Download or read book Aging and Stabilization of Polymers written by M. B. Neiman and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 374 pages. Available in PDF, EPUB and Kindle. Book excerpt: The need for a broad development of the production of polymer ma terials has become evident. All these materials are subject to various types of aging (destruction); hence, stabilizers which permit the stor age, reprocessing, and use of polymer materials without any appreci able change in their properties must be introduced into them. In recent years, this problem of stabilizing polymers has attracted the attention of many scientists and technologists, both in the USSR and abroad. The scientific basis of the foreign studies will be found in a number of theo retical premises, but chiefly the theory of chain reactions with un branched chains. In the Soviet Union, the concepts of Academician N. N. Semenov on chain reactions with degenerate branches have become the starting point of theoretical studies of the stabilization and destruction of polymers. Soviet scientists have developed a theory of critical concentrations of antioxidants and have shown that the processes of stabilization have a very complex chemical character. The nature of the polymers them selves greatly affects these processes and consequently, different stabil izers are required for polymers of different structures. In addition, it has been shown that the antioxidants used thus far can not only cause chain termination, but can also initiate oxidation and give rise to de generate branches.
Download or read book Polymer Durability written by Roger Lee Clough and published by . This book was released on 1996 with total page 736 pages. Available in PDF, EPUB and Kindle. Book excerpt: Provides a comprehensive overview of the science of polymer durability. Discusses the molecular mechanisms of polymer aging and deterioration, emphasizing UV and thermal exposure environments. Describes a variety of analytical techniques for studying degradation, with special emphasis on chemiluminescence. Covers advances in the use of additives and other approaches for enhancing polymer stability. Reviews mechanisms and applications of major classes of stabilizers, and discusses the problem of stabilizer migration and loss. Examines new methods for predicting the aging rate and lifetime of a material.
Download or read book Degradation of Filled Polymers written by Mikhail Teodorovich Bryk and published by Prentice Hall. This book was released on 1991 with total page 200 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume contains a survey of research studies of the thermal and thermo-oxidative destruction of filled polymers. It examines the thermal properties of the basic components as well as polymeric composite materials, and offers data on the kinetics and mechanism of destruction.
Download or read book Resistance and Stability of Polymers written by Gottfried Wilhelm Ehrenstein and published by Carl Hanser Verlag GmbH Co KG. This book was released on 2013-10-01 with total page 1462 pages. Available in PDF, EPUB and Kindle. Book excerpt: The stability and resistance of polymeric materials determine whether they can be utilized in a given application. Authoritative and reliable material information is needed during the material selection process and this information must consider the influences of material manufacturing, compounding and stabilization, processing, part design, use and subsequent disposal/recycling. This book is based on the review of more than 1200 literature sources and represents a comprehensive overview of the current know-how regarding the stability and resistance of thermoplastics, thermosets, elastomers as well as the most commonly used reinforcements and additives. Extensive tables document material resistance to given media, facilitating appropriate material selection or stabilization for a given application. Contents Volume 1: Principles of Aging Testing Methods Stabilization Influence of Processing and Use Resistance to Thermal and Thermal-Oxidative Loads, Weathering, Chemicals, Ionizing Radiation, Microorganisms, Biological Influences, and Mechanical Loads Creep and Fatigue of Reinforced Polymers Contents Volume 2: Chemical Resistance Tables White Lists of Media Influence (According to DIBt) References Index
Download or read book Accelerated Aging written by Robert L. Feller and published by Getty Publications. This book was released on 1995-03-02 with total page 292 pages. Available in PDF, EPUB and Kindle. Book excerpt: Accelerated Aging: Photochemical and Thermal Aspects represents the culmination of more than 40 years of research by noted scientist Robert L. Feller. The book focuses on the long-term performance of materials such as wool, dyes, and organic compounds; their resistance to change when exposed to environmental factors such as oxygen, ozone, moisture, heat, and light; and their physical durability with handling and use over time. Processes of deterioration are discussed based on speeded-up laboratory studies designed to clarify the chemical reactions involved and their physical consequences.
Download or read book Ageing and Stabilisation of Paper written by M. Strlic (ed.) and published by . This book was released on 2005 with total page 228 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Macromolecules 1 written by H.G. Elias and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 554 pages. Available in PDF, EPUB and Kindle. Book excerpt: The second edition of this textbook is identical with its fourth German edi tion and it thus has the same goals: precise definition of basic phenomena, a broad survey of the whole field, integrated representation of chemistry, physics, and technology, and a balanced treatment of facts and comprehen sion. The book thus intends to bridge the gap between the often oversimpli fied introductory textbooks and the highly specialized texts and monographs that cover only parts of macromolecular science. The text intends to survey the whole field of macromolecular science. Its organization results from the following considerations. The chemical structure of macromolecular compounds should be inde pendent of the method of synthesis, at least in the ideal case. Part I is thus concerned with the chemical and physical structure of polymers. Properties depend on structure. Solution properties are thus discussed in Part 11, solid state properties in Part Ill. There are other reasons for dis cussing properties before synthesis: For example, it is difficult to understand equilibrium polymerization without knowledge of solution thermodynamics, the gel effect without knowledge of the glass transition temperature, etc. Part IV treats the principles of macromolecular syntheses and reactions.
