modeling time period. This information will help quantify the uncertainty of the meteorological model inputs into the dispersion model, which will aid in understanding the propagated uncertainty in the dispersion modeling outputs. Next, an evaluation of the emission rates generated by both the Industrial Source Complex (Gaussian) model and the WindTrax (backward-Lagrangian stochastic) model revealed that the calculated emission concentrations from each model using the average emission rate generated by the model are extremely close in value. However, the average emission rates calculated by the models vary by a factor of 10. This is extremely troubling. In conclusion, current and future sources are regulated based on emission rate data from previous time periods. Emission factors are published for regulation of various sources, and these emission factors are derived based upon back-calculated model emission rates and site management practices. Thus, this factor of 10 ratio in the emission rates could prove troubling in terms of regulation if the model that the emission rate is back-calculated from is not used as the model to predict a future downwind pollutant concentration.

Download or read book Atmospheric Dispersion Modeling Compliance Guide written by Karl B. Schnelle and published by McGraw Hill Professional. This book was released on 2000 with total page 560 pages. Available in PDF, EPUB and Kindle. Book excerpt: CD-ROM includes: Practice problems that reinforces and deepen understanding of modeling principles.

Download or read book Emissions of Air Pollutants written by Rainer Friedrich and published by Springer Science & Business Media. This book was released on 2013-03-09 with total page 348 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book presents a wealth of new information that enables environmental scientists and authorities to design methods for measuring and modelling emission rates related to specific pollution sources, and thus to generate improved emission inventories and reduction strategies. The text shows how to carry out experiments to verify emission data, including tunnel and open motorway studies, comprehensive city experiments and tracer experiments.

Download or read book Review and Integration of Biosphere Atmosphere Modelling of Reactive Trace Gases and Volatile Aerosols written by Raia Silvia Massad and published by Springer. This book was released on 2015-07-16 with total page 231 pages. Available in PDF, EPUB and Kindle. Book excerpt: When considering biosphere–atmosphere exchange of trace gases and volatile aerosols, significant advances have been made both from an experimental and modelling point of view and on several scales. This was particularly stimulated by the availability of new datasets generated from improvements in analytical methods and flux measurement techniques. Recent research advances allow us, not only to identify major mechanisms and factors affecting the exchanges between the biosphere and the atmosphere, but also to recognize several gaps in the methodologies used in accounting for emissions and deposition in landscape and global scale models. This work aims at (i) reviewing exchange processes and modelling schemes, parameterisations and datasets, (ii) presenting a common conceptual framework to model soil-vegetation-atmosphere exchange of reactive trace gases and aerosols accounting for in-canopy transfer chemical interactions and (iii) discussing the key elements of the agreed framework.

Download or read book Air Emissions from Animal Feeding Operations written by National Research Council and published by National Academies Press. This book was released on 2003-04-07 with total page 286 pages. Available in PDF, EPUB and Kindle. Book excerpt: Air Emissions from Animal Feeding Operations: Current Knowledge, Future Needs discusses the need for the U.S. Environmental Protection Agency to implement a new method for estimating the amount of ammonia, nitrous oxide, methane, and other pollutants emitted from livestock and poultry farms, and for determining how these emissions are dispersed in the atmosphere. The committee calls for the EPA and the U.S. Department of Agriculture to establish a joint council to coordinate and oversee short - and long-term research to estimate emissions from animal feeding operations accurately and to develop mitigation strategies. Their recommendation was for the joint council to focus its efforts first on those pollutants that pose the greatest risk to the environment and public health.

Download or read book A Specialty Conference On Dispersion Modeling from Complex Sources written by Edward R. Frederick and published by . This book was released on 1981 with total page 352 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book User s Guide for the Climatological Dispersion Model written by Adrian D. Busse and published by . This book was released on 1973 with total page 144 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Air Dispersion Modeling of Particulate Matter from Ground level Area Sources written by Michael Todd Meister and published by . This book was released on 2000 with total page 186 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Developing Emission Factors of Fugitive Particulate Matter Emissions for Construction Sites in the Middle East written by Hala Abdelrahman Medani Hassan and published by . This book was released on 2015 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: A major source of airborne pollution in the arid Middle East countries is the fugitive particulate matter (PM), a frequent product of wind erosion. The meteorological conditions and topography of this region makes it highly susceptible to wind-blown particles which raise many air quality concerns. Important tools for estimating the dispersion and deposition of dust particles, which also help in designing dust control procedures, are Air Quality Models (AQM). The cornerstone of every AQM system is an emission inventory, but these are only available currently for the European and North American domains, calling for an immediate need to develop similar knowledge for MEA. The increasing level of urbanization in Middle East countries has thrown the light on the airborne pollution caused by construction and earth work activities. The main scope of the present study is to develop fugitive particulate matter emission factors for construction sites in MEA and to evaluate the accuracy of the existing emission factors to apply for Middle Eastern hot and arid conditions. An experimental campaign along with dispersion modeling using the Fugitive Dust Model (FDM) were implemented in a construction site to examine the relation between the meteorological variables, concentrations and emission rates to understand the behavior of the fugitive dust emissions for MEA. The time period of this work was chosen while the construction site was at rest, where the only particles source was wind erosion of the loose soil. A data analysis was done, using the modeling results, to identify the effect of each meteorological variable (i.e. wind direction, wind speed, stability, .etc.) and its relation to emissions concentrations and rates. Considering the wind-speed dependence of the source emission rate, a power law function was obtained for the calculation of the emission rates. This function was used to re-run the FDM model and the results were evaluated compared to the on-site measured concentrations and to the emission factors reported in USEPA's AP-42 (the related emission rates in this emission inventory have been developed mainly for open coal-mines). Surprisingly, our study showed that a very good agreement between the AP-42 emission factors and our calculations can be obtained if the former are slightly modified. The emission factors developed in this study have been confirmed and can be applied for the impact assessment of similar sources in Middle East and other dry-arid locations. The electronic version of this dissertation is accessible from http://hdl.handle.net/1969.1/155039

Download or read book Advances in Analytical and Numerical Dispersion Modeling of Pollutants Releasing from an Area source written by Praneeth Nimmatoori and published by . This book was released on 2014 with total page 141 pages. Available in PDF, EPUB and Kindle. Book excerpt: The air quality near agricultural activities such as tilling, plowing, harvesting, and manure application is of main concern because they release fine particulate matter into the atmosphere. These releases are modeled as area-sources in the air quality modeling research. None of the currently available dispersion models relate and incorporate physical characteristics and meteorological conditions for modeling the dispersion and deposition of particulates emitting from such area-sources. This knowledge gap was addressed by developing the advanced analytical and numerical methods for modeling the dispersion of particulate matter. The development, application, and evaluation of new dispersion modeling methods are discussed in detail in this dissertation. In the analytical modeling, a ground-level area source analytical dispersion model known as particulate matter deposition - PMD was developed for predicting the concentrations of different particle sizes. Both the particle dynamics (particle physical characteristics) and meteorological conditions which have significant effect on the dispersion of particulates were related and incorporated in the PMD model using the formulations of particle gravitational settling and dry deposition velocities. The modeled particle size concentrations of the PMD model were evaluated statistically after applying it to particulates released from a biosolid applied agricultural field. The evaluation of the PMD model using the statistical criteria concluded effective and successful inclusion of dry deposition theory for modeling particulate matter concentrations. A comprehensive review of analytical area-source dispersion models, which do not account for dry deposition and treat pollutants as gases, was conducted and determined three models - the Shear, the Parker, and the Smith. A statistical evaluation of these dispersion models was conducted after applying them to two different field data sets and the statistical results concluded that the Shear model performed the best out of the three dispersion models. The algorithms of each dispersion model were analyzed and it was determined that the best performance of the Shear model was due to incorporation of a variation of wind speed and vertical eddy diffusivity (atmospheric turbulence) with the height above ground surface. A new methodology was developed using computational fluid dynamics (CFD) - FLUENT for the numerical dispersion modeling of particulate matter emitting from an area-source (biosolids applied agricultural field). The discrete phase model (Lagrangian -Eulerian approach) was used in combination with each of the four turbulence models: Standard ke (ke), Realizable ke (Rke), Standard k¿ (k¿), and Shear-stress transport k-¿ (SST) to predict particulate matter size concentrations for distances downwind of the agricultural field. In this modeling approach, particulates were simulated as discrete phase and air as continuous phase. The discrete phase model accounted for the effects of atmospheric turbulence and drag force which is dependent on particle physical characteristics (diameter, density, and velocity), gravitational velocity, and air viscosity for predicting the trajectories of particles. The modeled particulate matter concentrations were compared statistically with their corresponding field study observations to evaluate the performance of proposed CFD model using the four turbulence models. The statistical analysis concluded that among four turbulence models, the discrete phase model when used with Rke performed the best in predicting particulate matter concentrations for low (u 2 m/s) and medium (2

Download or read book Compilation of Air Pollutant Emission Factors written by and published by . This book was released on 1985 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Atmospheric Ammonia written by Mark Sutton and published by Springer Science & Business Media. This book was released on 2008-12-30 with total page 468 pages. Available in PDF, EPUB and Kindle. Book excerpt: Anthropogenic emissions of ammonia cause a host of environmental impacts, including loss of biodiversity, soil acidification and formation of particulate matter in the atmosphere. Under the auspices of the UNECE Convention on Long Range Transboundary Air Pollution, around 80 international experts met to review the state of scientific knowledge. This book reports their analysis. It concludes that threshold levels for ammonia effects have been underestimated and sets new values, it assesses the independent evidence to verify reported reductions in regional ammonia emissions, and it reviews the uncertainties in modelling ammonia, both in "hot spots" and at the regional scale.

Download or read book The Code of Federal Regulations of the United States of America written by and published by . This book was released on 1997 with total page 512 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Code of Federal Regulations is the codification of the general and permanent rules published in the Federal Register by the executive departments and agencies of the Federal Government.

Download or read book Code of Federal Regulations written by and published by . This book was released on 1997 with total page 516 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Global Sources of Local Pollution written by National Research Council and published by National Academies Press. This book was released on 2010-02-15 with total page 248 pages. Available in PDF, EPUB and Kindle. Book excerpt: Recent advances in air pollution monitoring and modeling capabilities have made it possible to show that air pollution can be transported long distances and that adverse impacts of emitted pollutants cannot be confined to one country or even one continent. Pollutants from traffic, cooking stoves, and factories emitted half a world away can make the air we inhale today more hazardous for our health. The relative importance of this "imported" pollution is likely to increase, as emissions in developing countries grow, and air quality standards in industrial countries are tightened. Global Sources of Local Pollution examines the impact of the long-range transport of four key air pollutants (ozone, particulate matter, mercury, and persistent organic pollutants) on air quality and pollutant deposition in the United States. It also explores the environmental impacts of U.S. emissions on other parts of the world. The book recommends that the United States work with the international community to develop an integrated system for determining pollution sources and impacts and to design effective response strategies. This book will be useful to international, federal, state, and local policy makers responsible for understanding and managing air pollution and its impacts on human health and well-being.

Download or read book Master s Theses Directories written by and published by . This book was released on 2005 with total page 316 pages. Available in PDF, EPUB and Kindle. Book excerpt: "Education, arts and social sciences, natural and technical sciences in the United States and Canada".

Download or read book Klamath National Forest N F written by and published by . This book was released on 1998 with total page 976 pages. Available in PDF, EPUB and Kindle. Book excerpt: