Download or read book Aerodynamic Characteristics of Air cushion Models at Very Low Ground Clearances and at Free stream Dynamic Pressures Exceeding Cushion Pressure written by Kalman J. Grunwald and published by . This book was released on 1970 with total page 140 pages. Available in PDF, EPUB and Kindle. Book excerpt: Air-cushion models employing peripheral jet and plenum cushions of circular, rectangular, and side-by-side planforms were tested in hovering and at forward speed in the 17-foot (5.18-meter) test section of the Langley 300-MPH 7- by 10-foot tunnel. The principal purpose of these tests was to study the characteristics of air cushions when freestream dynamic pressure exceeded air-cushion pressure. Also examined were the hovering performance and the effects of moving ground belt, crosswind, height, and angle of attack. For the configurations tested, there was no significant loss in cushion performance when free-stream dynamic pressure exceeded cushion pressure.
Download or read book NASA Technical Note written by and published by . This book was released on 1970 with total page 1094 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Scientific and Technical Aerospace Reports written by and published by . This book was released on 1970 with total page 356 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Aeronautical Engineering written by and published by . This book was released on 1971 with total page 580 pages. Available in PDF, EPUB and Kindle. Book excerpt: A selection of annotated references to unclassified reports and journal articles that were introduced into the NASA scientific and technical information system and announced in Scientific and technical aerospace reports (STAR) and International aerospace abstracts (IAA)
Download or read book Applied Mechanics Reviews written by and published by . This book was released on 1971 with total page 776 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book UTIAS Review written by University of Toronto. Institute for Aerospace Studies and published by . This book was released on 1971 with total page 764 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Aeronautical Engineering A Special Bibliography with Indexes supplement 1 written by and published by . This book was released on 1971 with total page 572 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book NASA Technical Note written by and published by . This book was released on 1970 with total page 1094 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Fundamentals of Flight written by Richard Shepherd Shevell and published by Pearson Education India. This book was released on 1989 with total page 468 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Airframe and Powerplant Mechanics Airframe Handbook written by United States. Flight Standards Service and published by . This book was released on 1976 with total page 620 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Aerodynamics of a Lifting System in Extreme Ground Effect written by Kirill V. Rozhdestvensky and published by Springer Science & Business Media. This book was released on 2013-03-09 with total page 358 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book is dedicated to the memory of a distinguished Russian engineer, Rostislav E. Alexeyev, who was the first in the world to develop the largest ground effect machine - Ekranoplan. One of Alexeyev's design concepts with the aerodynamic configuration of a jlying wing can be seen on the front page. The book presents a description of a mathematical model of flow past a lifting system, performing steady and unsteady motions in close proximity to the underlying solid surface (ground). This case is interesting for practical purposes because both the aerodynamic and the economic efficiency of the system near the ground are most pronounced. Use of the method of matched asymptotic expansions enables closed form solutions for the aerodynamic characteristics of the wings-in-ground effect. These can be used for design, identification, and processing of experimental data in the course of developing ground effect vehicles. The term extreme ground effect, widely used through out the book, is associated with very small relative ground clearances of the order of 10% or less. The theory of a lifting surface, moving in immediate proximity to the ground, represents one of the few limiting cases that can be treated analytically. The author would like to acknowledge that this work has been influenced by the ideas of Professor Sheila E. Widnall, who was the first to apply the matched asymptotics techniques to treat lifting flows with the ground effect. Saint Petersburg, Russia February 2000 Kirill V. Rozhdestvensky Contents 1. Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Download or read book Theory of Ground Vehicles written by J. Y. Wong and published by John Wiley & Sons. This book was released on 2001-03-20 with total page 586 pages. Available in PDF, EPUB and Kindle. Book excerpt: An updated edition of the classic reference on the dynamics of road and off-road vehicles As we enter a new millennium, the vehicle industry faces greater challenges than ever before as it strives to meet the increasing demand for safer, environmentally friendlier, more energy efficient, and lower emissions products. Theory of Ground Vehicles, Third Edition gives aspiring and practicing engineers a fundamental understanding of the critical factors affecting the performance, handling, and ride essential to the development and design of ground vehicles that meet these requirements. As in previous editions, this book focuses on applying engineering principles to the analysis of vehicle behavior. A large number of practical examples and problems are included throughout to help readers bridge the gap between theory and practice. Covering a wide range of topics concerning the dynamics of road and off-road vehicles, this Third Edition is filled with up-to-date information, including: * The Magic Formula for characterizing pneumatic tire behavior from test data for vehicle handling simulations * Computer-aided methods for performance and design evaluation of off-road vehicles, based on the author's own research * Updated data on road vehicle transmissions and operating fuel economy * Fundamentals of road vehicle stability control * Optimization of the performance of four-wheel-drive off-road vehicles and experimental substantiation, based on the author's own investigations * A new theory on skid-steering of tracked vehicles, developed by the author.