Download or read book Brydson s Plastics Materials written by Marianne Gilbert and published by William Andrew. This book was released on 2016-09-27 with total page 894 pages. Available in PDF, EPUB and Kindle. Book excerpt: Brydson's Plastics Materials, Eighth Edition, provides a comprehensive overview of the commercially available plastics materials that bridge the gap between theory and practice. The book enables scientists to understand the commercial implications of their work and provides engineers with essential theory. Since the previous edition, many developments have taken place in plastics materials, such as the growth in the commercial use of sustainable bioplastics, so this book brings the user fully up-to-date with the latest materials, references, units, and figures that have all been thoroughly updated. The book remains the authoritiative resource for engineers, suppliers, researchers, materials scientists, and academics in the field of polymers, including current best practice, processing, and material selection information and health and safety guidance, along with discussions of sustainability and the commercial importance of various plastics and additives, including nanofillers and graphene as property modifiers. With a 50 year history as the principal reference in the field of plastics material, and fully updated by an expert team of polymer scientists and engineers, this book is essential reading for researchers and practitioners in this field. - Presents a one-stop-shop for easily accessible information on plastics materials, now updated to include the latest biopolymers, high temperature engineering plastics, thermoplastic elastomers, and more - Includes thoroughly revised and reorganised material as contributed by an expert team who make the book relevant to all plastics engineers, materials scientists, and students of polymers - Includes the latest guidance on health, safety, and sustainability, including materials safety data sheets, local regulations, and a discussion of recycling issues
Download or read book Photostabilization of Polymers written by J.F. Rabek and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 607 pages. Available in PDF, EPUB and Kindle. Book excerpt: During the last two decades, the production of polymers and plastics has been increasing rapidly. In spite of developing new polymers and polymeric materials, only 40-60 are used commercially on a large scale. It has been estimated that half of the annual production of polymers is employed outdoors. Increasing the stability of polymers and plastics towards heat, light, atmospheric oxygen and other environmental agents and weathering conditions has always been a very important problem. The photochemical instability of most of polymers limits them to outdoor application, where they are photo degraded fast over periods ranging from months to a few years. To the despair of technologists and consumers alike, photodegrada tion and environmental ageing of polymers occur much faster than can be expected from knowledge collected in laboratories. In many cases, improved methods of preparation and purification of both monomers and polymers yield products of better quality and higher resistance to heat and light. However, without stabilization of polymers by applica tion of antioxidants (to decrease thermal oxidative degradation) and photostabilizers (to decrease photo-oxidative degradation) it would be impossible to employ polymers and plastics in everyday use.
Download or read book Thermal Degradation of Polymeric Materials written by Krzysztof Pielichowski and published by iSmithers Rapra Publishing. This book was released on 2005 with total page 324 pages. Available in PDF, EPUB and Kindle. Book excerpt: Understanding the thermal degradation of polymers is of paramount importance for developing a rational technology of polymer processing and higher-temperature applications. Controlling degradation requires understanding of many different phenomena, including chemical mechanisms, the influence of polymer morphology, the complexities of oxidation chemistry, and the effects of stabilisers, fillers and other additives. This book offers a wealth of information for polymer researchers and processors requiring an understanding of the implications of thermal degradation on material and product performance.
Download or read book Characterization of Minerals Metals and Materials 2015 written by John Carpenter and published by Springer. This book was released on 2016-12-20 with total page 773 pages. Available in PDF, EPUB and Kindle. Book excerpt: This collection focuses on the characterization of minerals, metals, and materials as well as the application of characterization results on the processing of these materials. Papers cover topics such as clays, ceramics, composites, ferrous metals, non-ferrous metals, minerals, electronic materials, magnetic materials, environmental materials, advanced materials, and soft materials. In addition, papers covering materials extraction, materials processing, corrosion, welding, solidification, and method development are included. This book provides a current snapshot of characterization in materials science and its role in validating, informing, and driving current theories in the field of materials science. This volume will serve the dual purpose of furnishing a broad introduction of the field to novices while simultaneously serving to keep subject matter experts up-to-date.
