Download or read book Tunnel Support Loading Caused by Rock Failure written by Jaak J. K. Daemen and published by . This book was released on 1975 with total page 514 pages. Available in PDF, EPUB and Kindle. Book excerpt: Two methods are presented for the analysis of tunnel support loading caused by rock failure. In the first part of this thesis closed-form solutions are used, in the second part numerical techniques. Emphasis is put upon the statical indeterminacy of the problem and upon the necessity for considering the relative displacements between ground and support. From this follows the need for a realistic calculation of the stiffness of ground and support, as well as the need to consider the sequential development of the interaction between these two elements. It is assumed that the rock mass behavior during failure is softening and dilatant. Interface problems between ground and support that can strongly influence the effective support stiffness are discussed.
Download or read book Analysis of Tunnel Support Structure with Consideration of Support rock Interaction written by J. Donald Dixon and published by . This book was released on 1971 with total page 54 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Tunnel Support Loading Caused by Rock Failure written by Jaak Joseph K. Daemen and published by . This book was released on 1975 with total page 366 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Assessment and Prevention of Failure Phenomena in Rock Engineering written by O. Aydan and published by CRC Press. This book was released on 1993-01-01 with total page 1008 pages. Available in PDF, EPUB and Kindle. Book excerpt: A collection of papers addressing the issue of the failure of rock engineering structures. This phenomenon occurs in different forms depending on the geometry of structure, material properties of intact rock, structure of rock mass, environmental conditions and initial state of stress.
Download or read book Tunnelling in Weak Rocks written by Bhawani Singh and published by Elsevier. This book was released on 2011-08-29 with total page 509 pages. Available in PDF, EPUB and Kindle. Book excerpt: Vast knowledge has been developed in the area of tunnelling in weak rocks over the years, and this book bridges an important gap by bringing all the information together for the benefit of the tunnelling Industry. In particular, tunnelling in poor conditions is a huge challenge for engineers and designers, and this book tackles all typical problems headon. Topics covered include classification approach, design approaches for site-specific grounds, a new invention on shielded tunnel boring machine, case histories, tunnel mechanics, risk engineering and management culture. Based on extensive field research experiences in Himalayan region and Alps Exclusive chapters on tunnelling hazards, squeezing ground conditions (a full detailed case study), swelling ground conditions, critical state rock mechanics, etc. Supported by over 180 figures and 90 tables of data, and test examples (with solutions)
Download or read book ENGINEERING IN ROCKS FOR SLOPES FOUNDATIONS AND TUNNELS written by T. RAMAMURTHY and published by PHI Learning Pvt. Ltd.. This book was released on 2014-01-01 with total page 779 pages. Available in PDF, EPUB and Kindle. Book excerpt: With the ever-increasing developmental activities as diverse as the construction of dams, roads, tunnels, underground powerhouses and storage facilities, petroleum exploration and nuclear repositories, a more comprehensive and updated understanding of rock mass is essential for civil engineers, engineering geologists, geophysicists, and petroleum and mining engineers. Though some contents of this vast subject are included in under-graduate curriculum, there are full-fledged courses on Rock Mechanics/Rock Engineering in postgraduate programmes in civil engineering and mining engineering. Much of the material presented in this book is also taught to geology and geophysics students. In addition, the book is suitable for short courses conducted for teachers, practising engineers and engineering geologists. This book, with contributions from a number of authors with expertise and vast experience in various areas of rock engineering, gives an in-depth analysis of the multidimensional aspects of the subject. The text covers a wide range of topics related to engineering behaviour of rocks and rock masses, their classifications, interpretation of geological mapping of joints through stereographic projection, in situ stress measurements, laboratory and field tests, stability of rock slopes, foundations of structures, including dams and support systems for underground excavations. The Third Edition of the book is further enriched with the addition of a number of case histories in which the analyses and designs were carried out by adopting rock mass parameters as per RMR, Q or GSI. The consequence of such an approach is critically examined. With the adoption of parameters from joint factor, excellent performance prediction has been demonstrated for anisotropic rocks and tunnel. Various expressions developed for Kn and Ks for different conditions are included for adoption in numerical analyses. When dilatancy component is separated, the scale effect on shear response is insignificant. This edition provides a comprehensive understanding of rock mass response and enables students to tackle rock engineering problems more confidently and realistically, and therefore it will be of immense benefit to students, teachers, professionals and designers alike.
Download or read book Proceedings of the International Symposium on Engineering in Complex Rock Formations written by Li Chengxiang and published by Elsevier. This book was released on 2013-10-22 with total page 1001 pages. Available in PDF, EPUB and Kindle. Book excerpt: Proceedings of the International Symposium on Engineering in Complex Rock Formations
Download or read book Tunnel Design Methods written by Antonio Bobet and published by CRC Press. This book was released on 2023-09-12 with total page 626 pages. Available in PDF, EPUB and Kindle. Book excerpt: Tunnel Design Methods covers analytical, numerical, and empirical methods for the design of tunnels in soil and in rock. The material is intended for design engineers looking for detailed methods, for graduate students who are interested in tunnelling, and for researchers working on various aspects of ground-support interaction under static and seismic loading. The book is divided into seven chapters, covering fundamental concepts on ground and support behavior and on ground-excavation-support interaction and provides detailed information on analytical and numerical methods used for the design of tunnels, with applications, and on the latest developments on empirical methods. The principles and formulations included are used, throughout the book, to provide insight into the response of tunnels under both simple and complex loading conditions, thus providing the reader with fundamental understanding of tunnel behavior. Both authors have experience in tunnelling and have worked extensively in practice, designing tunnels both in the United States and abroad, and in research.
Download or read book Stability Analysis and Modelling of Underground Excavations in Fractured Rocks written by Jian Zhao and published by Elsevier. This book was released on 2003-12-18 with total page 308 pages. Available in PDF, EPUB and Kindle. Book excerpt: Provides practical solutions to the challenge of modeling and analyzing rock masses Consolidates a wealth of previously published technical papers on the subject and introduces previously unseen material This authoritative title is a key reference for any Geo-engineer. Rock masses differ considerably from man-made materials, and their properties can vary with location, direction and time. As a result there is a critical need to capture these variations via modeling and analysis. Zhu and Zhao provide an expert introduction to the techniques and analytical methods needed for studying underground excavations in fractured rock masses. The book brings together previously published and new material to provide a comprehensive and up-to-date reference. Provides practical solutions to the challenge of modeling and analyzing rock masses Consolidates a wealth of previously published technical papers on the subject and introduces previously unseen material
Download or read book Tunnels and Shafts in Rock written by United States. Army. Corps of Engineers and published by . This book was released on 1978 with total page 474 pages. Available in PDF, EPUB and Kindle. Book excerpt:
Download or read book Rock Mechanics and Engineering Volume 5 written by Xia-Ting Feng and published by CRC Press. This book was released on 2017-07-20 with total page 748 pages. Available in PDF, EPUB and Kindle. Book excerpt: Surface and Underground Projects is the last volume of the five-volume set Rock Mechanics and Engineering and contains twenty-one chapters from key experts in the following fields: - Slopes; - Tunnels and Caverns; - Mining; - Petroleum Engineering; - Thermo-/Hydro-Mechanics in Gas Storage, Loading and Radioactive Waste Disposal. The five-volume set “Comprehensive Rock Engineering”, which was published in 1993, has had an important influence on the development of rock mechanics and rock engineering. Significant and extensive advances and achievements in these fields over the last 20 years now justify the publishing of a comparable, new compilation. Rock Mechanics and Engineering represents a highly prestigious, multi-volume work edited by Professor Xia-Ting Feng, with the editorial advice of Professor John A. Hudson. This new compilation offers an extremely wideranging and comprehensive overview of the state-of-the-art in rock mechanics and rock engineering and is composed of peer-reviewed, dedicated contributions by all the key experts worldwide. Key features of this set are that it provides a systematic, global summary of new developments in rock mechanics and rock engineering practices as well as looking ahead to future developments in the fields. Contributors are worldrenowned experts in the fields of rock mechanics and rock engineering, though younger, talented researchers have also been included. The individual volumes cover an extremely wide array of topics grouped under five overarching themes: Principles (Vol. 1), Laboratory and Field Testing (Vol. 2), Analysis, Modelling and Design (Vol. 3), Excavation, Support and Monitoring (Vol. 4) and Surface and Underground Projects (Vol. 5). This multi-volume work sets a new standard for rock mechanics and engineering compendia and will be the go-to resource for all engineering professionals and academics involved in rock mechanics and engineering for years to come.
Download or read book Engineering Rock Mass Classification written by R K Goel and published by Elsevier. This book was released on 2011-08-09 with total page 384 pages. Available in PDF, EPUB and Kindle. Book excerpt: Rock mass classification methods are commonly used at the preliminary design stages of a construction project when there is very little information. It forms the bases for design and estimation of the required amount and type of rock support and groundwater control measures. Encompassing nearly all aspects of rock mass classifications in detail, Civil Engineering Rock Mass Classification: Tunnelling, Foundations and Landsides provides construction engineers and managers with extensive practical knowledge which is time-tested in the projects in Himalaya and other parts of the world in complex geological conditions. Rock mass classification is an essential element of feasibility studies for any near surface construction project prior to any excavation or disturbances made to earth. Written by an author team with over 50 years of experience in some of the most difficult mining regions of the world, Civil Engineering Rock Mass Classification: Tunnelling, Foundations and Landsides provides construction engineers, construction managers and mining engineers with the tools and methods to gather geotechnical data, either from rock cuts, drifts or core, and process the information for subsequent analysis. The goal is to use effective mapping techniques to obtain data can be used as input for any of the established rock classification systems. The book covers all of the commonly used classification methods including: Barton’s Q and Q’ systems, Bieniawski’s RMR, Laubscher’s MRMR and Hoek’s and GSI systems. With this book in hand, engineers will be able to gather geotechnical data, either from rock cuts, drifts or core, and process the information for subsequent analysis. Rich with international case studies and worked out equations, the focus of the book is on the practical gathering information for purposes of analysis and design. Identify the most significant parameters influencing the behaviour of a rock mass Divide a particular rock mass formulation into groups of similar behaviour, rock mass classes of varying quality Provide a basis of understanding the characteristics of each rock mass class Relate the experience of rock conditions at one site to the conditions and experience encountered at others Derive quantitative data and guidelines for engineering design Provide common basis for communication between engineers and geologists
Download or read book Ground Control and Improvement written by Petros P. Xanthakos and published by John Wiley & Sons. This book was released on 1994-06-14 with total page 942 pages. Available in PDF, EPUB and Kindle. Book excerpt: A comprehensive compilation concerned with a variety of modern methods being used worldwide to improve soil and rock conditions supporting new and remedial construction. Ground water lowering and drainage techniques, soil compaction, excavation support methods, permeation and jet grouting are among the many topics discussed. More than 100 tables and 650 figures illustrate the text.
Download or read book Underground Excavations in Rock written by E.T. Brown and published by CRC Press. This book was released on 1980-06-30 with total page 532 pages. Available in PDF, EPUB and Kindle. Book excerpt: Underground Excavations in Rock deals with the geotechnical aspects of the design of underground openings for mining and civil engineering processes.
Download or read book Software for Engineering Control of Landslide and Tunnelling Hazards written by Bhawani Singh and published by CRC Press. This book was released on 2002-01-01 with total page 368 pages. Available in PDF, EPUB and Kindle. Book excerpt: This practical study comprises eighteen practical and field-tested software packages on landslide in soil and rock and a further six on tunnels, complete with source programs, user manuals and worked examples. Using these software packages, this book illustrates how geomaterials in hazardous areas can be analyzed for potential failure and how predictions based on realistic input data can be generated.
Download or read book In situ Rock Stress written by Michael Tucker and published by CRC Press. This book was released on 2015-10-12 with total page 580 pages. Available in PDF, EPUB and Kindle. Book excerpt: With the new classification of chronic myeloproliferative disorders, and the rise of interest in molecularly targeted therapies, this timely text brings together international experts on the topic to discuss the current technologies and their implications for the treatment of patients. This title comprehensively covers chronic myeloid leukemia and Ph-negative chronic myeloproliferative disorders and is an essential resource for all practitioners in Hematologic Oncology.
Download or read book Rock Mechanics and Engineering written by C. Jaeger and published by Cambridge University Press. This book was released on 1979-06-28 with total page 544 pages. Available in PDF, EPUB and Kindle. Book excerpt: In this second, enlarged edition the author continues to emphasise aspects of rock mechanics. Firm in his belief that there is no better way to study the subject than by the detailed analysis of case histories, Dr Jaeger has incorporated a number of new ones.
