Download or read book An Experimental Study of Turbulent Boundary Layer on Rough Walls written by C. K. Liu and published by . This book was released on 1966 with total page 171 pages. Available in PDF, EPUB and Kindle. Book excerpt: Experimental data are presented on flow structure, mean, and fluctuating velocities in turbulent boundary layers over a family of flat surfaces with transverse roughness elements made of square bars of variable spacing. All flows were incompressible and had zero streamwise pressure gradient. The flow structures are described for surfaces extending from hydraulically smooth to fully rough. A distinct flow pattern is observed in the wall region for each of four cases: smooth, skimming, wake-interference and isolated-roughness flow. Maximum roughness was observed with a ratio of gap to bar width of approximately 11. The most obvious effect of an increase in surface roughness is the distinct increase of turbulence production and the concomittant increase in the value of eddy viscosity. It is shown that this increase in eddy viscosity increases the total thickness of the layer in the same way that an increase in molecular viscosity would do in a laminar layer. The normalization of eddy viscosity for the outer portion of the layer as suggested by Clauser is found to apply to the rough surfaces studied. (Author).
Download or read book The Mechanics of Turbulence written by and published by . This book was released on 1964 with total page 482 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Compressible Turbulent Skin Friction on Rough and Rough wavy Walls in Adiabatic Flow written by Daniel C. Reda and published by . This book was released on 1974 with total page 80 pages. Available in PDF, EPUB and Kindle. Book excerpt: An experimental program was conducted to investigate effects of roughness, and roughness superimposed on single and/or multiple, shallow, periodic waveforms, on turbulent boundary-layer skin friction and velocity profile, in compressible, adiabatic flow. Test conditions were Mach number = 2.9 and Reynolds number/ft = 2 million to 8 million. The planar models included smooth, sand-grain, machined and molded surface finishes. Direct measurements of surface shear and Pitot/recovery temperature profiles were obtained. (Modified author abstract).
Download or read book An Experimental Study of Turbulence Production Near a Smooth Wall in a Turbulent Boundary Layer with Zero Pressure gradient written by Heung-tae Kim and published by . This book was released on 1968 with total page 188 pages. Available in PDF, EPUB and Kindle. Book excerpt: The structure of the turbulent boundary layer on a smooth wall with zero pressure gradient has been studied experimentally. Emphasis has been given to the production of turbulence in the inner layers. Intensive studies of a few.
Download or read book NASA Technical Note written by and published by . This book was released on 1969 with total page 558 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Turbulence In Coastal And Civil Engineering written by B Mutlu Sumer and published by World Scientific. This book was released on 2020-03-23 with total page 758 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book discusses the subject of turbulence encountered in coastal and civil engineering.The primary aim of the book is to describe turbulence processes including transition to turbulence; mean and fluctuating flows in channels/pipes, and in currents; wave boundary layers (including boundary layers under solitary waves); streaming processes in wave boundary layers; turbulence processes in breaking waves including breaking solitary waves; turbulence processes such as bursting process and their implications for sediment transport; flow resistance in steady and wave boundary layers; and turbulent diffusion and dispersion processes in the coastal and river environment, including sediment transport due to diffusion/dispersion.Both phenomenological and statistical theories are described in great detail. Turbulence modelling is also described, and several examples for modelling of turbulence in steady flow and wave boundary layers are presented.The book ends with a chapter containing hands-on exercises on a wide variety of turbulent flows including experimental study of turbulence in an open-channel flow, using Laser Doppler Anemometry; Statistical, correlation and spectral analysis of turbulent air jet flow; Turbulence modelling of wave boundary layer flows; and numerical modelling of dispersion in a turbulent boundary layer, a set of exercises used by the authors in their Masters classes over many years.Although the book is essentially intended for professionals and researchers in the area of Coastal and Civil Engineering, and as a text book for graduate/post graduate students, the contents of the book will, however, additionally provide sufficient background in the study of turbulent flows relevant to many other disciplines, such as Wind Engineering, Mechanical Engineering, and Environmental Engineering.
Download or read book Technical Abstract Bulletin written by and published by . This book was released on with total page 912 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1994 with total page 836 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Analysis of Turbulent Boundary Layers written by Tuncer Cebeci and published by Elsevier. This book was released on 2012-12-02 with total page 423 pages. Available in PDF, EPUB and Kindle. Book excerpt: Analysis of Turbulent Boundary Layers focuses on turbulent flows meeting the requirements for the boundary-layer or thin-shear-layer approximations. Its approach is devising relatively fundamental, and often subtle, empirical engineering correlations, which are then introduced into various forms of describing equations for final solution. After introducing the topic on turbulence, the book examines the conservation equations for compressible turbulent flows, boundary-layer equations, and general behavior of turbulent boundary layers. The latter chapters describe the CS method for calculating two-dimensional and axisymmetric laminar and turbulent boundary layers. This book will be useful to readers who have advanced knowledge in fluid mechanics, especially to engineers who study the important problems of design.