Download or read book Antioxidant Polymers written by Giuseppe Cirillo and published by John Wiley & Sons. This book was released on 2012-06-07 with total page 601 pages. Available in PDF, EPUB and Kindle. Book excerpt: Antioxidant Polymers is an exhaustive overview of the recent developments in the field of polymeric materials showing antioxidant properties. This research area has grown rapidly in the last decade because antioxidant polymers have wide industry applications ranging from materials science to biomedical, pharmaceuticals and cosmetics.
Download or read book Developments in Polymer Stabilisation 8 written by G. Scott and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 303 pages. Available in PDF, EPUB and Kindle. Book excerpt: The purpose of the present series of publications is two-fold. In the first place it is intended to review progress in the development of practical stabilising systems for a wide range of polymers and applications. A complementary and ultimately more important objec tive is to accommodate these practical developments within the framework of antioxidant theory, since there can be little question that further major advances in the practice of stabilisation technology will only be possible on the basis of a firm mechanistic foundation. Research into the role of 'stable' free radicals as antioxidants and stabilisers for polymers has intensified in recent years. Nitroxyl radicals (nitroxides) were the earliest long-lived radicals to be investi gated in detail and Maslov and Zaikov review the developments that have taken place in understanding their reaction mechanisms from the time when they were first investigated in liquid hydrocarbon systems to the present day when their outstanding performance as light stabilisers has been the object of much scientific research. Although some features of their reactivity remain obscure, the authors approach the problem kinetically and indicate the factors limiting their effectiveness.
Download or read book Oxidation Inhibition in Organic Materials written by Jan Pospisil and published by CRC Press. This book was released on 1989-12-31 with total page 398 pages. Available in PDF, EPUB and Kindle. Book excerpt: This two volume publication provides an overview of processes developed to inhibit oxidative deterioration of organic materials. It discusses aspects of auto-oxidation, photo-oxidation and combustion, the major mechanisms involved, oxidation inhibitors classes, and practices in oxidation inhibition. The books include physical phenomena in polymer oxidation, and thermoanalytical methods for studying oxidation inhibition. Covered are analytical methods for inhibitors in organic materials, and scientific and technical prospects in the stabilization of organic materials. This comprehensive title is useful for investigators and students at all levels who have interest in polymer sciences.
Download or read book Engineered Materials Handbook Desk Edition written by ASM International. Handbook Committee and published by ASM International. This book was released on 1995-11-01 with total page 1313 pages. Available in PDF, EPUB and Kindle. Book excerpt: A comprehensive reference on the properties, selection, processing, and applications of the most widely used nonmetallic engineering materials. Section 1, General Information and Data, contains information applicable both to polymers and to ceramics and glasses. It includes an illustrated glossary, a collection of engineering tables and data, and a guide to materials selection. Sections 2 through 7 focus on polymeric materials--plastics, elastomers, polymer-matrix composites, adhesives, and sealants--with the information largely updated and expanded from the first three volumes of the Engineered Materials Handbook. Ceramics and glasses are covered in Sections 8 through 12, also with updated and expanded information. Annotation copyright by Book News, Inc., Portland, OR
Download or read book Degradation and Stabilization of Polymers written by Gennadiĭ Efremovich Zaikov and published by Nova Publishers. This book was released on 1995 with total page 250 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Mechanisms of Polymer Degradation and Stabilisation written by G. Scott and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 336 pages. Available in PDF, EPUB and Kindle. Book excerpt: The purpose of this publication is two-fold. In the first place it is intended to review progress in the development of practical stabilising systems for a wide range of polymers and applications. A complemen tary and ultimately more important objective is to accommodate these practical developments within the framework of antioxidant theory, since there can be little question that further major advances in the practice of stabilisation technology will only be possible on a firm mechanistic foundation. With the continual increase in the number of commercial anti oxidants and stabilisers, often functioning by mechanisms not even considered ten years ago, there is a need for a general theory which will allow the potential user to predict the performance of a particular antioxidant structure under specific practical conditions. Any such predictive tool must involve a simplified kinetic approach to inhibited oxidation and, in Chapter 1, Denisov outlines a possible mechanistic approach with the potential to predict the most useful antioxidant to use and the limits of its usefulness. In Chapter 2, Schwetlick reviews the current state of knowledge on the antioxidant mechanisms of the phosphite esters with particular emphasis on their catalytic peroxidolytic activity. Dithiophosphate v vi PREFACE derivatives show a similar behaviour but for quite different reasons and, in Chapter 3, AI-Malaika reviews information available from analytical studies, particularly using 31p_NMR spectroscopy, to elucid ate the complex chemistry that leads to the formation of the antioxidant -active agents.