Download or read book WIG Craft and Ekranoplan written by Liang Yun and published by Springer Science & Business Media. This book was released on 2009-12-03 with total page 459 pages. Available in PDF, EPUB and Kindle. Book excerpt: In the last half-century, high-speed water transportation has developed rapidly. Novel high-performance marine vehicles, such as the air cushion vehicle (ACV), surface effect ship (SES), high-speed monohull craft (MHC), catamaran (CAT), hydrofoil craft (HYC), wave-piercing craft (WPC) and small water area twin hull craft (SWATH) have all developed as concepts, achieving varying degrees of commercial and military success. Prototype ACV and SES have achieved speeds of 100 knots in at calm con- tions; however, the normal cruising speed for commercial operations has remained around 35–50 knots. This is partly due to increased drag in an average coastal s- way where such craft operate services and partly due to limitations of the propulsion systems for such craft. Water jets and water propellers face limitations due to c- itation at high speed, for example. SWATH are designed for reduced motions in a seaway, but the hull form is not a low drag form suitable for high-speed operation. So that seems to lead to a problem – maintain water contact and either water propulsion systems run out of power or craft motions and speed loss are a problem in higher seastates. The only way to higher speed would appear to be to disconnect completely from the water surface. You, the reader, might respond with a question about racing hydroplanes, which manage speeds of above 200 kph. Yes, true, but the power-to-weight ratio is extremely high on such racing machines and not economic if translated into a useful commercial vessel.
Download or read book Aeronautical Engineer s Data Book written by Cliff Matthews and published by Elsevier. This book was released on 2001-10-17 with total page 282 pages. Available in PDF, EPUB and Kindle. Book excerpt: Aeronautical Engineer's Data Bookis an essential handy guide containing useful up to date information regularly needed by the student or practising engineer. Covering all aspects of aircraft, both fixed wing and rotary craft, this pocket book provides quick access to useful aeronautical engineering data and sources of information for further in-depth information. - Quick reference to essential data - Most up to date information available
Download or read book Fox and McDonald s Introduction to Fluid Mechanics written by Robert W. Fox and published by John Wiley & Sons. This book was released on 2020-06-30 with total page 610 pages. Available in PDF, EPUB and Kindle. Book excerpt: Through ten editions, Fox and McDonald's Introduction to Fluid Mechanics has helped students understand the physical concepts, basic principles, and analysis methods of fluid mechanics. This market-leading textbook provides a balanced, systematic approach to mastering critical concepts with the proven Fox-McDonald solution methodology. In-depth yet accessible chapters present governing equations, clearly state assumptions, and relate mathematical results to corresponding physical behavior. Emphasis is placed on the use of control volumes to support a practical, theoretically-inclusive problem-solving approach to the subject. Each comprehensive chapter includes numerous, easy-to-follow examples that illustrate good solution technique and explain challenging points. A broad range of carefully selected topics describe how to apply the governing equations to various problems, and explain physical concepts to enable students to model real-world fluid flow situations. Topics include flow measurement, dimensional analysis and similitude, flow in pipes, ducts, and open channels, fluid machinery, and more. To enhance student learning, the book incorporates numerous pedagogical features including chapter summaries and learning objectives, end-of-chapter problems, useful equations, and design and open-ended problems that encourage students to apply fluid mechanics principles to the design of devices and systems.
Download or read book Parachute Recovery Systems written by Theo W. Knacke and published by . This book was released on 1992 with total page 524 pages. Available in PDF, EPUB and Kindle. Book excerpt: The purpose of this manual is to provide recovery system engineers in government and industry with tools to evaluate, analyze, select, and design parachute recovery systems. These systems range from simple, one-parachute assemblies to multiple-parachute systems, and may include equipment for impact attenuation, flotation, location, retrieval, and disposition. All system aspects are discussed, including the need for parachute recovery, the selection of the most suitable recovery system concept, concept analysis, parachute performance, force and stress analysis, material selection, parachute assembly and component design, and manufacturing. Experienced recovery system engineers will find this publication useful as a technical reference book; recent college graduates will find it useful as a textbook for learning about parachutes and parachute recovery systems; and technicians with extensive practical experience will find it useful as an engineering textbook that includes a chapter on parachute- related aerodynamics. In this manual, emphasis is placed on aiding government employees in evaluating and supervising the design and application of parachute systems. The parachute recovery system uses aerodynamic drag to decelerate people and equipment moving in air from a higher velocity to a lower velocity and to a safe landing. This lower velocity is known as rate of descent, landing velocity, or impact velocity, and is determined by the following requirements: (1) landing personnel uninjured and ready for action, (2) landing equipment and air vehicles undamaged and ready for use or refurbishment, and (3) impacting ordnance at a preselected angle and velocity.
Download or read book Ergonomics in the Automotive Design Process written by Vivek D. Bhise and published by CRC Press. This book was released on 2016-04-19 with total page 329 pages. Available in PDF, EPUB and Kindle. Book excerpt: The auto industry is facing tough competition and severe economic constraints. Their products need to be designed "right the first time" with the right combinations of features that not only satisfy the customers but continually please and delight them by providing increased functionality, comfort, convenience, safety, and craftsmanship. Based on t
