Download or read book A Review of High speed Convective Heat transfer Computation Methods written by Michael E. Tauber and published by . This book was released on 1989 with total page 44 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Convective Heat Transfer in Planetary Gases written by Joseph G. Marvin and published by . This book was released on 1965 with total page 60 pages. Available in PDF, EPUB and Kindle. Book excerpt: Equilibrium convective heat transfer in several real gases was investigated. The gases considered were air, nitrogen, hydrogen, carbon dioxide, and argon. Solutions to the similar form of the boundary-layer equations were obtained for flight velocities to 30,000 ft/sec for a range of parameters sufficient to define the effects of pressure level, pressure gradient, boundary-layer-edge velocity, and wall temperature. Results are presented for stagnation-point heating and for the heating-rate distribution. For the range of parameters investigated the wall heat transfer depended on the transport properties near the wall and precise evaluation of properties in the high-energy portions of the boundary layer was not needed. A correlation of the solutions to the boundary-layer equations was obtained which depended only on the low temperature properties of the gases. This result can be used to evaluate the heat transfer in gases other than those considered. The largest stagnation-point heat transfer at a constant flight velocity was obtained for argon followed successively by carbon dioxide, air, nitrogen, and hydrogen. The blunt-body heating-rate distribution was found to depend mainly on the inviscid flow field. For each gas, correlation equations of boundary-layer thermodynamic and transport properties as a function of enthalpy are given for a wide range of pressures to a maximum enthalpy of 18,000 Btu/lb.
Download or read book High speed Wind Tunnels written by Luigi Crocco and published by . This book was released on 1946 with total page 236 pages. Available in PDF, EPUB and Kindle. Book excerpt: The importance assumed in recent times by experimental supersonic wind tunnels, as well as the power required, has brought about the need for a study which would permit a comparison of the types tested and the principal theoretical plans.
Download or read book Facing the Heat Barrier written by T.A. Heppenheimer and published by Courier Dover Publications. This book was released on 2018-09-12 with total page 355 pages. Available in PDF, EPUB and Kindle. Book excerpt: This volume from The NASA History Series presents an overview of the science of hypersonics, the study of flight at speeds at which the physics of flows is dominated by aerodynamic heating. The survey begins during the years immediately following World War II, with the first steps in hypersonic research: the development of missile nose cones and the X-15; the earliest concepts of hypersonic propulsion; and the origin of the scramjet engine. Next, it addresses the re-entry problem, which came to the forefront during the mid-1950s, showing how work in this area supported the manned space program and contributed to the development of the orbital shuttle. Subsequent chapters explore the fading of scramjet studies and the rise of the National Aerospace Plane (NASP) program of 1985–95, which sought to lay groundwork for single-stage vehicles. The program's ultimate shortcomings — in terms of aerodynamics, propulsion, and materials — are discussed, and the book concludes with a look at hypersonics in the post-NASP era, including the development of the X-33 and X-34 launch vehicles, further uses for scramjets, and advances in fluid mechanics. Clearly, ongoing research in hypersonics has yet to reach its full potential, and readers with an interest in aeronautics and astronautics will find this book a fascinating exploration of the field's history and future.
Download or read book The Blunt Plate in Hypersonic Flow written by Donald Louis Baradell and published by . This book was released on 1960 with total page 54 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Aerodynamic Drag Mechanisms of Bluff Bodies and Road Vehicles written by Gino Sovran and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 381 pages. Available in PDF, EPUB and Kindle. Book excerpt: These Proceedings contain the papers and oral discussions presented at the Symposium on AERODYNAMIC DRAG MECHANISMS of Bluff Bodies and Road Vehides held at the General Motors Research Laboratories in Warren, Michigan, on September 27 and 28, 1976. This international, invitational Symposium was the twentieth in an annual series, each one having been in a different technical discipline. The Symposia provide a forum for areas of science and technology that are of timely interest to the Research Laboratories as weIl as the technical community at large, and in which personnel of the Laboratories are actively involved. The Symposia furnish an opportunity for the exchange of ideas and current knowledge between participating research specialists from educational, industrial arid governmental institutions and serve to stimulate future research activity. The present world-wide energy situation makes it highly desirable to reduce the force required to move road vehicles through the atmosphere. A significant amount of the total energy consumed for transportation is expended in overcoming the aerodynamic resistance to motion of these vehicles. Reductions in this aerodynamic drag can therefore have a large impact on ground transportation energy requirements. Although aerodynamic development work on road vehides has been performed for many years, it has not been widely reported or accompanied by much basic research.
