EBookClubs

Read Books & Download eBooks Full Online

EBookClubs

Read Books & Download eBooks Full Online

Book Use of Supplemental Solar Heat in the Kiln Drying of Hardwood Lumber

Download or read book Use of Supplemental Solar Heat in the Kiln Drying of Hardwood Lumber written by Robert Lewis Little and published by . This book was released on 1979 with total page 376 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Solar Industrial Process Heat for Kiln Drying Lumber

Download or read book Solar Industrial Process Heat for Kiln Drying Lumber written by S. James Robertson and published by . This book was released on 1977 with total page 72 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Design and Construction of Solar Kiln for Lumber Drying

Download or read book Design and Construction of Solar Kiln for Lumber Drying written by Awam Joel and published by GRIN Verlag. This book was released on 2019-06-18 with total page 9 pages. Available in PDF, EPUB and Kindle. Book excerpt: Academic Paper from the year 2015 in the subject Engineering - Chemical Engineering, , language: English, abstract: This research aims to design and fabricate a solar kiln dryer that uses a solar panel to trap the sun’s rich energy and also the design of an inverter that converts the direct current of the sun to an alternative current that will charge the battery and power heater element for drying. The principal mode of heat transfer is convection. The temperature of the incoming stream of air is raised by the heating element, a circular motion fan drives the heated air uniformly through the heating chamber, in this way heat is convectively transferred from the hot air to the cold air. Wood is a hygroscopic material which gains moisture content as a result of changes in humidity. Hygroscopicity is one of the most distinctive properties of wood. Any kind of wood product absorbs and desorbs moisture from the surrounding air until it reaches equilibrium moisture content (EMC), a balance point between the wood’s moisture content and that of the surrounding environment. Fresh cut lumber contains a great deal of water. If the water is not removed, the lumber can’t be used to produce a high quality finished product. Properly dried lumber sells for a higher price and is much easier to work with than lumber that have not been dried. When lumber is well dried it machines better, glues better, and finishes better. Drying also improves the strength of the lumber, kills infestations, hardens pitch, preserves colour, reduces weight and controls shrinkage. Lumber that is not dried under controlled conditions is prone to warping, staining, and other degradations that diminishes its selling price and workability.

Book Lumber Drying

    Book Details:
  • Author : Dan Bousquet
  • Publisher :
  • Release : 2000
  • ISBN :
  • Pages : 12 pages

Download or read book Lumber Drying written by Dan Bousquet and published by . This book was released on 2000 with total page 12 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Solar Energy Update

Download or read book Solar Energy Update written by and published by . This book was released on 1981 with total page 698 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Drying Eastern Hardwood Lumber

Download or read book Drying Eastern Hardwood Lumber written by John M. McMillen and published by . This book was released on 1978 with total page 112 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Drying Wood with a Solar Kiln   Plans Included

Download or read book Drying Wood with a Solar Kiln Plans Included written by John Davidson and published by Mendon Cottage Books. This book was released on 2016-04-25 with total page 55 pages. Available in PDF, EPUB and Kindle. Book excerpt: Table of Contents Introduction Benefits of Using Wood Drying of Wood Why is Wood Drying Necessary? Wood Drying Points and Categories Benefits of Wood Drying Process: Different Methods Used in the Wood Drying Process: Different Types of Kilns Used for Wood Drying: Solar Kiln: Conventional Kiln: Vacuum Kilns: Dehumidification Kiln: Solar Kiln Wood Drying and its Advantages: Key Features of a Solar Kiln: The Mechanism of the Solar Kiln Wood Drying: Important Indicators Used in the Solar Kiln for Wood Drying: Moisture Reading: Moisture Meter: Appropriate MC Level: Types of Solar Kiln Designs: The Greenhouse Design: The Semi-Greenhouse Design: The Opaque Wall Design: How to Build a Solar Kiln for Wood Drying Selection of the kiln design: Building the Solar Kiln: Assembling the Solar Kiln: Important Considerations While Building the Solar Kiln: The Storage: The Circulation System: The Ventilation System: The Glazing Material used: Insulation of the Walls: Size of the Collector: Plans for Building a Solar Kiln Conclusion: Author Bio Publisher Introduction Among the thousands of natural resources present in the world, wood is one of the most popular ones. It was not until the turn of the previous century that the human dependence on wood was higher than any other sources of energy. It was considered to be a one of the wonders of nature that was created to provide comfort and support to the humanly civilized way of living. Although there is no historical confirmation about the first use of wood by humans, still it dates back to a very long period of time when it was a major lifestyle resource for our ancestors from the ancient times. Wood was utilized not just as a source of heating or drawing energy, but also as a material for making tools, household furniture, sheltering objects, transporting objects, decorative purposes, culinary items and cutlery, and a large number of other items that one can only imagine. As per historians, wood was the original material used in most of the first time scientific inventions. To date, wood is a very important part of human living. Life without wood can be very difficult and expensive.

Book Drying hardwoods by intergrating solar energy  wood energy  and dehumidification

Download or read book Drying hardwoods by intergrating solar energy wood energy and dehumidification written by E. T. Choong and published by . This book was released on 1989 with total page 32 pages. Available in PDF, EPUB and Kindle. Book excerpt: The customary method of drying hardwoods in the southern United States has been to air-dry the lumber to 20 percent MC then to kiln-dry it. While air drying has the benefit of low cost and substantial energy savings, it also has the undesirable aspects of long drying times and uncontrollable climatic conditions. The unfavorable environment may be adequately controlled in an enclosed and efficient solar kiln. When using only solar heat, yellow-poplar lumber dried to 20 percent MC up to three times faster than by air-drying. Defects for yellow-poplar in both air-drying and solar-drying were minimal. When dried to 30 percent MC, red oak dried 45 percent faster in the kiln, using only solar energy, compared with air-drying. When the dehumidification system was used as a supplementary drying source from 35 percent to 30 percent MC, red oak dried 52 percent faster than by air-drying. Yellow-poplar can be solar dried to 15 percent MC in Louisiana provided unusually poor weather conditions are not persistente. It is recommended that high humidifity (80 percent RH) be used until 35 percent MC is reached to prevent defects. Solar-drying and high humidity to 35 percent MC is probably sufficient to dry hackberry and other easy-to-dry hardwoods; however, more testing is needed to substantiate this point. Below the fiber saturation point, most woods dried very slowly by both air-drying and solar-drying methods.

Book Improvements in Solar Dry Kiln Design

Download or read book Improvements in Solar Dry Kiln Design written by Eugene M. Wengert and published by . This book was released on 1971 with total page 12 pages. Available in PDF, EPUB and Kindle. Book excerpt: Interest in solar drying of lumber has increased in recent years because previous results had indicated that: Drying times are shorter and final moisture contents are lower in solar drying than in air drying; much less lumber degrade occurs in solar drying when compared to air drying; and the cost of energy is less in solar drying than in kiln drying. Work in the field of solar drying has reached the point at which dryer designs are being modified or need to be modified to provide more efficient dryers. In order that these modifications can be made intelligently, it is necessary to identify the weak areas (such as excessive solar reflectance from the walls) in the present dryer designs. The objective of this study was to identify the major energy losses in the solar dryer at Colorado State University, and then to suggest various design changes, based on theoretical considerations, to reduce these losses to leave more energy for the primary task of drying wood.

Book FPL Design for Lumber Dry Kiln Using Solar wood Energy in Tropical Latitudes

Download or read book FPL Design for Lumber Dry Kiln Using Solar wood Energy in Tropical Latitudes written by John L. Tschernitz and published by . This book was released on 1985 with total page 20 pages. Available in PDF, EPUB and Kindle. Book excerpt: Developing countries with a timber resource that can be manufactured into finished products either for local use or export often lack the capital to build high-cost dry kilns. Many of these countries are in the tropics where solar radiation and ambient temperatures are high. The low-cost solar/wood energy lumber dry kiln described in this report was designed and tested by the Forest Products Laboratory (FPL) for such countries where solar dry kilns can be built and operated at low cost. The FPL design is for a 6,000-fbm capacity kiln having an insulated drying compartment, an external horizontal solar collector, and a furnace room containing a wood burner. Capacities larger or smaller than 6,000 fbm are also possible. This design allows collector and wood burner sizing to match the energy demands of the dryer. The design also incorporates low-cost controls that allow unattended drying when operated as a solar-only dryer. Manual firing is necessary when the wood-burning system is supplying the energy. This kiln design is the final, commercial-size version established after years of testing several 1,000-fbm capacity prototypes. In December 1984 a kiln of this design was built in Sri Lanka at a factory that manufactures furniture and laminated beams from rubber and coconut wood.

Book Solar Industrial Process Heat for Kiln Drying Lumber

Download or read book Solar Industrial Process Heat for Kiln Drying Lumber written by S. James Robertson and published by . This book was released on 1977 with total page 0 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Improvements in Hardwood Lumber Drying Via Microprocessor Control

Download or read book Improvements in Hardwood Lumber Drying Via Microprocessor Control written by Robert L. Little and published by . This book was released on 1985 with total page 34 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Miscellaneous Publication

Download or read book Miscellaneous Publication written by and published by . This book was released on 1981 with total page 220 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book Drying Wood with the Sun

Download or read book Drying Wood with the Sun written by and published by . This book was released on 1983 with total page 34 pages. Available in PDF, EPUB and Kindle. Book excerpt:

Book The Art of Timber Drying with Solar Kilns

Download or read book The Art of Timber Drying with Solar Kilns written by G. S. Hall and published by . This book was released on 1981 with total page 50 pages. Available in PDF, EPUB and Kindle. Book excerpt: