Download or read book The Office of Environmental Management Technical Reports written by and published by . This book was released on 1997 with total page 972 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Radioactive Waste Management written by and published by . This book was released on 1996 with total page 430 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book The Office of Environmental Management Technical Reports written by and published by . This book was released on 1997 with total page 968 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book EPA Publications Bibliography written by and published by . This book was released on 1999 with total page 744 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Energy Research Abstracts written by and published by . This book was released on 1995 with total page 774 pages. Available in PDF, EPUB and Kindle. Book excerpt: Semiannual, with semiannual and annual indexes. References to all scientific and technical literature coming from DOE, its laboratories, energy centers, and contractors. Includes all works deriving from DOE, other related government-sponsored information, and foreign nonnuclear information. Arranged under 39 categories, e.g., Biomedical sciences, basic studies; Biomedical sciences, applied studies; Health and safety; and Fusion energy. Entry gives bibliographical information and abstract. Corporate, author, subject, report number indexes.

Download or read book INIS Atomindex written by and published by . This book was released on 1995 with total page 684 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Government Reports Announcements Index written by and published by . This book was released on 1996 with total page 660 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Download or read book Engineering and Design written by Us Army Corps Of Engineers and published by Military Bookshop. This book was released on 2002-06-01 with total page 434 pages. Available in PDF, EPUB and Kindle. Book excerpt: This manual provides practical guidance for the design and operation of soil vapor extraction (SVE) and bioventing (BV) systems. It is intended for use by engineers, geologists, hydrogeologists, and soil scientists, chemists, project managers, and others who possess a technical education and some design experience but only the broadest familiarity with SVE or BV systems.

Download or read book Backpacker written by and published by . This book was released on 2001-03 with total page 206 pages. Available in PDF, EPUB and Kindle. Book excerpt: Backpacker brings the outdoors straight to the reader's doorstep, inspiring and enabling them to go more places and enjoy nature more often. The authority on active adventure, Backpacker is the world's first GPS-enabled magazine, and the only magazine whose editors personally test the hiking trails, camping gear, and survival tips they publish. Backpacker's Editors' Choice Awards, an industry honor recognizing design, feature and product innovation, has become the gold standard against which all other outdoor-industry awards are measured.

Download or read book Chemical Engineering Design written by Gavin Towler and published by Elsevier. This book was released on 2012-01-25 with total page 1321 pages. Available in PDF, EPUB and Kindle. Book excerpt: Chemical Engineering Design, Second Edition, deals with the application of chemical engineering principles to the design of chemical processes and equipment. Revised throughout, this edition has been specifically developed for the U.S. market. It provides the latest US codes and standards, including API, ASME and ISA design codes and ANSI standards. It contains new discussions of conceptual plant design, flowsheet development, and revamp design; extended coverage of capital cost estimation, process costing, and economics; and new chapters on equipment selection, reactor design, and solids handling processes. A rigorous pedagogy assists learning, with detailed worked examples, end of chapter exercises, plus supporting data, and Excel spreadsheet calculations, plus over 150 Patent References for downloading from the companion website. Extensive instructor resources, including 1170 lecture slides and a fully worked solutions manual are available to adopting instructors. This text is designed for chemical and biochemical engineering students (senior undergraduate year, plus appropriate for capstone design courses where taken, plus graduates) and lecturers/tutors, and professionals in industry (chemical process, biochemical, pharmaceutical, petrochemical sectors). New to this edition: - Revised organization into Part I: Process Design, and Part II: Plant Design. The broad themes of Part I are flowsheet development, economic analysis, safety and environmental impact and optimization. Part II contains chapters on equipment design and selection that can be used as supplements to a lecture course or as essential references for students or practicing engineers working on design projects. - New discussion of conceptual plant design, flowsheet development and revamp design - Significantly increased coverage of capital cost estimation, process costing and economics - New chapters on equipment selection, reactor design and solids handling processes - New sections on fermentation, adsorption, membrane separations, ion exchange and chromatography - Increased coverage of batch processing, food, pharmaceutical and biological processes - All equipment chapters in Part II revised and updated with current information - Updated throughout for latest US codes and standards, including API, ASME and ISA design codes and ANSI standards - Additional worked examples and homework problems - The most complete and up to date coverage of equipment selection - 108 realistic commercial design projects from diverse industries - A rigorous pedagogy assists learning, with detailed worked examples, end of chapter exercises, plus supporting data and Excel spreadsheet calculations plus over 150 Patent References, for downloading from the companion website - Extensive instructor resources: 1170 lecture slides plus fully worked solutions manual available to adopting instructors

Download or read book Analysis of Selected Enhancements for Soil Vapor Extraction written by and published by DIANE Publishing. This book was released on 1997 with total page 246 pages. Available in PDF, EPUB and Kindle. Book excerpt: This report provides an engineering analysis of, and status report on, selected enhancements for soil vapor extraction (SVE) treatment technologies. The report is intended to assist project managers considering an SVE treatment system by providing them with an up-to-date status of enhancement technologies; an evaluation of each technology's applicability to various site conditions; a presentation of cost and performance information; a list of vendors specializing in the technologies; a discussion of relative strengths and limitations of the technologies; recommendations to keep in mind when considering the enhancements; and a compilation of references. The performance of an SVE system depends on properties of both the contaminants and the soil. SVE is generally applicable to compounds with a vapor pressure of greater than 1 millimeter of mercury at 20EC and a Henry s Law constant of greater than 100 atmospheres per mole fraction. SVE is most effective at sites with relatively permeable contaminated soil and with saturated hydraulic conductivities of greater than 1 x 10 or 1 x 10 centimeter per second (cm/s). SVE by itself does not effectively remove contaminants -3 -2 in saturated soil. However, SVE can be used as an integral part of some treatment schemes that treat both groundwater and the overlying vadose zone. Enhancement technologies should be considered when contaminant or soil characteristics limit the effectiveness of SVE or when contaminants are present in saturated soil. The five enhancement technologies covered in this report are as follows and are described in the following subsections: * Air Sparging * Dual-phase Extraction * Directional Drilling * Pneumatic and Hydraulic Fracturing * Thermal Enhancement.

Download or read book Principles of Environmental Physics written by John Monteith and published by Butterworth-Heinemann. This book was released on 1990-02-15 with total page 308 pages. Available in PDF, EPUB and Kindle. Book excerpt: Thoroughly revised and up-dated edition of a highly successful textbook.

Download or read book Transformers written by and published by Reclamation Bureau. This book was released on 2005 with total page 253 pages. Available in PDF, EPUB and Kindle. Book excerpt: On cover: Reclamation, Managing Water in the West. Describes how transformers work, how they are maintained, and how to test and evaluate their condition.

Download or read book Rules of Thumb for Chemical Engineers written by Carl Branan and published by Gulf Professional Publishing. This book was released on 2002 with total page 438 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fractionators, separators and accumulators, cooling towers, gas treating, blending, troubleshooting field cases, gas solubility, and density of irregular solids * Hundreds of common sense techniques, shortcuts, and calculations.

Download or read book Analysis Synthesis and Design of Chemical Processes written by Richard Turton and published by Pearson Education. This book was released on 2008-12-24 with total page 1562 pages. Available in PDF, EPUB and Kindle. Book excerpt: The Leading Integrated Chemical Process Design Guide: Now with New Problems, New Projects, and More More than ever, effective design is the focal point of sound chemical engineering. Analysis, Synthesis, and Design of Chemical Processes, Third Edition, presents design as a creative process that integrates both the big picture and the small details–and knows which to stress when, and why. Realistic from start to finish, this book moves readers beyond classroom exercises into open-ended, real-world process problem solving. The authors introduce integrated techniques for every facet of the discipline, from finance to operations, new plant design to existing process optimization. This fully updated Third Edition presents entirely new problems at the end of every chapter. It also adds extensive coverage of batch process design, including realistic examples of equipment sizing for batch sequencing; batch scheduling for multi-product plants; improving production via intermediate storage and parallel equipment; and new optimization techniques specifically for batch processes. Coverage includes Conceptualizing and analyzing chemical processes: flow diagrams, tracing, process conditions, and more Chemical process economics: analyzing capital and manufacturing costs, and predicting or assessing profitability Synthesizing and optimizing chemical processing: experience-based principles, BFD/PFD, simulations, and more Analyzing process performance via I/O models, performance curves, and other tools Process troubleshooting and “debottlenecking” Chemical engineering design and society: ethics, professionalism, health, safety, and new “green engineering” techniques Participating successfully in chemical engineering design teams Analysis, Synthesis, and Design of Chemical Processes, Third Edition, draws on nearly 35 years of innovative chemical engineering instruction at West Virginia University. It includes suggested curricula for both single-semester and year-long design courses; case studies and design projects with practical applications; and appendixes with current equipment cost data and preliminary design information for eleven chemical processes–including seven brand new to this edition.

Download or read book Rules of Thumb for Mechanical Engineers written by J. Edward Pope and published by Gulf Professional Publishing. This book was released on 1997 with total page 417 pages. Available in PDF, EPUB and Kindle. Book excerpt: Fluids -- Heat transfer -- Thermodynamics -- Mechanical seals -- Pumps and compressors -- Drivers -- Gears -- Bearings -- Piping and pressure vessels -- Tribology -- Vibration -- Materials -- Stress and strain -- Fatigue -- Instrumentation -- Engineering economics.

Download or read book Applied Engineering Principles Manual Training Manual NAVSEA written by Naval Sea Systems Command and published by . This book was released on 2019-07-15 with total page 454 pages. Available in PDF, EPUB and Kindle. Book excerpt: Chapter 1 ELECTRICAL REVIEW 1.1 Fundamentals Of Electricity 1.2 Alternating Current Theory 1.3 Three-Phase Systems And Transformers 1.4 Generators 1.5 Motors 1.6 Motor Controllers 1.7 Electrical Safety 1.8 Storage Batteries 1.9 Electrical Measuring Instruments Chapter 2 ELECTRONICS REVIEW 2.1 Solid State Devices 2.2 Magnetic Amplifiers 2.3 Thermocouples 2.4 Resistance Thermometry 2.5 Nuclear Radiation Detectors 2.6 Nuclear Instrumentation Circuits 2.7 Differential Transformers 2.8 D-C Power Supplies 2.9 Digital Integrated Circuit Devices 2.10 Microprocessor-Based Computer Systems Chapter 3 REACTOR THEORY REVIEW 3.1 Basics 3.2 Stability Of The Nucleus 3.3 Reactions 3.4 Fission 3.5 Nuclear Reaction Cross Sections 3.6 Neutron Slowing Down 3.7 Thermal Equilibrium 3.8 Neutron Density, Flux, Reaction Rates, And Power 3.9 Slowing Down, Diffusion, And Migration Lengths 3.10 Neutron Life Cycle And The Six-Factor Formula 3.11 Buckling, Leakage, And Flux Shapes 3.12 Multiplication Factor 3.13 Temperature Coefficient...