Download or read book Innovation in Flight written by Joseph R. Chambers and published by . This book was released on 2005 with total page 406 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Beyond Tube and Wing written by Bruce Larrimer and published by . This book was released on 2020-06-15 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Design and Development of Aerospace Vehicles and Propulsion Systems written by S. Kishore Kumar and published by Springer Nature. This book was released on 2021-03-18 with total page 529 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book presents selected papers presented in the Symposium on Applied Aerodynamics and Design of Aerospace Vehicles (SAROD 2018), which was jointly organized by Aeronautical Development Agency (the nodal agency for the design and development of combat aircraft in India), Gas-Turbine Research Establishment (responsible for design and development of gas turbine engines for military applications), and CSIR-National Aerospace Laboratories (involved in major aerospace programs in the country such as SARAS program, LCA, Space Launch Vehicles, Missiles and UAVs). It brings together experiences of aerodynamicists in India as well as abroad in Aerospace Vehicle Design, Gas Turbine Engines, Missiles and related areas. It is a useful volume for researchers, professionals and students interested in diversified areas of aerospace engineering.
Download or read book Intelligence Revolution 1960 written by Ingard Clausen and published by . This book was released on 2012 with total page 260 pages. Available in PDF, EPUB and Kindle. Book excerpt: Overview: Provides a history of the Corona Satellite photo reconnaissance Program. It was a joint Central Intelligence Agency and United States Air Force program in the 1960s. It was then highly classified.
Download or read book WIG Craft and Ekranoplan written by Liang Yun and published by Springer Science & Business Media. This book was released on 2009-12-03 with total page 459 pages. Available in PDF, EPUB and Kindle. Book excerpt: In the last half-century, high-speed water transportation has developed rapidly. Novel high-performance marine vehicles, such as the air cushion vehicle (ACV), surface effect ship (SES), high-speed monohull craft (MHC), catamaran (CAT), hydrofoil craft (HYC), wave-piercing craft (WPC) and small water area twin hull craft (SWATH) have all developed as concepts, achieving varying degrees of commercial and military success. Prototype ACV and SES have achieved speeds of 100 knots in at calm con- tions; however, the normal cruising speed for commercial operations has remained around 35–50 knots. This is partly due to increased drag in an average coastal s- way where such craft operate services and partly due to limitations of the propulsion systems for such craft. Water jets and water propellers face limitations due to c- itation at high speed, for example. SWATH are designed for reduced motions in a seaway, but the hull form is not a low drag form suitable for high-speed operation. So that seems to lead to a problem – maintain water contact and either water propulsion systems run out of power or craft motions and speed loss are a problem in higher seastates. The only way to higher speed would appear to be to disconnect completely from the water surface. You, the reader, might respond with a question about racing hydroplanes, which manage speeds of above 200 kph. Yes, true, but the power-to-weight ratio is extremely high on such racing machines and not economic if translated into a useful commercial vessel.
Download or read book Handbook of Supersonic Aerodynamics written by Johns Hopkins University. Applied Physics Laboratory, Silver Spring, Md and published by . This book was released on 1961 with total page 516 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Aerodynamics Aeronautics and Flight Mechanics written by Barnes W. McCormick and published by John Wiley & Sons. This book was released on 1994-09-28 with total page 677 pages. Available in PDF, EPUB and Kindle. Book excerpt: A New Edition of the Most Effective Text/Reference in the Field! Aerodynamics, Aeronautics, and Flight Mechanics, Second Edition Barnes W. McCormick, Pennsylvania State University 57506-2 When the first edition of Aerodynamics, Aeronautics, and Flight Mechanics was published, it quickly became one of the most important teaching and reference tools in the field. Not only did generations of students learn from it, they continue to use it on the job-the first edition remains one of the most well-thumbed guides you'll find in an airplane company. Now this classic text/reference is available in a bold new edition. All new material and the interweaving of the computer throughout make the Second Edition even more practical and current than before! A New Edition as Complete and Applied as the First Both analytical and applied in nature, Aerodynamics, Aeronautics, and Flight Mechanics presents all necessary derivations to understand basic principles and then applies this material to specific examples. You'll find complete coverage of the full range of topics, from aerodynamics to propulsion to performance to stability and control. Plus, the new Second Edition boasts the same careful integration of concepts that was an acclaimed feature of the previous edition. For example, Chapters 9, 10, and 11 give a fully integrated presentation of static, dynamic, and automatic stability and control. These three chapters form the basis of a complete course on stability and control. New Features You'll Find in the Second Edition * A new chapter on helicopter and V/STOL aircraft- introduces a phase of aerodynamics not covered in most current texts * Even more material than the previous edition, including coverage of stealth airplanes and delta wings * Extensive use of the computer throughout- each chapter now contains several computer exercises * A computer disk with programs written by the author is available
Download or read book Unsteady Aerodynamics Aeroacoustics and Aeroelasticity of Turbomachines written by Kenneth C. Hall and published by Springer Science & Business Media. This book was released on 2006-05-11 with total page 605 pages. Available in PDF, EPUB and Kindle. Book excerpt: This textbook is a collection of technical papers that were presented at the 10th International Symposium on Unsteady Aerodynamics, Aeroacoustics, and Aeroelasticity of Turbomachines held September 8-11, 2003 at Duke University in Durham, North Carolina. The papers represent the latest in state of the art research in the areas of aeroacoustics, aerothermodynamics, computational methods, experimental testing related to flow instabilities, flutter, forced response, multistage, and rotor-stator effects for turbomachinery.
