Download or read book 241 CX Tanks 70 71 72 Facility Waste Analysis Plan written by Joe M. Nickels and published by . This book was released on 1995 with total page 2 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book 241 CX 70 241 CX 71 and 241 CX 72 Underground Storage Tanks written by Victor G. Edens and published by . This book was released on 1997 with total page 10 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Office of Environmental Management Technical Reports written by and published by . This book was released on 1997 with total page 972 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book 241 CX 70 241 CX 71 and 241 CX 72 Underground Storage Tanks at the Strontium Semiworks Facility written by Sheere J. Ingle and published by . This book was released on 1996 with total page 10 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Waste Analysis Plan for 241 Z written by and published by . This book was released on 2000 with total page 35 pages. Available in PDF, EPUB and Kindle. Book excerpt: The 241-2 waste tanks are used to store, treat, and transfer waste to Tank Farms. The sampling requirements are established to identify the composition of the tank waste. The primary goal is to meet the Tank Farms acceptance criteria. Tank Farms will not accept waste without extensive characterization sample data. Process and lab wastes are sampled for suitability prior to routing to Tk-D8. The samples are helpful in tracking the amount of chemical constituents to determine treatment and are required to maintain Pu inventory and criticality prevention limitations. Likewise, the waste is sampled prior to inter-tank transfers. The revised Waste Analysis Plan for 241-2 (WAP) contains current facility, process and waste descriptions. The WAP lists the Double Shell Tank (DST) system acceptance criteria, sampling parameters and required analyses. The characterization data on historical process wastes was deleted. A section on the Tank Farms waste approval procedural process was added to describe the steps necessary and documentation required to transfer waste to the DST system. Failure to collect proper samples will result in Tank Farms' refusal to accept PFP waste until proper sampling conditions are met. This will use up unnecessary time and resources but not place the plant in a hazardous position.
Download or read book Energy and Water Development Appropriations for 1993 Federal Energy Regulatory Commission written by United States. Congress. House. Committee on Appropriations. Subcommittee on Energy and Water Development and published by . This book was released on 1992 with total page 2466 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Energy and Water Development Appropriations for 1993 written by United States. Congress. House. Committee on Appropriations. Subcommittee on Energy and Water Development and published by . This book was released on 1992 with total page 2480 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book The Office of Environmental Management Technical Reports written by and published by . This book was released on 1997 with total page 968 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Tank 241 AP 108 Grab Sampling and Analysis Plan written by and published by . This book was released on 1997 with total page 23 pages. Available in PDF, EPUB and Kindle. Book excerpt: This Sampling and Analysis Plan (SAP) will identify characterization objectives for sample collection, laboratory analytical evaluation, and reporting requirements for tank 241-AP-108 (AP 108). It is written in accordance with the Tank 241-AP-108 Tank Characterization Plan, the Tank Safety Screening Data Quality Objective, the 242-A Evaporator Liquid Effluent Retention Facility Data Quality Objectives, and the Data Quality Objectives for Tank Farms Waste Compatibility Program.
Download or read book Tank 241 Z 361 Vapor Sampling and Analysis Plan written by and published by . This book was released on 1999 with total page 178 pages. Available in PDF, EPUB and Kindle. Book excerpt: Tank 241-Z-361 is identified in the Hanford Federal Facility Agreement and Consent Order (commonly referred to as the Tri-Party Agreement), Appendix C, (Ecology et al. 1994) as a unit to be remediated under the authority of the Comprehensive Environmental Response, Compensation, and Liability Act of 1980 (CERCLA). As such, the U.S. Environmental Protection Agency will serve as the lead regulatory agency for remediation of this tank under the CERCLA process. At the time this unit was identified as a CERCLA site under the Tri-Party Agreement, it was placed within the 200-ZP-2 Operable Unit. In 1997, The Tri-parties redefined 200 Area Operable Units into waste groupings (Waste Site Grouping for 200 Areas Soils Investigations [DOE-RL 1992 and 1997]). A waste group contains waste sites that share similarities in geological conditions, function, and types of waste received. Tank 241-Z-361 is identified within the CERCLA Plutonium/Organic-rich Process Condensate/Process Waste Group (DOE-RL 1992). The Plutonium/Organic-rich Process Condensate/Process Waste Group has been prioritized for remediation beginning in the year 2004. Results of Tank 216-Z-361 sampling and analysis described in this Sampling and Analysis Plan (SAP) and in the SAP for sludge sampling (to be developed) will determine whether expedited response actions are required before 2004 because of the hazards associated with tank contents. Should data conclude that remediation of this tank should occur earlier than is planned for the other sites in the waste group, it is likely that removal alternatives will be analyzed in a separate Engineering Evaluation/Cost Analysis (EE/CA). Removal actions would proceed after the U.S. Environmental Protection Agency (EPA) signs an Action Memorandum describing the selected removal alternative for Tank 216-Z-361. If the data conclude that there is no immediate threat to human health and the environment from this tank, remedial actions for the tank will be defined in a feasibility study for the entire waste group.