Download or read book Applied Mechanics Reviews written by and published by . This book was released on 1974 with total page 592 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book IUTAM Symposium on The Physics of Wall Bounded Turbulent Flows on Rough Walls written by T. B. Nickels and published by Springer Science & Business Media. This book was released on 2010-09-08 with total page 183 pages. Available in PDF, EPUB and Kindle. Book excerpt: The study of wall-bounded turbulent ows is of considerable interest from both scienti c and practical view points. As such it has attracted a great deal of research over the last 100 years. Much research has concentratedon ows over smooth walls since these are simpler from experimental, numerical and theoretical standpoints. The ow over rough walls has still received considerable attention but progress has necessarilybeenslower.Perhapsthemostessentialproblem(certainlyfromaprac- cal point of view) is to be able to predict the skin-frictiondrag acting on a plate (or a body) given a certain known roughness characteristic of the surface. Unfortunately this has proved to be very dif cult since even the simplest rough surfaces can be characterised by a number of different parameters and we still cannot directly c- nectthese tothe uiddynamicdragin a givensituation.Varioustheoriesandmodels have been proposed in order to make progress but there is still some disagreement in the community as to the correct understanding of these important ows.
Download or read book Analysis of Turbulent Flows with Computer Programs written by Tuncer Cebeci and published by Butterworth-Heinemann. This book was released on 2013-02-26 with total page 465 pages. Available in PDF, EPUB and Kindle. Book excerpt: Analysis of Turbulent Flows is written by one of the most prolific authors in the field of CFD. Professor of Aerodynamics at SUPAERO and Director of DMAE at ONERA, Professor Tuncer Cebeci calls on both his academic and industrial experience when presenting this work. Each chapter has been specifically constructed to provide a comprehensive overview of turbulent flow and its measurement. Analysis of Turbulent Flows serves as an advanced textbook for PhD candidates working in the field of CFD and is essential reading for researchers, practitioners in industry and MSc and MEng students. The field of CFD is strongly represented by the following corporate organizations: Boeing, Airbus, Thales, United Technologies and General Electric. Government bodies and academic institutions also have a strong interest in this exciting field. - An overview of the development and application of computational fluid dynamics (CFD), with real applications to industry - Contains a unique section on short-cut methods – simple approaches to practical engineering problems
Download or read book DTNSRDC written by David W. Taylor Naval Ship Research and Development Center and published by . This book was released on 1984 with total page 638 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Structure of Turbulent Shear Flow written by A. A. R. Townsend and published by Cambridge University Press. This book was released on 1976 with total page 450 pages. Available in PDF, EPUB and Kindle. Book excerpt: Develops a physical theory from the mass of experimental results, with revisions to reflect advances of recent years.
Download or read book Fluctuating Properties of Turbulent Boundary Layers for Mach Numbers Up to 9 written by William D. Harvey and published by . This book was released on 1969 with total page 60 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fluctuating properties of turbulent boundary layers for Mach numbers up to 9.
Download or read book Turbulent Flows written by Jean Piquet and published by Springer Science & Business Media. This book was released on 2013-04-17 with total page 767 pages. Available in PDF, EPUB and Kindle. Book excerpt: obtained are still severely limited to low Reynolds numbers (about only one decade better than direct numerical simulations), and the interpretation of such calculations for complex, curved geometries is still unclear. It is evident that a lot of work (and a very significant increase in available computing power) is required before such methods can be adopted in daily's engineering practice. I hope to l"Cport on all these topics in a near future. The book is divided into six chapters, each· chapter in subchapters, sections and subsections. The first part is introduced by Chapter 1 which summarizes the equations of fluid mechanies, it is developed in C~apters 2 to 4 devoted to the construction of turbulence models. What has been called "engineering methods" is considered in Chapter 2 where the Reynolds averaged equations al"C established and the closure problem studied (§1-3). A first detailed study of homogeneous turbulent flows follows (§4). It includes a review of available experimental data and their modeling. The eddy viscosity concept is analyzed in §5 with the l"Csulting ~alar-transport equation models such as the famous K-e model. Reynolds stl"Css models (Chapter 4) require a preliminary consideration of two-point turbulence concepts which are developed in Chapter 3 devoted to homogeneous turbulence. We review the two-point moments of velocity fields and their spectral transforms (§ 1), their general dynamics (§2) with the particular case of homogeneous, isotropie turbulence (§3) whel"C the so-called Kolmogorov's assumptions are discussed at length.
Download or read book Engineering Turbulence Modelling and Experiments 5 written by W. Rodi and published by Elsevier. This book was released on 2002-08-21 with total page 1029 pages. Available in PDF, EPUB and Kindle. Book excerpt: Turbulence is one of the key issues in tackling engineering flow problems. As powerful computers and accurate numerical methods are now available for solving the flow equations, and since engineering applications nearly always involve turbulence effects, the reliability of CFD analysis depends increasingly on the performance of the turbulence models. This series of symposia provides a forum for presenting and discussing new developments in the area of turbulence modelling and measurements, with particular emphasis on engineering-related problems. The papers in this set of proceedings were presented at the 5th International Symposium on Engineering Turbulence Modelling and Measurements in September 2002. They look at a variety of areas, including: Turbulence modelling; Direct and large-eddy simulations; Applications of turbulence models; Experimental studies; Transition; Turbulence control; Aerodynamic flow; Aero-acoustics; Turbomachinery flows; Heat transfer; Combustion systems; Two-phase flows. These papers are preceded by a section containing 6 invited papers covering various aspects of turbulence modelling and simulation as well as their practical application, combustion modelling and particle-image velocimetry.