Download or read book Basics of Aerothermodynamics written by Ernst Heinrich Hirschel and published by Springer Science & Business Media. This book was released on 2006-01-16 with total page 419 pages. Available in PDF, EPUB and Kindle. Book excerpt: The last two decades have brought two important developments for aeroth- modynamics. One is that airbreathing hypersonic flight became the topic of technology programmes and extended system studies. The other is the emergence and maturing of the discrete numerical methods of aerodyn- ics/aerothermodynamics complementary to the ground-simulation facilities, with the parallel enormous growth of computer power. Airbreathing hypersonic flight vehicles are, in contrast to aeroassisted re-entry vehicles, drag sensitive. They have, further, highly integrated lift and propulsion systems. This means that viscous eflFects, like boundary-layer development, laminar-turbulent transition, to a certain degree also strong interaction phenomena, are much more important for such vehicles than for re-entry vehicles. This holds also for the thermal state of the surface and thermal surface effects, concerning viscous and thermo-chemical phenomena (more important for re-entry vehicles) at and near the wall. The discrete numerical methods of aerodynamics/aerothermodynamics permit now - what was twenty years ago not imaginable - the simulation of high speed flows past real flight vehicle configurations with thermo-chemical and viscous effects, the description of the latter being still handicapped by in sufficient flow-physics models. The benefits of numerical simulation for flight vehicle design are enormous: much improved aerodynamic shape definition and optimization, provision of accurate and reliable aerodynamic data, and highly accurate determination of thermal and mechanical loads. Truly mul- disciplinary design and optimization methods regarding the layout of thermal protection systems, all kinds of aero-servoelasticity problems of the airframe, et cetera, begin now to emerge.
Download or read book Natural Laminar Flow and Laminar Flow Control written by R.W. Barnwell and published by Springer Science & Business Media. This book was released on 2012-12-06 with total page 415 pages. Available in PDF, EPUB and Kindle. Book excerpt: Research on laminar flow and its transition to turbulent flow has been an important part of fluid dynamics research during the last sixty years. Since transition impacts, in some way, every aspect of aircraft performance, this emphasis is not only understandable but should continue well into the future. The delay of transition through the use of a favorable pressure gradient by proper body shaping (natural laminar flow) or the use of a small amount of suction (laminar flow control) was recognized even in the early 1930s and rapidly became the foundation of much of the laminar flow research in the U.S. and abroad. As one would expect, there have been many approaches, both theoretical and experimental, employed to achieve the substantial progress made to date. Boundary layer stability theories have been formu lated and calibrated by a good deal of wind tunnel and flight experiments. New laminar now airfoils and wings have been designed and many have been employed in aircraft designs. While the early research was, of necessity, concerned with the design of subsonic aircraft interest has steadily moved to higher speeds including those appropriate to planetary entry. Clearly, there have been substantial advances in our understanding of transition physics and in the development and application of transition prediction methodolo gies to the design of aircraft.
Download or read book Advances in Engineering Design and Simulation written by Chenfeng Li and published by Springer Nature. This book was released on 2019-10-03 with total page 348 pages. Available in PDF, EPUB and Kindle. Book excerpt: This book consists of selected peer-reviewed papers presented at the NAFEMS India Regional Conference (NIRC 2018). It covers current topics related to advances in computer aided design and manufacturing. The book focuses on the latest developments in engineering modelling and simulation, and its application to various complex engineering systems. Finite element method/finite element analysis, computational fluid dynamics, and additive manufacturing are some of the key topics covered in this book. The book aims to provide a better understanding of contemporary product design and analyses, and hence will be useful for researchers, academicians, and professionals.