Download or read book Government Reports Announcements Index written by and published by . This book was released on 1996 with total page 694 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Tank 241 T 204 Core 188 Analytical Results for the Final Report written by and published by . This book was released on 1997 with total page 402 pages. Available in PDF, EPUB and Kindle. Book excerpt: TANK 241-T-204, CORE 188, ANALYTICAL RESULTS FOR THE FINAL REPORT. This document is the final laboratory report for Tank 241 -T-204. Push mode core segments were removed from Riser 3 between March 27, 1997, and April 11, 1997. Segments were received and extruded at 222-8 Laboratory. Analyses were performed in accordance with Tank 241-T-204 Push Mode Core Sampling and analysis Plan (TRAP) (Winkleman, 1997), Letter of instruction for Core Sample Analysis of Tanks 241-T-201, 241- T-202, 241-T-203, and 241-T-204 (LAY) (Bell, 1997), and Safety Screening Data Qual@ Objective (DO) ODukelow, et al., 1995). None of the subsamples submitted for total alpha activity (AT) or differential scanning calorimetry (DC) analyses exceeded the notification limits stated in DO. The statistical results of the 95% confidence interval on the mean calculations are provided by the Tank Waste Remediation Systems Technical Basis Group and are not considered in this report.
Download or read book Tank 241 C 107 Tank Characterization Plan written by and published by . This book was released on 1995 with total page 34 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Defense Nuclear Facilities Safety Board (DNFSB) has advised the US Department of Energy (DOE) to concentrate the near-term sampling and analysis activities on identification and resolution of safety issues. The data quality objective (DQO) process was chosen as a tool to be used to identify sampling and analytical needs for the resolution of safety issues. As a result, a revision in the Federal Facility Agreement and Consent Order (Tri-Party Agreement or TPA) milestone M-44-00 has been made, which states that ''A Tank Characterization Plan (TCP) will also be developed for each double-shell tank (DST) and single-shell tank (SST) using the DQO process ... Development of TCPs by the DQO process is intended to allow users (e.g., Hanford Facility user groups, regulators) to ensure their needs will be met and that resources are devoted to gaining only necessary information.'' This document satisfies that requirement for the Tank 241-C-107 (C-107) sampling activities. Currently tank C-107 is categorized as a sound, low-heat load tank with partial isolation completed in December 1982. The tank is awaiting stabilization. Tank C-107 is expected to contain three primary layers of waste. The bottom layer should contain a mixture of the following wastes: ion exchange, concentrated phosphate waste from N-Reactor, Hanford Lab Operations, strontium semi-works, Battelle Northwest, 1C, TBP waste, cladding waste, and the hot semi-works. The middle layer should contain strontium recovery supernate. The upper layer should consist of non-complexed waste.
Download or read book Tank 241 U 105 Push Mode Core Sampling and Analysis Plan Revision 1 written by and published by . This book was released on 1995 with total page 18 pages. Available in PDF, EPUB and Kindle. Book excerpt: This document reports the core sampling and analysis event for tank 241-U-105.
Download or read book Mond Stern Elefant Auto written by and published by . This book was released on 1996 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Tank 241 S 107 Tank Characterization Plan written by and published by . This book was released on 1995 with total page 33 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Defense Nuclear Facilities Safety Board (DNFSB) has advised the Department of Energy (DOE) to concentrate the near-term sampling and analysis activities on identification and resolution of safety issues (Conway 1993). The data quality objective (DQO) process was chosen as a tool to be used to identify the sampling and analytical needs for the resolution of safety issues. As a result, a revision in the Federal Facility Agreement and Consent Order (Tri-Party Agreement) milestone M-44 has been made, which states that ''A Tank Characterization Plan (TCP) will also be developed for each double-shell tank (DST) and single-shell tank (SST) using the DQO process''. This document satisfies that requirement for tank 241-S-107 (S-107) sampling activities. The report gives a summary of descriptive information available on Tank S-107. Included are the present status and physical description of the tank, its age, process history, and expected tank contents from previous sampling and analytical data. The different types of waste, by layer, for Tank S-107 will also be discussed. As of December 1994, Tank S-107 has been categorized as sound and was partially isolated in December 1982. It is a low-heat load tank and is awaiting stabilization. Tank S-107 is expected to contain two primary layers of waste. The bottom layer should contain a mixture of REDOX waste and REDOX cladding waste. The second layer contains S1 saltcake (waste generated from the 242-S evaporator/crystallizer from 1973 until 1976), and S2 salt slurry (waste generated from the 242-S evaporator-crystallizer from 1977 until 1980).
Download or read book Tank 241 B 106 Push Mode Core Sampling and Analysis Plan written by and published by . This book was released on 1995 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:
